Page 154 of 328
152
Practical information
Removing a wheel
Parking the vehicle
Immobilise the vehicle where it does notblock traffic: the ground must be level,stable and not slippery. Apply the parking brake, switch off the
ignition and engage first gear *
to blockthe wheels. Check that the parking brake warninglamps in the instrument panel come on.
The occupants must get out of the vehicle and wait where they are safe.
Never go underneath a vehicle raised using a jack; use an axle stand.
List of operations
)
Remove the bolt cover from each of
the bolts using the tool 3(according toequipment). ) Fit the security socket 4on the wheelbrace 1to slacken the security bolt (if fitted). )
Slacken the other bolts using the
wheelbrace 1 only.
*
position R
for an electronic
gearbox; P
for an automatic gearbox.
Page 173 of 328
171
7
Practical information
Load reduction mode
System which manages the use of cer tainfunctions according to the level of charge
remaining in the battery.
When the vehicle is bein
g driven, the load
reduction function temporarily deactivates certain functions, such as the air conditioning,
the heated rear screen...
The deactivated functions are reactivatedautomatically as soon as conditions permit.
It is advisable to disconnect the battery if the vehicle is to be left unused for more than one month.
The batteries contain harmful substances such as sulphuric acid and lead. They must be disposed of in accordancewith regulations and must not, in any circumstances, be discarded with household waste.
Take used remote control batteries andvehicle batteries to a special collection point.
Do not reverse the polarity and use only a 12 V charger. Do not disconnect the terminals whilethe engine is running.
Do not charge the batteries withoutdisconnecting the terminals first.
Do not push the vehicle to star t the engine if you have an electronicgearbox or automatic gearbox.
Before disconnecting the battery
Wait 2 minutes after switching off the ignition
before disconnecting the battery.
Close the windows and the doors before disconnecting the battery.
Following reconnection of thebattery
Following reconnection of the battery, switch on
the ignition and wait 1 minute before star ting to permit initialisation of the electronic systems. However, if problems remain following this
operation, contact a PEUGEOT dealer or a
qualified workshop.
Referring to the corresponding section, you
must yourself reinitialise:
- the remote control key,
- the on-board satellite navi
gation system.
Page 176 of 328
174
Practical information
Towing the vehicle
Access to the tools
The towing eye is installed in the boot under
the floor.
To gain access to it: )open the boot, )lift the floor and remove it,
)remove the towing eye from the holder.
General recommendations
Observe the legislation in force in your country. Ensure that the weight of the towing vehicle is higher than that of the towed vehicle. The driver must stay at the wheel of the towed vehicle. Driving on motor ways and fast roads is prohibited when towing. When towing a vehicle with all four wheels on the ground, always use an approved towing bar; rope and straps are prohibited. When towing a vehicle with the engine off, there is no longer any power assistance for braking or steering.
In the following cases, you must always call on a professional recovery service: - vehicle broken down on a motor way or fast road, - when it is not possible to put the gearbox into neutral, unlock the steering, or release theparking brake, - towing with only two wheels on the ground, - where there is no approved towing bar available...
Procedure for havin
g your vehicle towed or for towing another vehicle using a removable towing eye.
Page 177 of 328
175
7
Practical information
To w i ng your vehicle
To w i ng another vehicle
)On the front bumper, unclip the cover bypressing at the bottom. )Screw the towing eye in fully. )Install the towing bar.
)
On the rear bumper, unclip the cover bypressing at the bottom. )
Screw the towing eye in fully. )
Install the towing bar. )
Switch on the hazard warning lamps on
both vehicles. )
Move off gently, drive slowly and for a shor t distance.
)Place the gear lever in neutral(position N
on an electronicgearbox or automatic gearbox).Failure to observe this instructioncould result in damage to certain components (braking, transmission...) and the absenceof braking assistance the next time the engine is star ted.
)
Unlock the steering by turning the key
in the ignition one notch and release the
parking brake. ) Switch on the hazard warning lamps onboth vehicles.
)
Move off gently, drive slowly and for a shor tdistance.
Page 197 of 328
195
8
Checks
Manual gearbox
The gearbox does not require anymaintenance (no oil change).
Refer to the servicing booklet for the
details of the level checking interval
for this component.
Electronic gearbox
The gearbox does not require any maintenance (no oil change).
Refer to the servicing booklet for
details of the checking inter val for thiscomponent.
Automatic gearbox
The gearbox does not require anymaintenance (no oil change).
Refer to the ser vicing booklet for
details of the level checkin
g interval
for this component. Brake wear depends on the st
yleof driving, par ticularly in the caseof vehicles used in town, over shor t
distances. It may be necessary tohave the condition of the brakes checked, even between vehicle services. Unless there is a leak in the circuit, a drop in
the brake fluid level indicates that the brake pads are worn.
Brake pads
For information on checking brake
disc wear, contact a PEUGEOT
dealer or a qualified workshop.
Brake disc wear
Parking brake
If excessive travel or a loss of
effectiveness of this system isnoticed, the parking brake must be checked, even between two ser vices.
Checkin
g this system must be done by a
PEUGEOT dealer or a qualified workshop.
Only use products recommended by PEUGEOT or products of equivalent quality and specification.
In order to optimise the operationof units as impor tant as the braking system, PEUGEOT selects and offers very specific products.
To avoid damaging the electrical units, the use of a high pressure washer in the engine compar tment is strictly prohibited.
Page 198 of 328
196
Technical data
ENGINES AND GEARBOXES
Petrol engines1.1 l i t r e V T i68 hp1.2 litre VTi82 hp1.4 litre VTi95 hpVTi110 hp
GearboxesManual(5-speed)
Manual(5-speed)
Electronic(5-speed)
Manual(5-speed)
Automatic
(4-speed)
Model codes: CC... CA...
ZMZ0
HMZ0 - HMX0
HMZ0/PS
8FP0 - 8FN05FS9
Cubic capacity (cc) 999
1 199
1 397
1 598
Bore x stroke (mm)
71 x 84.1
75 x 90.5
77 x 75
77 x 85.8
Max power: EU standard
(kW) 506070
105
Max power engine speed (rpm)
6 000 6 000
6 000
6 000
Max torque: EU standard
(Nm) 95
118
136
160
Max torque engine speed (rpm) 3 000
2 750
4 000
3 560
F
uel Unleaded Unleaded Unleaded Unleaded
Catalytic conver ter yes yes
yes
yes
OIL CAPACITIES (in litres)
Engine (with filter replacement) -3.2
4.25-
.../S: model fitted with Stop & Star t.
Page 199 of 328
9
197
Technical data
ENGINES AND GEARBOXES
Petrol engines1.6 litre VTi120 hp1.6 litre THP155 hp
Gearboxes
Manual(5-speed)
Manual(6-speed)
Model codes: CC... CA...5FS05FV8
Cubic capacity (cc)
1 598
1 598
Bore x stroke (mm)
77 x 85.8
77 x 85.8
Max power: EU standard (kW) 88
115
Max power en
gine speed (rpm) 6 000
6 000
Max torque: EU standard
(Nm)
160240
Max torque en
gine speed (rpm) 4 250
1 750
F
uel Unleaded Unleaded
Catalytic converter yes
yes
OIL CAPACITIES (in litres)
Engine (with filter replacement)
4.25-
Page 200 of 328
198
Technical data
Petrol engines1.1 litre VTi68hp1.2 litre VTi 82 hp
GearboxesManual (5-speed)
Manual(5-speed)
Electronic
(5-speed)
Model codes: CC... CA....ZMZ0
HMZ0 - HMX0
HMZ0/PS
Body3-door
5-door
3-door
5-door
3-door
5-door
- Unladen wei
ght 960
975960975 965 980
- Kerb weight *
1 0351 050
1 035
1 050 1 040
1 055
- Gross vehicle wei
ght (GV W)
1 4841 527 1 540
-
Gross train weight (GTW)
on a 12 % gradient1 934
2 347
2 040
- Braked trailer
(within GTW limit) on a 10 % or 12 % gradient450 820
500
- Braked trailer ** (with load transfer within the
GTW limit)
750
1 15 0
825
- Unbraked trailer
450
520
500
- Recommended nose weight 30
46
29
*
The kerb weight is equal to the unladen weight + driver (75 kg).
**
The weight of the braked trailer can be increased, within the GTW limit, if the GV W of the towing vehicle is reduced by an equal amount; warning,
towing using a lightly loaded towing vehicle may have an adverse effect on its road holding.
The
GTW and towed load values indicated are valid up to a maximum altitude of 1 000 metres; the towed load mentioned must be reduced by 10 % for
each additional 1 000 metres of altitude.
The speed of a towing vehicle must not exceed 60 mph (10 0 km/h) (comply with the legislation in force in your country).
High ambient temperatures may result in a reduction in the per formance of the vehicle to protect the engine; if the ambient temperature is above 37 °C,
limit the towed load.
