Page 49 of 328
47
2
Access
Electronic engine immobiliser
The key contains an electronic chip which has
a special code. When the ignition is switched on, this code must be recognised in order for star ting to be possible.
This electronic engine immobiliser locks theengine management system a few minutes
after the ignition is switched off and preventsstarting of the engine by anyone who does not
have the key.
Folding the key
)First press this button to fold the key.
)Press the closed padlock to
locate your locked vehicle in a car park.
Locating your vehicle
This is indicated by lighting of the cour tesy lamps and flashing of the direction indicators
for a few seconds.
Guide-me-home lighting
With the remote control
Make a long press this button to
operate the
guide-me-home lighting (switching on the sidelamps, dipped
beams and number plate lamps).
A second press be
fore the end of the timed period cancels the guide-me-home lighting.
Anti-theft protection
In the event of a fault, you are
informed by illumination of this
warning lamp, an audible signal and a message in the screen.
In this case, your vehicle will not start; contact
a PEUGEOT dealer as soon as possible.
If you do not press the button when folding the key, there is a risk of damageto the mechanism.
Keep safely the label attached to the keys given to you on acquisition of thevehicle.
Page 51 of 328
49
2
Access
Secondary control
doors in the event of a fault with the central
locking system or a battery failure.
Driver's door
Inser t the key in the lock to lock or unlock
the door.
Passenger doors
)On the rear doors, check that the child lock
is not on. )Remove the black cap located on the edge
of the door, using the key. )Inser t the key into the aper ture without forcing, then without turning, move the
latch sideways towards the inside of thedoor.
)Remove the key and refit the cap.
Changing the battery
Battery ref.: CR1620 / 3 volts.
Do not throw the remote control batteries away, they contain metalswhich are harmful to the environment.
Take them to an approved collectionpoint.
Remote control problem
Reinitialisation
)
Switch off the ignition. )
Turn the key to position 2 (Ignition). )
Press the closed padlock immediately
for a few seconds. ) Switch off the ignition and remove the key
from the ignition switch.
The remote control is fully operational again. Followin
g disconnection of the vehicle battery,replacement of the remote control battery or in the event of a remote control malfunction, you can no longer unlock, lock or locate your
vehicle. ) First of all, use the key in the lock to unlock
or lock your vehicle. ) Then, reinitialise the remote control.
I
f the problem persists, contact a PEUGEOT
dealer as soon as possible.
If the batter
y is flat, you are informed
by lighting of this warning lamp in the
instrument panel, an audible signal
and a message in the screen. ) Unclip the cover using a screwdriver in thecutout. )
Remove the cover. )
Extract the flat battery from its location.
)
Place the new battery into its location
observing the original direction. ) Clip the cover in place.
Page 58 of 328
56
Access
Panoramic sunroof System which comprises configurable light guides and a panoramic tinted glass area to increase
the light and visibility in the passenger compar tment. It is fitted with a manual blind in two par ts tomaintain a comfortable temperature.
)Take the blind by its handle and push it rear wards to the required position.
ClosingOpening
)Take the blind by its handle and pull it
for wards to the required position.
Page 66 of 328
64
!
Comfort
If the mirrors are folded using control A,they will not unfold when the vehicle isunlocked. Pull again on control A.
The folding and unfolding of the door mirrors using the remote control can bedeactivated by a PEUGEOT dealer or a qualified workshop.
Fold the mirrors when putting your vehicle through an automatic car wash.
Folding
- Automatic: lock the vehicle using the remote control or the key.
- Manual: with the ignition on, pull control Arearwards.
Unfolding
- Automatic: unlock the vehicle using the remote control or the key.
- Manual: with the ignition on, pull control Arearwards.
Automatic day/night model
By means of a sensor, which measures the
light from the rear of the vehicle, this system
automatically and progressively changes
between the day and night uses. Adjustable mirror providing a central rear ward
vi
ew.
Equipped with an anti-dazzle system, which
darkens the mirror glass: this reduces
the nuisance to the driver caused by the
headlamps from following vehicles, low sun...
Rear view mirror
Manual day/night model
Ad
justment
)
Adjust the mirror so that the glass is
directed correctl
y in the "day" position.
Day / night position
)
Pull the lever to change to the "night" anti-
dazzle position.
) Push the lever to change to the normal "day" position.
In order to ensure optimum visibilityduring your manoeuvres, the mirror lightens automatically when reversegear is engaged.
As a safety measure, the mirrors should be adjusted to reduce the "blind spot".
Page 70 of 328
68
Comfort
1. Temperature adjustment
)Turn the dial from blue (cold) to red (hot) to adjust
the temperature to your
requirements.
The air conditioning system only operates with the engine running.
2. Air fl ow adjustment
)Turn the dial from position 1to position 6to obtain acomfortable air flow.
If you put the air flow control in position 0
(system off), the temperature is no longer controlled. However,a slight flow of air can still be felt, resulting from the movement of thevehicle.
Manual air conditioning
Heating / Ventilation
Page 74 of 328
72
Comfort
7. Air fl ow adjustment
)
Press this "full fan"
button to
increase the air flow.
)
Press this "empty fan"button to
reduce the air flow.
8. Air intake/Air recirculation
)
Press the "empty fan"
air flow
button until the fan symboldisappears and "---" appears.
Switching the system off
)Press this button to recirculate
the interior air. The indicator lamp in the button comes on andthe air recirculation symbol is
displayed.
Air recirculation prevents exterior odours
and smoke from entering the passenger compartment. It is activated automatically when
operating the screen wash.
Avoid driving for too long with the system switched off (risk of misting and of deterioration of the air quality).
Pressing the "full fan"buttonreactivates the system with the settings prior to deactivation.
The air
flow symbol (a fan) appears in thescreen. It is filled in progressively in relation
to the value required. Thi
s action switches off all of the functions of
the air conditioning system.
The temperature is no longer maintained at acomfor table level. However, a slight flow of air,
due to the movement of the vehicle, can still be felt. ) As soon as possible, press this button
again to permit the intake of exterior air and
prevent misting. The indicator lamp in the
button
goes off.
) Press this button several times in succession to direct the air flowin turn towards:
6. Air distribution adjustment
- the windscreen, the side windows and the
footwells,
- the windscreen and side windows (demisting or defrosting),
- the central and side vents,
- the central vents, the side vents and the
footwells,
- the footwells.
Avoid prolonged operation in interior air recirculation mode (risk of misting and of deterioration of the air quality).
Page 81 of 328
79
3
Comfort
Rear parcel shelf Hooks
To remove the shelf: )unhook the two cords, )raise the shelf slightly, then remove it.
You have two stora
ge options:
- either upright behind the front seats,
- or upright behind the rear seats.The hooks can be used to secure shopping
ba
gs.
Page 82 of 328
80
Comfort
Warning triangle (stowing)
Before leaving your vehicle to set up
and install the triangle, put on your high visibility vest.
The dimensions o
f the triangle (once folded) or
its storage box must be:
- A: length = 438mm,
- B: height = 56
mm, -C: width = 38mm.To use the triangle, refer to the manufacturer'sinstructions.
Placing the triangle in the road
The location for stowing a folded triangle or its box is under the front seat.
Distance from your vehicle (in metres)
Road
Motorway
DayNight
50 m 80 m 150 m
These are the internationally recognisedvalues.
Use the triangle in line with local driving regulations.
The trian
gle is available as an accessory, contact a PEUGEOT dealer or a qualified
workshop.
) Place the triangle at a distance behindthe vehicle, as shown in the table below,
according to the type of road and the levelof ambient light.
