2012 PEUGEOT 107 battery

.
.
Contents
Child seats 57
ISOFIX mountings 62
Child safety
Changing a wheel 65
Changing a bulb 67
Changing a fuse 71
Battery 76
Mat 79
Fitting audio equipment/speakers 79
To w i ng the vehicle 80
Fitting roof bars 81
Accessories 82
Practical information
Audio system / Bluetooth 93
Audio system 116
Audio equipment
Alphabetical indexVisual search
Opening the bonnet 84
Engine 85
Checking levels 86
Checks 88
Checks
Engine 89
Weights 90
Dimensions 91
Identifi cation markings 92
Technical data

P/S
Instruments and controls
22



Deactivating
the passenger'sairbag fixed. The passen
ger's airbag control is set to the OFF
position.
The passenger's front airbag is
deactivated.
In this case you can install a
"rear
facing"child seat.
Set the control to the ON
position to activate the passenger's
front airbag. In this case, do not fit a child seat in therear-facing position.



Battery charge

fixed. The battery charging circuit has
a fault (dirty or loose terminals, slack or cut alternator belt, ...). The warnin
g lamp should go off when the engine is started.
If it does not go off, contact a PEUGEOT dealer or a qualified
workshop.

Electric power steering
fixed. The electric power steering hasa fault. Drive carefully at reduced speed.
Have it checked by a PEUGEOT dealer or qualified workshop.



Front seat beltnot fastened /
unfastened(depending on version)


flashing, then above
12 mph (20 km/h),
accompanied b
y an audible signal.
The driver and/or front
passenger has not fastened or has unfastened their seat belt. Pull the strap then inser t the tongue in the buckle.



Emission control system fixed. The emission control system has a fault. This lamp should
go off when the engine is started.
If it does not go off, contact a PEUGEOT dealer or a qualified
workshop without delay.

2 Tr o n i c gearbox
fixed. The 2 Tr o n i c gearbox has a
fault. Contact a PEUGEOT dealer or a qualified workshop without
delay.
Warning lampis onCauseAction/Observations

22
27 Access
Electronic engine immobiliser Chan
ging the remote
control battery
Reinitialising the remote
control
Following replacement of the remote control
batter
y or in the event of a remote control fault,it may be necessary to reinitialise the system. ) Switch off the ignition.)
Switch the ignition on again.)
Press one of the remote control buttons
immediately for a few seconds.) Switch off the ignition and remove the key
from the ignition lock.The remote control is now working again.If the fault persists, contact a PEUGEOT
dealer or a qualified workshop.
Do not discard the remote controlbatteries, they contain metals which are harmful to the environment. Take them to a PEUGEOT dealership,
or to any other approved collection point. Driving with the doors locked may make
access to the passenger compar tment
by the emergency ser vices more
difficult in an emergency.
As a safety measure (with children on
board), remove the key from the ignition
when leaving the vehicle, even for a
shor t time.
Do not make any modifications to the
electronic immobiliser system.

To change the battery, remove the screw then
unclip the housing using a coin inserted at
the rin
g.
Battery CR 2016/3 volts.
If the remote control does not work after thebattery has been changed, reinitialise it. The high frequency remote control is
a sensitive system; do not operate it
in your pockets as there is a risk that
it may unlock the vehicle without you
being aware of this.
Avoid pressing the buttons of your
remote control out of range of
your vehicle, you risk rendering it
inoperative. It would then have to be
reinitialised. This locks the engine management system as
soon as the ignition has been switched off and
therefore prevents star ting of the vehicle byanyone who does not have the key.
The ignition key has an electronic chip whichhas a special code. When the ignition is
switched on, the code must be recognised for
starting to be possible.
In the event of a malfunction, your vehicle willnot start.Contact a PEUGEOT dealer or a qualifiedworkshop.

9
71 Practical information




















Changing a fuse


Removing and fitting a fuse
Failed
Tweezer A
Th
ese are located on each side of the
instrument panel under the trim.
) If necessary, unlock the steering using the
key. ) Turn the steering wheel to the left, remove bolt B.
)
Turn the steering wheel to the right, removebolt C.


Always replace a failed fuse with a fuse of the same rating (same colour).


Instrument panel fuseboxes


The fuseboxes are located under the instrument panel trim and next to the battery in the engine compartment.

Before chan
ging a fuse, the cause of the
incident must be found and rectified. )Use the tweezer A located in the fusebox under the bonnet.

76Practical information
Connect the red cable to the positive
terminal
(+) of the flat battery A, then to the
positive terminal (+) of the slave battery B.) Connect one end of the green or black cable to the negative terminal (-) of theslave battery B.
Starting using another battery
)Connect the other end of the green or black
cable to the ear th point Con your vehicle(engine mounting). )Operate the star ter, let the engine run. )Wait until the engine returns to idle anddisconnect the cables.





Battery
Procedure for charging your battery when it
is flat or for star ting the engine using another
battery.
The batter
y is located under the bonnet.To gain access to it:)open the bonnet using the interior release lever, then the exterior safety catch,)secure the bonnet stay,)remove the plastic cover on the (+)
terminal.
Access to the battery

9
77 Practical information









Charging the battery using
a battery charger
)Disconnect the battery from the vehicle.
)Follow the instructions for use provided by
the manufacturer of the charger.)Connect the battery star ting with thenegative terminal (-).)Check that the terminals and connectorsare clean. If they are covered with sulphate (whitish or greenish deposit), remove themand clean them.

The batteries contain harmful substances such as sulphuric acidand lead. They must be disposed of inaccordance with regulations and mustnot, in any circumstances, be discarded with household waste.
Take used remote control batteries andvehicle batteries to a special collection point.
Do not push the vehicle to star t the engine if you have a 2 Tronic gearbox.

It is advisable to disconnect the batteryif the vehicle is to be left unused for more than one month.


Do not reverse the polarity and use onlya 12 V charger.
Do not disconnect the terminals whilethe engine is running.
Do not charge the batteries withoutdisconnecting the terminals first.

78Practical information
Before disconnecting the battery
Wait 2 minutes after switching off the ignition
before disconnecting the battery.
Close the windows and the doors before disconnecting the battery.


Following reconnection of thebattery

Following reconnection of the battery, switch on
the i
gnition and wait 1 minute before star ting to
permit initialisation of the electronic systems.However, if problems remain following this
operation, contact a PEUGEOT dealer or aqualified workshop.
Referring to the corresponding section, you
must yourself reinitialise:


- the remote control key,

- the audio system.

10
85 Checks
1. Coolant header tank2.Screenwash fluid reservoir 3.Brake fluid reservoir 4.Fusebox
5.Battery6. Air filter 7.Engine oil dipstick8.
Engine oil filler cap












Engine