2012 MITSUBISHI iMiEV wheel size

Overview
Outside (Rear)
N00100601307
Antenna P.5-40Back-up light P.7-36, 7-42
Tail and stop lights P.3-76, 7-36, 7-42
Rear turn signal lights P.3-82, 7-36, 7-42
Regular charging lid P.1-21
Tire pressure monitoring system P.3-49
Size of tires and wheels P.9-9
Tire inflation pressure P.7-21
Tire rotation P.7-24
Tire chains P.7-24 License plate lights
P.3-76, 7-36, 7-47 Liftgate P.3-16
Rear-view camera
(if so equipped) P.3-55
Rear side-marker lights P.3-76, 7-36,
7-44Keyless entry system
P. 3 - 7
Locking and unlocking
P. 3 - 1 2 High-mounted stop light
P.7-36, 7-45
Rear window wiper
P. 3 - 8 7
BK0140800US.book 6 ページ ２０１１年９月２９日　木曜日　午後３時２８分

General information/Charging
1-7
1 Modifications to and racing of your vehicle
N01200500017
This vehicle should not be modified with non-Mitsubishi
Motors genuine parts. Mitsubishi Motors designs and manufac-
tures high quality vehicles with an emphasis on safety and
durability. Modifications using non-Mitsubishi Motors genuine
parts may affect the performance, safety and/or durability of
your vehicle, and may violate applicable state and/or federal
regulations.
DAMAGE OR PERFORMANCE PROBLEMS RESULT-
ING FROM MODIFICATIONS TO OR RACING OF
YOUR VEHICLE ARE NOT COVERED UNDER WAR-
RANTY.
Examples of modifications to your vehicle that can cause dam-
age or performance problems include the following:

Failure to use Mitsubishi Motors genuine parts

Failure to use required fluids (refer to “Refill capacities”
on page 9-10)

Failure to use proper size tires and wheels

Modification of the suspension, electric motor, drive train,
batteries (main drive lithium-ion battery and 12V starter
battery), charging systems or electrical wiring systems

Modification of any onboard computer/control module,
including reprogramming, or replacing/adding chips to
any onboard computer/control module
Review the Warranty and Maintenance Manual for further
details regarding warranty coverage.
Installation of accessories
N01200600018

The installation of accessories, optional parts, etc., should
only be carried out within the limits prescribed by law in
the driving area and in accordance with the guidelines and
warnings contained within the documents accompanying
this vehicle.
Only Mitsubishi Motors approved accessories should be
fitted to your vehicle.

Improper installation of electrical parts could cause fire.
Refer to the “Modification/alterations to the electrical sys-
tems” section within this owner’s manual.

Tires and wheels which do not meet specifications must
not be used.
Refer to the “Specifications” section for information
regarding wheel and tire sizes.
CAUTION
!
Before any electrical or electronic accessories are
installed, consult a certified i-MiEV dealer.
WA R N I N G
!
If you choose to use a cellular phone while driving,
you must not allow that usage to distract you in the
safe operation of your vehicle. Anything, including
cellular phone usage, that distracts you from the
safe operation of your vehicle increases your risk of
an accident.
Refer to and follow all local laws in your area
regarding cellular phone usage while driving.
BK0140800US.book 7 ページ ２０１１年９月２９日　木曜日　午後３時２８分

3-42 Features and controls
3

An operation noise may be emitted from under the hood in
the following situations. The sound is associated with
checking the operations of the anti-lock braking system.
At this time, you may feel a shock from the brake pedal if
you depress it. These do not indicate a malfunction.
• When the electric motor switch is set to the “ON” posi-
tion.
• When the vehicle is driven for a while after the electric
motor is turned on.

The ABS can be used after the vehicle has reached a speed
over approximately 6 mph (10 km/h). It stops working
when the vehicle slows below approximately 3 mph (5
km/h).
Anti-lock braking system warning light
N00531600661
This light comes on in the event of a malfunction in the anti-
lock braking system. It will also come on as a self-check for a
few seconds when the electric motor switch is turned to the
“ON” position. Always make sure that the light goes out before
beginning to drive.
CAUTION
!
The anti-lock braking system cannot prevent acci-
dents. It is your responsibility to take safety precau-
tions and to drive carefully.
Be sure to use the specified type and size of tire on
all four wheels. Otherwise, the ABS may not work
properly.
Do not install any aftermarket limited slip differen-
tial (LSD) on your vehicle. The ABS may stop func-
tioning properly.
CAUTION
!
If the anti-lock braking system warning light comes
on and stays on after starting the electric motor unit
or while driving, it means that the anti-lock braking
system is not working and that only the standard
brake system is available. (The standard brake sys-
tem will still work properly.) If this happens, take
your vehicle to a certified i-MiEV dealer as soon as
possible.
BK0140800US.book 42 ページ ２０１１年９月２９日　木曜日　午後３時２８分

3-46 Features and controls
3Active stability control (ASC)
N00559100163
The active stability control (ASC) takes overall control of the
anti-lock braking system, traction control function and skid
control function to help maintain the vehicle’s control. Also
refer to the following pages on the anti-lock braking system,
traction control function and skid control function.
Anti-lock braking system (ABS) → P. 3 - 4 1
Traction control function → P. 3 - 4 6
Skid control function → P. 3 - 4 7
NOTE
An operation noise may be emitted from under the hood in
the following situations. The sound is associated with
checking the operations of the ASC. At this time, you may
feel a shock from the brake pedal if you depress it. These
do not indicate a malfunction.
• When the electric motor switch is set to the “ON” posi-
tion.
• When the vehicle is driven for a while after the electric
motor unit is turned on.

When the ASC is activated, you may feel a vibration in
the vehicle body or hear a whining sound from under the
hood.
This indicates that the system is operating normally. It
does not indicate a malfunction.

When the anti-lock braking system warning light is illu-
minated, the ASC is not active.Traction control function
N00559200050
On slippery surfaces, the traction control function prevents the
drive wheels from spinning excessively, thus helping the vehi-
cle to start moving from a stopped condition. It also provides
sufficient driving force and steering performance as the vehicle
turns while pressing the acceleration pedal.
CAUTION
!
Do not over-rely on the ASC. Even the ASC cannot
prevent the natural laws of physics from acting on
the vehicle. This system, like any other system, has
limits and cannot help you to maintain traction and
control of the vehicle in all circumstances. Reckless
driving can lead to accidents. It is the driver’s
responsibility to drive carefully. This means taking
into account the traffic, road and environmental
conditions.
Be sure to use the specified type and size of tire on
all four wheels. Otherwise, the ASC may not work
properly.
Do not install any aftermarket limited slip differen-
tial (LSD) on your vehicle. The ASC may stop func-
tioning properly.
CAUTION
!
When driving a vehicle on a snowy or icy road, be
sure to install snow tires and drive the vehicle at
moderate speeds.
BK0140800US.book 46 ページ ２０１１年９月２９日　木曜日　午後３時２８分

Vehicle care and maintenance
7-23
7
Replacing tires and wheels
N00939600427
Tire maintenance
N00939700170
The following maintenance steps are recommended:

Check tire pressures regularly.

Have regular maintenance done on the wheel balance and
front and rear suspension alignment.
Tread wear indicators
N00939800214
Tread wear indicators are built into the original equipment tires
on your vehicle to help you know when your tires should be
replaced. Many states have laws requiring that you replace
your tires at this point.
These indicators are molded into the bottom of the tread
grooves and will appear when the tire tread is worn down to
1/16 inch (1.6 mm).
When the bands appear next to one another in two or more
places, replace your tires. NOTE
Tire wear indicators can have different marks and loca-
tions depending on the tire manufacturer.
CAUTION
!
Avoid using different size tires and wheels from the
ones listed, and avoid the combined use of different
types of tires and wheels. Using different size or type
tires and wheels may affect driving safety.
Refer to “Tires and wheels” on page 9-9.
Even if a wheel has the same rim size and offset as
the specified type of wheel, its shape may prevent it
from being fitted correctly. Consult a certified
i-MiEV dealer before using wheels that you have.
Only Mitsubishi Motors genuine wheels should be
used, because your vehicle is equipped with a tire
pressure monitoring system.
Use of another type of wheel risks air leaks and
sensor damage, as it will not be possible to install the
tire pressure sensor properly.
1- Location of the tread wear indicator
2- Tread wear indicator
BK0140800US.book 23 ページ ２０１１年９月２９日　木曜日　午後３時２８分

7-24 Vehicle care and maintenance
7
Tire rotation
N00939900518
Because the front and rear tires and wheels are not the same
size, do not rotate the front and rear tires.
Snow tires
N00940000359
In some areas of the country, snow tires are required for winter
driving. If snow tires are required in your area, you must
choose snow tires of the same size and type as the original tires
provided with your vehicle. Snow tires should also be installed
on all four wheels. Otherwise your safety and vehicle handling
can be reduced.
Even where laws may permit it, snow tires should not be oper-
ated at sustained speeds over 75 mph (120 km/h).Tire chains
N00940100129
WA R N I N G
!
Rotating tires would compromise the stability and
drivability of the vehicle and could lead to a serious
accident.
CAUTION
!
If flange nuts are used on your vehicle, change to
tapered nuts when using snow tires with steel
wheels.
Only Mitsubishi Motors genuine wheels should be
used, because your vehicle is equipped with a tire
pressure monitoring system.
Use of another type of wheel risks air leaks and
sensor damage, as it will not be possible to install the
tire pressure sensor properly.
CAUTION
!
Tire chains cannot be used on your vehicle. The
clearance between the chains and the body is not
sufficient to allow proper clearance, and the vehicle
body might be damaged.
BK0140800US.book 24 ページ ２０１１年９月２９日　木曜日　午後３時２８分

Specifications
9-9
9 Tires and wheels
N01147900734
PCD: Pitch Circle Diameter (installation holes)NOTE
Contact a certified i-MiEV dealer for details on the combination used on your vehicle.

These tires satisfy vehicle loading conditions described in this owner’s manual.
Item
Front
Rear
Tire 145/65R15 72H 175/60R15 81HWheel
Size 15x4J 15x5JPCD 3.93 in (100 mm)Offset 1.37 in (35 mm)
BK0140800US.book 9 ページ ２０１１年９月２９日　木曜日　午後３時２８分

Alphabetical index
6Force limiter 2-23
Front passenger seat belt warning light 2-18
Maintenance and inspection 2-34
Pre-tensioner 2-21
Seat belt extender 2-20
Seat belt instructions 2-14
Seat belt use during pregnancy 2-21
Service brake 3-39
Service precautions 7-2
Service reminder 3-61
,3-63
Skid control function 3-47
Snow tires 7-24
Speedometer 3-59
Steering
Wheel lock 3-32
Stop lights
Bulb capacity 7-36
Replacement 7-42
Storage spaces 3-128
Sun visors 3-122
Supplemental Restraint System 2-35
How the Supplement Restraint System works 2-39
Servicing 2-57
Warning light 2-44
T
Tail lights
Bulb capacity 7-36
Replacement 7-42Theft-alarm system 3-18
Tire
Quality grading 8-2
Tire pressure monitoring system 3-49
Tire repair kit 6-7
Tires 7-18
Inflation pressure 7-21
Maintenance 7-23
Replacing tires and wheels 7-23
Rotation 7-24
Size (tire and wheel) 9-9
Snow tires 7-24
Tire and loading information placard 4-10
,9-4
Tire chains 7-24
Tread wear indicators 7-23
Towing 6-19
Traction control function 3-46
Trailer towing 4-14
Transmission 3-33
Selector lever operation 3-33
Selector lever position indicator 3-34
Selector lever positions 3-35
Trip odometer 3-61
,3-63
Turn signal lights
Indicators 3-72
Lever 3-82
U
USB input terminal 3-117
BK0140800US.book 6 ページ ２０１１年９月２９日　木曜日　午後３時２８分