2012 MITSUBISHI iMiEV inflation pressure

Overview
Outside (Rear)
N00100601307
Antenna P.5-40Back-up light P.7-36, 7-42
Tail and stop lights P.3-76, 7-36, 7-42
Rear turn signal lights P.3-82, 7-36, 7-42
Regular charging lid P.1-21
Tire pressure monitoring system P.3-49
Size of tires and wheels P.9-9
Tire inflation pressure P.7-21
Tire rotation P.7-24
Tire chains P.7-24 License plate lights
P.3-76, 7-36, 7-47 Liftgate P.3-16
Rear-view camera
(if so equipped) P.3-55
Rear side-marker lights P.3-76, 7-36,
7-44Keyless entry system
P. 3 - 7
Locking and unlocking
P. 3 - 1 2 High-mounted stop light
P.7-36, 7-45
Rear window wiper
P. 3 - 8 7
BK0140800US.book 6 ページ ２０１１年９月２９日　木曜日　午後３時２８分

Quick index
3
Selector lever position indicator in the instru-
ment cluster flashes slowly
Have the transmission checked at a certified i-MiEV dealer as soon as
possible.P. 3 - 3 4
and
ASC indicator and ASC OFF indicator
Park your vehicle in a safe place and turn off the electric motor unit.
Restart the electric motor unit and check to see if the indicator comes
on again.

If the indicator does not go out, or if it comes on again, have your
vehicle inspected at a certified i-MiEV dealer as soon as possible.

When this indicator comes on, the active stability control is not func-
tioning and normal operation of the vehicle will not be affected.P. 3 - 4 8
Tire pressure monitoring system warning light
If the warning light comes on, you should stop and adjust the tires to
the proper inflation pressure as soon as possible.
(See “Tire inflation pressures” on page 7-21.)
Once adjustments have been made, the warning light will go off after
a few minutes of driving.

If the warning light blinks for approximately 1 minute and then
remains continuously illuminated, the system is not operating prop-
erly. If the system returns to normal, the warning light will go off. If
the warning light does not go off, have the vehicle inspected at a cer-
tified i-MiEV dealer.P.3-50, 3-52
Warning light
Do this
Ref. page
BK0140800US.book 3 ページ ２０１１年９月２９日　木曜日　午後３時２８分

Features and controls
3-49
3 Tire pressure monitoring system
N00530200426
The tire pressure monitoring system uses tire inflation pressure
sensors (A) on the wheels to monitor the tire inflation pres-
sures. The system only indicates when a tire is significantly
under-inflated.
CAUTION
!
If an abnormal condition occurs in the system while
driving, the and indicators will illuminate.
In these cases, follow these procedures:
• Park your vehicle in a safe place and stop the elec-
tric motor unit. Restart the electric motor unit
again and check whether the and indicators
go out. If these indicators go out, there is no abnor-
mal condition.
If the and indicators remain on even after
your vehicle is driven a short distance after re-
starting the electric motor unit, have the vehicle
inspected by a certified i-MiEV dealer as soon as
possible.

When towing the vehicle with only the rear wheels
raised off the ground, do not place the electric motor
switch in the “ON” position. Placing the electric
motor switch in the “ON” position could cause the
ASC to operate, resulting in an accident.
For details, refer to “Towing” on page 6-19.
BK0140800US.book 49 ページ ２０１１年９月２９日　木曜日　午後３時２８分

3-50 Features and controls
3
NOTE
The tire pressure monitoring system is not a substitute for
regularly checking tire inflation pressures.
Be sure to check the tire inflation pressures as described in
“Tires” on page 7-18.

The tire inflation pressure sensor (A) is installed in the
illustrated location. Replace grommet (B) with a new one
when the tire is replaced.
For details, please contact a certified i-MiEV dealer.
Tire pressure monitoring system warning light
N00554800136
When the electric motor switch is turned to the “ON” position,
this light normally illuminates and goes off a few seconds later.
If one or more of the vehicle tires is significantly under-
inflated, however, this light will remain illuminated while the
electric motor switch is in the “ON” position.
Refer to “If the warning light illuminates while driving” on
page 3-52 and take the necessary measures.
CAUTION
!
If the tire pressure monitoring system warning light
does not illuminate when the electric motor switch is
turned to the “ON” position, it means that the tire
pressure monitoring system is not working properly.
Have the system inspected by a certified i-MiEV
dealer.
In such situations, a malfunctioning of the system
may be preventing the monitoring of the tire pres-
sure. Avoid sudden braking, sharp turning and
high-speed driving.
BK0140800US.book 50 ページ ２０１１年９月２９日　木曜日　午後３時２８分

Features and controls
3-51
3
Each tire, including the spare (if provided), should be checked
monthly when cold and inflated to the inflation pressure rec-
ommended by the vehicle manufacturer on the vehicle placard
or tire inflation pressure label. (If your vehicle has tires of a
different size than the size indicated on the vehicle placard or
tire inflation pressure label, you should determine the proper
tire inflation pressure for those tires.)
As an added safety feature, your vehicle has been equipped
with a tire pressure monitoring system (TPMS) that illuminates
a low tire pressure telltale when one or more of your tires is
significantly under-inflated.
Accordingly, when the low tire pressure telltale illuminates,
you should stop and check your tires as soon as possible, and
inflate them to the proper pressure.
Driving on a significantly under-inflated tire causes the tire to
overheat and can lead to tire failure.

If a malfunction is detected in the tire pressure mon-
itoring system, the tire pressure monitoring system
warning light will blink for approximately 1 minute
and then remain continuously illuminated. The
warning light will issue further warnings each time
the electric motor unit is restarted as long as the
malfunction exists.
Check to see whether the warning light goes off after
few minutes of driving.
If it then goes off during driving, there is no prob-
lem.
However, if the warning light does not go off, or if it
blinks again when the electric motor unit is
restarted, have the vehicle inspected by a certified i-
MiEV dealer.
In such situations, a malfunctioning of the system
may be preventing the monitoring of the tire pres-
sure. For safety reasons, when the warning light
appears while driving, avoid sudden braking, sharp
turning and high-speed driving.
CAUTION
!
BK0140800US.book 51 ページ ２０１１年９月２９日　木曜日　午後３時２８分

3-52 Features and controls
3
Under-inflation also reduces alternative fuel efficiency and tire
tread life, and may affect the vehicle’s handling and stopping
ability.
Please note that the TPMS is not a substitute for proper tire
maintenance, and it is the driver’s responsibility to maintain
correct tire pressure, even if under-inflation has not reached the
level to trigger illumination of the TPMS low tire pressure tell-
tale.
Your vehicle has also been equipped with a TPMS malfunction
indicator to indicate when the system is not operating properly.
The TPMS malfunction indicator is combined with the low tire
pressure telltale.
When the system detects a malfunction, the telltale will flash
for approximately one minute and then remain continuously
illuminated. This sequence will continue upon subsequent
vehicle start-ups as long as the malfunction exists.
When the malfunction indicator is illuminated, the system may
not be able to detect or signal low tire pressure as intended.
TPMS malfunctions may occur for a variety of reasons, includ-
ing the installation of replacement or alternate tires or wheels
on the vehicle that prevent the TPMS from functioning prop-
erly. Always check the TPMS malfunction telltale after replac-
ing one or more tires or wheels on your vehicle to ensure that
the replacement or alternate tires and wheels allow the TPMS
to continue to function properly.
If the warning light illuminates while driving
N00532800484
1. If the low tire pressure monitoring system warning light
illuminates, avoid hard braking, sharp steering maneuvers
and high speeds. You should stop and adjust the tires to
the proper inflation pressure as soon as possible. Refer to
“Tires” on page 7-18.NOTE
When inspecting or adjusting the tire pressure, to avoid
breakage, do not apply excessive force to the valve stem.

After inspecting or adjusting the tire pressure, always
reinstall the valve cap on the valve stem.
Without the valve cap, dirt or moisture could get into the
valve, resulting in damage to the tire inflation pressure
sensor.

Do not use metal valve caps, which may cause a metal
reaction, resulting in corrosion and damage of the tire
inflation pressure sensors.

Once adjustments have been made, the warning light will
go off after a few minutes of driving.
2. If the tire pressure monitoring system warning light
remains illuminated after you have been driving for about
20 minutes after you adjust the tire inflation pressure, one
or more of the tires may have a puncture. Inspect the tire
and if it has a puncture, have it repaired by a certified i-
MiEV dealer as soon as possible.
BK0140800US.book 52 ページ ２０１１年９月２９日　木曜日　午後３時２８分

Features and controls
3-53
3
NOTE
To avoid the risk of damage to the tire inflation pressure
sensors, have any punctured tire repaired by a certified i-
MiEV dealer. If the tire repair is not done by a certified i-
MiEV dealer, it is not covered by your warranty.

Do not use an aerosol puncture-repair spray on any tire.
Such a spray could damage the tire inflation pressure sen-
sors.

Using the tire repair kit may damage the tire inflation
pressure sensor. The vehicle must promptly be inspected
and repaired by a certified i-MiEV dealer after using the
tire repair kit.The tire pressure monitoring system may not work normally in
the following circumstances:

A wireless facility or device using the same frequency is
near the vehicle.

Snow or ice is stuck inside the fenders and/or on the
wheels.

The tire inflation pressure sensors’ battery is exhausted.

Wheels other than Mitsubishi Motors genuine wheels are
being used.

Wheels that are not fitted with tire inflation pressure sen-
sors are being used.

Wheels whose ID codes are not memorized by the vehicle
are used.

A window tint that affects the radio wave signals is
installed.
NOTE
Tire inflation pressures vary with the ambient tempera-
ture. If the vehicle is subjected to large variations in ambi-
ent temperature, the tire inflation pressures may be under-
inflated (causing the warning light to come on) when the
ambient temperature is relatively low. If the warning light
comes on, adjust the tire inflation pressure.
WA R N I N G
!
If the tire pressure monitoring system warning light
illuminates while you are driving, avoid hard brak-
ing, sharp steering maneuvers and high speeds.
Driving with an under-inflated tire adversely affects
vehicle performance and can result in an accident.
CAUTION
!
The tire pressure monitoring system warning light
may not illuminate immediately in the event of a tire
blowout or rapid leak.
BK0140800US.book 53 ページ ２０１１年９月２９日　木曜日　午後３時２８分

3-54 Features and controls
3
Whenever the tires and wheels are replaced with
new ones
N00532900182
If you use new wheels with new tire inflation pressure sensors,
their ID codes must be programmed into the tire pressure mon-
itoring system. Have tire and wheel replacement performed by
a certified i-MiEV dealer to avoid the risk of damaging the tire
inflation pressure sensors.
General information
N00533000207
Your tire pressure monitoring system operates on a radio fre-
quency subject to Federal Communications Commission
(FCC) Rules (For vehicles sold in U.S.A.) and Industry Canada
Rules (For vehicles sold in Canada). This device complies with
Part 15 of the FCC Rules and RSS- Gen of the Industry Canada
Rules.
Operation is subject to the following two conditions.

This device may not cause harmful interference.

This device must accept any interference received, includ-
ing interference that may cause undesired operation.
CAUTION
!
The use of non-genuine wheels will prevent the
proper fit of the tire inflation pressure sensors,
resulting air leakage or damage of the sensors.
CAUTION
!
Changes or modifications not expressly approved by
the manufacturer for compliance could void the
user’s authority to operate the equipment.
BK0140800US.book 54 ページ ２０１１年９月２９日　木曜日　午後３時２８分