2012 MITSUBISHI iMiEV ECU

5-24 Comfort controls
5
To listen to a CD
N00735501074
To set a disc1. Press the POWER button until it beeps to turn the audio
system ON and OFF. The system turns on in the last mode
used.
2. Insert the disc with the label facing up.
When a disc is inserted, the CD indicator will come on
and the CD player will begin playing even if the radio is
being used. The CD player will also begin playing when
the CD button is pressed with a disc set in the CD player
or in the disc loading slot, even if the radio is being used.NOTE
For information concerning the adjustment of volume and
tone, refer to “To adjust the volume” on page 5-19 and
“To adjust the tone” on page 5-20.

8 cm compact disc cannot be played on this CD player.

For information concerning the handing of the compact
discs, refer to “Handling of compact discs” on page 5-38.To eject a discWhen the eject button is pressed, the disc automatically stops
and is ejected. The system automatically switches to radio
mode.NOTE
If you do not remove an ejected disc before 15 seconds
have elapsed, the disc will be reloaded.
To listen to a music CDPush the CD button if a disc is already in the CD player. The
audio system will enter CD mode and start playback. The track
number and the playing time will appear on the display. The
tracks in the disc will be played consecutively and continu-
ously.
BK0140800US.book 24 ページ ２０１１年９月２９日　木曜日　午後３時２８分

5-40 Comfort controls
5
Notes on CD-Rs/RWs
N00751900112

You may have trouble playing back some CD-R/RW discs
recorded on CD recorders (CD-R/RW drives), either due
to their recording characteristics or dirt, fingerprints,
scratches, etc. on the disc surface.

CD-R/RW discs are less resistant to high temperatures and
high humidity than ordinary music CDs and can therefore
be damaged and rendered unplayable if left inside your
vehicle for a long time.

Depending on the combination of the writing software,
the CD recorder (CD-R/RW drive), and the disc used to
create a CD-R/RW, the disc might not play successfully.

This player cannot play the CD-R/RW discs if the session
is not closed.

This player cannot play CD-R/RW discs which contain
data other than CD-DA or MP3 data (Video CD, etc.).

Be sure to observe the handling instructions for the CD-
R/RW disc.
Antenna
N00734200471
To removeTurn the pole (A) counterclockwise.To installScrew the pole (A) clockwise into the base (B) until it is
securely retained.NOTE
Be sure to remove the roof antenna in the following cases:
• When using an automatic car wash
• When covering your vehicle with a car cover
• When driving into a structure that has a low ceiling.
WA R N I N G
!
Operating the CD player in a manner other than
specifically instructed herein may result in hazard-
ous radiation exposure. Do not remove the cover
and attempt to repair the CD player by yourself.
There are no user serviceable parts inside. In case of
malfunction, contact a certified i-MiEV dealer.
BK0140800US.book 40 ページ ２０１１年９月２９日　木曜日　午後３時２８分

6-14 For emergencies
6
11. Holding the sealant bottle upside-down, squeeze it again
and again to inject all of the sealant into the tire.12. After injecting the sealant, pull the hose off the valve,
remove any residual sealant from the valve, rim and/or
tire.
Fit the valve insert (J) into the valve (H), and screw the
valve insert securely into place using the valve remover
(I).BK0140800US.book 14 ページ ２０１１年９月２９日　木曜日　午後３時２８分

For emergencies
6-15
6
13. Pull out the compressor hose (M) from the side of the tire
compressor, and then securely attach the hose to the tire
valve (H).14. Place the compressor (N) with its air pressure gauge (O)
on top.
Pull out the compressor’s power cord (P), insert the plug
on the cord into the 12 V power outlet (Q), and then turn
the electric motor switch to the “ACC” position.
Turn ON the compressor switch (R) and inflate the tire to
the specified pressure. (Refer to “Tire inflation pressures”
on page 7-21.)
If there is a gap between the tire and wheel, push the tread
area toward the center of the wheel to close the gap before
running the compressor.
BK0140800US.book 15 ページ ２０１１年９月２９日　木曜日　午後３時２８分

6-18 For emergencies
6
18. When you have inflated the tire to the specified pressure,
stow the compressor, bottle, and other items in the vehicle
and make sure that the seat cushion is properly secured.
(Refer to “Tire repair kit storage” on page 6-8.) Promptly
start driving the vehicle so that the tire sealant can spread
evenly in the tire. Drive with great care. Do not exceed a
speed of 50 mph (80 km/h). Observe local speed limits.19. After driving for 10 minutes or 3 miles (5 km), park the
vehicle in safe place. Remove the air compressor from the
stowed position. (Refer to “Tire repair kit storage” on
page 6-8.) Check the tire pressure using the air pressure
gauge on the compressor. (Refer to “Tire inflation pres-
sures” on page 7-21.)
If the tire pressure is not sufficient, inflate the tire to the
specified pressure again and drive the vehicle carefully
without exceeding a speed of 50 mph (80 km/h).
Before driving, stow the compressor and make sure that
the rear seat cushion is properly secured. (Refer to “Tire
repair kit storage” on page 6-8.)
CAUTION
!
If you sense any abnormality while driving, stop the
vehicle and contact a certified i-MiEV dealer. Other-
wise the tire pressure may drop before the emer-
gency repair procedure is completed, rendering the
vehicle unsafe to drive.
CAUTION
!
If the tire pressure is lower than the minimum per-
mitted pressure (18 psi {130 kPa}), the tire cannot
successfully be repaired with the tire sealant. Do not
drive the vehicle any further. Contact a certified i-
MiEV dealer.
BK0140800US.book 18 ページ ２０１１年９月２９日　木曜日　午後３時２８分

For emergencies
6-19
6
20. After driving for 10 minutes or 3 miles (5 km) again,
check the tire pressure using the air pressure gauge on the
compressor. (Refer to “Tire inflation pressures” on page
7-21.) If the tire pressure has apparently not dropped, the
emergency repair procedure is complete. Before driving,
make sure that the compressor is stowed and the seat
cushion is properly secured. You must still not exceed a
speed of 50 mph (80 km/h). Observe local speed limits.NOTE
If the tire pressure has dropped below the specified level
when you check it at the end of the repair procedure, do
not drive the vehicle any further. Contact a certified i-
MiEV dealer.

In cold conditions (when the ambient temperature is 32 °F
{0 °C} or lower), the time and driving distance necessary
until completion of the repair can become longer than in
warmer conditions, and the tire pressure may drop below
the specified level even after you have inflated the tire the
second time and subsequently driven the vehicle. If this
happens, inflate the tire to the specified pressure once
more, drive for about 10 minutes or 3 miles (5 km), then
check the tire pressure again. If the tire pressure has again
dropped below the specified level, stop driving the vehicle
and contact a certified i-MiEV dealer.

Please give the empty sealant bottle to a certified i-MiEV
dealer or dispose of the sealant bottle according to regula-
tions for the disposal of chemical waste.
To w i n g
N00837000859
If your vehicle needs to be towedIf you need to tow your vehicle, contact a certified i-MiEV
dealer or a commercial tow truck service.
Transport the vehicle on a flatbed truck or tow the vehicle
either with all wheels or the rear wheels (drive wheels) off the
ground.Flat bed type
Dolly type
Towing with rear wheels off the ground
BK0140800US.book 19 ページ ２０１１年９月２９日　木曜日　午後３時２８分

For emergencies
6-21
6
If a wheel gets stuck in a ditch, do not try to tow the vehicle.
Please contact a certified i-MiEV dealer or a commercial tow
truck service for assistance.
There may be local regulations concerning towing in your area.
Obey the regulations in the area where you are driving your
vehicle.Towing the vehicle by a tow truckTowing with rear wheels off the ground
Place the selector lever in the “N” (NEUTRAL) position. Turn
the electric motor switch to the “ACC” position and secure the
steering wheel in a straight-ahead position with a rope or tie-
down strap. Never place the electric motor switch in the
“LOCK” or “ON” position when towing.
WA R N I N G
!
Never get under your vehicle after it has been lifted
by a tow truck.
Never ride in a vehicle that is being towed.
CAUTION
!
If the transmission or the steering system has a
problem or damage, transport the vehicle on a flat-
bed truck or tow the vehicle with the all wheels off
the ground.
If the electric motor switch is in the “ON” position,
the Active Stability Control (ASC) system may oper-
ate, resulting in an accident. Make sure the electric
motor switch is in the “ACC” position before tow-
ing.
BK0140800US.book 21 ページ ２０１１年９月２９日　木曜日　午後３時２８分

Vehicle care and maintenance
7-5
7
Support the hood by inserting the support prop (B) into its slot
on the underside of the hood arm.
To closeMake sure the hood is securely locked by softly lifting the cen-
tre of the hood.
Slowly lower the hood about 12 inches (30 cm), then let it drop
from its own weight.
CAUTION
!
Always insert the support prop into the hole spe-
cially made for it. Propping the hood at any other
place could cause the prop to slip out and lead to an
accident.
The hood prop can fall out if the hood is lifted by a
strong wind.
CAUTION
!
Be careful not to trap your hands or fingers when
closing the hood.
Make sure the hood is firmly closed before driving.
If you drive without the hood completely closed, it
could open up while driving.
BK0140800US.book 5 ページ ２０１１年９月２９日　木曜日　午後３時２８分