2012 MITSUBISHI ECLIPSE Car seat

2-30 Seat and restraint systems
2
NOTE
In order to secure a child restraint systems compatible
with the LATCH system, use the lower anchor points in
the rear seat. It is not necessary to use the vehicle’s seat
belt.2. Open the rear hatch. Remove the rear shelf panel. Refer to
“Rear shelf panel” on page 3-178.
3. Cut out the notch (F) in the cargo floor carpet by hand,
then lift the carpet.
WA R N I N G
!
If there is any foreign material in or around the
lower anchors, remove it before installing the child
restraint system. Also, make sure the seat belt is
away from, not looped through or otherwise inter-
fering with, the child restraint system. If foreign
matter is not removed and/or the seat belt interferes
with the child restraint system, the child restraint
system will not be secured properly, could detach
and move forward in the event of sudden braking or
an accident, and could result in injury to the child or
other vehicle occupants.
When the vehicle is moving, do not adjust the seat
where the child restraint system is installed.
In an ECLIPSE, install a tether strap in accordance with steps 2 to
4 shown hereafter.
* - Rear of the vehicle
BK0132701US.book 30 ページ ２０１０年１２月６日　月曜日　午後２時３分

Seat and restraint systems
2-33
2
5. After confirming that the belt is locked, grab the shoulder
part of the belt near the buckle and pull up to remove any
slack from the lap part of the belt allowing the slack to
feed into the retractor. Remember, if the lap belt portion is
not tight, the child restraint system will not be secure. It
may help to put your weight on the child restraint system
and/or push on its seatback while pulling up on the belt
(see illustration). 6. Open the rear hatch. Remove the rear shelf panel. Refer to
“Rear shelf panel” on page 3-178.
7. Cut out the notch (A) in the cargo floor carpet by hand,
then lift the carpet.In an ECLIPSE, if your child restraint system requires the use of
a tether strap fasten the tether strap in accordance with steps 6 to
8 shown hereafter.
* - Rear of the vehicle
BK0132701US.book 33 ページ ２０１０年１２月６日　月曜日　午後２時３分

Seat and restraint systems
2-49
2
The front air bags MAY DEPLOY when … The front air bags may deploy if the underside of the vehicle
suffers a moderate to severe impact (undercarriage impact).
Some typical situations are shown in the illustrations.
Because the front air bags may deploy in certain types of unex-
pected impacts, as shown in the illustrations, and these unex-
pected impacts can move you out of position, it is important to
always wear your seat belts properly. When worn properly, seat
belts can help maintain your distance from the air bags when
they begin to inflate. The beginning stage of air bag inflation is
the most forceful and can cause serious injury or death if you
are close to the deploying air bag.
Collision with an elevated median/island or curb
Vehicle travels over a deep hole/pothole
Vehicle drives down a steep slope and hits the ground
BK0132701US.book 49 ページ ２０１０年１２月６日　月曜日　午後２時３分

Seat and restraint systems
2-53
2
WA R N I N G
!
The side air bag and curtain air bag can cause seri-
ous injury or death to anyone too close to the air bag
when it deploys. To reduce the risk of injury from a
deploying side air bag and curtain air bags, driver
and front passenger must be properly restrained
and seated well back, upright, and in the middle of
the seat. Do not lean against the door.
WA R N I N G
!
In order to reduce the risk of injury from a deploy-
ing side air bag, do not allow any rear seat passen-
gers to hold onto the back of either front seat.
Special care should be taken with children.
Do not place any objects near or around the front of
either front seatback. Such objects can interfere
with proper side air bag deployment and cause
injury during deployment of the side air bag.
Do not place stickers, labels or additional trim on
the back of either front seat. They can interfere with
proper side air bag deployment.
Do not install seat covers or re-cover seats that have
side air bags. Covers can interfere with proper side
air bag deployment and adversely affect side air bag
performance.
BK0132701US.book 53 ページ ２０１０年１２月６日　月曜日　午後２時３分

2-58 Seat and restraint systems
2
NOTE
When you transfer ownership of the vehicle to another
person, we urge you to alert the new owner that it is
equipped with the SRS and refer that owner to the applica-
ble sections in this owner’s manual.

If you decide to junk or scrap your vehicle, we urge you to
first take it to an authorized Mitsubishi Motors dealer so
that the SRS can be made safe for disposal.

If any of the following parts needs to be modified for use
by a handicapped person, the advanced air bag system
will be greatly affected. Please consult an authorized
Mitsubishi Motors dealer.
• Driver’s seat
• Front passenger seat
• Front seat belt
• Steering wheel
• Instrument panel
For ECLIPSE, if you find a crack in or damage to
the front pillar, rear pillar, or roof side rail where
the curtain air bag is located, have the SRS
inspected by an authorized Mitsubishi Motors
dealer.
WA R N I N G
!
[For vehicles sold in U.S.A.]
To contact Mitsubishi Motors North America, Inc.
call 1-888-648-7820 or write to:
Mitsubishi Motors North America, Inc.
Customer Relations Department
P. O. Box 6400
Cypress, CA 90630-0064
[For vehicles sold in Canada]
To contact Mitsubishi Motor Sales of Canada, Inc.
call 1-888-576-4878 or write to:
Mitsubishi Motor Sales of Canada, Inc.
Customer Relations Department
P.O. Box 41009
4141 Dixie Road
Mississauga, ON L4W 5C9
[For vehicles sold in Puerto Rico]
To contact Mitsubishi Motor Sales of Caribbean,
Inc.
call 1-787-251-8715 or write to:
Mitsubishi Motor Sales of Caribbean, Inc.
Customer Service Department
P.O. Box 192216
SAN JUAN PR 00919-2216
BK0132701US.book 58 ページ ２０１０年１２月６日　月曜日　午後２時３分

3-2 Features and controls
3Break-in recommendations
N00508700226
Advanced automobile manufacturing techniques permit you to
operate your new vehicle without requiring a long break-in
period of low-speed driving.
However, you can add to the future performance and economy
of your vehicle by observing the following precautions during
the first 300 miles (500 km).
Drive your vehicle at moderate speeds during the break-in
period.

Avoid revving the engine.

Avoid rough driving such as fast starts, sudden accelera-
tion, prolonged high-speed driving and sudden braking.
These would have a detrimental effect on the engine and
also cause increased fuel and oil consumption, which
could result in malfunction of the engine components. Be
particularly careful to avoid full acceleration while in low
gear.

Do not overload the vehicle. Observe the seating capacity
(See “Cargo load precautions” on page 4-12).

Do not use this vehicle for trailer towing.
Keys
N00508800445
Two keys are provided.
The keys fit all locks. Keep one in a safe place as a spare key.
BK0132701US.book 2 ページ ２０１０年１２月６日　月曜日　午後２時３分

Features and controls
3-19
3
3. Push out on the rear hatch to open it.ECLIPSE SPYDERThe inside trunk lid key cylinder provides a way to open the
trunk lid in the case of a discharged battery.
1. Make sure the tonneau panel is securely closed to prevent
the tonneau panel from contacting the trunk lid when it
opens.
2. Remove the woofer cover (A) in the center of the rear seat
by gently pulling at its side edges.The trunk lid key cylinder (see illustration) is located near
the sub woofer.
You and your family should familiarize yourselves with
the location and operation of the inside trunk lid key cyl-
inder.
CAUTION
!
Always keep the release lever lid on rear hatch
closed when driving so that your cargo cannot acci-
dentally bump the lever and open the rear hatch.
A
BK0132701US.book 19 ページ ２０１０年１２月６日　月曜日　午後２時３分

3-32 Features and controls
3
NOTE
The opening or closing operation of the top cannot be per-
formed when the vehicle is in motion.

For information about the cleaning of the top, refer to the
section “Convertible top” on page 7-77.

When leaving the vehicle unattended, be sure to close the
top and remove the ignition key.

To avoid damage, do not sit or place luggage or any heavy
objects on the top itself, or the area around it.

Make sure nothing is in the top storage area (top and
behind the rear seats) when raising or lowering the top.
Even a small article may interfere with the operation of
the top and may damage the top or cause it to malfunction.

Always be sure the top is completely dry before it is low-
ered. Lowering the top while wet or damp may cause inte-
rior water damage, water stains or mildew of the top. It
can also cause the top to deteriorate and shrink.

Never operate the top when temperatures are 32 °F (0 °C)
or below. The fabric of the top may be damaged. If neces-
sary, allow the vehicle to set for a while in a heated garage
prior to operating the convertible top mechanism.

A roof top or luggage carrier of any type or design MUST
NOT be used on the ECLIPSE SPYDER’s top. This
includes, but is not limited to ski, bicycle or luggage
racks. Damage to the top may result.

Before opening or closing the top, make sure there are no
obstructions above the vehicle. For opening and closing of
the top, there must be upward clearance of approximately
6.6 feet (2 m) as measured from the ground.

The trunk lid cannot be opened until opening or closing of
the electric convertible top is complete.
The power windows cannot be operated until opening or
closing of the electric convertible top is complete.
Normal operation
N00504900015
The top can be opened and closed using the top switches.Requirements for operation
N00505000026
The top can be opened and closed when the following require-
ments are all satisfied.

The ambient temperature is 32 °F (0 °C) or higher.

The vehicle is stationary.

The ignition switch is in the “ON” position.

The trunk lid is closed.

The latch handles are unlocked.NOTE
If either of the top switches is operated when the require-
ments for operation are not all satisfied, the operation
indicator lamp will flash slowly (approximately one flash
per second) and a tone will sound intermittently and rap-
idly (approximately three times per second) to indicate
that opening/closing operation is not possible.
If you are not able to perform opening/closing operation
when the requirements are all satisfied, have the vehicle
inspected by an authorized Mitsubishi Motors dealer.
BK0132701US.book 32 ページ ２０１０年１２月６日　月曜日　午後２時３分