2012 LEXUS RX350 maintenance schedule

Scheduled Maintenance l og
MAINTENANCE
Scheduled Maintenance Log 65162 Months or 135,000 Miles❏ Inspect and adjust all fluid levels
❏ Re-torque nuts and bolts of drive shaft (AWD)
❏ Replace Smart Key battery
❏ Reset maintenance reminder light
❏ Rotate tires
❏ Visually inspect brake pads, calipers and rotors
❏ Check installation of driver’s floor mat
❏ Road-test vehicle
❏ Inspect the following:
__ Axle shaft boots
__ Ball joints and dust covers
__ Body
__ Brake lines and hoses
__ Drive belt
__ Exhaust pipes and mountings
Note: If 0W-20 oil was not used at last oil change, or if you drive primarily under certain special operat
-
ing conditions, you should also replace the engine oil with 0W-20 oil and replace the oil filter. See page
44 for conditions that apply
. Some conditions require additional maintenance. See below.
If you drive primarily under any of these special operating conditions, perform
these additional items:
D
riving off-road, on dirt roads or on dusty roads:
❏ Inspect engine air filter
❏ Tighten nuts and bolts on chassis
Towing a trailer, using a car-top carrier or heavy vehicle loading:
❏ Replace rear differential oil (AWD)
❏ Replace transfer case oil (AWD)
❏ Tighten nuts and bolts on chassis __ Rack-and-pinion assembly
__ Rear differential oil (AWD)
__ Steering linkage and boots
__ Transfer case oil (AWD)
__ Wiper blades
d ate: __________________________ Mileage: __________________________

Scheduled Maintenance l og
MAINTENANCE Scheduled Maintenance Log66 168 Months or 140,000 Miles❏ Replace engine oil with 0W-20 oil; replace
oil filter
❏ Reset maintenance reminder light
❏ Rotate tires
❏ Visually inspect brake pads, calipers and rotors
❏ Check installation of driver’s floor mat
❑ Inspect wiper blades
❏ Road-test vehicle
I f you drive primarily under any of
these special operating conditions,
perform these additional items:
Driving off-road, on dirt roads or on
dusty roads:
❏ Inspect axle shaft boots
❏ Inspect ball joints and dust covers
❏ Inspect engine air filter
❏ Inspect steering linkage and boots
❏ Re-torque nuts and bolts of drive shaft (AWD)
❏ Tighten nuts and bolts on chassis
Towing a trailer, using a car-top carrier
or heavy vehicle loading:
❏ Re-torque nuts and bolts of drive shaft (AWD)
❏ Tighten nuts and bolts on chassis
Driving on roads on which road salt has
been applied:
❏ Re-torque nuts and bolts of drive shaft (AWD) 174 Months or 145,000 Miles
d ate: _______ Mileage: ________ d ate: _______ Mileage: ________❏ Inspect and adjust all fluid levels
❏ Inspect engine coolant (see page 70)
❏ Reset maintenance reminder light
❏ Rotate tires
❏ Visually inspect brake pads, calipers and rotors
❏ Check installation of driver’s floor mat
❑ Inspect wiper blades
❏ Road-test vehicle
Note: If 0W-20 oil was not used at last oil
change, or if you drive primarily under certain
special operating conditions, you should also
r
eplace the engine oil with 0W-20 oil and
replace the oil filter. See page 44 for conditions
that apply. Some conditions require additional
maintenance. See belo
w.
If you drive primarily under any of
these special operating conditions,
perform these additional items:
D
riving off-road, on dirt roads or on
dusty roads:
❏ Inspect axle shaft boots
❏ Inspect ball joints and dust covers
❏ Inspect engine air filter
❏ Inspect steering linkage and boots
❏ Re-torque nuts and bolts of drive shaft (AWD)
❏ Tighten nuts and bolts on chassis
Towing a trailer, using a car-top carrier
or heavy vehicle loading:
❏ Re-torque nuts and bolts of drive shaft (AWD)
❏ Tighten nuts and bolts on chassis
Driving on roads on which road salt has
been applied:
❏ Re-torque nuts and bolts of drive shaft (AWD)

Scheduled Maintenance l og
MAINTENANCE
Scheduled Maintenance Log 67180 Months or 150,000 Miles❏ Replace engine oil with 0W-20 oil; replace oil filter
❏ Re-torque nuts and bolts of drive shaft (AWD)
❏ Replace cabin air filter
❏ Replace brake fluid
❏ Replace engine air filter
❏ Replace engine coolant (see page 70)
❏ Replace Smart Key battery
❏ Inspect the following:
__ Axle shaft boots
__ Ball joints and dust covers
__ Body
__ Brake lines and hoses
__ Brake rotor thickness and runout
__ Drive belt
__ Exhaust pipes and mountings
__ F uel lines and connections, fuel tank band

and fuel tank vapor vent system hoses
I
f you drive primarily under any of these special operating conditions, perform
these additional items:
D riving off-road, on dirt roads or on dusty roads:
❏ Tighten nuts and bolts on chassis
Towing a trailer, using a car-top carrier or heavy vehicle loading:
❏ Replace rear differential oil (AWD)
❏ Replace transfer case oil (AWD)
❏ Tighten nuts and bolts on chassis __ Fuel tank cap gasket
__ Rack-and-pinion assembly
__ Rear differential oil (AWD)
__ Steering linkage and boots
__ Transfer case oil (AWD)
__ Transmission for signs of leakage
__ Wiper blades❏ Reset maintenance reminder light
❏ Rotate tires
❏ Visually inspect brake pads, calipers
and r otors
❏ Check installation of driver’s floor mat
❏ Road-test vehicle
d ate: __________________________ Mileage: __________________________

e xplanation of Maintenance i te MS
MAINTENANCE Scheduled Maintenance Log68 The following descriptions are
provided to give you a better under -
standing of the maintenance services
that should be performed on your
vehicle. The scheduled maintenance
log indicates at which time/mileage
intervals each service should be
performed. Please note that many
maintenance services should be per -
formed only by a qualified technician.
Axle Shaft Boots
Check the axle shaft boots and
clamps for cracks, deterioration and
damage. Replace any damaged parts
and, if necessary, repack the grease.
A qualified technician should perform
these operations.
Ball Joints and Dust Covers
Check the suspension and steering
linkage ball joints for looseness and
damage. Check all dust covers for
deterioration and damage. A quali -
fied technician should perform
these inspections. Body Inspection
Visually check for corrosion,
scratches and other damage. Check
outer body panels, inner panels of
the hood and doors, and underneath
the vehicle. Apply touch-up paint to
any chips and scratches or have them
repaired by a qualified technician.
Brake Fluid
Replace using fluid type specified in
your Owner’s Manual . A qualified tech -
nician should perform this operation.
Brake Lines and Hoses
Visually inspect for proper instal -
lation. Check for chafing, cracks,
deterioration and signs of leakage.
Replace any deteriorated or dam -
aged parts. A qualified technician
should perform these operations.
Brake Pads, Calipers and Rotors
Check brake pads and rotors for
excessive wear; check brake rotors
for runout. Check brake calipers for
fluid leakage. A qualified technician
should perform these inspections.
For further information on
maintenance services that you
can perform yourself, see the
maintenance sections of your
Owner’s Manual .

e xplanation of Maintenance i te MS
MAINTENANCE
Scheduled Maintenance Log 69Cabin Air Filter
Replace at specified intervals.
More frequent replacement may
be required when driving in dusty
conditions, heavy traffic areas, urban
areas, desert areas or dirt roads.
Refer to your Owner’s Manual for
service details.
Differential Oil
Check for correct oil level and
inspect each differential component
for signs of leakage. If you discover
any leakage, have it repaired
immediately by a qualified technician.
Refer to your Owner’s Manual for
fluid specifications.
Drive Belt
Inspect for cracks, excessive wear
and oiliness. Check the belt tension
and adjust if necessary. Replace the
belts if they are damaged. Drive Shaft
Re-torque the flange nuts and bolts.
A qualified technician should perform
this operation.
Driver’s Floor Mat
• Only use the driver’s floor mat
de si gned specifically for the
model and model year of your
vehicle, such as Lexus Genuine
floor mats.
• Always properly secure the
driver’s floor mat using the
retaining hooks.
• Never install another floor mat
on top of the existing driver’s
floor mat.
• Never install the driver’s floor
mat upside down.
Engine Air Filter
Check for excessive dirt, damage and
oiliness. Replace if necessary.

e xplanation of Maintenance i te MS
MAINTENANCE Scheduled Maintenance Log70 Engine Coolant
When inspecting, visually check
the level of the engine coolant on the
see-through reservoir. Add coolant
as necessary. When replacing, drain
the cooling system and refill with
coolant. Always use Genuine Toyota
Super Long-Life Coolant or similar
high-quality non-silicate, non-amine,
non-nitrate, non-borate ethylene-
glycol coolant with long-life hybrid
organic acid technology (i.e., a
combination of low phosphates and
organic acids). A qualified technician
should perform these operations.
Check the radiator and condenser
for blockage by leaves, dirt or insects
and clean if necessary. Also check
the hose connections for corrosion
and condition of installation.
n ote: Initial replacement of engine
coolant is at 120 months/100,000
miles. Replace every 60 months/
50,000 miles thereafter. Engine Oil and Oil Filter
Replace the oil filter and drain and
refill the engine oil at specified
intervals. SAE 0W-20 oil is the best
choice for good fuel economy and
good starting in cold weather. If SAE
0W-20 is not available, SAE 5W-20
may be used; however, it must be
replaced with SAE 0W-20 at the
next oil change. See your Lexus
dealer for oil specifically formulated
for your vehicle’s engine.
Your vehicle is equipped with a
replaceable oil-filter element and oil-
filter cap O-ring; replace both at each
oil change. For instructions on how to
reset the reminder light, refer to your
Owner’s Manual.
n ote: If you do the majority of your
driving under any of the special
operating conditions indicated on
page 44, you should replace the
engine oil and oil filter every six
months or 5,000 miles, regardless
of the oil used or the certification
of the vehicle.

e xplanation of Maintenance i te MS
MAINTENANCE
Scheduled Maintenance Log 71Exhaust Pipes and Mountings
Visually inspect the exhaust pipes,
muffler and hangers for cracks,
deterioration and damage. Start
the engine and listen carefully for
any exhaust leakage. Tighten connec -
tions and replace parts as necessary.
Fuel Lines and Connections, Fuel
Tank Band and Fuel Tank Vapor
Vent System Hoses
Visually inspect for corrosion,
damage, cracks, and loose or leaking
connections. Tighten connections
and replace parts as necessary.
Fuel Tank Cap Gasket
Visually inspect for cracks, deterio -
ra tion and damage and replace
if necessary.
Nuts and Bolts on Chassis
Check that tightness of the seat-
mounting bolts and front/rear
suspension-member retaining bolts
matches torque measurements
specified in the Repair Manual .
Rack-and-Pinion Assembly
Inspect the rack-and-pinion assembly
for signs of leakage, damage and
loose electrical connections. Tighten
connections and if you discover any
leakage or damage, have it repaired
immediately by a qualified technician. Road Test
While driving the vehicle, check for
proper operation of engine, transmis -
sion, brakes and steering. Also check
the parking brake, and check for
abnormal noise or vibration from
any part of the vehicle.
Spark Plugs
Replace at specified interval. Install
new plugs of the same type as origi -
nally equipped (see your Owner’s
Manual ). A qualified technician
should perform this operation.
t o ensure optimum engine perfor -
mance, replace only with d enso
f K20 h R11 plugs or equivalent.
Steering Linkage and Boots
With the vehicle stopped, check for
excessive freeplay in the steering
wheel. Inspect the linkage for bend -
ing and damage and the dust boots
for deterioration, cracks and damage.
Replace any damaged parts. A
qualified technician should perform
these operations.

e xplanation of Maintenance i te MS
MAINTENANCE Scheduled Maintenance Log72 Timing Chain
The timing chain requires no
periodic inspection.
Tire Rotation
See your Owner’s Manual for tire
rotation requirements. Check tire
pressure and check tires for damage
and uneven wear. If the vehicle is
equipped with a spare tire, check the
condition and pressure of the spare.
Tire-Pressure Warning Sensors
A tire-pressure sensor is mounted on
each full-size wheel. These sensors
do not require periodic maintenance.
When a sensor’s long-life lithium bat -
tery becomes discharged, the battery
should be replaced by a qualified
technician following procedures in
Lexus service and repair publications.
Transfer Case Oil
Check for correct oil level and
inspect each component for signs of
leakage. If you discover any leakage,
have it repaired immediately by a
qualified technician. For correct oil,
refer to your Owner’s Manual . Transmission
The transmission and transmission
fluid are a completely sealed unit.
Therefore, periodic checks and
replacement of the transmission
fluid are not required, and there is
no dipstick on the transmission.
Any repairs that require adding or
replacing fluid should be performed
by a qualified technician following
procedures in Lexus service and
repair publications.
Wiper Blades
The wiper blades should not show
any signs of cracking, splitting, wear,
contamination or deformation. The
wiper blades should clear the wind -
shield without streaking or skipping.