53
Braking
■
■Brake discs
Each brake disc is made from CCM (Carbon Ceramic Material) and features a two-
piece floating construction with an aluminum center hat. With this construction, disc
deformation due to expansion at high temperatures is more effectively mitigated;
thereby enabling a more consistent application of pressure from the brake pads for
stable and confidence-inspiring brake performance under any circumstances.
CCM discs provide the high stopping
power and thermal capacity needed
to provide consistent braking at high
speeds.
The discs are impregnated with silicone
material to ensure outstanding stopping
power and endurance when they are not
yet at optimal operating temperature or
in wet conditions. However, one should
avoid spraying water directly onto a hot
brake disc. Fur thermore, CCM discs
are susceptible to microscopic cracking
and local damage resulting from a direct
impact. Care is required when installing a
tire and wheel as accidental contact may
result in damage.
Bedding-in new brake pads or rotors:
In order to ensure maximum performance from a set of replacement CCM discs
or brake pads, it is necessary to bed them in. Please consult your Lexus dealer
regarding the appropriate bedding procedure. The LFA is shipped from the factory
with pre-bedded CCM discs and brake pads.
The disc diameters are 15.35 in. (390
mm) for the front and 14.17 in. (360 mm)
for the rear. Both front and rear discs are
ventilated with 0.20 in. (5 mm) diameter
d r i l l e d c o o l i n g h o l e s . T h e a d o p t i o n o f
CCM as opposed to conventional cast-iron
results in a reduction in unsprung weight of
approximately 11.03 lb. (5 kg) per wheel.
114
Index
AAccelerating 32
Accelerator pedal mechanism 32
Active rear wing (maintenance) 80
Active rear wing
(manual operation) 80
Active rear wing (operation) 28
Adding fuel 12
Adding gasoline 12
Adding petrol 12
Adjusting the steering wheel
position 23
Advice for long-term storage 92
Alcantara® care 85
Alcantara® cleaning 85
Alcantara® maintenance 85
Alignment 47
Aluminum center hat 53
Analog gauge 59
Approach angle 100
AUTO mode 58
AUTO mode
(control characteristics) 26
AUTO mode (selection) 27
Automated car-wash 79
Automatic 41
Automatic downshift control 40
BBack door 12
Backing up 11
Battery
(vehicle long-term storage) 93
Battery dark current 93
Battery terminal disconnection 99
Bedding-in new brake pads
or rotors 53
Blipping control 40
Bonnet 12
Bonnet stay 12
Boot 12
Brake caliper 52
Brake discs 53
Brake override system 50
Brake pad bedding 53
Brake pad bed-in 53
Brake pad replacement 53
Brake pedal 51
Brake rotors 53
Brake system 50
Braking 50
Break-over angle 100
Brightness 67
CCarbon fiber care 86
Carbon fiber cleaning 86
Cardan shaft 38
CCM (Carbon Ceramic
Material) discs 53
Ceramic brake discs 53
Ceramic brake rotors 53
CFRP (Carbon Fiber Reinforced
Plastics) maintenance 86
Changing gears 36
