Page 190 of 839
188
2-1. Driving procedures
GX460_U.S.A. (OM60J00U)
■Selecting second start mode
Use second start mode for accelerating and driving on slippery
road surfaces such as snow.
Press the menu switch.
The multi-information display
will change modes to electronic
features control mode.
Press the “ENTER” switch
upwards or downwards until
“2ND START” appears.
Press the “ENTER” switch to
change to “ON”.
The “2nd STRT” indicator will be
displayed.
Each pressing of the switch
turns second start mode on and
off.
Press the menu switch to
change to the normal display.
STEP1
STEP2
Page 199 of 839

197
2-2. Instrument cluster
2
When driving
GX460_U.S.A. (OM60J00U)
■The meters and display illuminate when
The “ENGINE START STOP” switch is in IGNITION ON mode.
■Instrument cluster brightness adjustment
The instrument cluster brightness levels when the tail lights are on and off can be
adjusted.
■The brightness of the instrument cluster lights
When the tail lights are on, the brightness will change. However, when the sur-
roundings are bright (daytime, etc.) turning on the tail lights will not change the
instrument cluster brightness.
In addition, the brightness of the instrument cluster lights is automatically adjusted
based on the light sensor detecting how bright the surroundings are.
■When disconnecting and reconnecting battery terminals
The trip meter data will be reset.
If the trip meter was displayed last, the ODO screen will be displayed after reset-
ting.
■Customization
Setting of sensitivity of the ambient light sensor used for dimming the meter lights
can be changed. (Customizable features →P. 7 8 2 )
NOTICE
■To prevent damage to the engine and its components
●Do not let the indicator needle of the tachometer enter the red zone, which indi-
cates the maximum engine speed.
●The engine may be overheating if the engine coolant temperature gauge is in the
red zone (H). In this case, immediately stop the vehicle in a safe place, and check
the engine after it has cooled completely. ( →P. 74 4 )
Page 203 of 839

201
2-2. Instrument cluster
2
When driving
GX460_U.S.A. (OM60J00U)
*1: These lights turn on when the “ENGINE START STOP” switch is turnedto IGNITION ON mode to indicate that a system check is being per-
formed. They will turn off after the engine is on, or after a few seconds.
There may be a malfunction in a system if the lights do not come on, or
turn off. Have the vehicle inspected by your Lexus dealer.
*2: The light flashes to indicate that the system is operating.
*3: The light comes on when pre-collision braking is disabled. The lightflashes faster than usual to indica te that the system is operating.
(if equipped)
Crawl Control indicator
(→ P. 3 2 8 )AIR BAG ON/OFF
indicator ( →P. 1 3 9 )
(if equipped)
Downhill assist control
system indicator
(→ P. 3 3 2 )
(if equipped)
Intuitive parking assist
indicator ( →P. 266)
“2nd STRT” indicator
(→ P. 1 8 8 )
(if equipped)
“AFS OFF” indicator
(→ P. 223)
Low speed four-wheel
drive indicator light
(→ P. 322)“RSCA OFF” indicator
(→ P. 1 3 7 )
Center differential lock
indicator ( →P. 3 2 3 )
(if equipped)
“PCS” warning
(→ P. 3 4 3 )
*1
*1
*1
*1
*1, 3
Page 204 of 839
202
2-2. Instrument cluster
GX460_U.S.A. (OM60J00U)
■Warning lights
Warning lights inform the driver of malfunctions in the indicated
vehicle’s systems. ( →P. 688, 700)
*1: These lights turn on when the “ENGINE START STOP” switch is turned
to IGNITION ON mode to indicate that a system check is being per-
formed. They will turn off after the engine is on, or after a few seconds.
There may be a malfunction in a system if a light does not come on, or if
the lights do not turn off. Have the vehicle inspected by your Lexus
dealer.
*2: The light flashes to indicate a malfunction.
(U.S.A.)(Canada)(U.S.A.)(Canada)
(U.S.A.)(Canada)(for driver)(for front
passenger)(if equipped)
(if equipped)(if equipped)(if equipped)(if equipped)
(if equipped)
*1*1*1*1*1*1
*1*1*1*1*1, 2*1
*1*2*2*2*1, 2*2*2*2
*2
Page 210 of 839
208
2-2. Instrument cluster
GX460_U.S.A. (OM60J00U)■
Electronic features control contents
●Multi-terrain Select (if equipped) ( →P. 2 9 6 )
● Intuitive parking assist (if equipped) ( →P. 266)
● AFS (Adaptive Front-lighting System) (if equipped) ( →P. 223)
● Second start mode ( →P. 188)
■ Other contents
●Multi-terrain Select display (if equipped) ( →P. 2 9 6 )
● Intuitive parking assist display
* (if equipped) ( →P. 2 6 6 )
● Crawl Control display
* (if equipped) ( →P. 328)
● Dynamic radar cruise control display
* (if equipped) (→ P. 2 5 0 )
● LDA (Lane Departure Alert) display
* (if equipped) (→ P. 275)
● Warning messages ( →P. 7 0 0 )
Automatically displayed when a malfunction occurs in one of the
vehicles systems.
● Customization
Settings (e.g.available language) can be changed.
(Customizable features →P. 7 8 2 )
*: Automatically displayed when the system is used
Page 212 of 839
210
2-2. Instrument cluster
GX460_U.S.A. (OM60J00U)
■Eco Driving IndicatorEco Driving Indicator Light
During Eco-friendly acceleration (Eco
driving), Eco Driving Indicator Light will
turn on.
Eco Driving Indicator Zone Display
Suggests Zone of Eco driving with current
Eco driving ratio based on acceleration.
Zone of Eco driving
Eco driving ratio based on acceleration
If the vehicle exceeds Zone of Eco driving,
the right side of Eco Driving Indicator
Zone Display will blink and Eco Driving
Indicator Light will turn off.
The Eco Driving Indicator Light will not oper-
ate in the following conditions:
●The shift lever in anything other than D.
●The vehicle is set to second start mode.
( → P. 1 8 8 )
●The vehicle speed is approximately 81 mph
(130 km/h) or higher.
Page 226 of 839

224
2-3. Operating the lights and windshield wipers
GX460_U.S.A. (OM60J00U)
■Daytime running light system
●To make your vehicle more visible to other drivers, the headlights turn on auto-
matically (at a reduced intensity) whenever the engine is started and the parking
brake is released. Daytime running lights are not designed for use at night.
For the U.S.A.: Daytime running lights can be turned off by operating the switch.
●Compared to the headlights, the daytime running light system offers greater
durability and consumes less electricity, so it can help fuel economy.
■Headlight control sensor
■Automatic light off system
●When only the tail lights come on: The parking/front side marker, tail, license
plate and fog lights turn off if the “ENGINE START STOP” switch is turned to
ACCESSORY mode or turned off and the driver’s door is opened.
●When the headlights come on: The headlights, parking/front side marker, tail,
license plate and fog lights turn off 30 seconds after a door or the glass hatch is
opened and closed. (The lights turn off immediately if on the key is
pressed after all the doors are locked.)
To turn the lights on again, turn the “ENGINE START STOP” switch to IGNITION
ON mode, or turn the light switch off once and then back to
or .
The sensor may not function properly if an
object is placed on the sensor, or anything
that blocks the sensor is affixed to the wind-
shield.
Doing so interferes with the sensor detecting
the level of ambient light and may cause the
automatic headlight system to malfunction.
Page 242 of 839

240
2-3. Operating the lights and windshield wipers
GX460_U.S.A. (OM60J00U)
■Effects of vehicle speed on wiper operation
With the settings other than “AUTO” also, the time until drip prevention wiper
sweep occurs is changed depending on vehicle speed.
Ty p e A
With selected, wiper operation will be switched from low speed to intermit-
tent wiper operation only when the vehicle is stationary. (However, when the sensor
sensitivity is adjusted to the highest level, the mode cannot be switched.)
Ty p e B
With selected, wiper operation will be switched from low speed to intermit-
tent wiper operation only when the vehicle is stationary. (However, when the sensor
sensitivity is adjusted to the highest level, the mode cannot be switched.)
■If no windshield washer fluid sprays
Check that the washer nozzles are not blocked if there is washer fluid in the wind-
shield washer fluid reservoir.
CAUTION
■Caution regarding the use of windshield wipers in “AUTO” mode
The windshield wipers may operate unexpectedly if the sensor is touched or the
windshield is subject to vibration in “AUTO” mode. Take care that your fingers etc.
anything else does not become caught in the windshield wipers.