2012 Lexus GX460 ECO mode

720
5-2. Steps to take in an emergency
GX460_U.S.A. (OM60J00U)
Other messagesIf the following message is displayed, take appropriate action and confirm
that the message has disappeared. ( →P. 328)
MessageCorrection procedure
(If equipped)
Select the four-wheel driving position switch in L4
and shift the shift lever to D or R.
(If equipped)
Confirm the operating conditions.
■Warning light display in radar cruise mode (if equipped)
In the following cases, the warning light may not be displayed even if vehicle-to-
vehicle distance decreases:
●When your vehicle and the vehicle ahead are traveling at the same speed or the
vehicle ahead is traveling more quickly than your vehicle
●When the vehicle ahead is traveling at a very low speed
●Immediately after cruise control speed is set
●At the instant the accelerator pedal is depressed
■After changing the engine oil (U.S.A. only)
Make sure to reset the oil maintenance data. ( →P. 6 1 4 )

736
5-2. Steps to take in an emergency
GX460_U.S.A. (OM60J00U)
Emergency start function
When the engine does not start, the following steps can be used as an
interim measure to start the engine if the “ENGINE START STOP” switch
is functioning normally:Set the parking brake.
Shift the shift lever to P.
Turn the “ENGINE START STOP” switch to ACCESSORY
mode.
Press and hold the “ENGINE START STOP” switch for about 15
seconds while depressing the brake pedal firmly.
Even if the engine can be started using the above steps, the system may
be malfunctioning. Have the vehicle inspected by your Lexus dealer.
■ The starter motor does not turn ov er, interior lights and headlights
do not turn on, or the horn does not sound
One of the following may be the cause of the problem:
● One or both of the battery terminals may be disconnected.
● The battery may be discharged. ( →P. 74 1 )
● There may be a malfunction in the steering lock system.
Contact your Lexus dealer if the problem cannot be repaired, or if
repair procedures are unknown.
STEP1
STEP2
STEP3
STEP4

740
5-2. Steps to take in an emergency
GX460_U.S.A. (OM60J00U)
Changing “ENGINE START STOP” switch modes and starting the engine
Ensure that the shift lever is in P and depress the brake pedal.Touch the Lexus emblem side of
the electronic key to the
“ENGINE START STOP” switch.
If any of the doors is opened or
closed while the key is being
touched to the switch, an alarm will
sound to indicate that the start
function cannot detect the elec-
tronic key.
To change “ENGINE START ST OP” switch modes: Within 10
seconds of the buzzer sounding, release the brake pedal and
press the “ENGINE START STOP” switch. Modes can be
changed each time the switch is pressed. ( →P. 1 8 1 )
To start the engine: Press the “ENGINE START STOP” switch
within 10 seconds of the buzzer sounding, keeping the brake
pedal depressed.
In the event that the “ENGINE START STOP” switch still cannot be oper-
ated, contact your Lexus dealer.
STEP1
STEP2
■Stopping the engine
Shift the shift lever to P and press the “ENGINE START STOP” switch as you nor-
mally do when stopping the engine.
■Replacing the key battery
As the above procedure is a temporary measure, it is recommended that the elec-
tronic key battery be replaced immediately when the battery is depleted.
( → P. 6 4 4 )
STEP3

742
5-2. Steps to take in an emergency
GX460_U.S.A. (OM60J00U)
■Starting the engine when the battery is discharged
The engine cannot be started by push-starting.
■To prevent battery discharge
●Turn off the headlights and the audio system while the engine is off.
●Turn off any unnecessary electrical components when the vehicle is running at a
low speed for an extended period, such as in heavy traffic, etc.
■Charging the battery
The electricity stored in the battery will discharge gradually even when the vehicle
is not in use, due to natural discharge and the draining effects of certain electrical
appliances. If the vehicle is left for a long time, the battery may discharge, and the
engine may be unable to start. (The battery recharges automatically during driving.)
Start the engine of the second vehicle. Increase the engine
speed slightly and maintain at that level for approximately 5
minutes to recharge the battery of your vehicle.
Open and close any of the doors of your vehicle with the
“ENGINE START STOP” switch off.
Maintain the engine speed of the second vehicle and start the
engine of your vehicle by turning the “ENGINE START STOP”
switch to IGNI TION ON mode.
Once your vehicle’s engine has started, remove the jumper
cables in the exact reverse order in which they were con-
nected.
Once the engine starts, have the vehicle checked at your Lexus dealer
as soon as possible.STEP3
STEP4
STEP5
STEP6

823
Alphabetical index
GX460_U.S.A. (OM60J00U)
Electronic keyIf the electronic key does not
operate properly ............................ 739
Emergency, in case of
If the electronic key does not operate properly ............................ 739
If the engine will not start ............... 735
If the shift lever cannot be shifted from P.................................... 737
If the vehicle has discharged
battery.................................................... 741
If the warning buzzer sounds..... 688
If the warning light turns on ......... 688
If the warning message is
displayed ............................................ 700
If you have a flat tire .......................... 721
If you lose your keys ........................ 738
If you think something is
wrong...................................................683
If your vehicle becomes stuck .....747
If your vehicle has to be stopped in an emergency ......... 749
If your vehicle needs to be towed ....................................................677
If your vehicle overheats.................744
Emergency flashers
Switch ...................................................... 676 Engine
Accessory mode..................................179
Compartment..................................... 609
Engine switch .........................................179
Hood ....................................................... 608
How to start the engine ....................179
Identification number .......................753
If the engine will not start................735
Ignition switch ........................................179
Overheating ......................................... 744
Engine compartment cover .............. 610
Engine coolant Capacity ................................................. 757
Checking ................................................ 616
Preparing and checking before winter ................................... 366
Engine coolant temperature gauge....................................................... 195
Engine immobilizer system..................115
Engine oil Capacity .................................................755
Checking .................................................. 611
Preparing and checking before winter ................................... 366
Engine oil maintenance data............. 613
Engine switch ...........................................179
Engine switch light................................. 519
Event data recorder ........................... 685E
*: For vehicles with a navigation system, refer to the “Navigation System Owner’s Manual”.