2012 Lancia Musa technical specifications

178
WARNING
LIGHTS AND
MESSAGES
TECHNICAL
SPECIFICA-
TIONS
INDEX
DASHBOARD
AND
CONTROLS
SAFETY
STARTING
AND DRIVING
IN
EMERGENZA
MAINTENANCE
AND CARE
Running the battery with
an excessively low liquid
level will damage the battery be-
yond repair and even cause an ex-
plosion.
WARNING
CHANGING THE BATTERY
If required, replace the battery with a
genuine spare part having the same
specifications.
If a battery with different specifica-
tions is fitted, the service intervals
given in the “Service schedule” in this
section will no longer apply.
Follow the battery manufacturer’s in-
structions for maintenance.Batteries contain very dan-
gerous substances for the
environment. You are rec-
ommended to go to a Lan-
cia Dealership to have the battery
replaced where the old battery will
be disposed of respecting both the
environment and the laws in force.Incorrect assembly of elec-
tric and electronic devices
may cause severe damage
to your car. Go to a Lancia
Dealership if you want to install ac-
cessories (alarms, mobile phone,
etc.): they will suggest the most suit-
able devices and advise you if a
higher capacity battery needs to be
installed.USEFUL ADVICE FOR
LENGTHENING THE LIFE OF
YOUR BATTERY
To avoid draining your battery and
lengthen its life, observe the following
indications:
❒when the car is parked, make sure
that the doors, bonnet and tailgate
are closed properly to make sure
that the lights inside the passenger
compartment go out;
❒switch off all lights inside the vehi-
cle: the car is however equipped
with a system which switches all in-
ternal lights off automatically;
❒do not keep devices (e.g. sound sys-
tem, hazard lights, etc.) on for a
long time with the engine off;
❒before performing any operation on
the electrical system, disconnect the
battery negative cable;
❒battery terminals shall always be
perfectly tightened.
If the car is left for long
periods in very cold envi-
ronments, remove the battery and
store it in a warm place to prevent
freezing.
WARNING
Always wear the proper
protective eyewear when
working on the battery or near it.
WARNING

179
WARNING
LIGHTS AND
MESSAGES
TECHNICAL
SPECIFICA-
TIONS
INDEX
DASHBOARD
AND
CONTROLS
SAFETY
STARTING
AND DRIVING
IN AN
EMERGENCY
MAINTENANCE
AND CARE
IMPORTANT A battery which is kept
at a charge of less than 50% (optical
indicator with dark colour without
green area in the middle) for any
length of time will be damaged by sul-
phation leading to a reduction in
cranking power.
The battery will also be more at risk
of freezing (e.g. already at -10°C).
In case of prolonged halt, refer to the
“Storing the car” paragraph in the
“Starting and driving” chapter.
If after buying the car, you want to in-
stall electric accessories which require
permanent electric supply (alarm,
etc.) contact Lancia Dealership whose
qualified personnel, in addition to
suggesting the most suitable devices
from Lineaccessori Lancia, will eval-
uate the overall electric absorption,
checking whether the car’s electric
system is capable of withstanding the
load required, or whether it should be
integrated with a more powerful bat-
tery.
Since these devices continue absorb-
ing energy even when the ignition key
is off, they gradually run down the
battery.WHEELS AND
TYRES
Check the pressure of each type, in-
cluding the spare, approximately once
every two weeks and before starting a
long journey: this check must be per-
formed with the tyre rested and cold.
It is normal for pressure to increase
when the car is used. For the correct
tyre inflation pressure, see “Wheels”
in “Technical specifications” section.
Incorrect pressure causes abnormal
tyre wearfig. 15:
A: normal pressure: evenly worn
tread.
B: low pressure: tread particularly
worn on the edges.
C: excessive pressure: tread particu-
larly worn in the middle.
The tyres must be replaced when the
tread is less than 1.6 mm thick. In all
cases, follow the laws in force in the
country where you are driving.IMPORTANT NOTES
❒Avoid braking suddenly, burning
starts and violent knocks against
the curb, potholes or other obsta-
cles if possible. Long distances on
rough roads may damage the tyres;
❒check the tyres regularly for cuts on
the sides, swelling or irregular tread
wear. Go to a Lancia Dealership if
required.
❒Do not overload your vehicle: this
may cause serious damage to
wheels and tyres;
❒if a tyre is punctured, stop the ve-
hicle immediately and charge it to
avoid damage to the tyre, the rim,
suspensions and steering system;
fig. 15L0D0216m

183
WARNING
LIGHTS AND
MESSAGES
TECHNICAL
SPECIFICA-
TIONS
INDEX
DASHBOARD
AND
CONTROLS
SAFETY
STARTING
AND DRIVING
IN AN
EMERGENCY
MAINTENANCE
AND CARE
These include:
❒painting products and systems
which give the car particular re-
sistance to corrosion and abrasion;
❒use of galvanised (or pretreated)
steel sheets, with high resistance
to corrosion;
❒spraying of plastic parts with a pro-
tective function in the more ex-
posed points: under door, inner
wing parts, edges, etc.;
❒boxed parts are designed to pre-
vent condensation and pooling of
water which can cause corrosion
from the inside.BODY AND UNDERBODY
WARRANTY
Your car is covered by warranty
against perforation due to rust of any
original element of the structure or
body. For the general terms of this
warranty, refer to Lancia Warranty
Booklet.ADVICE FOR PRESERVING THE
BODYWORK
Paint
Paintwork does not only serve an aes-
thetic purpose, but also protects the
underlying sheet metal.
Touch up abrasions and scratches im-
mediately to prevent the formation of
rust. Only use genuine spare paint
products for touch-ups (see “Body-
work paint identification plate” in the
“Technical Specifications” section).
Normal maintenance of paintwork
consists in washing the car: the fre-
quency depends on the conditions and
environment where the car is used.
For example, it is advisable to wash
the car more often in areas with a
high environmental pollution or on
roads sprinkled with salt.

TECHNICAL SPECIFICATIONS
IDENTIFICATION DATA .................................. 188
ENGINE CODES -
BODYWORK VERSIONS.................................. 190
ENGINE........................................................... 191
FUEL FEED .................................................... 192
TRANSMISSION .............................................. 192
BRAKES........................................................... 193
SUSPENSIONS ................................................. 193
STEERING SYSTEM ........................................ 193
WHEELS .......................................................... 194
DIMENSIONS ................................................... 198
PERFORMANCE.............................................. 199
WEIGHTS........................................................ 200
CAPACITIES .................................................... 201
FLUIDS AND LUBRICANTS ............................ 202
FUEL CONSUMPTION.................................... 204
CO
2EMISSIONS ............................................... 205
187
WARNING
LIGHTS AND
MESSAGES
INDEX
DASHBOARD
AND
CONTROLS
SAFETY
STARTING
AND DRIVING
IN AN
EMERGENCY
MAINTENANCE
AND CARE
TECHNICAL
SPECIFICA-
TIONS

1.48V(▲)
350A1000
Otto
4 in line
2
72 x 84
1368
11±0,2
57
77
6000
115
11,7
3000
NGK ZKR7A-10
Unleaded petrol
95 RON
(EN228
specifications)
1.6 Multijet
350A2000
Diesel
4 in line
4
79.5 x 80.5
1598
16,5±1
88
120
3500
300
30.5
1500
–
Diesel fuel for
motor vehicles
(EN590
specifications)
1.416V
843A1000
Otto
4 in line
4
72 x 84
1368
11±0,2
70
95
5800
128
13
4500
NGK ZKR7A-10
Unleaded petrol
95 RON
(EN228
specifications)
1.3 Multijet
70 HP
188A9000
Diesel
4 in line
4
69.6 x 82
1248
18±0.4
51
70
4000
180
18,3
1750
–
Diesel fuel for
motor vehicles
(EN590
specifications)
1.3 Multijet
95 HP
199B1000
Diesel
4 in line
4
69.6 x 82
1248
16,8 + 0.2/- 0.4
70
95
4000
200
20
1500
–
Diesel fuel for
motor vehicles
(EN590
specifications)
1.3 Multijet
90 HP
199A3000
Diesel
4 in line
4
69.6 x 82
1248
17,6±0,4
66
90
4000
200
20
1750
–
Diesel fuel for
motor vehicles
(EN590
specifications)
191
WARNING
LIGHTS AND
MESSAGES
INDEX
DASHBOARD
AND
CONTROLS
SAFETY
STARTING
AND DRIVING
IN AN
EMERGENCY
MAINTENANCE
AND CARE
TECHNICAL
SPECIFICA-
TIONS
ENGINE
INTRODUCTION
Type code:
Cycle:
Cylinder number and position:
Number of valves per cylinder:
Piston bore and stroke mm
Total displacement cm3
Compression ratio
Max. EEC power kW
HP
corresponding rpm: rpm
Max. EEC torque Nm
kgm
corresponding rpm: rpm
Spark plugs:
Fuel:
(▲)Engine version for some versions/markets only

Modifications or repairs to the fuel feed system that are not carried out properly or do not take the system’s
technical specifications into account can cause malfunctions leading to the risk of fire.
(▲) Engine version for some versions/markets only
FUEL FEED
Fuelfeed
1.48V(▲)-1.416V
Multipoint sequential phased injection,
integrated with ignition,
returnless system1.3 Multijet - 1.6 Multijet
Common Rail Multijet direct injection
electronically controlled with
turbo and intercooler
TRANSMISSION
Gearbox
Clutch
Traction1.4
16V
Five forward gears plus reverse
with synchronisers for forward gears
Hydraulic control and play-less pedal
Front 1.4
8V(▲)-1.3 Multijet - 1.6 Multijet
Five forward gears plus reverse
with synchronisers for forward gears
Hydraulic control and play-less pedal
Front
192
WARNING
LIGHTS AND
MESSAGES
INDEX
DASHBOARD
AND
CONTROLS
SAFETY
STARTING
AND DRIVING
IN AN
EMERGENCY
MAINTENANCE
AND CARE
TECHNICAL
SPECIFICA-
TIONS

WHEELS
RIMS AND TYRES fig. 5
Pressed steel or alloy rims. Tubeless
radial carcass tyres. All approved
tyres are listed in the Log Book.
IMPORTANT In the event of discrep-
ancies between the information pro-
vided on this “Owner’s handbook”
and the “Log book”, consider the
specifications shown in the log book
only.
Respect the prescribed size to ensure
safety of the car in movement. Fit
tyres of the same make and type on
all wheels.
IMPORTANT Do not use inner tubes
with Tubeless tyres.
SPACE SAVER SPARE WHEEL
Pressed steel rim Tubeless tyre.
WHEEL GEOMETRY
Front wheel toe-in measured between
rims: 0 ±1 mm.
The values refer to the car in running
order.HOW TO READ TYRE DATA
Example: 185/65 R 14 86 T
185= Nominal width (S, distance in
mm between sidewalls).
65= Percentage height/width ratio
(H/ S).
R= Radial tyre.
14= Rim diameter in inches (Ø).
86= Load rate (capacity).
T= Maximum speed rating.
fig. 5L0D0229m
194
WARNING
LIGHTS AND
MESSAGES
INDEX
DASHBOARD
AND
CONTROLS
SAFETY
STARTING
AND DRIVING
IN AN
EMERGENCY
MAINTENANCE
AND CARE
TECHNICAL
SPECIFICA-
TIONS
If after-sale tyres with rim
protector are used (fig. 6)
and the car has integral caps fixed
(by springs) to the sheet wheel, DO
NOT fit wheel caps. The use of un-
suitable tyres and wheel caps could
cause a sudden pressure loss of the
tyre.
WARNING
fig. 6L0D0502m
RIM PROTECTOR TYRES fig. 6

1.6 Multijet 1.416V1.48V(▲)1.3 Multijet
CAPACITIES
Fuel tank:
including a reserve of:
Fuel tank: including a reserve of:
Engine cooling
system:
Engine sump:
Engine sump and filter:
Engine sump:
Engine sump and filter:
Gearbox/differential
casing:
Hydraulic brake circuit:
Windscreen/rear window
washer fluid reservoir:
(▲) Engine version for some versions/markets only
(❐) When the vehicle is used under particularly harsh climate conditions, we recommend using a mix of 60% PARAFLUUPand 40%
demineralised water.
kg
–
–
–
–
–
–
–
3.74
4.0
1.6
–
–Recommended fuels
Genuine products
Unleaded petrol with no less
than 95 R.O.N.
(EN 228 Specification)
Diesel fuel for motor vehicles
(EN590 specifications)
50% mixture of demineralized
water and PARAFLU
UP(❐)
SELENIA K P.E.
SELENIA WR P.E.
TUTELA CAR
TECHNYX
TUTELA TOP 4
Mixture of water and
TUTELA PROFESSIONAL
SC35 litres
47
5 - 7
–
–
4.5
2.4
2.6
–
–
1.65
0.45
1.5kg
–
–
–
–
–
2.1
2,25
–
–
1.5
–
–litres
47
5 - 7
–
–
4.5
2.5
2.7
–
–
1.65
0.45
1.5kg
–
–
–
–
–
2.2
2.35
–
–
1.5
–
–litres
–
–
47
5 - 7
6.0
–
–
2.85
3.0
1.98
0.45
1.5kg
–
–
–
–
–
–
–
2.54
2.65
1.8
–
–litres
–
–
47
5 - 7
7.8
–
–
4.4
4.7
–
0.45
1.5
201
WARNING
LIGHTS AND
MESSAGES
INDEX
DASHBOARD
AND
CONTROLS
SAFETY
STARTING
AND DRIVING
IN AN
EMERGENCY
MAINTENANCE
AND CARE
TECHNICAL
SPECIFICA-
TIONS