Page 239 of 295
SERVICING AND MAINTENANCE237
5
CHECK FLUID LEVELS –1.4 Turbo Jet version
fig. 1L0E0092m
Page 240 of 295
238SERVICING AND MAINTENANCE
1.4 Turbo Multi Air version
fig. 2L0E0204m
Page 241 of 295
SERVICING AND MAINTENANCE239
5
1.6 Multijet/2.0 Multijet version
fig. 3L0E0254m
Page 242 of 295
240SERVICING AND MAINTENANCE
1.9 Twin Turbo Multijet version
fig. 4L0E0254m
Page 243 of 295

SERVICING AND MAINTENANCE241
5
ENGINE OIL A-fig.1-2-3-4
Check the oil level a few minutes (about five) after the
engine has stopped, with the car parked on level ground.
The oil level should be between the MIN and MAX marks
on the dipstick. The range between the MIN. and MAX.
marks corresponds to about 1 litre of oil.
If the level of the oil is close to or below the MIN. mark,
add oil via the filler fitting until the MAX. mark is
reached.
The oil level should never exceed the MAX line.
Engine oil consumption
The maximum engine oil consumption is usually
400 grams every 1000 km. When the car is new, the en-
gine need
s to run in, therefore the engine oil consump-
tion can only be considered stabilised after the first
5,000–6,000 km.
IMPORTANT The oil consumption depends on driving
style and the car usage conditions.
IMPORTANT After adding or changing the oil, let the en-
gine run for a few seconds and wait a few minutes after
switching it off before checking the level.
When the engine is hot, take care when work-
ing inside the engine compartment to avoid
burns. Remember that when the engine is hot,
the fan may cut in: danger of injury. Pay attention
to scarves, ties and other loose fitting garments: they
might get caught by moving components.
Do not add any oil with different specifica-
tions to those of the existing engine oil.
The used engine oil and the replaced oil fil-
ter contain substances that may be danger-
ous for the environment. It is advisable to
have oil and filters changed by a Lancia Dealer-
ship, where they will be disposed of properly and
in accordance with the law.
Page 244 of 295

242SERVICING AND MAINTENANCE
ENGINE COOLANT B-fig. 1-2-3-4
The coolant level must be checked when the engine is
cold and must range between the MIN. and MAX. marks
on the reservoir. If the level is low, slowly pour a mixture
of 50% demineralised water and 50% PARAFLU
UPof
PETRONAS LUBRICANTS through the filler neck un-
til the level reaches MAX.
The mixture of 50% PARAFLU
UPand 50% distilled wa-
ter protects against freezing down to temperatures of
−35 °C. For particularly harsh climate conditions, we rec-
ommended using a mixture of 60% PARAFLU
UPand
40% distilled water.
PARAFLUUPanti-freeze is used in the en-
gine cooling system. Use the same fluid as in
the cooling system when topping up.
PARAFLU
UPmay not be mixed with any other
types of fluids. If this accidentally occurs, do not
start the engine and contact a Lancia Dealership.
The engine cooling system is pressurised. If
necessary, only replace the cap with another
genuine one or the operation of the system
may be adversely affected. Do not remove the cap
from the reservoir when the engine is hot: danger of
scalding.
Page 245 of 295

SERVICING AND MAINTENANCE243
5
WINDSCREEN/REAR WINDOW WASHER FLUID
C-fig. 1-2-3-4
Remove the cap, using the special tab, to add fluid.
Use a mixture of water and TUTELA PROFESSIONAL
SC 35, in the following concentrations:
❍30% TUTELA PROFESSIONAL SC 35 and 70% wa-
ter in summer.
❍50% TUTELA PROFESSIONAL SC 35 and 50% wa-
ter in winter.
At temperatures below −20 °C, use undiluted TUTELA
PROFESSIONAL SC 35 fluid.
Check level through the reservoir.
Close the cap by pressing the centre section.
Do not travel if the windscreen washer
reservoir is empty: using the windscreen
washer is essential for improving visibility.
Some commercial windscreen washer additives
are flammable. The engine compartment contains
hot parts which could start a fire if they come into
contact.
BRAKE FLUID D-fig. 1-2-3-4
Undo the cap and check that the liquid contained in the
reservoir is at the maximum level. The fluid level in the
reservoir must not exceed the MAX mark. If you need to
top up, you should use the brake fluid shown in the “Flu-
ids and lubricants” table (see chapter “6”).
NOTE Carefully clean the cap of the reservoir and the
surrounding surface.
Take great care to ensure that impurities do not enter the
reservoir when the cap is opened.
For topping-up, always use a funnel with integrated fil-
ter with mesh equal to or lower than 0.12 mm.
IMPORTANT Brake fluid is hygroscopic (i.e. it absorbs
moisture). For this reason, if the car is mainly used in ar-
eas with a high degree of atmospheric humidity, the fluid
should be replaced at more frequent intervals than spec-
ified in the “Scheduled Servicing Programme”.
Page 246 of 295
244SERVICING AND MAINTENANCE
Prevent brake fluid which is highly corro-
sive from coming into contact with painted
parts. Should this occur, immediately wash
with water.
Brake fluid is poisonous and highly corro-
sive. In the event of accidental contact, im-
mediately wash the affected parts with wa-
ter and neutral soap. Then rinse thoroughly.
If swallowed call a doctor straight away.
The symbol πon the container indicates
a synthetic brake fluid, which is different
from a mineral fluid. Use of mineral type
fluids will damage the special rubber seals of the
braking system beyond repair.
AIR FILTER/POLLEN FILTER
Have the air filter or pollen filter replaced by a Lancia
Dealership.