- Oil Pressure Warning Light
• This light indicates low engine oil pressure. If the light turns on while
driving, stop the vehicle and shut off the engine as soon as possible. A
chime will sound for four minutes when this light turns on.
• We recommend you do not operate the vehicle or engine damage will
occur. Have the vehicle serviced immediately.
- Anti-Lock Brake (ABS) Light
• This light monitors the Anti-Lock Brake System (ABS).
• If the light is not on during starting, stays on, or turns on while driving,
we recommend you drive to the nearest service center and have the
vehicle serviced immediately.
- Electronic Throttle Control (ETC) Light
• This light informs you of a problem with the Electronic Throttle Control
(ETC) system.
• If a problem is detected, the light will come on while the engine is
running. Cycle the ignition when the vehicle has completely stopped and
the shift lever is placed in the PARK position; the light should turn off.
• If the light remains lit with the engine running, your vehicle will usually be
drivable; however, see an authorized service center immediately. If the
light is flashing when the engine is running, immediate service is required
and you may experience reduced performance, an elevated/rough idle or
engine stall and your vehicle may require towing.
- Air Bag Warning Light
• If the light is not on during starting, stays on, or turns on while driving,
have the vehicle serviced by an authorized service center immediately.
4WD!- 4WD System Fault Indicator Light
• When lit solid: There is a 4WD system fault. The 4WD performance will
be at a reduced level. We recommend you do not operate the vehicle.
Have the vehicle serviced immediately.
• When blinking: The 4WD system is temporarily disabled due to overload
condition.
- Transmission Temperature Warning Light
• This light indicates that there is excessive transmission fluid temperature
that might occur with severe usage such as trailer towing. If this light
turns on, you will experience reduced vehicle performance until the
automatic transmission cools down. If the overheating continues, stop
the vehicle and run the engine at idle, with the transmission in NEUTRAL,
until the light turns off. Once the light turns off, you may continue to
drive normally.
WHAT TO DO IN EMERGENCIES
66
FLUIDS AND CAPACITIES
ComponentFluid, Lubricant, or Genuine PartCapacities
Engine Coolant
2.0L, 2.4LMOPAR® Antifreeze/Coolant
Five Year/100,000 Mile Formula
HOAT (Hybrid Organic Additive
Technology) or equivalent.7.2 Quarts
(6.8 Liters) Includes
heater and coolant
recovery bottle
filled to MAX level.
Engine Oil with
Filter 2.0L, 2.4LAPI Certified SAE 5W-20 engine
oil, meeting the requirements of
Chrysler Material Standard
MS-6395. Refer to the engine oil
filler cap for correct SAE grade.4.5 Quarts
(4.26 Liters)
Fuel Selection 2.0L,
2.4L87 Octane 13.6 Gallons
(51.5 Liters)
(Approximate)
Engine Oil Filter
2.0L, 2.4LMOPAR® Engine Oil Filter or
equivalent.—
Spark Plugs 2.0L,
2.4LZFR5F-11 (Gap 0.043 in
[1.11 mm])—
Automatic
Transmission (CVT)MOPAR® CVTF + 4®
Continuously Variable
Transmission Fluid.—
Manual
TransmissionMOPAR® ATF+4® Automatic
Transmission Fluid or equivalent
licensed ATF+4® product.—
Rear Drive
Assembly (RDA)MOPAR® Gear & Axle Lubricant
SAE 80W-90 API GL 5 or
equivalent non-synthetic
product.—
Power Transfer Unit
(PTU)MOPAR® Gear & Axle Lubricant
SAE 80W-90 API GL 5 or
equivalent non-synthetic
product.—
Brake Master
CylinderMOPAR® DOT 3 and SAE J1703
should be used or equivalent. If
DOT 3 is not available, then DOT
4 is acceptable. Use only
recommended brake fluids or
equivalent.—
Power Steering
ReservoirMOPAR® Power Steering Fluid
+4 or MOPAR® ATF+4®
Automatic Transmission Fluid or
equivalent licensed ATF+4®
product.—
MAINTAINING YOUR VEHICLE
83
