2012 JAGUAR XF tow

JAGUAR XF JAGUAR XF JAGUAR XF
JAGUAR XF JAGUAR XF JAGUAR XF
3
Vehicle accessDriver controls
Emergency key access
If there is a problem with the Smart Key and it will not unlock the vehicle, use the emergency key access procedure. Press the Smart Key release button 1.Remove the key blade 2.
Insert the blade into the slot beneath the front left-hand door lock cover. Lift slightly and twist to remove the cover. Insert the key into the exposed lock and turn it towards the rear of the vehicle then release it to unlock.
If the vehicle security system was previously armed with the Smart Key, the alarm will sound. To disarm the alarm, press the START STOP button while the Smart Key is inside the vehicle.
Unlocking mode alternatives
Single-point entry allows only the driver’s door to unlock with a single press. A second press unlocks all other doors and the luggage area.
Multi-point entry will unlock all doors and luggage area with a single press.
To change between modes, with the vehicle unlocked, press the lock and unlock buttons simultaneously for three seconds. The hazard warning lamps will flash twice to confirm the change.
Trunk opening
With the vehicle unlocked, the luggage compartment can also be opened by pressing the release button under the chrome finisher at the rear of the vehicle.
Powerfold mirrors
Press buttons 31 simultaneously to fold the mirrors inward. Press again to unfold.
Jaguar Smart Key Jaguar Smart Key
Keyless entry/exit Keyless entry/exit
2
Press once to lock the vehicle and arm only the exterior (perimetric) alarm.
Multi-point entry - Press once to disarm the alarm, unlock all doors and unlock the luggage compartment.
Press once to switch the headlamps on for 25 seconds. Press again to switch off.
Press to open only the luggage compartment. The rest of the security system remains active.
Press and hold for three seconds to activate/cancel the panic alarm.1
2
To unlock the vehicle and disarm the alarm, simply press a door handle button or luggage compartment release button while the Smart Key is within 3 ft (1 metre) of the vehicle.
To lock the vehicle and arm the alarm, first ensure that the Smart Key is outside the vehicle but within 3 ft (1 metre).
Press a door handle button once to single lock. Press it twice within three seconds to double lock.
Rear seat release handles
The split fold rear seats have release handles located in the luggage compartment. Pull to release one or both seat backs and fold forward. Head restraints can be removed if required.
412567
15
19
20
21
22
23
1716
18
2425
29
28
27
26
30
31
32
33
3
891110121314
Turn signals and headlamp control1.
Gearshift down2.
Audio and phone switches3.
Instrument panel, message centre and warning lamps4.
Cruise control switches5.
Gearshift up6.
Wiper/washers7.
Central locking/unlocking8.
Touch screen on/off9.
Touch screen10.
Hazard warning lamps on/off11.
Navigation menu 12.
Phone menu13.
Home menu14.
Climate controls15.
JaguarDrive selector16.
Stability control (DSC) 17.
Speed limiter (ASL)18.
Parking brake 19.
Dynamic mode 20.
Winter mode21.
STOP/START22.
Audio controls23.
Horn/air bag24.
Steering column adjuster25.
Instrument illumination26.
Fog lamps on/off27.
Trunk release28.
Forward alert29.
Mirror controls30.
Powerfold mirror controls31.
Window controls32.
Rear window isolator33.
Care point
The Smart Key may not be detected if it is placed within a metal container or if it is shielded by a device with a back lit LCD screen, (e.g. laptop, smartphone etc.) Keep the Smart Key clear of such devices when attempting Keyless entry or Keyless starting.
Do not leave your Jaguar Smart Key within the luggage compartment, the vehicle WILL NOT automatically unlock (should it become shielded).

JAGUAR XF JAGUAR XF JAGUAR XF
JAGUAR XF JAGUAR XF JAGUAR XF
Setting the driving position Setting the driving position See page 3, items See page 3, items 25, 30 25, 30 and 31and 31and Engine start/stop Engine start/stop See page 3, item See page 3, item 22
Transmission See page 3, items See page 3, items 2, 6 2, 6 and 16and 16and
Restraints
Comfort adjustmentsStarting and driving
5
4
Driver’s seat
Set the seat position using the following controls.
Cushion length.1.
Side bolster - inflate.2.
Side bolster - deflate.3.
Lumber support.4.
Seat back angle and head restraint.5.
Seat forwards and back, cushion height and cushion 6. angle.
Note:Seat heater controls are accessed via the touch screen.
Steering column
With the vehicle stationary, adjust the steering column 7. to your ideal driving position.
Door mirrors
1. Press the left or right mirror selector.
2. Use the mirror adjuster to set mirror position.
Storing the driving position to memory
Once you have adjusted the driver’s seat, steering column and door mirrors for your ideal driving position, the settings can be stored.
8. Press the SET button to activate the memory store function. The button will illuminate to indicate the memory store function is active.
9. Within 5 seconds, press button 1 or 2 to store the current driving position.
A stored memory position can now be recalled with a press of the appropriate button; 1 or 2. The seat, steering wheel and mirrors will move to their preset positions.
Operating note
Memory buttons must be pressed within five seconds after pressing the SET button otherwise the memory store function will cancel.
Operating note
The engine will continue to run even if the Smart Key is removed from the vehicle by more than 3ft (1 metre). However, if the engine is stopped, it cannot be restarted until the Smart Key is returned to the vehicle.
Operating note
If the engine is switched off with Neutral selected, automatic selection of P is delayed for 10 minutes. DONOTuse this feature to enable towing of the vehicle. Refer to Vehicle recovery in the Owner’s Handbook.A warning indicator on the instrument panel will illuminate if the seat belt of an occupied front seat is not fastened. This may be accompanied by an audible warning.
Using child seats
Refer to Child Seats in the Owner’s Handbook to determine the correct seat for your child.
If it becomes necessary to fit a child restraint on the front passenger seat, make the following seat adjustments.
Move the seat fully rearward.•
Lumber support to minimum setting.•
Seat cushion to highest position.•
Cushion front tilt to lowest position.•
Seat back to upright position.•
Adjust the upper seat belt anchorage to its lowest • position.
Ignition on:
With the Jaguar Smart Key inside the vehicle, press • the START/STOP button to switch on ignition.
A second press will switch off the ignition.•
Engine start
The selector lever must be in • Park or Neutral position to enable engine starting.
With the foot brake depressed, press and release the • START/STOP button to start the engine.
Press again to stop the engine and switch off the • ignition.

Rolling start
If the engine is switched off while the vehicle is moving, it can be restarted by selecting N position then pressing the START/STOP button.
Gearshift interlock
The brake pedal must be depressed before the selector can be moved from the Park position. Maintain brake pressure until a gear is selected.
Select P before switching off the engine. However, if the engine is switched off with Reverse, Drive or Sport selected, the selector will automatically return to P while retracting.
Automatic gear selection
Select D for fully automatic gear changes.
Sport mode
This is an automatic gear change mode, however, change points are modified to make full use of engine power.
Press the selector down and rotate from D to Sport.
Manual gear changes
Manual gear change mode is effective when rapid acceleration and engine braking are required.
To shift down, briefly pull the left-hand paddle.•
To shift up, briefly pull the right-hand paddle.•
P R N D S
STARTENGINESTOP
DSC
5432
1
6
8
7
9
Supercharged vehicles: When the paddles are used in D, gear selection will revert to automatic if use of the paddles is not maintained. With Sselected, continuous manual operation is initiated if the paddles are used.
Non Supercharged vehicles: Manual gear selection is only available in S.
Note:To return to automatic operation pull and hold the right-hand paddle for two seconds.
JJM189640121.indd 4-5JJM189640121.indd 4-5JJM189640121.indd 4-521/03/2011 13:48:3721/03/2011 13:48:3721/03/2011 13:48:3721/03/2011 13:48:3721/03/2011 13:48:3721/03/2011 13:48:3721/03/2011 13:48:3721/03/2011 13:48:3721/03/2011 13:48:3721/03/2011 13:48:3721/03/2011 13:48:3721/03/2011 13:48:37

JAGUAR XF JAGUAR XF JAGUAR XF
JAGUAR XF JAGUAR XF JAGUAR XF
NavigationTelephone
14
15
Touch screen navigation Touch screen navigation Bluetooth® phones phones See page 3, item See page 3, item 3
On initial activation, ensure that both the correct country and search area have been selected.
For more information refer to the Navigation section of the Owner’s Handbook.
Setting a destination
From the 1.Nav menu screen, select Destination entry.
Select 2.Address from the Destination entry screen and input the town name.
Once sufficient letters have been entered, touch 3.Listto display all the possible towns. Select the town.
Enter road name. Once sufficient letters have been 4.entered, touch List to display all the possible roads. Select the road.
Enter the house number (if known) then touch 5.OK to confirm. If the house number is not known, touch OK - the mid point of the road is then used as a destination.
Touch 6.Destination to begin calculation of the route options.`
There is now a choice to select 7.3 Routes, Change route or to Start navigation guidance.
Touch 8.3 Routes to display a choice of alternative routes. To use an alternative route, touch the respective box 1, 2 or 3 displayed on the right side of the map.
Touch 9.Go to commence guidance.
The selected route will be displayed and guidance will 10.begin. When your destination is reached, voice and visual confirmation is given.
If the map is moved away from your current location, the position icon will be replaced by a touch button near the top left of the screen. Touch to bring the current location map back into view.While navigation is operating, touch to repeat the last given navigation instruction.
Select Device to vehicle option when using a
iPhone®.
Nav
Cancelling guidance
To cancel guidance, select Nav menu on the map menu and then Cancel guidance.
Compatible Bluetooth® phones can communicate with ® phones can communicate with ®
the vehicle’s inbuilt telephone system. Connection must be made with ignition on or engine running.
Pairing and connecting using the touch screen
Up to 10 mobile phones can be paired. Ensure your
Bluetooth® phone is in ‘discoverable’ mode, sometimes ® phone is in ‘discoverable’ mode, sometimes ®
referred to as ‘find me’ mode. See your operating instructions for more information.
From the Home menu1., select Phone.
A menu will appear. Select 2.Search new.
Select 3.Vehicle to device option.
Indentify your phone from the list and select 4.Pair and connect option.
When prompted, enter the PIN code into your phone. 5.See your operating instructions for more information.
Confirmation of connection will be displayed before 6.switching to the Digit Dial screen.
Changing a connected phone
To change from the currently connected phone to another that has already been paired, follow the steps below:
1. From the Home menu,select Phone.
2. A menu will appear. Select Change phone.
3. Select your phone from the displayed list.
4. Confirmation of connection will be displayed before switching to the Digit Dial screen.
Downloading phonebook entries
When a phone with phonebook download capability is paired and docked, its phonebook directory will automatically download to the vehicle system.
The vehicle phonebook will be updated each time a mobile phone is docked to the system.
Jaguar Bluetooth® Connectivity® Connectivity®
For the latest compatibility information, refer to the Ownership section of the Jaguar website at www.jaguar.com
Bluetooth® selection® selection®
When the starter is turned on, the vehicle searches for up to 10 previously connected phones, starting with the most recent connection.
Telephone echo
If echo is experienced when using the phone, reduce the audio system volume during the call.
Calls via the touch screen
Making a call
1. With a paired and active phone, select Phone from
the Home menu.
2. From the Digit dial screen, enter the number using
the on-screen keypad.
3. Touch icon on the screen to make the call.
4. To end a call touch .
Calls via the steering wheel controls
Volume control. Turn to increase/decrease call 1. volume.
Scroll control. Turn to scroll up/down lists of calls or 2. phone book entries.
Phone/Voice control. Press and release to send, 3. accept or end a call. If Voice control is not fitted, in addition to the above, press and release to access last 10 dialed list; press and hold to access the phonebook search view.
2
3
1
5GVVKPIU
&GNGVG
2JQPGDQQM
&KIKVFKCNName
01234567890_
2JQPG
123
456
789
0#$% &'(
)*+ ,-. /01
2345 6789 :;<
.CUV
%JCPIG2JQPG

JCPFUGV 7UG
'OGTIGPE['OGTIGPE['OGTIOGTIGPE[E[

0CX
&WPOQTG4QCF)25
5GVOGOQT[
RQKPV&GUVKPCVKQP 5GVKPVGTGUV 2QKPVQH
0CXOGPW
MOMO
%CPEGN
DTQYUG
OQFG


JJM189640121.indd 14-15JJM189640121.indd 14-15JJM189640121.indd 14-1521/03/2011 13:48:4721/03/2011 13:48:4721/03/2011 13:48:4721/03/2011 13:48:4721/03/2011 13:48:4721/03/2011 13:48:4721/03/2011 13:48:4721/03/2011 13:48:4721/03/2011 13:48:4721/03/2011 13:48:4721/03/2011 13:48:4721/03/2011 13:48:47