2012 INFINITI G37 traction control

Black plate (474,1)
[ Edit: 2012/ 1/ 17 Model: V36-D ]9-24 Technical and consumer informationdolly MUST be placed under the towed
vehicle ’ s drive wheels. Always follow the
dolly manufacturer ’ s recommendations
when using their product.
Manual transmission GUID-B30ED557-E6C5-4E25-B21C-5F9B6B9B165D
. Always tow with the manual transmis-
sion in Neutral.
. Your vehicle speed should never exceed
70 MPH (112 km/h) when flat towing
your vehicle.
. After towing 500 miles, start and idle
the engine with the transmission in
Neutral for two minutes. Failure to idle
the engine after every 500 miles of
towing may cause damage to the
transmission ’ s internal parts. GUID-3E088555-DC3D-4483-A05A-8DA986F1D29D
DOT (Department Of Transportation) Qual-
ity Grades: All passenger car tires must
conform to federal safety requirements in
addition to these grades.
Quality grades can be found where applic-
able on the tire sidewall between tread
shoulder and maximum section width. For
example:
Treadwear 200 Traction AA Temperature A
TREADWEAR GUID-499F0B52-9319-4A2F-9811-B95040CBA836
The treadwear grade is a comparative
rating based on the wear rate of the tire
when tested under controlled conditions
on a specified government test course. For
example, a tire graded 150 would wear one
and one-half (1 1/2) times as well on the
government course as a tire graded 100.
The relative performance of tires depends
upon actual conditions of their use, how-
ever, and may depart significantly from the
norm due to variations in driving habits,
service practices and differences in road
characteristics and climate. TRACTION AA, A, B AND C GUID-06FD06F1-0BA4-4FE2-98C0-CCD1E9E9D435
The traction grades, from highest to low-
est, are AA, A, B and C. Those grades
represent the tire ’ s ability to stop on wet
pavement as measured under controlled
conditions on specified government test
surfaces of asphalt and concrete. A tire
marked C may have poor traction perfor-
mance.
WARNING The traction grade assigned to this tire is
based on straight-ahead braking traction
tests, and does not include acceleration,
cornering, hydroplaning, or peak traction
characteristics.
TEMPERATURE A, B AND C GUID-D08B43D7-C76A-4659-BF4F-9C199B188B10
The temperature grades A (the highest), B,
and C, representing the tire ’ s resistance to
the generation of heat and its ability to
dissipate heat when tested under con-
trolled conditions on a specified indoor
laboratory test wheel. Sustained high
temperature can cause the material of the
tire to degenerate and reduce tire life, and
excessive temperature can lead to suddenUNIFORM TIRE QUALITY GRADING