
17
Introduction
INDICATOR SYMBOLS ON THE INSTRUMENT CLUSTER ❈For more detailed explanations, refer to “Instrument cluster” in section 4.
Seat belt warning light
Tailgate open warning light
High beam indicator
Light on indicator
Turn signal indicator
Front fog light indicator*
ABS warning light
Parking brake & Brake fluid 
warning light
Engine oil pressure warning light
AWD system warning light* 
AWD LOCK indicator*
Malfunction indicator
Air bag warning light
Low fuel level warning light DBC indicator*
Charging system warning light
Door ajar warning light
* : if equipped
ESC indicator*
ESC OFF indicator*
Low tire pressure telltale /TPMS malfunction indicator
ECO indicator*
Shift pattern indicator*
Manual transaxle shift indicator*
Engine coolant temperature 
warning light
Electric power steering (EPS) 
system warning light
Cruise indicator*
Cruise SET indicator*             

419
Features of your vehicle
Opening the hood 
1. Pull the release lever to unlatch thehood. The hood should pop open 
slightly. 2. Go to the front of the vehicle, raise the
hood slightly, pull the secondary latch (1) inside of the hood center and lift the hood (2). 3. Pull out the support rod from the
engine room.
4. Hold the hood open with the support rod.
HOOD 
OLM049025OLM049026OLM049027
WARNING
- Hot parts
Grasp the support rod in the area 
wrapped in rubber. The rubber will
help prevent you from being burned 
by hot metal when the engine is hot.
WARNING
Open the hood after turning off the 
engine on a flat surface, shifting
the shift lever to the P(Park) posi-
tion for automatic transaxle and to 
the 1st(First) gear or R(Reverse) for 
manual transaxle, and setting the
parking brake.       

439
Features of your vehicle
Average speed 
This mode calculates the average speed 
of the vehicle since the last averagespeed reset. 
Even if the vehicle is not in motion, the 
average speed is calculated while the
engine is running. 
Pressing the TRIP button for more than 1 
second, when the average speed is 
being displayed, clears the average
speed to zero (---).Driving time 
This mode indicates the total time trav- 
eled since the last driving time reset. 
Even if the vehicle is not in motion, the 
driving time is calculated while the 
engine is running. 
The meter’s working range is from 0:00~99:59. 
Pressing the TRIP button for more than 1 
second, when the driving time is being
displayed, clears the driving time to zero (0:00).
Warnings and indicators
All warning lights are checked by turning 
the ignition switch ON (do not start the 
engine). Any light that does not illuminate 
should be checked by an authorized
HYUNDAI dealer. 
After starting the engine, check to make 
sure that all warning lights are off. If any are still on, this indicates a situation that
needs attention. When releasing the 
parking brake, the brake system warning 
light should go off. The fuel warning light
will stay on if the fuel level is low.
OLM049066NOLM049067N    

Features of your vehicle
40
4
Active ECO system
(if equipped)
When the active ECO is operating, the 
ECO indicator is green. 
For more detailed information, refer to 
“Active ECO” in chapter 5.
Air bag warning light
This warning light will illuminate for 
approximately 6 seconds each time you
turn the ignition switch to the ON posi- tion. This light also comes on when the  
Supplemental Restraint System (SRS) is
not working properly. If the AIR BAG 
warning light does not come on, or con- 
tinuously remains on after operating for
about 6 seconds when you turned the 
ignition switch to the ON position or start- 
ed the engine, or if it comes on while
driving, have the SRS inspected by an
authorized HYUNDAI dealer.
Anti-lock brake system(ABS) warning light 
This light illuminates if the ignition switch 
is turned ON and goes off in approxi-
mately 3 seconds if the system is operat- 
ing normally. 
If the ABS warning light remains on, 
comes on while driving, or does not
come on when the ignition switch is 
turned to the ON position, this indicates 
that there may be a malfunction with the
ABS. 
If this occurs, have your vehicle checked 
by an authorized HYUNDAI dealer as
soon as possible. The normal braking
system will still be operational, but with- 
out the assistance of the anti-lock brake system.
ECO
WARNING
Don't keep watching the indicator 
while driving. It will distract you while driving and cause an acci- 
dent that results in severe personal
injury.   

441
Features of your vehicle
Electronic brake 
force distribution
(EBD) system
warning light 
If two warning lights shown illuminate at 
the same time while driving, your vehicle
may have a malfunction with ABS andEBD system. 
In this case, your ABS and regular brake 
system may not work normally. Have the
vehicle checked by an authorized 
HYUNDAI dealer as soon as possible.✽✽NOTICE
If the ABS warning light or EBD warn- 
ing light is on and stays on, the 
speedometer or odometer/tripmeter 
may not work. Also, the EPS warning
light may illuminate and the steering
effort may increase or decrease. In this 
case, have your vehicle checked by an 
authorized HYUNDAI dealer as soon as
possible.Parking brake & brake fluid warning light
Parking brake warning  
This light is illuminated when the parking 
brake is applied with the ignition switch in 
the START or ON position. The warning 
light should go off when the parking
brake is released while engine is run-ning. 
The parking brake warning chime will 
sound to remind you that the parking
brake is applied when you are driving 
above 6 mph (10 km/h). Always release 
the parking brake before you drive. 
Low brake fluid level warning 
If the warning light remains on, it may 
indicate that the brake fluid level in the 
reservoir is low. 
If the warning light remains on:
1. Drive carefully to the nearest safe location and stop your vehicle.
2. With the engine stopped, check the brake fluid level immediately and add 
fluid as required. Then check all brake 
components for fluid leaks.
WARNING
If both ABS and Brake warning 
lights are on and stay on, your vehi- 
cle’s brake system will not work 
normally. So you may experience
an unexpected and dangerous situ- 
ation during sudden braking. In this 
case, avoid high speed driving and
abrupt braking. Have your vehicle
checked by an authorized HYUNDAI 
dealer as soon as possible.   

Features of your vehicle
42
4
3. Do not drive the vehicle if leaks are
found, the warning light remains on or 
the brakes do not operate properly.
Have the vehicle towed to any author-
ized HYUNDAI dealer for a brake sys- 
tem inspection and necessary repairs.
Your vehicle is equipped with a dual-diag- 
onal braking system. This means you still 
have braking on two wheels even if one of 
the brake circuits is damaged or malfunc-
tions. With only one of the circuits work-
ing, more than normal pedal travel and 
greater pedal pressure are required to 
stop the car. Also, the car will not stop in
as short a distance with only a portion of 
the brake system working. If the brakes 
fail while you are driving, shift to a lower
gear for additional engine braking and
stop the car as soon as it is safe to do so. 
To check bulb operation, check whether 
the parking brake and brake fluid warning
light illuminates when the ignition switch is in the ON position.Seat belt warning 
As a reminder to the driver, the seat belt 
warning light will blink for approximately
6 seconds each time you turn the ignition
switch ON, regardless of belt fastening. 
For details, refer to the seat belt on chap- ter 3.
Turn signal indicator
The blinking green arrows on the instru- 
ment panel show the direction indicated
by the turn signals. If the arrow comes on
but does not blink, blinks more rapidly 
than normal, or does not illuminate at all, 
a malfunction in the turn signal system is
indicated. Your dealer should be consult- 
ed for repairs. 
This indicator also blinks when the haz- 
ard warning switch is turned on.
Light on indicator 
The indicator illuminates when the tail lights or headlights are ON.
High beam indicator 
This indicator illuminates when the head- lights are on and in the high beam posi-
tion or when the turn signal lever is pulled
into the Flash-to-Pass position.
Front fog light indicator  (if equipped)
The indicator illuminates when the front 
fog lights are ON.
WARNING 
Driving the vehicle with a warning 
light on is dangerous. If the brake 
warning light remains on, have the 
brakes checked and repaired imme-
diately by an authorized HYUNDAI 
dealer.   

445
Features of your vehicle
ESC indicator (ElectronicStability Control) 
(if equipped)
The ESC indicator will illuminate when 
the ignition switch is turned ON, but
should go off after approximately 3 sec- 
onds. When the ESC is on, it monitors 
the driving conditions and under normal
driving conditions, the ESC indicator will
remain off. When a slippery or low trac- tion condition is encountered, the ESC 
will operate, and the ESC indicator will
blink to indicate the ESC is operating. If the ESC system malfunctions the indica- 
tor illuminates and stays on. Take your
vehicle to an authorized HYUNDAI deal-
er and have the system checked.
ESC OFF indicator (if equipped)
The ESC OFF indicator will illuminate 
when the ignition switch is turned ON,
but should go off after approximately 3 
seconds. To switch to ESC function off, 
press the ESC OFF button. The ESCOFF indicator will illuminate indicating
the ESC is deactivated.
DBC (Downhill brake con-
trol) indicator (if equipped)
The DBC indicator will illuminate when 
the DBC button is pressed and the sys-tem is on. 
When driving down a steep hill at a speed under 22 mph (35 km/h), the DBC
will operate and the DBC indicator will
blink to indicate the DBC is operating. 
If the red indicator illuminates, the DBC 
system may have malfunctioned. Take 
your vehicle to an authorized HYUNDAI
dealer and have the system checked.
CAUTION
 Prolonged driving with the
Emission Control SystemMalfunction Indicator Light illumi-
nated may cause damage to theemission control systems whichcould effect drivability and/or fueleconomy.
If the EmissionControl System
Malfunction Indicator Light illumi- nates, potential catalytic converterdamage is possible which couldresult in loss of engine power.
Have the Engine Control Systeminspected as soon as possible byan authorized HYUNDAI dealer.  

Features of your vehicle
46
4
AWD system warning light
(if equipped) 
When the ignition switch is turned to the 
ON position, the AWD indicator will illu-
minate and then go off in a few seconds. 
If the AWD system warning light  
illuminates, this indicates that there is a
malfunction in the AWD system. If this
occurs, have your vehicle checked by an 
authorized HYUNDAI dealer as soon as 
possible.
AWD LOCK indicator  (if equipped)
The AWD LOCK indicator light is illumi- 
nated when the AWD LOCK button is
pushed. The purpose of this AWD LOCK 
mode is to increase the drive power 
when driving on wet pavement, snow-
covered roads and/or off-road. The AWD 
LOCK indicator light is turned off by 
pushing the button again.
Low tire pressure indica-tor
The low tire pressure telltale comes on 
for 3 seconds after the ignition switch is
turned to the "ON" position. 
The low tire pressure telltale illuminates 
when one or more of your tires is signifi-
cantly underinflated. 
The low tire pressure telltale will illumi- 
nate after it blinks for approximately one 
minute when there is a problem with the
Tire Pressure Monitoring System. 
If this occurs, have the system checked 
by an authorized HYUNDAI dealer as 
soon as possible. 
For details, refer to the TPMS on section 6.
CAUTION
Do not use AWD LOCK mode on dry
paved roads or highway, it can cause noise, vibration or damage ofAWD related parts.
WARNING- Safe stopping
 The TPMS cannot alert you to severe and sudden tire damage 
caused by external factors.
 If you feel any vehicle instability, immediately take your foot off the
accelerator, apply the brakes
gradually and with light force,
and slowly move to a safe posi- 
tion off the road.