2012 Hyundai H-1 (Grand Starex) paint

[x] Cancel search: paint

Page 95 of 338

Hyundai H-1 (Grand Starex) 2012  Owners Manual 425
Features of your vehicle
D100500AUN
Emergency fuel filer lid release
If the fuel filler lid does not open using
the remote fuel filler lid release, you can
open it manually. Unsnap and remove the

Page 124 of 338

Hyundai H-1 (Grand Starex) 2012  Owners Manual Features of your vehicle
54 4
✽NOTICE
If there is heavy accumulation of snow
or ice on the windshield, defrost the
windshield for about 10 minutes, or
until the snow and/or ice is removed
before usi

Page 227 of 338

Hyundai H-1 (Grand Starex) 2012  Owners Manual 539
Driving your vehicle
E120600AUN
To keep locks from freezing
To keep the locks from freezing, squirt an
approved de-icer fluid or glycerine into
the key opening. If a lock is covered with
ice, squi

Page 282 of 338

Hyundai H-1 (Grand Starex) 2012  Owners Manual Maintenance
28 7
G070200AEN
Changing the coolant
Have coolant changed by an authorized
HYUNDAI dealer according to the
Maintenance Schedule at the beginning
of this section.
G080100AEN
Checking the br

Page 283 of 338

Hyundai H-1 (Grand Starex) 2012  Owners Manual 729
Maintenance
G090100AEN
Checking the power steering fluid
level  
With the vehicle on level ground, check
the fluid level in the power steering reser-
voir periodically. The fluid should be
between

Page 286 of 338

Hyundai H-1 (Grand Starex) 2012  Owners Manual Maintenance
32 7
✽NOTICE
New automatic transmission fluid
should be red. The red dye is added so
the assembly plant can identify it as
automatic transmission fluid and distin-
guish it from engine o

Page 291 of 338

Hyundai H-1 (Grand Starex) 2012  Owners Manual 737
Maintenance
WIPER BLADES 
G180100AUN
Blade inspection
✽NOTICE
Commercial hot waxes applied by auto-
matic car washes have been known to
make the windshield difficult to clean.  
Contamination of

Page 293 of 338

Hyundai H-1 (Grand Starex) 2012  Owners Manual 739
Maintenance
2. Install the new blade assembly by
inserting the center part into the slot in
the wiper arm until it clicks into place.
3. Make sure the blade assembly is
installed firmly by trying
Page:   1-8 9-16 next >