2012 Hyundai Elantra fog light

761
Maintenance
Front turn signal bulb
Follow steps 1 to 4 from previous page.
5. Remove the socket from the assemblyby turning the socket counterclockwise
until the tabs on the socket align with
the slots on the assembly.
6. Remove the bulb from the socket by
pressing it in and rotating it counter-
clockwise until the tabs on the bulb
align with the slots in the socket. Pull
the bulb out of the socket.
7. Insert a new bulb by inserting it into the socket and rotating it until it locks
into place. 8. Install the socket in the assembly by
aligning the tabs on the socket with the
slots in the assembly. Push the socket
into the assembly and turn the socket
clockwise.
9. Reinstall the light assembly to the body of the vehicle.
Front fog light and Dedicated light
(if equipped)
1. Disconnect the negative battery cable.
2. Remove the screws under the front bumper.
3. Disconnect the power connector from the socket.
OMD071058LOMD071056L
Turn signal

Maintenance
62
7
Front fog light (if equipped)
4. Remove the bulb-socket from the
housing by turning the socket counter
clockwise until the tabs on the socketalign with the slots on the housing. 5. Install the new bulb-socket into the
housing by aligning the tabs on the
socket with the slots in the housing.
Push the socket into the housing and
turn the socket clockwise.
6. Connect the power connector to the socket. Dedicated light (if equipped)
Follow steps 1 to 3 from previous page.
4. Remove the socket from the assembly
by turning the socket counterclockwise
until the tabs on the socket align with
the slots on the assembly.
5. Remove the bulb by pulling it out.
6. Insert a new bulb by inserting it into the socket.
7. Install the socket in the assembly by aligning the tabs on the socket with the
slots in the assembly. Push the socket
into the assembly and turn the socket
clockwise.
OMD071059L
OMD071060L
■
Type A
■ Type B
Front fog light
Front fog light
Dedicated lamp

763
Maintenance
Headlight and front fog light aim- ing
Headlight aiming
1. Inflate the tyres to the specified pres-sure and remove any loads from the
vehicle except the driver, spare tyre,
and tools.
2. The vehicle should be placed on a flat floor.
3. Draw vertical lines (Vertical lines pass- ing through respective head lamp cen-
tres) and a horizontal line (Horizontalline passing through centre of headlamps) on the screen.
4. With the head lamp and battery in nor- mal condition, aim the head lamps so
the brightest portion falls on the hori-
zontal and vertical lines. 5. To aim the low beam left or right, turn
the driver (1) clockwise or counter-
clockwise. To aim the low beam up or
down, turn the driver (2) clockwise or
counterclockwise.
To aim the high beam up or down, turnthe driver (3) clockwise or counter-
clockwise.
Front fog light aiming
The front fog lamp can be aimed as the same manner of the head lamps aiming.
With the front fog lamps and battery nor-
mal condition, aim the front fog lamps. To
aim the front fog lamp up or down, turn
the driver (1) clockwise or counterclock-
wise.
OMD071057LOMD071061L

Maintenance
64
7
Aiming point
H1 : Height between the head lamp bulb centre and ground (Low beam) H2 : Height between the head lamp bulb centre and ground (High beam)H3 : Height between the fog lamp bulb centre and groundW1 : Distance between the two head lamp bulbs centres (Low beam)W2 : Distance between the two head lamp bulbs centres (High beam)W3 : Distance between the two fo
g lamp bulbs centres
W2
H1 H2 H3
W1 W3
Screen
Ground< Distance between lamps >
< Ground Height >
Vehicle condition H1 H2 H3
W1 W2 W3
with DRL* without DRL* with DRL* without DRL*
Without driver 713 (28.1) 666 (26.2) 389 (15.3) 414 (16.3) 1,334 (52.5) 1,100 (43.3) 1400 (55.1) 1460 (57.5)
With driver 706 (27.8) 659 (25.9) 382 (15.0) 407 (16) 1,334 (52.5) 1,140 (44.9) 1400 (55.1) 1460 (57.5)
DRL : Daytime Running Light Unit: mm (in)

767
Maintenance
Front fog light
1. Turn the front fog lamp on without the driver abroad.
2. The cut-off line should be projected in the allowable range (shaded region).
OMD051056L
centre
centre
centre

Maintenance
68
7
Side repeater light bulb replace- ment (if equipped)
If the light bulb is not operating, have the
vehicle checked by an authorised
HYUNDAI dealer. Rear combination light bulb replacement
(1) Rear fog light (if equipped)
(2) Back-up light
(3) Tail light
(4) Rear turn signal light(5) Stop / tail lightOutside light
1. Open the boot lid.
2. Remove the service cover by pulling out
the service cover.
OMD070032OMD071031LOMD070030

Maintenance
70
7
Inside light
1. Open the boot.
2. Loosen the retaining screw of the boot
lid cover and then remove the cover.
3. Disconnect the connector and then remove the nuts by turning the nuts
counter clockwise. Back up light
1. Take the light assembly out.
2. Remove the socket from the assembly
by turning the socket counterclockwise
until the tabs on the socket align with
the slots on the assembly.
3. Remove the bulb by pulling it out. 4. Insert a new bulb by inserting it into the
socket.
5. Install the light assembly to the boot.
6. Reinstall the nuts and connector and then the boot lid cover by pushing in
the screw.
Rear fog light (if equipped)
4. Remove the socket from the assembly by turning the socket counterclockwise
until the tabs on the socket align with
the slots on the assembly.
5. Remove the bulb from the socket by pressing it in and rotating it counter-
clockwise until the tabs on the bulb
align with the slots in the socket. Pull
the bulb out of the socket.
6. Insert a new bulb by inserting it into the socket and rotating it until it locks
into place.
7. Install the socket in the assembly by aligning the tabs on the socket with the
slots in the assembly. Push the socket
into the assembly and turn the socket
clockwise.
OMD070037
OMD070038
OMD070039
OMD070040
Rear fog light (if equipped)
Back up light

Specifications & Consumer information
2
8
ENGINE DIMENSIONS BULB WATTAGE
* : If equipped
Item
1.8 Engine
Displacement cc (cu. in) 1797 (109.66)
Bore x Stroke mm (in.)81x87.2 (3.19x3.43)
Firing order 1-3-4-2
No. of cylinders 4, In-line
Item mm (in)
Overall length 4530 (178.3)
Overall width 1775 (69.9)
Overall height 1445 (56.9)
Front tread 1563 (61.5)* 1
/ 1549 (61.0)* 2
/ 1551 (61.1)* 3
Rear tread1576 (62.0)*1
/ 1562 (61.5)* 2
/ 1564 (61.6)* 3
Wheelbase2700 (106.3)
Light BulbWattageBulb type
Headlights (Low)55H7
Headlights (High)55H1
Front turn signal light28PY21W
Position lights5W5W
Side repeater lightsLED-
Front fog lights*27H27W
Stop / tail lights21/5PY21/5W
Tail light 5W5W
Rear turn signal lights 21PY21W
Rear fog lights21H21W
Back-up lights16W16W
High mounted stop light21P21W
License plate lights5W5W
Map lamps8FASTON 8W
Room lamps8FASTON 8W
Luggage lamp*5FASTON 5W
*1
: with R15 tyre
* 2
: with R16 tyre
* 3
: with R17 tyre