2012 HONDA PILOT height

The f ront seats and second row seats
have adjustable seat belt anchors. To
adjust the height of an anchor,
squeeze the two release buttons, and
slide the anchor up or down as
needed (it has f our positions).
If the seat belt touches or crosses
your neck, or if it crosses your arm
instead of your shoulder, you need to
adjust the seat belt anchor height.
If necessary, pull up on the belt again
to remove any slack, then check that
the belt rests across the center of
your chest and over your shoulder.
This spreads the f orces of a crash
over the strongest bones in your
upper body.
Protecting A dults and Teens
18
RELEASE BUTTON
Improperly positioning the seat
belts can cause serious injury
or death in a crash.
Make sure all seat belts are
properly positioned beforedriving.
Table of ContentsMain Menu

When a child reaches the
recommended weight or height limit
for a forward-facing child seat, the
child should sit in a back seat on a
booster seat and wear the lap/
shoulder belt.
The f ollowing pages give
instructions on how to check proper
seat belt f it, what kind of booster
seat to use if one is needed, and
important precautions f or a child
who must sit in f ront.To determine if a lap/shoulder belt
properly f its a child, have the child
put on the seat belt, then ask
yourself :
Does the child sit all the way back
against the seat?
Do the child

The height of your driver

CONT INUED
The head restraints adjust f or height.
You need both hands to adjust the
restraint.Donotattempttoadjustit
while driving. To raise it, pull upward.
To lower the restraint, push the
release button sideways, and push
the restraint down.
Your vehicle is equipped with head
restraints in all seating positions to
help protect you and your
passengers f rom the likelihood of
whiplash and other injuries.
They are most ef f ective when you
adjust them so the center of the back
of the occupant

When reinstalling a head restraint,
put the legs back in place. Then
adjust it to the appropriate height
while pressing the release button.
When reinstalling a head restraint,
install the cap with the long side
toward the release button. Then
adjust it to the appropriate height
while pressing the release buttons.
Make sure the head restraint locks
in position when you reinstall it.The driver

µµ
ÎÎ Î ÎÎ
Î Î ÎÎ
Î
ÎÎ
ÎÎ Î Î
ÎÎ
Î Î
Specif ications
642 Seating Capacities
Air Conditioning
Dimensions
Weights
Capacities
191.4 in (4,861 mm)
78.5 in (1,995 mm)
70.9 in (1,802 mm)
Total
Front
Second
Third 3
3
2
8
Refrigerant type
Charge quantity
Lubricant type ND-OIL8
21.2 22.9 oz (600 650 g)HFC-134a (R-134a)
The GCWR must be reduced 2 percent for every 1,000 feet (305
meters) of elevation.
8,466 lbs (3,840 kg)
Length
Width
Height
Wheelbase
Track
67.5 in (1,715 mm)
67.7 in (1,720 mm)
109.3 in (2,775 mm)
72.7 in (1,846 mm)
9,579 lbs (4,345 kg)
Gross vehicle weight rating
Gross combined weight
rating (GCWR) See the tire information label
attached to the driver’s doorjamb.
Excluding the oil remaining in the engine
Including the coolant in the reserve tank and that remaining in the
engine
Reserve tank capacity: 0.196 US gal (0.74
)
1.98 US gal (7.5
)
2.48 US gal (9.4)
4.5 US qt (4.3
)
4.2 US qt (4.0
)
5.3 US qt (5.0
)
6.9 US qt (6.5
)
4.2 US qt (4.0)
0.48 US qt (0.45
)
0.45 US qt (0.43)
3.01 US qt (2.85
)
Fuel tank
Engine
coolant
Engine oil Automatic
transmission
fluid Rear
differential
fluid (4WD)
Transfer
assembly
fluid (4WD)
Windshield
washer
reservoir
2.79 US qt (2.64)
8.6 US qt (8.1)
3.6 US qt (3.4)
8.6 US qt (8.1)
3.6 US qt (3.4
)
3.3 US qt (3.1)
8.0 US qt (7.6
)
21.00 US gal (79.5
)
Front Rear
U.S. vehicles
Canadian
vehicles
1 : 2 : Except U.S. LX models
U.S. LX models
2WD models
1:
2: 3: 4WDmodels
1: 2: 3:4:ChangeTotal
Change
Including
filter
Without
filter
Total
Change Total
Change Total
ChangeTotal
Change Total
2WD
4WD Approx.
Without automatic transmission fluid cooler
With automatic transmission fluid cooler
1
12
23 1 2
44
3 3
Main MenuTable of Contents