Page 289 of 681
BluetoothAudio System (EX, EX-L , and Canadian L X models without navigation system)
282
SELECTOR KNOBBluetooth Indicator
SETUP BUTTON
SKIP BAR
POWER/VOLUME KNOB
RETURN BUTTON CD/AUX BUTTON
U.S. EX and Canadian LX models
Main MenuTable of Contents
Page 290 of 681
CONT INUED
BluetoothAudio System (EX, EX-L , and Canadian L X models without navigation system)
Features
283
EX-L models
Canadian EX models EX-L models with Rear
Entertainment System
Bluetooth Indicator
SELECTOR KNOB
RETURN BUTTON SETUP BUTTON
RETURN BUTTON SETUP BUTTON
SKIP BAR
RETURN BUTTON
USB/AUX BUTTON
SKIP BAR
SELECTOR KNOB POWER/VOLUME KNOB
POWER/VOLUMEKNOB
POWER/VOLUMEKNOB USB/AUX BUTTON
USB/AUX BUTTON
SKIP BAR
SELECTOR KNOBSETUP BUTTON
Main MenuTable of Contents
Page 318 of 681

µIn some audio playing modes
(XM,AUX),whenDPLIIison,the
music coming f rom the rear
speakers may sound distorted. This
is due to compression of the music,
and it does not indicate a problem
with the setting.
The SVC mode controls the volume
based on vehicle speed. The f aster
you go, the louder the audio volume
becomes. As you slow down, the
audio volume decreases.
The SVC has f our modes: SVC OFF,
SVC LOW, SVC MID, and SVC
HIGH. To change the SVC mode,
select SVC, then press ENTER on
the interf ace selector. The current
setting is shown on the screen. Turn
the interface knob to the desired
level, and enter your selection by
pressing ENTER on the interf ace
selector. If you f eel the sound is too
loud, choose low. If you f eel the
sound is too quiet, choose high.
Dolby
PL (ProLogic) II signal processing
creates multi-channel surround
sound f rom 2 channel stereo audio
sources. Dolby ProLogic II can only
be activated when listening to DISC
(CD-DA, MP3/WMA), XM Radio,
andAUX.WhenProLogicIIisactive,
‘‘PL II
Page 370 of 681
Playing an iPod(Models wit h navigat ion syst em)
Features
Wit hout rear ent ert ainment syst em Wit h rear ent ert ainment syst em
363
POWER/
VOLUMEKNOB
AUDIO
BUTTONINTERFACE DIAL
SKIP BAR USB/AUX
BUTTON
CANCEL
BUTTON ALBUM ART
AUDIO SCREEN
POWER/
VOLUME KNOB
AUDIO
BUTTON
SKIP BAR USB/AUX
BUTTON
CANCEL
BUTTON INTERFACE DIAL
Main MenuTable of Contents
Page 371 of 681

The audio system reads and plays
playable sound f iles on the iPod. The
system cannot operate an iPod as a
mass storage device. The system will
only play songs stored on the iPod
with iTunes.
iPod and iTunes are registered
trademarks owned by Apple Inc.
You can select the AUX mode by
using the voice control buttons.
iPods compatible with your audio
system using the USB adapter cable
are:
The audio system, including the
music search f eature Song By
Voice , can be operated by voice
control. See the navigation system
manual f or complete details.
This audio system can select and
play the audio f iles on the iPod
with
the same controls used f or the in-
dash disc player. To play an iPod,
connect it to the USB adapter cable
in the console compartment by using
your dock connector, then press the
USB/AUX button. The ignition
switch must be in the ACCESSORY
(I) or ON (II) position. The iPod will
also be charged with the ignition
switch in these settings.
Sof tware
Ver. 1.3 or more
Ver. 1.1.2 or more
Ver. 1.3.1 or more
Ver. 1.1.3 or more
Ver. 1.1.3 or more
Ver. 1.0.4 or more
Ver. 1.1.1 or more
Ver. 2.2.1 or more
Ver. 2.1.0 or more
Ver. 2.1.0 or more
Ver. 5.12.1 or more
Model
iPod 5th
generation
iPod classic
iPod nano
1st generation
iPod nano
2nd generation
iPod nano
3rd generation
iPod nano
4th generation
iPod touch
1st generation
iPod touch
2nd generation
iPhone
iPhone 3G
iPhone 3GSTo Play an iPod
Voice Cont rol Syst em
Playing an iPod(Models wit h navigat ion syst em)
364
TM
Main MenuTable of Contents
Page 377 of 681
ÎÎ
The displayed message may
vary on models or versions. On
some models, there is no
message to disconnect.
To take the system out of the iPod
mode, press one of the other source
buttons than the USB/AUX button.
When a compatible audio unit is
connected to the auxiliary input jack,
press the USB/AUX button to select
it. When you disconnect the iPod while
it is playing, the audio screen (if
selected) shows NO DATA.
If you reconnect the same iPod, the
system may begin playing where it
lef t of f , depending on what mode the
iPod is in when it is reconnected.
You can also press the MODE
buttononthesteeringwheelto
change modes.
You can disconnect the iPod at any
time when you see the ‘‘OK to
disconnect
Page 379 of 681
Playing a USB Flash Memory Device (Models with navigation syst em)
Wit hout rear ent ert ainment syst em Wit h rear ent ert ainment syst em
372
AUDIO
BUTTONCATEGORY
BAR
SCAN
BUTTON
SKIP BAR USB/AUX
BUTTON
AUDIO SCREEN
INTERFACE DIAL
POWER/
VOLUMEKNOB
AUDIO
BUTTON CATEGORY
BAR
SCAN
BUTTON
SKIP BAR USB/AUX
BUTTON
INTERFACE DIAL
POWER/
VOLUMEKNOB
Main MenuTable of Contents
Page 380 of 681

ÎÎ
Only AAC f ormat f iles recorded
with iTunes are playable on this
audio unit.
Some USB f lash memory devices
(such as devices with security lock-
out f eatures, etc.) will not work in
this audio unit.
The recommended USB f lash
memory devices are 256 MB or
higher, and f ormatted with the FAT
f ile system. Some digital audio
players may be compatible as well.
Do not use a device such as a card
reader or hard drive as it or your
f iles may be damaged.
Do not connect your USB f lash
memory device using a hub.
Do not use an extension cable to
the USB adapter cable equipped
with your vehicle.
The audio system reads and plays
the audio f iles on the USB f lash
memory device in MP3, WMA or
AAC formats.
This audio system can select and
play the audio f iles f rom a USB f lash
memory device with the same
controls used f or the in-dash disc
player. To play a USB f lash memory
device, connect it to the USB adapter
cable in the console compartment,
then press the USB/AUX button.
The ignition switch must be in the
ACCESSORY (I) or ON (II) position.
:
CONT INUED
To Play a USB Flash Memory
Device
Playing a USB Flash Memory Device (Models with navigation syst em)
Features
373
NOTE:
Main MenuTable of Contents