2012 HONDA FIT clock reset

11Quick Reference Guide
Heating and Cooling
* System
(P118)
●Rotate the fan control dial to adjust the fan speed.
●Rotate the Mode control dial ( / / / / ) to select the vents air flows
from.
●Rotate the temperature control dial to adjust the temperature.
●Rotate the fan control dial to OFF to turn the system off.
●Rotate the mode to defrost the windshield.
Fan Control Dial
(Rear Window Defogger/
Heated Mirror
*) Button
A/C (Air Conditioning) Button
*
Air flows from floor and
windshield defroster vents. Air flows from floor vents. Air flows from floor and
dashboard vents. Air flows from dashboard
vents.
Temperature Control Dial
Air flows from windshield
defroster vents.
Mode Control Dial
Fresh Air/Recirculation Lever
Clock
(P76)
a
Press the CLOCK button until the
displayed time begins flashing.
b
Press the
(1
(Hour) or
(2
(Minute)
button to set the time. Press the
(3

(Reset) button to set the time to the
nearest hour.
c
Press the CLOCK button again to set
the time.
The navigation system receives signals from
GPS satellites, updating the clock
automatically.
Models without navigation systemModels with navigation system
* Not available on all models

76Controls
Setting the ClockClockYou can adjust the time in the clock display, using the CLOCK button with the
ignition switch in ACCESSORY
(q
or ON
(w
.
1.Press and hold the CLOCK button until the clock display begins to blink.
2.Press the
(1
(Hour) button to change the hours.
3.Press the
(2
(Minute) button to change the minutes.
4.Press the CLOCK button to go back to the normal display.
■
Adjusting the Time
1Clock
Press and hold the CLOCK button until the clock
display begins to blink, then press the
(3
(Reset)
button.
Depending on the displayed time, the clock sets
forward or backward.
Example:
1:06 will reset to 1:00
1:53 will reset to 2:00
The clock is automatically updated through the
navigation system, so the time does not need to be
adjusted.
Models without navigation system Models with navigation system
Models without navigation system
(1
Button
(3
ButtonClock Display
CLOCK Button
(2
Button

231
Maintenance
BatteryChecking the Battery
Check the battery condition monthly. Look at
the test indicator window and check the
terminals for corrosion.
If your vehicle’s battery is disconnected or goes dead:
•The audio system
* is disabled.
2Entering the Audio Security Code P. 124
•The clock resets.
2Setting the Clock P. 76
•The navigation system
* is disabled.
2Refer to the navigation system manual
Charging the BatteryDisconnect both battery cables to prevent damaging your vehicle’s electrical system.
Always disconnect the negative (–) cable first, and reconnect it last.
1BatteryWARNING: Battery post, terminals,
and related accessories contain lead
and lead compounds.
Wash your hands after handling.The test indicator’s color information is on the
battery.
When you find corrosion, clean the battery terminals
by applying a baking powder and water solution.
Rinse the terminals with water. Cloth/towel dry the
battery. Coat the terminals with grease to help
prevent future corrosion.
3
WARNING
The battery gives off explosive hydrogen
gas during normal operation.
A spark or flame can cause the battery to
explode with enough force to kill or
seriously hurt you.
When conducting any battery
maintenance, wear protective clothing and
a face shield, or have a skilled technician do
it.
Test Indicator Window
* Not available on all models