2012 HONDA CROSSTOUR ECU

Whatever type you have, f ollow
the child seat maker’s instructions
f or adjusting or tightening the f it. Other LATCH-compatible seats
have a f lexible-type connector as
shown above.Attach the tether strap hook to the
tether anchor, then tighten the
strap as instructed by the child
seat maker.
If the tether strap is too long and
cannot be tightened f irmly, f ind a
route where the strap can be
tightened securely.
Push and pull the child seat
f orward and f rom side-to-side to
verify that it is secure.
Lif t the head restraint (see page ), then route the tether strap
through the legs of the head
restraint and over the seat-back,
making sure the strap is not
twisted.
Open the anchor cover.
4. 5.7.
6. 8.
94
Installing a Child Seat
43
ANCHOR
Flexible type
TETHER STRAP HOOK
ANCHOR COVER

Driver and Passenger Saf ety

2012 Crosstour

When not using the LATCH system,
all child seats must be secured to the
vehicle with the lap part of a lap/
shoulder belt.With the child seat in the desired
seating position, route the belt
through the child seat according
to the seat maker’s instructions,
then insert the latch plate into the
buckle and remove any slack f rom
the lap portion of the belt.To activate the lockable retractor,
slowly pull the shoulder part of the
belt all the way out until it stops,
then let the belt f eed back into the
retractor.
Af ter the belt has retracted, tug on
it. If the belt is locked, you will not
be able to pull it out. If you can pull
thebeltout,itisnotlocked,and
you will need to repeat these steps.
In addition, the lap/shoulder belts in
all seating positions except the
driver’s have a lockable retractor
that must be activated to secure a
child seat.
1.2.
3.
Installing a Child Seat with a L ap/
Shoulder Belt
Installing a Child Seat
44

Driver and Passenger Saf ety

2012 Crosstour

Af ter conf irming that the belt is
locked, grab the shoulder part of
the belt near the buckle, and pull
up to remove any slack from the
lap part of the belt. Remember, if
the lap part of the belt is not tight,
the child seat will not be secure.To deactivate the lockable retractor
and remove a child seat, unlatch the
buckle, unroute the seat belt, and let
the belt fully retract.
Push and pull the child seat
f orward and f rom side-to-side to
verify that it is secure enough to
stay upright during normal driving
maneuvers. If the child seat is not
secure, unlatch the belt, allow it to
retract f ully, then repeat these
steps.
To remove slack, it may help to
putweightonthechildseat,or
push on the back of the seat while
pulling up on the belt.
4.
5.
Installing a Child Seat
45

Driver and Passenger Saf ety

2012 Crosstour

A child seat with a tether can be
installed in any seating position in
the back seat, using one of the
anchorage points shown above.
Since a tether can provide additional
security to the lap/shoulder belt
installation, we recommend using a
tether whenever one is required or
available.For the center seat, lower the
head restraint, then route the
tether strap over the head
restraint and seat-back.
Tighten the strap according to the
seat maker’s instructions. Open the anchor cover, then
attach the tether strap hook to the
anchor, making sure the strap is
not twisted.
Af ter properly securing the child
seat (see page ), lif t the head
restraint, then route the tether
strap over the seat-back and
through the head restraint legs.
1.
2.
3.
44
Installing a Child Seat
Installing a Child Seat
Using an A nchor
46
TETHER STRAP HOOK
Center Position
ANCHOR
ANCHOR COVER
Outer Position
TETHER STRAP HOOK ANCHOR COVER
ANCHOR
TETHER ANCHORAGE P OINTS

Driver and Passenger Saf ety
with a Tether

2012 Crosstour

Devices intended to
improve a child’s comf ort or
reposition the shoulder part of a
seat belt can make the belt less
ef f ective and increase the chance
of serious injury in a crash.
This could result
in serious neck injuries during a
crash.
This could
cause very serious injuries during
a crash. It also increases the
chance that the child will slide
under the belt in a crash and be
injured.
If they do, they
could be very seriously injured in a
crash.
If you decide that a child can saf ely
ride up f ront, be sure to:
Caref ully read the owner’s manual,
and make sure you understand all
seat belt instructions and all saf ety
inf ormation.
Move the vehicle seat to the rear-
most position.
Have the child sit up straight, back
against the seat, and feet on or
near the f loor.
Check that the child’s seat belt is
properly and securely positioned.
Supervise the child. Even mature
children sometimes need to be
reminded to f asten the seat belts
or sit properly.
Protecting L arger Children
Do not put any accessories on aseat belt.
Do not let a child wear a seat belt
across t he neck.
Do not let a child put the shoulderpart of a seat belt behind t he backor under t he arm.
T wo children should never use thesame seat belt .Additional Saf ety Precautions
50

Driver and Passenger Saf ety

2012 Crosstour

The U.S. instrument panel is shown. Dif f erences f or the Canadian models are noted in the text.
Instrument Panel
55
LOW FUEL INDICATOR
ANTI-LOCK BRAKE SYSTEM
(ABS) INDICATOR
LIGHTS ON INDICATOR
CRUISE CONTROL
INDICATOR
(P.61)
(P. 57)
(P.58)
(P.
62)
CRUISE CONTROL
MAIN INDICATOR
(P.
62)
(P.56) (P.
60)
(P.59)
(P.61)
HIGH BEAM INDICATOR
MAINTENANCE MINDER INDICATOR (P.62) (P.60)
TIRE PRESSURE MONITORING
SYSTEM (TPMS) INDICATOR (P.59)
DAYTIME RUNNING LIGHTS INDICATOR (P.61
)
PARKING BRAKE AND BRAKE SYSTEM INDICATOR (P.57)
(P.58) FUEL ECONOMY INDICATOR (P.59) SIDE AIRBAG OFF INDICATOR
LOW TIRE PRESSURE
INDICATOR
SEAT BELT REMINDER
INDICATOR
DOOR AND TAILGATE OPEN INDICATOR
MALFUNCTION INDICATOR LAMP SECURITY SYSTEM INDICATOR
CHARGING SYSTEM INDICATOR
LOW OIL PRESSURE INDICATOR
IMMOBILIZER SYSTEM
INDICATOR (P.62) (P.61)
VEHICLE STABILITY ASSIST (VSA) SYSTEM
INDICATOR VSA OFF INDICATOR (P.58)
SUPPLEMENTAL RESTRAINT
SYSTEM (SRS) INDICATOR (P.57)
(P.56,
386)
(P.56, 386)
(P.56,387) FOG LIGHT INDICATOR (P.62)

Inst rument s and Cont rols

2012 Crosstour

This indicator comes on with the
high beam headlights. For more
inf ormation, see page .
This indicator also comes on with
reduced brightness when the
daytime running lights (DRL) are on
(see page ).
If this indicator comes on when you
turn the ignition switch to the ON
(II) position and release the parking
brake, it means there is a problem
with the DRL. There may also be a
problem with the high beam
headlights. Have your vehicle
checked by your dealer.
This indicator comes on as a
reminder that you must ref uel soon.
When the indicator comes on, there
are about 2.8 U.S. gal (10.5
)on
2WD models and 2.5 U.S. gal (9.6
)
on 4WD models of f uel remaining in
the tank.
When the needle reaches E, there is
a very small amount of f uel in the
tank.
This indicator comes on when the
security system is set. See pagef or more inf ormation on the
security system. 70
72
241 High Beam Indicator
Daytime Running
Security System Indicator
Low Fuel Indicator
Instrument Panel Indicators
61
SECURITY SYSTEM INDICATOR

Inst rument s and Cont rols
Lights Indicator

2012 Crosstour

Move the steering wheel up or
down, and in or out, so it points
toward your chest, not toward
your f ace. Make sure you can see
the instrument panel gauges and
indicators.Push the lever up to lock the
steering wheel in position.
Make sure you have securely
locked the steering wheel in place
by trying to move it up, down, in,
and out.
Push the lever under the steering
column all the way down.
Make any steering wheel
adjustments before you start driving.
1.
2.3.
4.
Steering Wheel A djustments
76
Adjusting the steering wheel
position while driving may
cause you to lose control of the
vehicle and be seriously injured
inacrash.
Adjust the steering wheel only
when the vehicle is stopped.

Inst rument s and Cont rols

2012 Crosstour