2012 FORD SUPER DUTY bulb

11. For the park or turn lamp bulb,
remove the bulb by turning it
counterclockwise and pulling it
straight out.
WARNING:Handle a halogen headlamp bulb carefully and keep
out of children’s reach. Grasp the bulb only by its plastic base
and do not touch the glass. The oil from your hand could cause the
bulb to break the next time the headlamps are operated.
Install the new bulb(s) in reverse order.
Replacing brake/tail/turn/back-up lamp bulbs (pick-ups only)
1. Make sure the headlamps are off,
then open the tailgate to expose the
lamp assemblies.
2. Remove the two bolts from the
tail lamp assembly and carefully pull
the lamp assembly from the tailgate
pillar by releasing the two retaining
tabs.
3. Rotate the bulb socket counterclockwise and remove from lamp
assembly.
4. Pull the bulb straight out of the socket.
Install the new bulb(s) in reverse order.
Lights
97
2012 F-250/350/450/550(f23)
Owners Guide, 1st Printing
USA(fus)

Replacing brake/tail/turn/back-up lamp bulbs (chassis cabs only)
(if equipped)
1. Make sure the headlamps are off.
2. Remove the four screws and the
lamp lens from lamp assembly.
3. Carefully pull the bulb straight
out of the socket and push in the
new bulb.
Replacing cargo lamp and high-mount brake lamp bulbs
1. Make sure the headlamps are off.
2. Remove the screws and lamp
assembly from the vehicle as wiring
permits.
3. Remove the bulb socket by
rotating it counterclockwise.
4. Pull the bulb straight out of the
socket.
Lights
98
2012 F-250/350/450/550(f23)
Owners Guide, 1st Printing
USA(fus)

Replacing front clearance and identification lamp bulbs
(if equipped)
1. Make sure the headlamps are off.
2. Remove the screw and lens from
the lamp assembly.
3. Pull the bulb straight out of the
socket.
Install the bulb(s) in reverse order.
Replacing fog lamp bulbs (if equipped)
1. Make sure the headlamps are off.
2. Remove the bulb socket from the
fog lamp by turning it
counterclockwise.
3. Disconnect the electrical
connector from the fog lamp bulb.
Install the new bulb(s) in reverse order.
Replacing license plate lamp bulbs
The license plate bulbs are located
behind the rear bumper. To change
the license plate lamp bulbs:
1. Reach behind the rear bumper to
locate the bulb.
2. Twist the bulb socket
counterclockwise and carefully pull
to remove it from the lamp
assembly.
3. Pull out the old bulb from the
socket and push in the new bulb.
4. Install the bulb socket in lamp assembly by turning it clockwise.
Lights
99
2012 F-250/350/450/550(f23)
Owners Guide, 1st Printing
USA(fus)

Switching off AdvanceTracwith RSC
If the vehicle is stuck in snow, mud or sand, and seems to lose engine
power, switching off certain features of the AdvanceTracwith RSC
system may be beneficial because the wheels are allowed to spin. This
will restore full engine power and will enhance momentum through the
obstacle. To switch off the AdvanceTracwith RSCsystem, press the
stability control button located on the instrument panel to the right of
the climate control system. Full features of the AdvanceTracwith RSC
system can be restored by pressing the button again or by turning off
and restarting the engine.
If you switch off the AdvanceTracwith RSCsystem, the stability
control off light will illuminate steadily. Pressing the stability control
button again will turn off the stability control off light and reactivate the
system.
In R (Reverse), ABS and the engine traction control and brake traction
control features will continue to function; however, ESC and RSCare
disabled.
AdvanceTracwith RSCFeatures (SRW only)
Button functionsStability
control
light
RSCESC TCS
Default at start-upIlluminated
during bulb
checkEnabled Enabled Enabled
Button pressed
momentarilyIlluminated
solidEnabled Enabled
1Disabled
Button pressed and
held for more than
5 seconds at vehicle
speed under 35 mph
(56 km/h)Flashes then
illuminated
solid
2Disabled Disabled Disabled
Vehicle speed
exceeds 35 mph
(56 km/h) after
button is pressed
and held for more
than 5 secondsIlluminated
solidEnabled Enabled
1Disabled
Driving
283
2012 F-250/350/450/550(f23)
Owners Guide, 1st Printing
USA(fus)

On-board diagnostics (OBD-II)
Your vehicle is equipped with a computer that monitors the engine’s
emission control system. This system is commonly known as the
on-board diagnostics system (OBD-II). The OBD-II system protects the
environment by ensuring that your vehicle continues to meet
government emission standards. The OBD-II system also assists your
authorized dealer in properly servicing your vehicle. When the service
engine soon
indicator illuminates, the OBD-II system has detected
a malfunction. Temporary malfunctions may cause the service engine
soon
indicator to illuminate. Examples are:
1. The vehicle has run out of fuel—the engine may misfire or run poorly.
2. Poor fuel quality or water in the fuel—the engine may misfire or run
poorly.
3. The fuel cap may not have been securely tightened. SeeFuel filler
capin this chapter.
4. Driving through deep water—the electrical system may be wet.
These temporary malfunctions can be corrected by filling the fuel tank
with good quality fuel, properly tightening the fuel cap or letting the
electrical system dry out. After three driving cycles without these or any
other temporary malfunctions present, the service engine soon
indicator should stay off the next time the engine is started. A driving
cycle consists of a cold engine startup followed by mixed city/highway
driving. No additional vehicle service is required.
If the service engine soon
indicator remains on, have your vehicle
serviced at the first available opportunity. Although some malfunctions
detected by the OBD-II may not have symptoms that are apparent,
continued driving with the service engine soon
indicator on can
result in increased emissions, lower fuel economy, reduced engine and
transmission smoothness, and lead to more costly repairs.
Readiness for Inspection/Maintenance (I/M) testing
Some state/provincial and local governments may have
Inspection/Maintenance (I/M) programs to inspect the emission control
equipment on your vehicle. Failure to pass this inspection could prevent
you from getting a vehicle registration. Your vehicle may not pass the I/M
test if the service engine soon
indicator is on or not working
properly (bulb is burned out), or if the OBD-II system has determined
that some of the emission control systems have not been properly
checked. In this case, the vehicle is considered not ready for I/M testing.
Maintenance and Specifications
401
2012 F-250/350/450/550(f23)
Owners Guide, 1st Printing
USA(fus)

If the service engine soonindicator is on or the bulb does not
work, the vehicle may need to be serviced. Refer toOn-board
diagnostics (OBD-II)in this chapter.
If the vehicle’s engine or transmission has just been serviced, or the
battery has recently run down or been replaced, the OBD-II system may
indicate that the vehicle is not ready for I/M testing. To determine if the
vehicle is ready for I/M testing, turn the ignition key to the on position
for 15 seconds without cranking the engine. If the service engine
soon
indicator blinks eight times, it means that the vehicle is not
ready for I/M testing; if the service engine soon
indicator stays on
solid, it means that the vehicle is ready for I/M testing.
The OBD-II system is designed to check the emission control system
during normal driving. A complete check may take several days. If the
vehicle is not ready for I/M testing, the following driving cycle consisting
of mixed city and highway driving may be performed:
15 minutes of steady driving on an expressway/highway followed by
20 minutes of stop-and-go driving with at least four 30-second idle
periods.
Allow the vehicle to sit for at least eight hours without starting the
engine. Then, start the engine and complete the above driving cycle. The
engine must warm up to its normal operating temperature. Once started,
do not turn off the engine until the above driving cycle is complete. If
the vehicle is still not ready for I/M testing, the above driving cycle will
have to be repeated.
POWER STEERING FLUID
Check the power steering fluid. Refer toscheduled maintenance
information.If adding fluid is necessary, use only MERCONAT F.
•Gasoline engine shown; diesel
engine similar. Refer to
Identifying components in the
engine compartmentin the
diesel supplement.
Check the fluid level when it is at ambient temperature, 20°F–80°F
(-7°C–25°C):
1. Check the fluid level in the reservoir. It should be between the MIN
and MAX range. Do not add fluid if the level is within this range.
Maintenance and Specifications
402
2012 F-250/350/450/550(f23)
Owners Guide, 1st Printing
USA(fus)

A
Accessory delay ........................107
AdvanceTrac ..............................279
Airbag supplemental restraint
system ........................184, 188, 190
and child safety seats ............186
description ..............184, 188, 190
disposal ....................................198
driver airbag ............186, 189, 191
indicator light .........................193
operation .................186, 189, 191
passenger airbag .....186, 189, 191
passenger deactivation
switch ......................................194
side airbag ...............................188
Air cleaner filter ...............408, 413
Air conditioning ....................80, 83
manual heating and air
conditioning system .................80
Ambulance packages ....................7
Antifreeze
(see Engine coolant) ................383
Anti-lock brake system
(see Brakes) ..............................275
Anti-theft system ..............153, 155
arming the system ..........154, 156
disarming a triggered
system .....................................156
triggering .................................156
Audio system (see Radio) ...61, 63
Automatic transmission ............294
driving an automatic
overdrive .................................291
fluid, adding ............................404
fluid, checking ........................404
fluid, refill capacities ..............414
Selectshift (SST) ....................297
Auxiliary Input Jack ...................71Auxiliary power point ...............103
Axle
refill capacities ........................414
B
Battery .......................................381
acid, treating emergencies .....381
jumping a disabled battery ....351
maintenance-free ....................381
replacement, specifications ...413
servicing ..................................381
Bed extender ............................130
Belt-Minder.............................180
Booster seats .............................215
Brakes ........................................275
anti-lock ...................................275
anti-lock brake system (ABS)
warning light ...........................276
fluid, checking and adding ....403
fluid, refill capacities ..............414
parking ....................................277
shift interlock ..........................289
trailer .......................................260
Bulbs ............................................94
C
Capacities for refilling fluids ....414
Car2UHome Automation
System .......................................120
Cassette tape player ...................61
Cell phone use ............................10
Changing a tire .........................334
Child safety seats ......................203
attaching with tether straps ..210
in front seat ....................204, 210
in rear seat ......................204, 210
Index
448
2012 F-250/350/450/550(f23)
Owners Guide, 1st Printing
USA(fus)

checking and adding ..............379
dipstick ....................................379
filter, specifications ........380, 413
recommendations ...................380
refill capacities ........................414
Event data recording ....................8
Exhaust fumes ..........................273
F
Fail safe cooling ........................387
Fleet MyKey programming ......133
Flexible Fuel Vehicle (FFV) ....390
Floor mats .........................126–127
Fluid capacities .........................414
Fog lamps ....................................90
Four-Wheel Drive vehicles .......304
driving off road .......................311
electronic shift ................305, 309
indicator light .........................306
lever operated shift ................306
manual locking hubs ..............305
preparing to drive your
vehicle .....................................289
Fuel ............................................390
calculating fuel
economy ............................25, 396
cap ...........................................393
capacity ...................................414
choosing the right fuel ...........394
detergent in fuel .....................396
filling your vehicle with
fuel ...........................390, 393, 397
filter, specifications ........390, 413
fuel pump shut-off ..................324
improving fuel economy ........396
octane rating ...........394–395, 418
quality ......................................395
running out of fuel .................396safety information relating to
automotive fuels .....................390
Fuel - flex fuel vehicle
(FFV) .........................390, 394–395
Fuses ..................................324–325
G
Garage door opener ..................120
Gas cap (see Fuel cap) ............393
Gas mileage
(see Fuel economy) .................396
Gauges .........................................21
H
Hazard flashers .........................323
Headlamps ...................................89
aiming ..................................91–92
autolamp system .......................89
daytime running lights .............91
flash to pass ..............................90
high beam .................................90
replacing bulbs .........................95
turning on and off ....................89
Heating
heating and air conditioning
system .................................80, 83
Hill descent mode .....................285
Hill start assist ..........................299
Hood ..........................................375
I
Ignition ...............................269, 418
Illuminated visor mirror ...........101
Infant seats
(see Safety seats) .....................203
Index
450
2012 F-250/350/450/550(f23)
Owners Guide, 1st Printing
USA(fus)