Page 5 of 36
•Front fenders with functional air extractors
•Seats with increased bolstering and unique covers
•Front and rear LED marker lamps
•Switch pack with “off-road mode” and “hill descent” buttons, and four
auxiliary switches
•Longer, cast aluminum lower control arms
•Longer, forged steel upper control arms
•Front coil springs and rear leaf springs
•Fox Racing 47 mm piston internal bypass front shocks
•Fox Racing 47 mm pistons, internal bypass, remote reservoir rear
shocks
•Micro-cellular urethane jounce bumpers (front and rear)
•Raptor navigation welcome screen
•17” cast aluminum wheels and 315/70-17 BFGoodrichall-terrain tires
•Full-size all-terrain spare tire
•Off-road specific calibrations for engine, transmission and
AdvanceTracsystem
•Instrument panel cluster graphics
•High line LCD cluster with unique SVT off-road screen
•Steering wheel - unique wrap with on-center marker, thumb pads, and
improved grip contour
F-150 SVT Raptor-specific features
5
2012 F-150(f12)
Supplement, 1st Printing
USA(fus)
Page 7 of 36
6.2L V8 ENGINE
1. Auxiliary switch circuit pass through circuits
2. Windshield washer fluid reservoir
3. Engine oil dipstick
4. Brake fluid reservoir
5. Engine coolant reservoir
6. Auxiliary power distribution box
7. Air filter assembly
8. Power steering fluid reservoir
9. Power distribution box
10. Engine oil filler cap
11. Battery
21
11
345
10987
6
Engine/Transmission
7
2012 F-150(f12)
Supplement, 1st Printing
USA(fus)
Page 8 of 36
ENGINE INFORMATION
6.2L V8 engine
Bore x Stroke102x95mm
(4.01 x 3.74 in.)
Displacement6.2L (6207 cc)
Compression ratio9.8:1
Horsepower (SAE
net)401 hp @ 5500 rpm on 87 octane
411 hp @ 5500 rpm on 91 octane
Torque434 lb-ft @ 4500 rpm on 87 octane
434 lb-ft @ 4500 rpm on 91 octane
Redline6000 rpm
Specific output64.6 hp/l on 87 octane
66.2 hp/l on 91 octane
ValvetrainSingle overhead cam, roller rocker shaft with
hydraulic lash adjustment, inverted-tooth chain
drive, ovate-wire valve springs, two valves per
cylinder
Fuel systemSequential electronic fuel injection, returnless
fuel system
Ignition systemCoil-on-plug electronic ignition with secondary
wire and dual-plug
Throttle bodySingle 80 mm (3.15 in)
Exhaust manifoldsCast-iron high silicon, molybdenum (HiSiMo)
TOWING CAPACITY
The maximum weight the SuperCab vehicle can tow is limited to
6,000 lb. (2721 kg). The Gross Combination Weight Rating (GCWR) is
12,400 lb. (5624 kg).
The maximum weight the SuperCrew vehicle can tow is limited to
8,000 lb. (3629 kg). The Gross Combination Weight Rating (GCWR) is
14,700 lb. (6668 kg).
Refer toTrailer towingin theTires, Wheels and Loadingchapter of
yourOwner’s Guidefor additional towing information.
Engine/Transmission
8
2012 F-150(f12)
Supplement, 1st Printing
USA(fus)
Page 30 of 36
Item CapacityFord part name or
equivalentFord part number /
Ford Specification
Rear axle fluid friction
modifier4 oz. (118 ml) Additive Friction ModifierXL-3
EST-M2C118-A
Fuel tank26 gallons
(98.4L)——
Transmission fluid
3
12.4L
(13.1 quarts)
4
Motorcraft
MERCONLV AT FXT-10-QLV /
MERCONLV
Transfer case lubricant1.4-1.5L
(2.9-3.1 pints)Motorcraft Transfer Case
FluidXL-12 / —
1Add the coolant type originally equipped in your vehicle.2Fill 6 mm to 14 mm (1/4 inch to 9/16 inch) below bottom of fill hole.
Your vehicle’s rear axle is filled with a synthetic rear axle lubricant and is considered lubricated for
life. These lubricants do not need to be checked or changed unless a leak is suspected, service is
required or the axle assembly has been submerged in water. The axle lubricant should be changed
any time the rear axle has been submerged in water.3Ensure the correct automatic transmission fluid is used. Transmission fluid requirements are
indicated on the dipstick or on the dipstick handle. Check the container to verify the fluid being
added is of the correct type. Refer to yourscheduled maintenance informationto determine the
correct service interval.4Approximate dry fill capacity including transmission fluid cooling system, actual refill capacities
will vary based on vehicle application and transmission fluid cooling system (i.e. coolers size,
cooling lines, auxiliary cooler capacities). The amount of transmission fluid and fluid level should
be set by the indication on the dipstick’s normal operating range.5Use of synthetic or synthetic blend motor oil is not mandatory. Engine oil need only meet the
requirements of Ford specification WSS-M2C945-A and the API Certification mark.
Maintenance
30
2012 F-150(f12)
Supplement, 1st Printing
USA(fus)
Page 36 of 36
A
Air cleaner filter .........................28
Automatic transmission
fluid, refill capacities ................29
Axle
refill capacities ..........................29
B
Battery
replacement, specifications .....28
C
Capacities for refilling fluids ......29
Coolant
refill capacities ..........................29
E
Engine ............................................8
refill capacities ..........................29
service points ..............................7
Engine oil
filter, specifications ..................28
refill capacities ..........................29
F
Fluid capacities ...........................29
Fuel
capacity .....................................29
filter, specifications ..................28
octane rating .........................8, 31I
Ignition ...........................................8
M
Motorcraftparts ........................28
O
Octane rating ..............................31
P
Parts (see Motorcraftparts) ...28
S
Spark plugs, specifications .....8, 28
T
Tires
changing ....................................31
rotating ......................................31
Towing
wrecker ......................................26
Transmission
fluid, refill capacities ................29
U
Upfitter controls .........................14
W
Wrecker towing ...........................26
Index
36
2012 F-150(f12)
Supplement, 1st Printing
USA(fus)
