2012 FIAT DOBLO COMBI open bonnet

91
KNOW
YOUR
VEHICLE
SAFETY
STAR

TING
AND
DRIVING
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
SERVICING
AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
SECURING YOUR LOAD
To make it easier to secure your load, there are hooks (in
various quantities depending on the version) fixed to the
floor figs. 91-92.
F0V0047mfig. 93
BONNET
Opening figs. 93-94-95
Proceed as follows:
❒pull lever A-fig. 93 in the direction indicated by the ar-
row;
❒release catch B-fig. 94, lift the bonnet and, at the same
time, release the support rod C-fig. 95 from its lock-
ing device D-fig. 95, then insert the end of the rod in-
to housing E-fig. 95 of the bonnet (bigger hole) and push
into the safety position (smaller hole), as shown in the
diagram.
If the supporting rod is not positioned cor-
rectly, the bonnet may fall violently. On-
ly perform these operations when the vehicle is
stationary.
WARNING
F0V0122mfig. 92
F0V0114mfig. 91

F0V0048mfig. 9492
KNOWYOUR
VEHICLE
SAFETY
ST AR

TING AND
DRIVING
WARNING
LIGHTS AND MESSAGES
IN AN
EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
Before opening the bonnet, check that
windscreen wiper arm is not lifted from the
windscreen.
WARNING
When the engine is warm, work carefully
inside the engine compartment to avoid
getting burnt. Keep your hands away from the fan:
it may turn on even with key removed from the
switch. Wait for the engine to cool down.
WARNING
Pay attention to scarves, ties and other
loose-fitting garments. If they accidental-
ly come into contact with moving parts, they may
get caught up and dragged with serious risks for
those wearing them.
WARNING

93
KNOW
YOUR
VEHICLE
SAFETY
STAR

TING
AND
DRIVING
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
SERVICING
AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
Closing fig. 95
Proceed as follows:
❒Hold the bonnet up with one hand and, with the oth-
er, remove rod C from housing E and fit it back into its
catch D;
❒Lower the bonnet to approximately 20 centimetres
from the engine compartment and let it drop. Make
sure that the bonnet is completely closed and not on-
ly fastened by the safety catch by trying to open it. If
it is not perfectly closed, do not try to press the bon-
net down but open it and repeat the procedure.
For safety reasons, the bonnet must al-
ways be perfectly closed while travelling.
Make sure that the bonnet is perfectly closed and
that the lock is engaged. If you discover whilst dri-
ving that the lock is not fully engaged, stop im-
mediately and close the bonnet in the correct
manner.
WARNING
F0V0049mfig. 95

108
KNOWYOUR
VEHICLE
SAFETY
ST AR

TING AND
DRIVING
WARNING
LIGHTS AND MESSAGES
IN AN
EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
F0V0043mfig. 107
EMERGENCY STARTING fig. 107
When jump starting, never connect the negative lead ( –)
of the auxiliary battery to the negative pole C of the ve-
hicle battery, but rather to either the false pole B or to
an engine/gearbox earth point.
WARNINGS
When replacing the battery, always go to
the Fiat Service Network. Replace the bat-
tery using a new one of the same type and spec-
ifications.
WARNING
Before opening the bonnet, make sure
that the vehicle is switched off and the key
is in the OFF position. Follow the instructions on
the dedicated plate on the front crossmember. It
is advisable to extract the key when there are oth-
er people in the vehicle.
WARNING
F0V0218mfig. 106a
Versions without dummy pole fig. 106a
In case of car inactivity, special attention must be paid due
to the disconnection of the battery power supply. Proceed
as follows: detach the connector (by pressing button B) from
sensor C for monitoring the battery status installed on the
battery negative pole D. This sensor should never be dis-
connected from the pole except if the battery is replaced.

220
KNOWYOUR
VEHICLE
SAFETY
STARTING AND
DRIVING
WARNING
LIGHTS AND MESSAGES
IN AN
EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICAT IO

NS
INDEX
F0V0118mfig. 192F0V0117mfig. 194
F0V0116mfig. 193
ENGINE MARKING
This is printed onto the cylinder block and shows the type
and production serial number.
BODYWORK PAINT IDENTIFICATION
PLATE fig. 192
This plate is fitted inside the bonnet and contains the fol-
lowing information:
A Paint manufacturer.
B Colour name.
C Fiat colour code.
D Re-spray and touch-up colour code.
CHASSIS MARKING fig. 193-194
These are located respectively:
– on the passenger compartment floor panel, near the right
front seat; open flap A-fig. 193 to access
– on the lower part of the windscreen B-fig. 194
The marking includes:
❒vehicle model;
❒chassis number.

267
KNOW
YOUR
VEHICLE
SAFETY
STARTING
AND
DRIVING
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
SERVICING
AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
Battery recharging ................. 188
Battery ...................................... 206
– jump starting .................... 155
– maintenance ..................... 208
– recharg e ............................. 188
– replace ment....................... 207
– tips for extending battery life ........................ 208
Body (mark ing) ...................... 220
Body codes .............................. 221
Body mark ing ......................... 220
Body paintwork identification plate .............. 220
Body vers ions ......................... 221
Body – body version codes ........ 221
– cleaning, care and maintenance ............. 214 Bonnet
– opening/closing ...... 91-92-93
Bookrest .................................... 76
Boot ........................................... 85
– expanding the boot ........... 89
– parcel shelf (removal) ....... 88
– removing the parcel shelf 88
– securing your load ............ 91
Boot courtesy light ................. 67
Boot – emergency opening from the inside ............................... 85-86
– expanding the boot ........... 89
– opening with remote contro l ................................... 6
– securing your load ............ 91
Brake Assist system ................ 98
A
BS system .............................. 96
Additional brake light – bulb replace ment.............. 176
Adjusting the vehicle interior lighting ..................................... 20
Air bag deactivation ............. 130
Air filter .................................. 206
Air recirculation ..........46-49-56
Air vents ................................... 43
Antifreeze – checking levels and topping up .................. 202
– specifications .................... 248
Ashtray ....................................... 75
ASR function .......................... 100
ASR system ............................ 100
Automatic climate control system ..................................... 51
INDEX

270
KNOWYOUR
VEHICLE
SAFETY
STARTING AND
DRIVING
WARNING
LIGHTS AND MESSAGES
IN AN
EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEXDPF (diesel particulate filter) ...................................... 114
E lectrical/electronic devices 110
Emergency starting ................ 155
– bump starting ................... 166
– jump starting .................... 155
Emissions of CO
2................. 257
End of vehicle life .................. 260
Engine codes ........................... 221
Engine compartment – checking le vels ................. 199
– opening/closing the bonnet .......................... 91
– washing .............................. 216
Engine coolant – checking levels and topping up ................. 203
– specifications .................... 248
– temperature gauge and warning light ................. 13Engine coolant temperature
gauge ........................................ 13
– type of coolant ................ 248
Engine coolant temperature overheating warning light .. 145
Engine coolant – checking levels and topping up ......................... 203
– specifications .................... 248
Engine cooling – checking levels and topping up ................. 203
– specifications .................... 248
Engine immobiliser (Fiat CODE) ............................. 4
Engine mark ing ...................... 220
Engine oil consumption ....... 201 – consumption .................... 202
– engine oil specifications .. 247 Engine oil
– checking levels and topping up .................. 202
– consumption .................... 202
– specifications .................... 247
Engine starting ....................... 133
– emergency starting ..134-155
– ignition switch .......................9
– procedure for Diesel versio ns ..............................134
– procedure for petrol versio ns .............................. 133
– stopping the engine ........ 135
– warming up the engine .. 134
Engine
– engine immobiliser (Fiat CODE) ......................... 4
– identification c odes .......... 221
– marking .............................. 220
– technical data ................... 223