Button volume (adjusting the button
volume)
This function may be used to adjust (up to 8 levels)
the volume of the acoustic signal made when the
MODE,
and
buttons are pressed.
To set the desired volume, proceed as follows:
❒press the MODE button briefly, making the
display flash the previously set volume "level";
❒press the
or
button to make the adjustment;
❒briefly press the MODE button to return to the
menu screen or hold the button down to return
to the standard screen without memorising.
Belt buzzer (Buzzer activation for SBR
indication)
This function can only be displayed after a Fiat
Dealership has deactivated the SBR system (see
paragraph “SBR system” in the “Safety” chapter).Service (Scheduled servicing)
Using this function you can display information
about the mileage intervals for car servicing.
To consult this information, proceed as follows:
❒briefly press the MODE button: the display
shows service requirements in km or mi
according to the previous setting (see paragraph
“Distance unit of measurement”);
❒briefly press the MODE button to go back to the
menu screen or hold the button down to go back
to the standard screen.
Note The "Scheduled Servicing Plan" requires the
car to be serviced every 30,000 km (or 18,000
miles). This is automatically displayed, when the
ignition key is turned to MAR-ON, starting from
2,000 km (or the equivalent in miles) from this
point and reappears every 200 km (or the
equivalent in miles). Below 200 km servicing
indications are more frequent. The indication will
appear in kilometres or miles depending on the unit
of measurement settings. When the next
scheduled servicing is approaching, the message
"Service" will appear on the display, followed by the
number of kilometres or miles left, when the
ignition key is turned to MAR-ON. Go to a Fiat
Dealership, where the "Scheduled Servicing Plan"
operations will be performed and the message will
be reset.
42GETTING TO
KNOW YOUR CAR
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
Thousands of miles 18 36 54 72 90 108
Thousands of km 30 60 90 120 150 180
Months 24 48 72 96 120 144
Visually inspect condition of toothed timing drive belt (petrol versions)●●
Check tension of accessory drive belts and adjust if necessary (excluding engines
equipped with automatic tensioner)●●
Check exhaust emissions (petrol versions)●●●●●●
Check engine management system operation (through the diagnosis socket)●●●●●●
Replace accessory drive belt/s●
Replace toothed timing drive belt (petrol versions)
(*)
●
Replace spark plugs (petrol versions)
(#)
●●●●●●
Replace air cleaner cartridge (petrol versions)●●●
Change engine oil and oil filter (petrol versions) (or ever 24 months)
(°**)
●●●●●●
Change brake fluid (or every 24 months)●●●
Change pollen filter (or every 15 months)●●●●●●
(*) Regardless of the distance covered, the timing drive belt must be changed every 4 years for particularly demanding use (cold
climates, town driving, long periods of idling) or at least every 5 years
(#) On the 1.4 T-Jet and 1.4 Turbo MultiAir versions the following are extremely important to ensure correct operation and prevent
serious damage to the engine: only use spark plugs specially tested for T-Jet and MultiAir engines (see paragraph "Engine") of the
same mark and type; strictly comply with the Scheduled Servicing Plan; you are advised to contact a Fiat Dealership
(°**) If the vehicle is mainly used for town driving or has an annual mileage of less than 10,000 km, the engine oil and engine oil filter
should be changed every 12 months.
226GETTING TO KNOW
YOUR CAR
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCYSERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
