2012 Citroen DS4 driver seat adjustment

17Familiarisation
Sitting comfortably
Manual adjustment88

Driver's seat


Forwards-backwards Height
Electric adjustment


Seat back angle
89

Sitting comfortably
Head restraint height and angle
Front seats
Other functions available...
Lumbar massage.Storing driving positions (driver's electric seat). Heated seats.
90
1.
Release the steering wheel. 2.Adjust for height and reach.3.Lock the steering wheel.


Steering wheel adjustment
94

As a safety precaution, these operations must only be carried outwhen stationary.


Lumbar
91

Front seats Seat consisting of a seat cushion, a seat back and a head restraint which can all be adjusted to adapt your position for ease of driving and comfort.
Manual adjustments
Forwards-backwards adjustment
)Raise the control and slide the seatforwards or backwards.


Driver's or passenger's seat
height adjustment
) Pull the control upwards to raise or push
it downwards to lower, as many times as
necessary, to obtain the position required.

Seat back angle adjustment
)Turn the control knob to adjust the seat
backrest angle.




As a safety measure, seat adjustmentsshould only be done when stationary.

89Comfort











Front seats Seat consisting of a seat cushion, a seat back and a head restraint which can all be adjusted to
adapt your position for ease of driving and comfort.


Driver's seat electric adjustments


Forwards-backwards adjustment
)Push the control forwards or rearwards toslide the seat.
Seat cushion height and angle adjustment
)
Tilt the rear par t of the control upwards or
downwards to obtain the required height.) Tilt the front part of the control upwards or
downwards to obtain the required an
gle.

Seat back angle adjustment
)
Tilt the control forwards or rearwards to
adjust the angle of the seat back.

The electrical functions of the driver's seat are deactivated approximately one minute after the ignition is switched off.

To reactivate them, switch on the ignition.

Storing driving positions
System which registers the electrical settings of the driver's seat and door mirrors. It enablesyou to store and recall two positions using the buttons on the side of the driver's seat.

Storing a position

Usin
g buttons M/1/2
)
Switch on the ignition. )
Adjust your seat and the door mirrors. )
Press button M
, then press button 1or 2within four seconds.
An audible signal indicates that the position
h
as been stored.
Recalling a stored position

I
gnition on or engine running
)Press button 1
or 2to recall the corresponding position.
An audible signal indicates the end of the
adjustment.
Storing a new position cancels theprevious position.
You can interrupt the current movementby pressing button M, 1
or 2
or by using one of the seat controls.
A stored position cannot be recalled
while driving.
Recalling stored positions is deactivated 45 seconds after switching off the ignition.

Automatic adjustment of xenon headlamps
Do not touch the xenon bulbs. Contact a CITROËN dealer or a
qualified workshop. This s
ystem adjusts the height of the xenon
headlamp beams automatically and when
stationary, according to the load in the vehicle, so
as to avoid causing a nuisance to other road user.
I
f a malfunction occurs, this
warning lamp is displayed in the
instrument panel, accompanied byan audible signal and a message in the screen.
The system then places your headlamps in the lowest position.







Manual adjustment
of halogen
headlamps
To avoid causing a nuisance to other road
users, the height of the halogen headlampsshould be adjusted according to the load in the
vehicle.0.1 or 2 people in the front seats. -.3 people.1. 5 people.-.Intermediate setting. 2.
5 people + maximum authorised load. -.Intermediate setting. 3.
Driver + maximum authorised load.
The initial setting is position "0".

Safety
Seat belts


Front seat belts


The front seat belts are fitted with apretensioning and force limiting system.
This system improves safety in the frontseats in the event of a front or side impact.
Dependin
g on the severity of the impact, thepretensioning system instantly tightens the seat
belts against the body of the occupants.
The pretensioning seat belts are active when
the ignition is on.
The force limiter reduces the pressure of the seat belt on the chest of the occupant, so improving their protection.

Fastening
)Pull the strap, then inser t the tongue in the buckle.)Check that the seat belt is fastenedcorrectly by pulling the strap.



Unfastening
)Press the red button on the buckle.)Guide the seat belt as it reels in.

Seat belt not fastened/unfastened warning lamp in the instrument panel
When the ignition is switched on,
this warning lamp comes on in the
instrument
panel if the driver and/or
the front passenger has not fastened their seat belt.
From approximately 12 mph (20 km/h)this warning lamp flashes for two minutes
accompanied by an audible signal of increasingvolume. Once these two minutes have elapsed,
this warning lamp remains on until the driver
and/or the front passenger fastens their seat belt.
Height adjustment
) To lower the attachment point, squeeze thecontrol Aand slide it downwards. )
To raise the attachment point, slide the control Aupwards.

The driver must ensure that passengers usethe seat belts correctly and that they are allrestrained securely before setting off.
Wherever you are seated in the vehicle, always fasten your seat belt, even for short journeys. Do not interchange the seat belt buckles as they will not fulfil their role fully.
The seat belts are fitted with an inertia reel permitting automatic adjustment of the lengthof the strap to your size. The seat belt isstowed automatically when not in use.
Before and after use, ensure that the seatbelt is reeled in correctly.
The lower part of the strap must be positioned as low as possible on the pelvis.
The upper par t must be positioned in the hollow of the shoulder.
The inertia reels are fitted with an automatic locking device which comes into operation inthe event of a collision, emergency braking or if the vehicle rolls over. You can release the device by pulling firmly on the strap and releasing it so that it reels in slightly.

In order to be effective, a seat belt must:


- be tightened as close to the body as possible,


- be pulled in front of you with a smooth movement, checking that it does nottwist,

- be used to restrain only one person,

- not bear any trace of cuts or fraying,

- not be converted or modified to avoidaffecting its per formance.
In accordance with current safety regulations, for all repairs on your vehicle, go to aqualified workshop with the skills and equipment needed, which a CITROËN dealer is able to provide. Have your seat belts checked regularly by a CITROËN dealer or a qualified workshop, particularly if the straps show signs of damage.
Clean the seat belt straps with soapy water or a textile cleaning product, sold by CITROËN dealers.
After folding or moving a seat or rear benchseat, ensure that the seat belt is positioned and reeled in correctly.


Recommendations for children

Use a suitable child seat if the passenger is less than 12 years old or shor ter than one and a half metres.
Never use the same seat belt to secure more than one person.
Never allow a child to travel on your lap.


In the event of an impact
Depending on the nature andseriousness of the impact , the pretensioning device may be deployed before and independently of the airbags.Deployment of the pretensioners is accompanied by a slight discharge of harmless smoke and a noise, due to theactivation of the pyrotechnic cartridge incorporated in the system.
In all cases, the airbag warning lampcomes on.
Following an impact, have the seat beltssystem checked, and if necessary replaced, by a CITROËN dealer or a qualified workshop.