2012 Citroen C5 RHD seats

CONTENTS
Monochrome screen C 43
16/9 colour screen (MyWay) 45
16/9 high defi nition colour screen
(NaviDrive 3D) 47„
„
„
II - MULTIFUNCTION
SCREENS 43 Î 48
Ventilation 49
Mono-zone digital
air conditioning 51
Dual-zone digital
air conditioning 54
Programmable heating 58
Front seats 62
Rear seats 66
Mirrors 67
Steering wheel adjustment 68„
„
„
„
„
„
„
„
III - COMFORT 49 Î 68
Remote control key 69
Alarm 75
Electric windows 77
Doors 79
Boot 81
Sunroof (Saloon) 84
Panoramic sunroof (Tourer) 85
Fuel tank 86
Misfuel prevention (Diesel) 87„
„
„
„
„
„
„
„
„
IV - ACCESS 69 Î 87
Lighting controls 88Automatic illumination of headlamps 90
Headlamp adjustment 91
Directional lighting 92
Wiper controls 94
Automatic rain sensitive
windscreen wipers 95
Courtesy lamps 96
Interior mood lighting 98„
„
„
„
„
„
„
„
V - VISIBILITY 88 Î 99
Interior fi ttings 100
Mats 101
Front armrest 101
Boot fi ttings 103„
„
„
„
VI - FITTINGS 100 Î 106
Instrument panels 26
Trip computer 29
Warning and indicator lamps 32
Adjustment buttons 42„
„
„
„
FAMILIARISATION 4 Î 23
I - MONITORING
26 Î 42
Child seats 107
ISOFIX child seats 111
Child lock 115„
„
„
VII - CHILD SAFETY 107 Î 11 5












































ECO-DRIVING 24 Î 25

11
FAMILIARISATION
SITTING COMFORTABLY



1.
Seat cushion height, angle and slide
adjustments.

2.
Adjustment of the backrest angle.

3.
Adjustment of top of backrest.

4.
Adjustment of lumbar support height
and level.

5.
Massage function.

6.
Heated seat control.


A.
Adjustment of the backrest angle.

B.
Adjustment of the seat height.

C.
Heated seat control.

D.
Longitudinal adjustment of seat.

E.
Adjustment of the backrest lumbar
support.


Storing settings

This function allows you to programme
and store the driver’s seat and the air
conditioning settings. The correct position
for the upper seat
belt anchorage places the belt across
the middle of the shoulder.


)
To adjust the seat belt for height,
compress the control and slide
it in
the desired direction.


Seat belt height adjustment

Front seats


Electrical adjustments

Manual adjustments



62



63




122




65

16
FAMILIARISATION
MONITORING


Tyre under-inflation detection

The tyre under-infl ation detection sys-
tem is a driving aid which informs you
of the state of your tyres.
It does not replace either vigilance or
responsibility on the part of the driver.

Economy mode

After switching off the engine, some sys-tems (radio, wipers, electric windows,
opening roof, electric seats, telephone,
video, interior lighting, motorised tail-
gate, etc.) are supplied electrically for a
maximum of no more than around one
hour, so as to avoid discharging the
battery.
This period may be reduced considerably
if the battery’s state of charge is low.
Once this period is over, a message is
displayed in the instrument panel screen
and the active functions are placed on
standby.
These functions will be automatically
reactivated when the vehicle is restarted.


117




200

25

Limit the causes of excess
consumption

Spread loads throughout the vehicle;
place the heaviest items in the bottom
of the boot, as close as possible to the
rear seats.
Limit the loads carried in the vehicle
and reduce wind resistance (roof bars,
roof rack, bicycle carrier, trailer...). Use
a roof box in preference.
Remove roof bars and roof racks after
use.

At the end of winter, remove snow
tyres and refi t your summer tyres.



Observe the recommendations
on maintenance

Check the tyre pressures regularly,
when cold, referring to the label in the
door aperture, driver's side.
Carry out this check in particular:


- before a long journey,

- at each change of season,

- after a long period out of use.
Don't forget the spare wheel and the
tyres on any trailer or caravan.

Have your vehicle serviced regularly
(engine oil, oil fi lter, air fi lter...) and
observe the schedule of operations
recommended by the manufacturer.


When refuelling, do not continue after
the 3 rd cut-off of the nozzle to avoid
any overfl ow.

At the wheel of your new vehicle,
it is only after the fi rst 1 800 miles
(3 000 kilometres) that you will see
the fuel consumption settle down to a
consistent average.

III
49
COMFORT











VENTILATION



A.
Sunshine sensor.

B.
Soft air diffusion grille.
The soft air diffusion grille located
in the centre of the dashboard
provides optimum distribution of
the air for the front seats.
This system eliminates unpleas-
ant air currents while maintaining
an optimum temperature in the
passenger compartment.
To open the soft air diffusion
grille, turn the wheel upwards.
To close the soft air diffusion grille,
turn the wheel fully downwards.
In very hot weather, to obtain
more satisfactory central and
side ventilation, it is advisable to
close the diffused air grille.

C.
Cooled glove box.

D.
Rear passenger vents.

III
50
COMFORT

Air conditioning

We recommend use of the automatic
regulation of the air conditioning.
It permits automatic and optimised
control of all of the following functions:
air fl ow, temperature in the passenger
compartment and air distribution, by
means of various sensors (ambient
temperature, sunshine). This elimi-
nates any need for you to change
your settings other than the tempera-
ture value displayed.


)
Take care not to cover the sun-
shine sensor A
.
If you select the automatic mode
(by pressing the "AUTO" control)
and leave all of the vents open, opti-
mum comfort will be maintained and
humidity and condensation will be
removed regardless of the exterior
climatic conditions.
The temperature in the passenger
compartment can only be lower than
the ambient temperature if the air
conditioning is on.














HEATING, VENTILATION
AND AIR CONDITIONING
RECOMMENDATIONS In order to be effective, the air
conditioning must be used with the
windows closed. If the vehicle has
been parked in the sun for a long
period and the interior tempera-
ture is very high, fi rst ventilate the
passenger compartment with the
windows open for a few minutes,
then close the windows.
To keep the air conditioning system
in good working order it is essential
that it is operated at least once a
month.
The air conditioning uses engine
power during its operation. As a
result, the fuel consumption of the
vehicle increases.
In certain cases of particularly ardu-
ous use (e.g. towing the maximum
load on a steep gradient in high
temperatures), switching off the air
conditioning saves engine power
and improves the towing capacity.


Air inlet

Check that the exterior grille for the
air inlet, at the bottom of the wind-
screen, is clean and free of dead
leaves, snow, etc.
When washing the vehicle using a
high pressure nozzle, avoid spraying
at the air inlet.


Air circulation

Maximum comfort is obtained by
means of a good distribution of air in
the passenger compartment, both in
the front and in the rear.
To obtain a uniform distribution of
air, take care not to block the ex-
terior air intake grille located at the
base of the windscreen, the vents,
the air outlets under the front seats
and the air extractor located behind
the fl aps in the boot.
The front and rear vents are fi tted
with thumbwheels to adjust the air
fl ow and direction. We recommend
that you leave all of the vents open.


Dust filter/Odour filter
(active carbon)
There is a fi lter for excluding odours
and dust.
This fi lter must be changed in line
with the vehicle’s servicing schedule
(see the vehicle’s servicing booklet).

III
62
COMFORT

















FRONT SEATS MANUAL ADJUSTMENTS



1.
Adjustments to the height and
angle of the head restraint

To raise it, pull upwards.
To lower it, press on the control A

to unlock it, and simultaneously
on the head restraint itself. The
adjustment is correct when the
top edge of the head restraint is
at the same height as the top of
the head. It is also tilt adjustable.
To raise it, press control A
to
unlock it, then pull it upwards.
It may be necessary to adjust the
backrest angle.

2.

Adjustment of the backrest angle

Operate the control and adjust
the position of the backrest to
the front or to the rear.

3.
Adjustment of the seat height

Raise or lower the control the
number of times required to
obtain the desired position.

4.
Longitudinal adjustment of seat

Lift the control bar and adjust to
the desired position.

5.
Adjustment of lumbar support



Turn the control and adjust to the
desired position.

6.
Heated seat controls

The heated seats only operate
when the engine is running. Seat consisting of a seat cushion, seat back and head restraint which can all be
adjusted for optimum driving comfort.

For your safety, do not drive with
the head restraints removed; they
must be in place and correctly
adjusted.

III
63
COMFORT








FRONT SEATS
ELECTRIC ADJUSTMENTS

To adjust the electric seats, switch on the ignition or start the engine if the
vehicle has gone into economy mode.
Seat adjustments are also possible for a short period after opening one of the
front doors or switching off the ignition.

2.


Adjustment of the backrest angle


Move the control forwards or
backwards to adjust the backrest
angle.

3.
Adjustment of the angle of the
top of the backrest


Move the control forwards or
backwards to adjust the angle of
the top of the backrest.

1.
Adjustment of the seat height
and angle, and longitudinal
adjustment



)
Raise or lower the front of the
control to adjust the seat cushion
angle.

)
Raise or lower the rear of the
control to raise or lower the seat.

)
Simultaneously raise or lower
the front and rear of the control
in order to raise or lower the
entire seat.
4.
Adjustment of lumbar support


This function allows you to inde-
pendently adjust the height and
level of lumbar support.
Move the control:


)

Forwards or backwards to increase
or reduce the lumbar support.

)
Upwards or downwards to raise or
lower the lumbar support zone.







Head restraint height and
angle adjustments on electric
seats


)
To adjust the angle of the head
restraint, push back or pull for-
ward section C
of the head re-
straint until you reach the desired
position.

)
To raise it, pull upwards.

)
To lower it, press on the control D

to unlock it, and simultaneously
on the head restraint itself.

)
To remove it, press on the
control D
to unlock it, then pull it
upwards.