2012 Citroen C5 RHD seats
[x] Cancel search: seatsPage 66 of 340
III
64
COMFORT
This function provides the driver with
a back massage. It only operates
when the engine is running.
)
Press on button A
.
The warning lamp comes on and the
massage function is activated for a
period of 1 hour. During this time,
massage is performed in cycles of
6 minutes (4 minutes of massage fol-
lowed by 2 minutes break). In total,
the system will perform 10 cycles.
After 1 hour, the function is deacti-
vated. The warning lamp goes out.
Massage function
Welcome function
The welcome function assists entry
and leaving the vehicle.
After switching off the ignition and
opening the driver’s door, the seat
moves back automatically and then
stays in this position, ready for the
next entry to the vehicle.
When switching on the ignition, the
seat moves forward to the memo-
rised driving position.
When moving the seat, take care
that no person or object hinders the
automatic movement of the seat.
This function is deactivated by de-
fault. You may activate or deactivate
this function using the "Main Menu"
on the instrument panel screen. To
do so, select "Vehicle parameters/
Comfort/Driver welcome".
Deactivation
You can deactivate the massage
function at any time by pressing on
button A
.
Heated seats control
With the engine running, the front
seats can operate separately.
)
Use the corresponding adjust-
ment dial, placed on the outer
side of each front seat, to switch
on and select the level of heating
required:
0
: Off.
1
: Low.
2
: Medium.
3
: High.
Page 68 of 340
III
66
COMFORT
REAR SEATS
Bench seat, the left-hand (2/3) or
right-hand (1/3) section of which
can be folded to adapt the boot load
space.
Removing the seat cushion
)
Move the corresponding front
seat forwards if necessary.
)
Raise the front of the seat cushion 1
.
)
Tilt the seat cushion 1
fully
against the front seat.
)
Remove the seat cushion 1
from
its fi xings by pulling upwards.
Refitting the seat cushion
)
Position the seat cushion 1
verti-
cally in its fi xings.
)
Fold down the seat cushion 1
.
)
Press on the seat cushion to
secure it.
Folding the seat
In order to fold a rear seat without
any risk of damage, always start
with the seat cushion, never with
the seat back:
)
move the corresponding front
seat forwards if necessary,
)
raise the front of the seat cushion 1
,
)
tilt the seat cushion 1
fully against
the front seat,
)
check that the seat belt is posi-
tioned correctly on the side of
the seat back,
)
lower or remove the head re-
straints if necessary,
)
pull the control 3
forwards to re-
lease the seat back 2
,
)
tilt the seat back 2
.
The seat cushion 1
can be removed
to increase the loading volume.
Returning the seat back to its
original position
When returning the rear seat to its
original position:
)
put the seat back 2
in the upright
position and secure it,
)
fold the seat cushion 1
,
)
refi t the head restraints or put
them back in place.
When returning the rear seat to its
original position, take care not to trap
the seat belts and ensure that their
buckles are positioned correctly.
The red indicator on the control 3
should no longer be visible; if it is,
push the seat fully back.
Page 83 of 340
IV
81
ACCESS
BOOT (SALOON)
)
Press upwards on lever 1
and lift
up the boot lid.
With the vehicle stationary, this is
carried out using:
- The remote control.
- The key in a door lock.
- The interior central locking/un-
locking control.
The boot automatically locks when
the vehicle is moving at a speed of
over 6 mph (10 km/h), even if auto-
matic central locking is deactivated.
It is unlocked when a door is opened
or when the central locking button is
pressed (speed lower than 6 mph
(10 km/h)).
Opening
Locking/unlocking
Emergency boot release
System for mechanical unlocking of
the boot in the event of a battery or
central locking malfunction.
Unlocking
)
Fold back the rear seats to gain
access to the lock from inside
the boot.
)
Insert a small screwdriver into
hole A
of the lock to unlock the
tailgate.
)
Push the white part, located in-
side the lock, to the left to unlock
the boot.
Page 93 of 340
V
91
VISIBILITY
Linked with the automatic
"Guide-me-home" lighting
The link with the automatic illumi-
nation of headlamps provides the
"guide-me-home" lighting with the
following additional options:
- selection of the duration of ligh-
ting for 15, 30 or 60 seconds in
the vehicle parameters on the in-
strument panel screen confi gu-
ration menu,
- automatic activation of "guide-
me-home" lighting when auto-
matic illumination of headlamps
is in operation.
Operating fault
In the event of a fault with the sun-
shine sensor, the lighting comes on
and a message appears in the instru-
ment panel screen, accompanied by
an audible signal.
Contact a CITROËN dealer or a
qualifi ed workshop.
In fog or snow, the sunshine sen-
sor may detect suffi cient light.
Therefore, the lighting will not
come on automatically.
Do not cover the sunshine sen-
sor, linked with the rain sensor and
located in the centre of the wind-
screen behind the rear view mirror;
the associated functions would no
longer operate.
MANUAL HEADLAMP
ADJUSTMENT
To avoid dazzling other road users,
the height of the halogen bulb head-
lamps must be adjusted according
to the load in the vehicle.
0.
1 or 2 people in the front seats.
-. 3 people.
1.
5 people.
-. Intermediate setting.
2.
5 people + maximum authorised
loads.
-. Intermediate setting.
3.
Driver + maximum authorised
loads.
Initial setting is position "0"
.
AUTOMATIC ADJUSTMENT
OF DIRECTIONAL
HEADLAMPS
Do not touch the xenon bulbs.
Contact a CITROËN dealer or a
qualifi ed workshop. If a fault occurs, this
warning lamp comes
on in the instrument
panel, accompanied by an audible signal and a
message in the instru-
ment panel screen.
The system then places your head-
lamps in the lowest position. To avoid causing a nuisance to other
road users, this system corrects
the height of the xenon headlamp
beams automatically and when sta-
tionary, depending on the load in the
vehicle.
Page 107 of 340
VI
105
FITTINGS
LUGGAGE COVER (TOURER)
To roll up
)
Press the handle (PRESS) gently.
The luggage cover rolls up auto-
matically.
The moving part A
can be folded
along the rear bench seat backrest.
To remove
)
Compress the control 1
and lift
the luggage cover on the right
then on the left to remove it.
To install
)
Position the left-hand end of the
luggage cover roller in its loca-
tion B
behind the rear bench
seat.
)
Compress the roller control 1
and put the roller in place in its
location C
on the right.
)
Release the control to secure
the luggage cover.
)
Unroll it to its fastening on the
rear pillar.
High load retaining net
(Tourer)
Hooked onto the special upper and
lower fi xings, this permits use of the
entire loading volume up to the roof:
- behind the rear seats (row 2),
- behind the front seats (row 1)
when the rear seats are folded.
When positioning the net, check that
the strap loops are visible from the
boot; this will make slackening or
tightening easier.
Page 108 of 340
VI
106
FITTINGS
Installation
)
fold down the backs of the rear
seats,
)
position the high load retaining
net roller above the two rails 1
located behind the rear seats
(2/3 bench seat). The two notch-
es 2
must be placed above the
two rails,
)
slide the two rails 1
into the
notches 2
and push the roller
(lengthways) from right to left to
secure it,
)
reposition the rear seat backs.
Row 1
Row 2
To use it in row 1:
)
fold down the
backs of the
rear seats,
)
open the cov-
ers 3
of the
corresponding
upper fi xings,
)
unroll the high load retaining net
and position one of the ends of
the net's metal bar in the cor-
responding fi xing cover. Check
that the hook is secured in the
rail located inside the cover 3
,
)
pull the high load retaining net's
metal bar to position the other
hook in the second fi xing cover.
To use it in row 2:
)
open the cov-
ers 4
of the
corresponding
upper fi xings,
)
from the rear bench seat, unroll
the high load retaining net, push-
ing it to detach it from the retaining
hooks,
)
position one of the ends of the
net's metal bar in the corre-
sponding fi xing cover. Check
that the hook is secured in the
rail located inside the cover,
)
position the other hook in the
second fi xing cover and pull the
metal bar towards you.
Page 109 of 340
VII
107
CHILD SAFETY
*
The rules for carrying children are
specifi c to each country. Refer to the
current legislation in your country.
GENERAL POINTS RELATING
TO CHILD SEATS
Although one of CITROËN’s main
criteria when designing your vehi-
cle, the safety of your children also
depends on you.
For maximum safety, please observe
the following recommendations:
- in accordance with European
regulations, all children under
the age of 12 or less than one
and a half metres tall must
travel in approved child seats
suited to their weight
, on seats
fi tted with a seat belt or ISOFIX
mountings * ,
- statistically, the safest seats in
your vehicle for carrying chil-
dren are the rear seats,
- a child weighing less than 9 kg
must travel in the "rearwards-
facing" position both in the
front and in the rear.
CITROËN recommends
that
children should travel in the rear
seats
of your vehicle:
- "rearwards-facing"
up to the
age of 2,
- "forwards-facing"
over the
age of 2.
CHILD SEAT IN THE FRONT
"Rearwards-facing"
When a "rearwards-facing" child
seat is installed on the front pas-
senger seat
, it is essential that the
passenger airbag is deactivated.
Otherwise, the child would risk
being seriously injured or killed if
the airbag were to infl ate
.
"Forwards-facing"
When a "forwards-facing" child seat
is installed on the front passenger
seat
, adjust the vehicle’s seat to the
intermediate longitudinal position
with the seat back upright and leave
the passenger airbag activated.
Intermediate longitudinal
position
Page 111 of 340
VII
109
CHILD SAFETY
CHILD SEATS RECOMMENDED BY CITROËN
CITROËN offers a complete range of recommended child seats which are secured using a three point seat belt
:
Group 0+: from birth to 13 kg
L1
"RÖMER Baby-Safe Plus"
Installed in the rearwards-facing position.
Groups 2 and 3: from 15 to 36 kg
L3
"RECARO Start''
L4
"KLIPPAN Optima"
From the age of 6 years
(approximately 22 kg),
the booster is used on its own.
L5
"RÖMER KIDFIX"
Can be fi tted to the vehicle's ISOFIX mountings.
The child is restrained by the seat belt.