Page 194 of 340
XI
192
PRACTICAL INFORMATION
Interior lamps
Roof lamps
)
Unclip the transparent cover of
the roof lamp to reach the bulb.
Bulb:
W 5W
Rear reading lamps (Tourer)
)
Detach the cover of the reading
lamp to access the bulb.
Bulb:
W 5W
Map reading lamp
)
Detach the cover.
)
If necessary, detach the partition
of the affected map reading lamp.
Boot lamp
)
Detach the cover and use a W 5W
bulb.
Pavement lighting
)
Detach the cover and use a W 5W
bulb.
Floor lighting
)
Detach the cover and use a W 5W
bulb.
Glovebox
)
Detach the cover and use a W 5W
bulb.
Page 196 of 340
XI
194
PRACTICAL INFORMATION
FUSEBOX A
Table of fuses
Fuse N°
Rating
Function
G29
-
Not used
G30
5 A
Heated door mirrors
G31
5 A
Rain and sunshine sensor
G32
5 A
Seat belt not fastened warning lamps
G33
5 A
Electrochromatic rear view mirror
G34
20 A
Sunroof (saloon)
G35
5 A
Passenger door lighting - passenger door mirror adjustment
G36
30 A
Electric tailgate (tourer)
G37
20 A
Heated front seats
G38
30 A
Driver’s electric seat
G39
30 A
Passenger’s electric seat - HIFI amplifi er
G40
3 A
Trailer relay unit supply
FUSEBOX B
Fuse N°
Rating
Function
G36
15 A
6 speed automatic gearbox
5 A
4 speed automatic gearbox
G37
10 A
Daytime running lamps - Diagnostic socket
G38
3 A
ESP
G39
10 A
Hydraulic suspension
G40
3 A
STOP switch
Page 197 of 340
XI
195
PRACTICAL INFORMATION
FUSEBOX C
Fuse N°
Rating
Function
F1
15 A
Rear screen wipe (Tourer)
F2
30 A
Locking and deadlocking relay
F3
5 A
Airbags
F4
10 A
Automatic gearbox - additional heater unit (Diesel) -
electrochrome rear view mirror
F5
30 A
Front window - sunroof - passenger door lighting -
passenger door mirror adjustment
F6
30 A
Rear window
F7
5 A
Vanity mirror lighting - Glove box lighting - interior lamps -
torch (tourer)
F8
20 A
Radio - CD changer - Steering mounted controls - Screen - Under-infl ation detection -
Electric boot ECU
F9
30 A
Cigar lighter - front 12 V socket
F10
15 A
Alarm - Steering mounted controls, signalling and wiper controls
F11
15 A
Low current ignition switch
F12
15 A
Driver’s electric seat - instrument panel - seat belt not fastened warning lamps -
air conditioning controls
F13
5 A
Engine relay unit - Hydraulic suspension pump cut-off relay -
airbag ECU supply
F14
15 A
Rain and sunshine sensor - parking sensors - passenger’s electric seat -
trailer relay unit - HIFI amplifi er ECU - Bluetooth system -
Lane Departure Warning System
F15
30 A
Locking and deadlocking relay
F17
40 A
Heated rear screen - heated door mirrors
FSH
SHUNT
PARK SHUNT
Page 201 of 340
XI
!
199
PRACTICAL INFORMATION
Starting using another
battery
)
Lift the pins to remove the front
left headlamp cover (V6 HDi en-
gine).
)
Connect the red cable to the
positive terminal (+) of the fl at
battery A
, then to the positive ter-
minal (+) of the slave battery B
.
)
Connect one end of the green or
black cable to the negative ter-
minal (-) of the slave battery B
.
V6 HDi engine: the positive ter-
minal (-) is located under the red
cover.
)
Connect the other end of the
green or black cable to the earth
point C
on the broken down ve-
hicle.
)
Operate the starter, let the en-
gine run.
)
Wait until the engine returns to
idle and disconnect the cables.
Charging the battery using a
battery charger
The batteries contain harmful
substances such as sulphuric
acid and lead. They must be
disposed of in accordance
with regulations and must not, in
any circumstances, be discarded
with household waste.
Take used remote control batteries
and vehicle batteries to an autho-
rised collection point.
It is advisable to disconnect the
battery if the vehicle is to be left un-
used for more than one month. Do not disconnect the terminals
while the engine is running.
Do not charge the batteries without
disconnecting the terminals fi rst.
Do not touch the clips during the
operation.
Do not lean over the batteries.
Disconnect the cables in the re-
verse order to connection, ensur-
ing that they do not touch.
Before disconnecting the
battery
Wait 2 minutes after switching off
the ignition before disconnecting
the battery.
Close the windows and the doors
before disconnecting the battery.
Following reconnection of the
battery
Following reconnection of the bat-
tery, switch on the ignition and wait
1 minute before starting to permit
initialisation of the electronic sys-
tems. However, if slight malfunctions
remain following this operation, con-
tact a CITROËN dealer or a qualifi ed
workshop.
Referring to the corresponding sec-
tion, you must yourself reinitialise:
- the remote control key,
- the glass panoramic roof blind,
- the GPS satellite navigation
system.
)
Disconnect the battery from the
vehicle.
)
Follow the instructions for use
provided by the manufacturer of
the charger.
)
Reconnect starting with the neg-
ative terminal (-).
)
Check that the terminals and
connectors are clean. If they are
covered with sulphate (whitish or
greenish deposit), remove them
and clean them.
The Stop & Start battery does not
have to be disconnected for charging.
Page 205 of 340
XI
!
203
PRACTICAL INFORMATION
ROOF BARS
The design of your vehicle requires
the use of roof bars that are tested
and approved by CITROËN, for your
safety and to avoid damage to the
roof and tailgate.
Regardless of the type of loading
equipment to be transported on the
roof (bicycle carrier, ski carrier…), it
is imperative that you add transverse
roof bars. Any securing or lashing to
components other than the roof bars
is strictly prohibited.
Recommendations
)
Distribute your load evenly, avoid-
ing overloading on one side.
)
Arrange the heaviest part of the
load as close as possible to the
roof.
)
Anchor the load securely and
draw attention to it if any part of
it is overhanging.
)
Drive gently, as the vehicle will
be more liable to the effects of
side winds (vehicle stability may
be altered).
)
Remove the roof bars as soon
as they are no longer needed.
Maximum load that can be
distributed on the roof bars
(for a loading height not
exceeding 40 cm; except bicycle
carrier): 80 kg.
If the height exceeds 40 cm, adapt
your speed to the profi le of the road
to avoid damaging the roof bars
and the fi xings on the roof.
Please refer to national legislation
in order to comply with the regula-
tions concerning the transportation
of objects which are longer than
the vehicle.
Blanking cover
When towing, you must remove the
blanking cover in the front bumper
as well as the bonnet seal if fi tted .
Contact a CITROËN dealer or a
qualifi ed workshop for this.
Page 209 of 340
XI
207
PRACTICAL INFORMATION
* To avoid any risk of jamming of
the pedals:
- ensure that the mat is posi-
tioned and secured correctly,
- never fi t one mat on top of
another.
ACCESSORIES
A wide range of accessories and
genuine parts is available from the
CITROËN dealer network.
These accessories and parts have
been tested and approved for reli-
ability and safety.
They are all adapted to your vehicle
and benefi t from CITROËN's recom-
mendation and warranty.
"Comfort":
front and rear parking sensors, iso-
therm module, reading lamp, sun
blinds…
"Transport solutions":
boot liner, boot carpet, towbars, tow-
bar wiring harness, transverse roof
bars, bicycle carrier, ski carrier, roof
boxes, boot dividers, boot net…
"Style":
alloy wheels, rear spoiler, chromed
mirror shells…
"Security and safety":
anti-intrusion alarm, warning triangle
and high visibility vest, breathalyzer,
fi rst aid kit, snow chains, non-skid
covers, security wheel bolts, vehicle
tracking system, child seats, fi re ex-
tinguisher, caravan mirror…
"Protection":
mats * , seat covers, mud fl aps, bum-
per protectors, vehicle covers, door
sill protectors…
Page 221 of 340
XII
219
TECHNICAL DATA
* Without roof bars.
DIMENSIONS (IN MM)
Exterior (Saloon)
A
2 815
B
1 054
C
910
D
4 779
E
1 586
F
2 096
G
1 557
H
1 860
I
*
1 451
Page 223 of 340
XII
221
TECHNICAL DATA
Exterior (Tourer)
A
2 815
B
1 054
C
959
D
4 829
E
1 586
F
2 096
G
1 557
H
1 860
I
*
1 479
*
Without roof bars.
