2012 Citroen C5 warning

I
38
MONITORING










Deactivation indicator lamps
If one of the following indicator lamps comes on, this confi rms that the corresponding system has been switched off intentionally.
This is may be accompanied by an audible signal and a message on the multifunction screen.



Warning lamp



is on



Cause



Action / Observations






Passenger's
airbag
system


fi xed. The control, located in the
glove box, is set to the OFF

position.
The passenger's front airbag
is deactivated.
In this case you can install a
"rear facing" child seat. Set the control to the ON
position to
activate the passenger's front airbag.
In this case, do not fi t a child seat in the
rear-facing position.




ESP/ASR


fi xed. The button, located in the
middle of the dashboard, is
pressed. Its indicator lamp
is on.
The ESP/ASR is deactivated.
ESP: electronic stability
programme.
ASR: anti-skid regulation. Press the button to activate the ESP/ASR.
Its indicator lamp switches off.
The ESP/ASR system is activated
automatically when the vehicle is started.
If deactivated, the system is reactivated
automatically from approximately 30 mph
(50 km/h).

I
41
MONITORING















Engine oil temperature gauge

Under normal operating conditions,
the bars should be within section 1
.
In severe operating conditions, the
bars may extend into section 2
.
In this event, slow down, and if neces-
sary, stop the engine and check the
levels (see corresponding section).


Coolant temperature gauge

Under normal operating conditions,
the bars should be within section 1
.
In severe operating conditions, the
bars may extend into section 2
, the
engine coolant temperature warning
lamp A
and the STOP
warning lamp
come on, stop as soon as it is safe
to do so
. Switch off the ignition. The
cooling fan may continue to oper-
ate for a certain time
.
Contact a CITROËN dealer or a
qualifi ed workshop.
If the SERVICE
warning lamp comes
on, check the levels (see corre-
sponding chapter). On horizontal ground, illumination of
the fuel low warning lamp indicates
that you are at the reserve level.
An alert message is displayed in the
instrument panel.







Fuel gauge

III
62
COMFORT
This function provides the driver
with a back massage. It only oper-
ates when the engine is running.


)
Press on button A
.
The warning lamp comes on and the
massage function is activated for a
period of 1 hour. During this time,
massage is performed in cycles of
6 minutes (4 minutes of massage fol-
lowed by 2 minutes break). In total,
the system will perform 10 cycles.
After 1 hour, the function is deacti-
vated. The warning lamp goes out.






Massage function





Welcome function

The welcome function assists entry
and leaving the vehicle.
After switching off the ignition and
opening the driver’s door, the seat
moves back automatically and then
stays in this position, ready for the
next entry to the vehicle.
When switching on the ignition, the
seat moves forward to the memo-
rised driving position.
When moving the seat, take care
that no person or object hinders the
automatic movement of the seat.
This function is deactivated by de-
fault. You may activate or deactivate
this function using the "Main Menu"
on the instrument panel screen. To
do so, select "Vehicle parameters/
Comfort/Driver welcome".

Deactivation
You can deactivate the massage
function at any time by pressing on
button A
.











Heated seats control


With the engine running, the front
seats can operate separately.


)
Use the corresponding adjust-
ment dial, placed on the outer
side of each front seat, to switch
on and select the level of heating
required:

0
: Off.

1
: Low.

2
: Medium.

3
: High.

III
66
COMFORT
As a safety precaution, these ope-
rations must only be carried out
while the vehicle is stationary.
STEERING WHEEL ADJUSTMENT

The steering wheel can be adjusted
for height and reach to adapt the
driving position to the size of the
driver.

Adjustment



)
First, adjust the driver's seat to
the most suitable position.

)
When stationary
, pull the lever A

to unlock the steering wheel ad-
justment.

)
Adjust for height and reach.

)
Push the lever to lock the steering
wheel adjustment.
After locking, if you press fi rmly on
the steering wheel, a slight click may
be heard.






Automatic day/night model

In order to guarantee optimum visi-
bility during your manoeuvres, the
mirror lightens automatically when
reverse gear is engaged. By means of a sensor, which mea-
sures the light from the rear of the
vehicle, this system automatically
and progressively changes between
the day and night uses.
It has an anti-dazzle system which
darkens the mirror glass: this reduc-
es any driver discomfort caused by
the light beam of following vehicles,
the sun... In vehicles fi tted with electrochro-
matic door mirrors, the system has
an on/off button and an associated
warning lamp.

On


)
With the ignition on, press on
button 1
.
The warning lamp 2
comes on and the
mirror glass is in automatic mode.

Off


)
Press on button 1
.
The warning lamp 2
goes off and the
mirror glass remains in its lightest
defi nition.

IV
71
ACCESS















Operating problem

Following disconnection of the ve-
hicle battery, replacement of the re-
mote control battery or in the event
of a remote control fault, you can no
longer unlock, lock or locate your
vehicle.


)
First of all, use the key in the lock
to unlock or lock your vehicle.

)
Then, reinitialise the remote con-
trol.
If the problem persists, contact a
CITROËN dealer or a qualifi ed work-
shop as soon as possible.

Reinitialisation


)
Switch off the ignition.

)
Turn the key to position 2 (Drive)
.

)
Press the closed padlock imme-
diately for a few seconds, until
the operation requested is trig-
gered.

)
Switch off the ignition and re-
move the key from the ignition
switch.
The remote control is fully opera-
tional again. Battery ref.: CR0523 / 3 volts.
This replacement battery is avail-
able from CITROËN dealers or a
qualifi ed workshop.
If the battery is fl at,
you are informed by
illumination of this
warning lamp, an au-
dible signal and a message in the
multifunction screen.


)
Unclip the casing using a coin at
the notch.

)
Slide the fl at battery out of its lo-
cation.

)
Slide the new battery into its
location observing the original
direction.

)
Clip the casing.

)
Reinitialise the remote control.


Changing the battery

IV
!
84
ACCESS
FUEL TANK

Capacity of the tank: approxi-
mately
71 litres

*
.



Low fuel level

When the minimum level
in the tank is reached, this
warning lamp comes on
in the instrument panel,
accompanied by an audible warning
and a message on the multifunction
screen. When it fi rst comes on, there
remains around 5 litres of fuel in the
tank.
You must refuel to avoid running out
of fuel.


)
Press at the top left corner, then
pull open from the left.


)
turn the key a quarter turn to lock
and unlock the fi ller cap,

)
when refuelling, place the cap on
hook A
,

)
fi ll the tank, but do not persist
after the third cut-off
; this could
cause your vehicle to malfunc-
tion.


While you are refuelling, the engine must be stopped and the ignition
switched off.


For a petrol engine with a cata-
lytic converter, unleaded fuel is
compulsory.



Opening the fuel flap

Additions of fuel must be of at least
5 litres to be taken into account by
the fuel gauge.
The fi ller neck is narrower to ensure
that only unleaded petrol nozzles
can be put in.
Opening the fi ller cap may create
a noise of an inrush of air. This
vacuum, which is entirely normal,
is caused by the sealing of the fuel
system.


Refuelling








With Stop & Start, never re-
fuel with the system in STOP
mode; you must switch off
the ignition with the key.

*
55 litres for Slovakia.

V
89
VISIBILITY

Linked with the automatic
"Guide-me-home" lighting
The link with the automatic illumi-
nation of headlamps provides the
"guide-me-home" lighting with the
following additional options:


- selection of the duration of lighting
for 15, 30 or 60 seconds in the ve-
hicle parameters on the instrument
panel screen confi guration menu,

- automatic activation of "guide-
me-home" lighting when auto-
matic illumination of headlamps
is in operation.


Operating fault
In the event of a fault with the sun-
shine sensor, the lighting comes
on and a message appears in the
instrument panel screen, accompa-
nied by an audible signal.
Contact a CITROËN dealer or a quali-
fi ed workshop.
In fog or snow, the sunshine sen-
sor may detect suffi cient light.
Therefore, the lighting will not
come on automatically.
Do not cover the sunshine sen-
sor, linked with the rain sensor and
located in the centre of the wind-
screen behind the rear view mirror;
the associated functions would no
longer operate.
MANUAL HEADLAMP ADJUSTMENT

To avoid dazzling other road users,
the height of the halogen bulb head-
lamps must be adjusted according
to the load in the vehicle.

0.
1 or 2 people in the front seats.

-. 3 people.

1.
5 people.

-. Intermediate setting.

2.
5 people + maximum authorised
loads.

-. Intermediate setting.

3.
Driver + maximum authorised
loads.
Initial setting is position "0".
AUTOMATIC ADJUSTMENT OFDIRECTIONAL HEADLAMPS

Do not touch the xenon bulbs.
Contact a CITROËN dealer or a
qualifi ed workshop. If a fault occurs, this
warning lamp comes
on in the instrument
panel, accompanied by
an audible signal and a
message in the instru-
ment panel screen.
The system then places your head-
lamps in the lowest position. To avoid causing a nuisance to other
road users, this system corrects
the height of the xenon headlamp
beams automatically and when sta-
tionary, depending on the load in the
vehicle.

V
91
VISIBILITY

Programming
The function is activated or deac-
tivated via the instrument panel
screen "Main Menu".
To do this, select "Vehicle parameters \
Lighting Directional headlamps".

Operating fault
If a fault occurs, this warning
lamp fl ashes in the instru-
ment panel, accompanied
by a message in the multi-
function screen.
Contact a CITROËN dealer or a quali-
fi ed workshop.
When stationary or moving at very
low speed or when reverse gear is
engaged, the function is inactive.
The status of the function remains
in the memory when the ignition is
switched off.










Directional headlamps
function
When the dipped or main beam
headlamps are on, this function, as-
sociated with the "cornering lighting"
function, enables the light beam to
follow the direction of the road.
The use of this function, linked with
the xenon headlamps only, conside-
rably improves the quality of your
lighting when cornering.

with directional lighting

without directional lighting