Page 168 of 316
X
!
166
CHECKS
Vehicles fi tted with the 2.0i 16v
engine may be fi tted with metal
spring suspension. In this case,
a different power steering fl uid reser-
voir is fi tted.
2.0i 16V
1.
Screenwash and headlamp wash
reservoir.
2.
Power steering fl uid reservoir or
power steering and suspension
fl uid reservoir.
3.
Engine coolant header tank.
4.
Engine oil dipstick.
5.
Engine oil fi ller cap.
6.
Brake fl uid reservoir.
7.
Battery.
8.
Air fi lter.
Page 169 of 316
X
!
167
CHECKS
DIESEL ENGINES
The various caps and covers allow
access for checking fl uid levels, for
replacing certain components and
for priming the fuel system.
1.
Screenwash and headlamp wash
reservoir.
2.
Power steering fl uid reservoir or
power steering and suspension
fl uid reservoir, depending on
equipment.
3.
Engine coolant header tank.
4.
Engine oil dipstick.
5.
Engine oil fi ller cap.
6.
Air fi lter.
7.
Brake fl uid reservoir.
8.
Battery.
As the Diesel fuel system op-
erates under high pressure,
any work on the fuel system
is prohibited.
Vehicles fi tted with the HDi 140
en-
gine may be fi tted with metal spring
suspension. In this case, a differ-
ent power steering fl uid reservoir is
fi tted.
HDi 115
/ e-HDi 115
HDi 140
Page 170 of 316
X!
168
CHECKS
HDi 160 - HDi 200 engines
(with particle emissions filter)
1.
Screenwash and headlamp wash
reservoir.
2.
Power steering and suspension
fl uid reservoir.
3.
Engine coolant header tank.
4.
Engine oil dipstick.
5.
Engine oil fi ller cap.
6.
Air fi lter.
7.
Brake fl uid reservoir.
8.
Battery.
As the Diesel fuel system ope-
rates under high pressure:
- All work on the fuel system is
prohibited.
- HDi engines make use of ad-
vanced technology.
All maintenance and repairs require
special qualifi cations which only a
CITROËN dealer can guarantee.
HDi 160
HDi 200
Page 171 of 316
X!
169
CHECKS
V6 HDi 240 engine
(with particle emissions filter)
V6 HDi 240
1.
Screenwash and headlamp wash
reservoir.
2.
Power steering and suspension
fl uid reservoir.
3.
Engine coolant header tank.
4.
Engine oil dipstick.
5.
Engine oil fi ller cap.
6.
Air fi lter.
7.
Brake fl uid reservoir.
8.
"+" and "-" terminals for emergency
starting with a slave battery.
As the Diesel fuel system ope-
rates under high pressure:
- All work on the fuel system is
prohibited.
- HDi engines make use of ad-
vanced technology.
All maintenance and repairs require
special qualifi cations which only a
CITROËN dealer can guarantee.
Page 172 of 316
X
!
170
CHECKS
CHECKING LEVELS
Oil level
The check is carried out either
when the ignition is switched
on using the oil level indicator
on the instrument panel, or
using the dipstick.
This manual check will only be cor-
rect if the vehicle is on level ground
and the engine has been off for more
than 30 minutes.
It is normal to top up the oil level be-
tween two services (or oil changes).
CITROËN recommends that you
check the level, and top up if neces-
sary, every 3 000 miles (5 000 kms).
After topping up the oil, the check
when switching on the ignition with
the oil level indicator in the instru-
ment panel is not valid during the
30 minutes after topping up.
If a level drops signifi cantly, have
the corresponding system checked
by a CITROËN dealer or a qualifi ed
workshop.
Check all of these levels regularly
and top them up if necessary, unless
otherwise indicated.
Take care when working under the
bonnet, as certain areas of the en-
gine may be extremely hot (risk of
burns).
Engine oil change
Refer to the servicing booklet for
details of the interval for this opera-
tion.
In order to maintain the reli-
ability of the engine and emis-
sion control system, the use
of additives in the engine oil is
prohibited.
Oil specifi cation
The oil must be the correct grade
for your engine and conform to the
manufacturer's recommendations.
Brake fluid level
The brake fl uid level should
be close to the "MAX" mark.
If it is not, check the brake
pad wear.
Changing the fl uid
Refer to the servicing booklet for de-
tails of the interval for this operation.
Fluid specifi cation
The brake fl uid must conform to the
manufacturer's recommendations
and meet the DOT4 standard.
Power steering or power
steering and suspension
fluid level
For topping up, it is necessary
to go to a CITROËN dealer or
a qualifi ed workshop.
Dipstick
There are two marks on
the dipstick:
A
= max; never exceed
this level,
B
= min; top up the oil
level via the oil fi ller cap,
using the correct grade of
oil for your engine.
Page 181 of 316
XI
!
179
PRACTICAL INFORMATION
Removing a wheel
)
Park the vehicle on stable, fi rm
ground that is not slippery. apply
the parking brake.
)
If your vehicle is equipped with
"Hydractive III+" suspension,
with the engine running at idle,
adjust the ground clearance to
its maximum height.
)
Switch off the ignition and en-
gage fi rst gear or reverse gear
depending on any slope (for a
vehicle with automatic gearbox,
select position P
).
)
If your vehicle is fi tted with
"Hydractive III+" suspension,
position the chock, whichever di-
rection the gradient may be in, in
front of the front wheel diametri-
cally opposite to the one to be
replaced.
)
Position the jack at one of the four
jacking-points provided on the un-
derbody close to the wheels, then
use the wheelbrace to unwind the
jack until it reaches the ground.
)
Remove the protector from each
bolt using tool 3
.
)
Slacken the wheel bolts.
Before positioning the jack:
)
Always adjust the vehicle’s
ground clearance to the "maxi-
mum height" position and re-
tain this adjustment for as long
as the jack is under the vehicle
(do not use the hydraulic ad-
justments),
)
Immobilise your vehicle on hor-
izontal, stable and non-slippery
ground,
)
Ensure that any passengers
have left the vehicle and are in
a safe place .
Never get underneath the vehicle if
it is supported only by the jack.
The jack and all of the tools are
specifi c to your vehicle. Do not use
them for any other applications.
Have the original wheel repaired
and refi tted as soon as possible.
)
Continue to extend the jack until
the wheel is a few centimetres
off the ground.
)
Undo the bolts, remove the wheel.
Page 194 of 316
XI
192
PRACTICAL INFORMATION
Table of fuses
Fuse N°
Rating
Function
G29
-
Not used
G30
5 A
Heated door mirrors
G31
5 A
Rain and sunshine sensor
G32
5 A
Seat belt not fastened warning lamps
G33
5 A
Electrochromatic rear view mirror
G34
20 A
Sunroof (saloon)
G35
5 A
Passenger door lighting - passenger door mirror adjustment
G36
30 A
Electric tailgate (tourer)
G37
20 A
Heated front seats
G38
30 A
Driver’s electric seat
G39
30 A
Passenger’s electric seat - HIFI amplifi er
G40
3 A
Trailer relay unit supply
FUSEBOX B
Fuse N°
Rating
Function
G36
15 A
6 speed automatic gearbox
5 A
4 speed automatic gearbox
G37
10 A
Daytime running lamps - Diagnostic socket
G38
3 A
ESP
G39
10 A
Hydraulic suspension
G40
3 A
STOP switch
Page 195 of 316
XI
193
PRACTICAL INFORMATION
FUSEBOX C
Fuse N°
Rating
Function
F1
15 A
Rear screen wipe (Tourer)
F2
30 A
Locking and deadlocking relay
F3
5 A
Airbags
F4
10 A
Automatic gearbox - additional heater unit (Diesel) - electrochrome rear view mirror
F5
30 A
Front window - sunroof - passenger door lighting - passenger door mirror adjustment
F6
30 A
Rear window
F7
5 A
Vanity mirror lighting - Glove box lighting - interior lamps - torch (tourer)
F8
20 A
Radio - CD changer - Steering mounted controls - Screen - Under-infl ation detection -
Electric boot ECU
F9
30 A
Cigar lighter - front 12 V socket
F10
15 A
Alarm - Steering mounted controls, signalling and wiper controls
F11
15 A
Low current ignition switch
F12
15 A
Driver’s electric seat - instrument panel - seat belt not fastened warning lamps - air
conditioning controls
F13
5 A
Engine relay unit - Hydraulic suspension pump cut-off relay - airbag ECU supply
F14
15 A
Rain and sunshine sensor - parking sensors - passenger’s electric seat - trailer relay unit -
HIFI amplifi er ECU - Bluetooth system - Lane Departure Warning System
F15
30 A
Locking and deadlocking relay
F17
40 A
Heated rear screen - heated door mirrors
FSH
SHUNT
PARK SHUNT
