2012 Citroen C5 brake

I
33
MONITORING





Braking


fi xed, associated
with the STOP
warning lamp. The braking system fl uid level
is too low. You must stop as soon as it is safe to
do so.
Top up with brake fl uid recommended by
CITROËN.
If the problem persists, have the system
checked by a CITROËN dealer or a
qualifi ed workshop.

+

fi xed, associated
with the STOP
and ABS warning
lamp. The electronic brake force
distribution (EBFD) system
has a fault. You must stop as soon as it is safe to
do so.
Have it checked by a CITROËN dealer or
a qualifi ed workshop.

Warning lamp



is on



Cause



Action / Observations






Anti-lock
Braking
System
(ABS)


fi xed. The anti-lock braking system
has a fault. The vehicle retains conventional braking.
Drive carefully at reduced speed and
contact a CITROËN dealer or a qualifi ed
workshop without delay.




Electric
parking
brake


fl ashing. The electric parking brake is
not applied automatically.
The application/release is
faulty. You must stop as soon as it is safe to
do so.
Park on fl at level ground, switch off the
ignition and contact a CITROËN dealer or
a qualifi ed workshop.




Electric
parking
brake fault


fi xed. The electric parking brake
has a fault. Contact a CITROËN dealer or a qualifi ed
workshop without delay.
The parking brake can be released
manually.
For more information on the electric
parking brake, refer to the "Driving"
section.

I
34
MONITORING




Dynamic
stability
control
(ESP/ASR)


fl ashing. The ESP/ASR regulation is
active. The system optimises traction and
improves the directional stability of the
vehicle.
fi xed, accompanied
by an audible signal
and a message
in the instrument
panel screen.
Unless it has been
deactivated with the indicator
lamp in the button on, the
ESP/ASR system has a fault. Have it checked by a CITROËN dealer or
a qualifi ed workshop.




Engine
autodiagnosis
system


fi xed. The emission control system
has a fault. The warning lamp should go off when the
engine is started.
If it does not go off, contact a CITROËN
dealer or qualifi ed workshop without delay.

fl ashing. The engine management
system has a fault. Risk of destruction of the catalytic converter.
Have it checked by a CITROËN dealer or
a qualifi ed workshop.

Warning lamp



is on



Cause



Action / Observations



Brake pad
wear


fi xed, accompanied
by an audible signal
and a message in
the multifunction
screen.
The brake pads are at an
advanced state of wear. Have the brake pads replaced by a
CITROËN dealer or a qualifi ed workshop.

Deactivation of
the automatic
functions of
the electric
parking brake


fi xed. The "automatic application"
(on switching off the engine)
and "automatic release"
functions are deactivated or
faulty. Activate the function (according to country)
via the vehicle confi guration menu or
contact a CITROËN dealer or a qualifi ed
workshop if automatic application / release
is not possible.
The parking brake can be released
manually using the emergency release
procedure.
For more information on the electric parking
brake, refer to the "Driving" section.

I
37
MONITORING


Warning lamp



is on



Cause



Action / Observations






Diesel engine
pre-heating


fi xed. The ignition switch is at the
2nd position (ignition on).
Wait until the warning lamp has switched
off before starting.
The duration for which the warning lamp is
on is determined by the climatic conditions.




Parking
brake


fi xed. The parking brake is applied or not
properly released. Release the parking brake to switch
off the warning lamp, keeping your
foot on the brake pedal.
Observe the safety
recommendations.
For further information on the
parking brake, refer to the "Driving"
section.
fl ashing. The parking brake is not fully
applied or is released.



Passenger's
airbag
system
fi xed. The control switch, located in the
glove box, is in the " ON
" position.
The passenger's front airbag is
activated.
In this case, do not install a rear-
facing child seat. Turn the control switch to the " OFF
"
position to deactivate the front
passenger's airbag.
In this case you can install a rear-facing
child seat.


Stop & Start


fi xed. When the vehicle stops (red lights,
traffi c jams, ...) the Stop & Start
system has put the engine into
STOP mode. The warning lamp goes off and the
engine restarts automatically in
START mode, as soon as you want
to move off.

fl ashes for a few
seconds, then
goes off. STOP mode is temporarily
unavailable.
or
START mode is invoked
automatically. Refer to "Driving - § Stop & Start"
for special cases with STOP mode
and START mode.

VIII
11 7
SAFETY
BRAKING ASSISTANCE
SYSTEMS
Group of supplementary systems
which help you to obtain optimum
braking in complete safety in emer-
gency situations:


- anti-lock braking system (ABS),

- electronic brake force distribution
(EBFD),

- emergency braking assistance
(EBA).


Anti-lock braking system
and electronic brake force
distribution
Linked systems which improve the
stability and manoeuvrability of your
vehicle when braking, in particular
on poor or slippery surfaces.

Activation
The anti-lock braking system comes
into operation automatically when
there is a risk of wheel lock.
Normal operation of the ABS may
make itself felt by slight vibration of
the brake pedal.
Operating fault
When braking in an emergency,
press very fi rmly without releasing
the pressure. If this warning lamp comes
on, accompanied by an
audible signal and a mes-
sage in the instrument panel
screen, it indicates a fault with the
anti-lock braking system which could
result in loss of control of the vehicle
when braking.
If this warning lamp comes
on, together with the STOP

and ABS
warning lamps, ac-
companied by an audible sig-
nal and a message in the instrument
panel screen, it indicates a fault with
the electronic brake force distribution
which could result in loss of control of
the vehicle when braking.

You MUST stop as soon as it is
safe to do so.

In both cases, contact a CITROËN
dealer or a qualifi ed workshop.
When replacing wheels (tyres and
rims), ensure that they conform to
the manufacturer's recommenda-
tions.











Emergency braking assistance

System which, in an emergency,
enables you to obtain the optimum
braking pressure more quickly, thus
reducing the stopping distance.

Activation
It is triggered by the speed at which
the brake pedal is pressed.
The effect of this is a reduction in
the resistance of the pedal and an
increase in braking effi ciency.
When braking in an emergency,
press fi rmly without releasing the
pressure.

VIII
118
SAFETY
TRAJECTORY CONTROL
SYSTEMS

Anti-slip regulation (ASR)
and electronic stability
programme (ESP)

Activation
These systems are activated auto-
matically each time the vehicle is
started.
They come into operation in the event
of a grip or trajectory problem.
This is indicated by fl ashing
of this warning lamp in the
instrument panel.


Deactivation
In exceptional conditions (starting a
vehicle which is bogged down, stuck
in snow, on soft ground...), it may be
advisable to deactivate the ASR and
ESP systems, so that the wheels
can move freely and regain grip.


)
Press the "ESP OFF"
button, lo-
cated in the middle of the dash-
board.

If this warning lamp comes on in
the instrument panel and the in-
dicator lamp in the button comes
on, this indicates that the ASR and
ESP systems are deactivated.
Your vehicle has a system to im-
prove traction on snow: intelligent
traction control
.
This system detects situations of low
adhesion that might make moving off
and progress diffi cult on deep fresh
snow or compacted snow .
In these situations the intelligent
traction control
system regulates
the amount of wheel slip to optimise
the traction and trajectory control of
your vehicle.
The anti-slip regulation (also known
as Traction Control) optimises trac-
tion to prevent skidding of the wheels,
by acting on the brakes of the driving
wheels and on the engine.
The electronic stability programme acts
on the brake of one or more wheels
and on the engine to keep the vehicle
on the trajectory required by the driver,
within the limits of the laws of physics.








Intelligent traction control
system ("Snow motion") For vehicles with Hydractive III +
suspension, manual adjustment of
ground clearance to the intermediate
position improves further the ability
to make progress in deep snow (see
the relevant paragraph).
The use of snow tyres is strongly
recommended on surfaces with low
adhesion.

It is recommended that these systems
be reactivated as soon as possible.

IX
!
126
DRIVING
MANUAL PARKING BRAKE

Mechanical device for immobilising
the vehicle when stationary. This warning lamp comes
on if the parking brake is en-
gaged or not fully released.

If the parking brake is released,

the illumination of this warning lamp
along with the STOP
warning lamp
indicates that the brake fl uid level
is low or a fault with the brake force
distributor.

You must stop as soon as it is safe
to do so.
Contact a CITROËN dealer or a
qualifi ed workshop.

Application


)
Pull the parking brake lever up to
immobilise your vehicle.
To facilitate the action on the lever,
you are recommended to press the
brake pedal at the same time.

In all circumstances, as a pre-
cautionary measure, engage
fi rst gear.
On steep gradients, turn the steering
wheel towards the pavement.
Release


)
Press on the end of the lever
whilst pulling it then lower it fully.

IX
!!
127
DRIVING
ELECTRIC PARKING BRAKE
The electric parking brake combines
2 operating modes:


- AUTOMATIC

Automatic application when the
engine stops and automatic re-
lease on use of the accelerator
(automatic operation by default),

- MANUAL

Manual application / release of
the parking brake is always pos-
sible by pulling control lever A

while pressing the brake pedal.


Automatic operation


Application with the engine off
With the vehicle stationary, the park-
ing brake is automatically applied
when the engine is switched off.

The application of the parking brake
is confi rmed by:
Application with the engine running
With the engine running and the ve-
hicle stationary, in order to immobi-
lise the vehicle you need to manually
apply the parking brake by pulling

on control lever A
.
The application of the parking brake
is confi rmed by:

- warning lamp P
in the con-
trol lever A
coming on,
Before leaving the vehicle,
check that warning lamp P

and the warning lamp in the
instrument panel are on fi xed (not
fl ashing).
Never leave a child alone inside the
vehicle with the ignition on, as they
could release the parking brake.
- display of a message "parking
brake on" in the instrument panel
screen.
The noise of operation will confi rm to
you the application/ release of your
electric parking brake.

- warning lamp P
in the con-
trol lever A
coming on,

- display of a message "parking
brake on" in the instrument panel
screen.
When the driver’s door is opened, a
beep is heard and a message dis-
played if the parking brake has not
been applied.
Before leaving the vehicle,
check that warning lamp P

and the warning lamp in the
instrument panel are on fi xed (not
fl ashing).
-
this warning lamp in the in-
strument panel coming on,

- this warning lamp in the in-
strument panel coming on,

IX!
!
128
DRIVING

Release
The electric parking brake releases
automatically and progressively

when you press the accelerator:


)
with a manual gearbox
(fi rst
gear or reverse gear engaged),
press down fully on the clutch
pedal then press on the accele-
rator pedal and move off.

)
with an automatic gearbox
, ac-
celerate with the selector in posi-
tion D
, M
or R
.
Full release of the parking brake is
confi rmed by:


- warning lamp P
in the
control lever A
going off,

- display of a message "parking
brake off" in the instrument panel
screen.
When stationary, with the engine
running, do not press the accelera-
tor pedal unnecessarily (particularly
when starting the engine, including
in neutral), as you may release the
parking brake.
Do not place any object (packet of
cigarettes, telephone...) between
the gear lever and the electric park-
ing brake control.
Activation / Deactivation of the
automatic functions
Depending on the country of sale,
automatic application when switch-
ing off the engine and automatic
release when moving off can be de-
activated. The activation / deactiva-
tion is done in the instrument panel
screen confi guration menu. Select
"Vehicle parameters / Comfort / Auto
parking brake".
Deactivation of these func-
tions is signalled by this
warning lamp in the instru-
ment panel.
With the automatic functions deac-
tivated, the parking brake must be
applied and released manually.
In some special circumstanc-
es, with the engine not run-
ning, (towing, icy conditions...) the
automatic parking brake can be
released manually, with the key in
the running position.
Manual operation

Manual application / release of the
parking brake is always possible.

Application
With the vehicle stationary, to apply the
parking brake whether the engine is
running or off, pull
on control lever A
.
The application of the parking brake
is confi rmed by:


- warning lamp P
in the con-
trol lever A
coming on,

- display of a message "parking
brake on" in the instrument panel
screen.
When the driver’s door is opened
with the engine running, a mes-
sage is displayed accompanied
by an audible signal if the parking
brake has not been applied.
-
this warning lamp in the in-
strument panel coming on,

- this warning lamp in the in-
strument panel going off,
If the confi guration menu does not
have the option to activate / deac-
tivate the automatic functions, this
can be done by a CITROËN dealer
or a qualifi ed workshop.