2012 Citroen C4 RHD lock

4
ACCESS
87

Operating fault


When the ignition is switched on, fi xed
illumination of the indicator lamp in the
button indicates a fault with the system.
Have it checked by a CITROËN dealer
or a qualifi ed workshop.



Locking the vehicle with exterior
perimeter monitoring only
Deactivate the interior volumetric and
anti-tilt monitoring to avoid unwanted
triggering of the alarm in certain cases
such as:


- leaving a pet in the vehicle,

- leaving a window partially open,

- washing your vehicle,

- changing a wheel,

- having your vehicle towed,

- transport by sea.

Deactivation of the interior
volumetric and anti-tilt monitoring


)
Switch off the ignition.

)
Within ten seconds, press the but-
ton until the indicator lamp is on
continuously.

)
Get out of the vehicle.

)
Press the locking button on the re-
mote control immediately. The exterior perimeter monitoring alone
is activated: the indicator lamp in the
button fl ashes once per second.
To be effective, this deactivation
must be carried out each time
the ignition is switched off.

Reactivation of the interior
volumetric and anti-tilt monitoring


)
Press the unlocking button on the
remote control to deactivate the ex-
terior perimeter monitoring.

)
Press the locking button on the re-
mote control to activate all the moni-
toring functions.
The indicator lamp in the button again
fl ashes once per second.



Triggering of the alarm


This is indicated by sounding of the si-
ren and fl ashing of the direction indica-
tors for thirty seconds.
The monitoring functions remain active
until the alarm has been triggered elev-
en times in succession.
When the vehicle is unlocked using the
remote control, rapid fl ashing of the in-
dicator lamp in the button informs you
that the alarm was triggered during your
absence. When the ignition is switched
on, this fl ashing stops immediately.



Failure of the remote control

To deactivate the monitoring functions:



)
unlock the vehicle using the key in
the driver's door lock,

)
open the door; the alarm is trig-
gered,

)
switch on the ignition; the alarm
stops; the indicator lamp in the but-
ton goes off.




Locking the vehicle without
activating the alarm



)
Lock or deadlock the vehicle using
the key in the driver's door lock.

4
ACCESS
88











DOORS

Opening



)
After unlocking the vehicle com-
pletely using the remote control or
the key, pull the door handle.


From outside
When the selective unlocking is
activated, the fi rst press of the
remote control unlocking button
permits unlocking of the driver's
door only.

)
Pull the interior control lever of a
front door; this unlocks the vehicle
completely.



From inside
With the selective unlocking ac-
tivated:


- opening the driver’s door un-
locks the driver’s door only (if
the vehicle has not already
been completely unlocked).

- opening the passenger’s
door unlocks the rest of the
vehicle.


Closing

When a door is not closed correctly:


- when the engine is run-
ning
, this warning lamp
comes on, accompanied by
an alert message for a few
seconds,

- when the vehicle is moving
(speed
higher than 6 mph (10 km/h)), this
warning lamp comes on, accom-
panied by an alert message for a
few seconds.

The interior door controls do
not operate when the vehicle is
deadlocked.

4
ACCESS
89

















BOOT

Opening



)
After unlocking the boot or the ve-
hicle using the remote control or the
key, press the opening control, then
raise the tailgate.



Closing



)
Lower the tailgate using the interior
grab handle.

)
If necessary, press down on the tail-
gate to fully close it.







Tailgate release

System allowing the mechanical unlock-
ing of the boot in the event of a battery or
central locking system malfunction.

Unlocking


)
Fold back the rear seats to gain
access to the lock from inside the
boot.

)
Insert a small screwdriver into hole A

of the lock to unlock the tailgate.

)
Move the latch to the left.
If the tailgate is not closed correctly:


- when the engine is running
,
this warning lamp comes on,
accompanied by the display
of an alert message for a few
seconds,

- when the vehicle is moving
(speed
above 6 mph (10 km/h)), this warn-
ing lamp comes on, accompanied by
an audible signal and the display of
an alert message for a few seconds.


Locking after closing
If the fault persists after closing again,
the boot will remain locked.

4
ACCESS
90

















ELECTRIC WINDOWS

Fitted with a safety anti-pinch system
and a deactivation system to prevent
misuse of the rear controls.


1.
Driver's electric window control.


2.


Passenger's electric window control.



3.
Rear right electric window control.


4.
Rear left electric window control.


5.
Deactivation of the rear electric
window controls.

The electric window controls
remain operational for approxi-
mately 45 seconds after the ig-
nition is switched off or until the
vehicle is locked after a door is
opened.
If one of the passenger windows
cannot be operated from the
driver's door control panel, carry
out the operation from the con-
trol panel of the passenger door
concerned, and vice versa. After approximately ten con-
secutive complete opening/clos-
ing movements of the window, a
protection function is activated
which only authorises closing of
the window to prevent damage
to the electric window motor.
Once the window is closed,
the controls will become avail-
able again after approximately
40 minutes.
If the window cannot be closed (for
example, in the presence of ice),
once the window has lowered:


)
press and hold the control
until the window opens fully,

)

then pull the control immediate-
ly and hold it until the window
closes,

)
continue to hold the control
for approximately one second
after the window has closed.


The safety anti-pinch function
is not operational during these
operations.



There are two options:


- manual mode



)
Press or pull the control gently.
The window stops when the con-
trol is released.

- automatic mode



)
Press or pull the control fi rmly.
The window opens or closes fully
when the control is released.

)
Pressing the control again stops
the movement of the window.

Safety anti-pinch
When the window rises and meets an
obstacle, it stops and partially lowers
again.

One-touch electric windows

5
VISIBILITY
101

Switching off
On the outside, the welcome lighting
switches off automatically after a set
time, when the ignition is switched on
or on locking the vehicle.
On the inside, the welcome lighting
switches off automatically after a pre-
determined time or on opening one of
the doors.

Programming
The lighting duration for the wel-
come lighting is selected via the
vehicle confi guration menu.
On the inside, the footwell and courtesy
lamps come on.












WELCOME LIGHTING


Switching on


)
Press the open padlock on
the remote control; your ve-
hicle is unlocked.
The remote switching on of the pas-
senger compartment lighting makes
your access to the vehicle easier in
poor light. It is activated depending on
the light level detected by the sunshine
sensor.
On the outside, the sidelamps and
dipped beam headlamps, as well as the
side spotlamps, located under the door
mirrors, come on.

5
VISIBILITY
108


1.
Front courtesy lamp


2.
Front map reading lamps


3.
Rear courtesy lamp


4.
Rear map reading lamps














COURTESY LAMPS



- when the vehicle is unlocked,

- when the key is removed from the
ignition,

- on opening a door,

- when the remote control locking but-
ton is used to locate your vehicle.


Front and rear courtesy lamps

In this position, the courtesy
lamp comes on gradually:
It switches off gradually:


- when the vehicle is locked,

- when the ignition is switched on,

- 30 seconds after the last door is
closed. To switch off the rear courtesy lamp, put
it in the the "permanently off" position.
Permanently off.
Permanent lighting. In permanent lighting mode, the
lighting time varies according to
the circumstances:


- with the ignition off, approxi-
mately ten minutes,

- in energy economy mode, ap-
proximately thirty seconds,

- with the engine running, un-
limited.
When the courtesy lamp is in
the "permanent lighting" posi-
tion, the rear courtesy lamp also
comes on, except if it is in the
"permanently off" position.


Front and rear map reading
lamps
Take care not to put anything in
contact with the courtesy lamps.

)
With the ignition on, press
the corresponding switch.

6
FITTINGS
11 5


)
To connect a 12 V accessory (max
power: 120 W), lift the cover and
connect a suitable adaptor.






12 V ACCESSORY SOCKET







FRONT ARMREST

Comfort and storage device for the driver
and front passenger.
The length of the armrest cover can be
adjusted.

Longitudinal adjustment



)
To move forwards, raise the lever.
The armrest slides forwards to its
stop.

)
To stow it, slide it fully back and
press down to lock it.



Storage

The armrest's compartment can hold
up to 6 CDs.


)
Raise the cover fully.

7
CHILD SAFETY
125
Children under the age of 10 must
not travel in the "forwards-facing"
position on the front passenger seat,
unless the rear seats are already oc-
cupied by other children, cannot be
used or are absent.
Deactivate the passenger airbag
when a "rearwards-facing" child seat
is installed on the front seat.
Otherwise, the child would risk being
seriously injured or killed if the airbag
were to infl ate.





ADVICE ON CHILD SEATS

As a safety precaution, do not leave:


- a child or children alone and un-
supervised in a vehicle,

- a child or an animal in a vehicle
which is exposed to the sun, with
the windows closed,

- the keys within reach of children
inside the vehicle.
To prevent accidental opening of the
doors and rear windows, use the
"Child lock".
Take care not to open the rear windows
by more than one third.
To protect young children from the
rays of the sun, fi t side blinds on the
rear windows.


Installing a booster seat
The chest part of the seat belt must
be positioned on the child's shoulder
without touching the neck.
Ensure that the lap part of the seat
belt passes correctly over the child's
thighs.
CITROËN recommends the use of
a booster seat which has a back, fi t-
ted with a seat belt guide at shoulder
level. The incorrect installation of a child
seat in a vehicle compromises the
child's protection in the event of an
accident.
Remember to fasten the seat belts or
the child seat harnesses keeping the
slack relative to the child's body to a
minimum, even for short journeys.
When installing a child seat using the
seat belt, ensure that the seat belt is
tightened correctly on the child seat
and that it secures the child seat fi rm-
ly on the seat of your vehicle. If your
passenger seat is adjustable, move it
forwards if necessary.
For optimum installation of the "for-
wards-facing" child seat, ensure that
the back of the child seat is in contact
with the back of the vehicle's seat
and that the head restraint does not
cause any discomfort.
If the head restraint has to be removed,
ensure that it is stored or attached se-
curely to prevent it from being thrown
around the vehicle in the event of sharp
braking.