2012 Citroen C4 PICASSO RHD ignition

XI
188
PRACTICAL INFORMATION












Removing a wheel



)
Park the vehicle on level, stable
and non-slippery ground. Apply
the parking brake (a message
and a warning lamp appear in
the instrument panel).
Switch off the ignition and en-
gage fi rst gear or reverse gear
depending on the slope (position
P
if an automatic gearbox, D
or
R
if a 6-speed electronic gear-
box).

)
Use a chock to secure the vehi-
cle more safely. Place the chock
9
in front of the wheel opposite
the punctured wheel.
)
Detach the trim using the remov-
ing tool 4
, pulling in the area of
the valve.
For vehicles with alloy wheels,
insert the trim removing tool 1

into the recess in the central trim
and lever it off.
For vehicles with alloy wheels
that have visible bolts, remove
the chrome covers using the re-
moving tool 2
.
)
Slacken the wheel bolts. For ve-
hicles with alloy wheels, slacken
the security bolts using the secu-
rity bolt socket 6
.

)
Position the jack under the vehi-
cle, at the jacking point A
closest
to the wheel to be changed.

)
Unwind the jack 5
until its brack-
et is in contact with the ground.
Make sure that the jack is verti-
cal under the jacking point used.

)
Continue to extend the jack so
as to raise the vehicle.

)
Undo the wheel bolts and re-
move the wheel.

Before any operation of this
sort, it is advisable to deactivate
your pneumatic suspension.

XI
198
PRACTICAL INFORMATION

Access to the fuses


)
Open the glove box.

)
Undo the screw by a quarter turn
and pivot the housing.

Table of fuses



Fuse N°



Rating



Functions




F1



15 A

Rear screen wipe


F2



30 A

Locking and unlocking earth


F3



5 A

Airbags and pretensioners


F4



10 A

Multimedia, photochromic rear view mirror, particle
fi lter, diagnostic socket, air conditioning, manual
headlamp height adjustment


F5



30 A

Front windows, front door electronic control panel,
panoramic sunroof


F6



30 A

Rear windows


F7



5 A

Interior lamps, cooled glove box, radio


F8



20 A

Multifunction screen, radio, steering mounted
controls, multimedia, defl ation detection, alarm,
trailer


F9



30 A

Multimedia, front 12 V sockets, torch, radio


F10



15 A

Height corrector (suspension)


F11



15 A

Brake switch, ignition switch


F12



15 A

Parking sensors, automatic screen wipe and
lighting, passenger’s electric seat, lane departure
warning system, Hi-Fi amplifi er, trailer


F13



5 A

Engine relay unit (BSM), driver’s electric seat


F14



15 A

Air conditioning, Bluetooth
®
hands-free kit,
automatic gearbox lever, airbags, instrument panel


F15



30 A

Locking and unlocking


F16



-

SHUNT


F17



40 A

Heated rear screen


Fuses under the dashboard

XI
203
PRACTICAL INFORMATION
12 V BATTERY
Procedure for starting the engine
using another battery or for charging
your fl at battery.


The Stop & Start battery does not
have to be disconnected for charging.







The presence of this label, in
particular with the Stop & Start
system, indicates the use of
a 12 V lead-acid battery with
special technology and specifi cation;
the involvement of a CITROËN deal-
er or a qualifi ed workshop is essential
when replacing or disconnecting the
battery.

After refi tting the battery, the Stop &
Start system will only be active after
a continuous period of immobilisa-
tion of the vehicle, a period which
depends on the climatic conditions
and the state of charge of the bat-
tery (up to about 8 hours).

*
or position P
for an automatic gear-
box.


Access to the battery

Before doing any work
Immobilise the vehicle: ap-
ply the parking brake, put
the gearbox in neutral * , then switch
off the ignition.
Check that all electrical equipment
is switched off.


Check that the battery posts and
terminals are clean. If they are
covered with sulphate (white or
green deposit), disconnect them
and clean them.

Batteries contain harmful
substances such as sul-
phuric acid and lead. They
must be disposed of in accordance
with regulations and must not, in
any circumstances, be discarded
with household waste.
Take used cell batteries and vehi-
cle batteries to an authorised col-
lection point.
The battery is located under the
bonnet.
For access to the (+) terminal:


)
Release the bonnet using the
interior lever, then the exterior
safety catch,

)
raise the bonnet and secure it
with its stay,

)
lift the plastic cover for access to
the (+) terminal.

XI
205
PRACTICAL INFORMATION

Before disconnecting


)
Go to the battery.

)
Check that all of the openings -
doors, boot... - are closed but not
locked.

)
Wait at least four minutes after
switching off the ignition.
Charging


)
Disconnect the (+) terminal.

)
Follow the instructions on use
provided by the manufacturer of
the charger.

)
Connect the red cable of the
charger to the (+) post of the bat-
tery, then the black cable to the
(-) terminal.

)
Once charging is complete, dis-
connect the charger cables in re-
verse order.
The charging operation
must be carried out in a
well ventilated area and
well away from naked fl ames and
sources of sparks, so as to avoid
any risk of explosion and fi re.
Do not try to charge a frozen bat-
tery; the battery must fi rst be
thawed out to avoid any risk of ex-
plosion. If the battery has frozen,
before charging, have it checked
by a CITROËN dealer or a quali-
fi ed workshop, who will ensure that
the internal components have not
been damaged and that the casing
is not cracked, which would intro-
duce the risk of a leak of toxic and
corrosive acid.



Charging the battery using a
battery charger
If the battery of your vehicle is fl at
or prior to taking the vehicle out of
service for an extended period, you
can charge the battery using a bat-
tery charger.
For information on the specifi cation
of battery chargers compatible with
your battery, refer to a CITROËN
dealer or a qualifi ed workshop.
It is recommended that the battery
be disconnected if the vehicle is not
be used for more than a month.
Reinitialisation after
reconnection

After any reconnection of the bat-
tery, switch on the ignition and wait
at least one minute before starting,
to allow time for the initialisation of
the electronic systems.
By referring to the corresponding
sections, you should set or initialise
the following systems yourself:


- the date and time,

- the anti-pinch on the driver's
electric window and the sunroof.

- the panoramic sunroof blind,

- the multifunction screen settings,

- the audio system or navigation
system settings,
Check that there no error message
or warning lamp comes on after
switching on the ignition.
However, if minor problems persist
after carrying out these operations,
contact a CITROËN dealer or a
qualifi ed workshop.

228







CITROËN LOCALISED EMERGENCY CALL
In an emergency, press this button for more than2 seconds. Flashing of the green LED and a voice message confi rm that the call has been made to the CITROËN Emergency team * .gg
Pressing this button again immediately cancels the request. The green LED goes off.
A press
(at any time) of more than 8 seconds on this button, cancels
the request.

CITROËN LOCALISED ASSISTANCE CALL

When the ignition is switched on, thegreen LED comes on for 3 seconds indicating that the system is operating correctly.

I
f the orange LED fl ashes: there is asystem fault.
If the oran
ge LED is on continuously: the
backup battery must be replaced.
In either case, contact a CITRO
ÀN. Pressin
g this button again immediately cancels the request.
The cancellation is con
fi rmed by a voice message.
Press this button
for more than 2 seconds to requestassistance if the vehicle breaks down.
A voice message confi rms that the call has been made * .


OPERATION OF THE SYSTEM
The green LED remains on (without fl ashing) when communication is established. It goes off at the end of communication.
If
you purchased your vehicle outside the CITROËN dealer network,
we invite you to have a dealer check the confi guration of these servicesand, if desired, modifi ed to suit your wishes. In a multi-lingual country, confi guration is possible in the offi cial national language of your choice. This call is dealt with b
y the CITROÀN Emergency team which receiveslocating information from the vehicle and can send a detailed alert to theappropriate emergency services. In countries in which the team is not
operational, or when the locating service has been expressly declined,
the call is dealt with directly by the emergency services (11 2) without the
vehicle location.

I
f an impact is detected by the airbag ECU, and independentlyof the deployment of any airbags, an emergency call is made
automatically.


*

These services are subject to conditions and availability.
Consult a CITRO
ÀN dealer. For technical reasons, particularl
y to improve the quality of Telematic
services to customers, the manufacturer reserves the right to carry out updates to the vehicle's on-board telematic system.

260
07
1
2
1
2
3
INTERNAL TELEPHONE
Install the SIM card
in the holder andthen insert it in theslot.
Open the holder by pressing the buttonusing the tip of a pen.

Your
SIM card must be installed and removed with the NaviDrive
audio and telematics system switched off and the ignition off.

To remove the
SIM card, repeat step 1.
Confi rm the PIN code by pressing the # button.
Enter the PIN code on the ke
ypad.

When enterin
g your PIN code, tick the "Store PIN" tab to gain
access to the telephone without having to enter this code when
it is used subsequently.






INSTALLING YOUR SIM CARD
(NOT SUPPLIED)

ENTERING THE PIN CODE
PINcode

295
08
1
2
3
4
BLUETOOTH TELEPHONE
*
The services available depend on the network, the SIM card and thecompatibility of the Bluetooth telephone used. Check the telephone
manual and with your network provider for details of the servicesavailable to you.
















PAIRING A TELEPHONE
FIRST CONNECTION



For reasons of safety and because they require prolonged attentionon the part of the driver, the operations for pairing the Bluetooth mobile telephone to the hands-free system of the MyWay must be carried out with the vehicle stationary. The ignition must be on.

Activate the telephone's Bluetooth
function
and ensure that it is "visible to all" (refer to the
telephone instructions). Enter the authentication code on the tele
phone.
The code to be entered is displayed on the screen
of the system.
Some telephones offer automatic reconnection o
f
the telephone every time the ignition is switched on.
A messa
ge confi rms the pairing.

To change the telephone connected, press the PHONE button, then select Phone Menu and press the dial toconfi rm.
Once the telephone has been connected, MyWay can synchronise
the address book and the call list. This synchronisation may take a few minutes * . Pairin
g can also be started from the telephone (refer to the
telephone instructions). Visit www.citroen.co.uk
for more information (compatibility, more
help, ...).
Press the PH
ONE button.
For a
fi rst connection, select"Search phone" and press the dial to confi rm. Then select the name of thetelephone.
Search
phone

296
08
1
2
2
1
*

The services available depend on the network, the SIM card and the compatibility of the Bluetooth telephone used. Check the telephone manual and with your network provider for details of the services
available to you.
BLUETOOTH TELEPHONE















CONNECTING A TELEPHONE

For reasons of safety and because they require prolonged attention
on the part of the driver, the operations for pairing the Bluetooth
mobile telephone to the hands-free system of the MyWay must becarried out with the vehicle stationary. The ignition must be on.

Activate the tele
phone's Bluetooth function and ensure that it is "visible to all" (refer to the
telephone instructions).
The last telephone connected is reconnected automatically.
A messa
ge confi rms the connection. When a telephone is alread
yconnected, to change it press the
PHONE button, then select PhoneMenu and press the dial to confi rm.
Once the telephone has been connected, MyWay can synchronise
the address book and the call list. This synchronisation may take afew minutes * .

The list o
f telephones connected previously (4 maximum) appearson the multifunction screen. Select the telephone required for a
new connection. Visit www.citroen.co.uk
for more information (compatibility, more
help, ...).

Press the PH
ONE button.Select "Connect
phone". Select the
telephone and press to confi rm.
Connect
phone