15
FAMILIARI
S
AT I
ON
Translucent digital instrument panel
Switch panels
A.
With the ignition on, the level of fuel
remaining is displayed in the digital
instrument panel.
B.
With the ignition on, the oil level in-
dicator should display "OIL OK"
for
a few seconds.
If the levels are not correct, top up the
levels which are low. Illumination of the indicator lamp indi-
cates the status of the corresponding
function.
A.
Deactivation of the ESP/ASR system.
101
B.
Deactivation of the rear parking sen-
sors.
124
C.
Central locking.
65
D.
Deactivation of the Stop & Start system.
11 7
With the ignition on, the orange and red
warning lamps come on.
With the engine running, these warning
lamps should go off almost immediately,
with the exception of warning lamp C
(passenger’s front airbag activated)
which goes off after approximately
one minute.
If warning lamps remain on, refer to the
relevant page.
Warning lamps
22
23
MONITORING
17
FAMILIARI
S
AT I
ON
DRIVING SAFELY
This 6-speed gearbox offers the choice of
the comfort of automated operation or the
pleasure of manual gear changing.
1.
Gear lever.
2.
"-"
steering mounted control paddle.
3.
"+"
steering mounted control paddle.
The gear engaged or the driving mode
selected appears in the instrument pan-
el screen.
N.
Neutral.
R.
Reverse.
1 to 6.
Gears engaged.
AUTO.
Automated mode.
)
Select position N
and press the
brake pedal fi rmly while starting the
engine.
)
Select automated mode (position A
)
or manual mode (position M
) by
moving the gear lever 1
,
or
engage reverse by pushing the gear
lever 1
towards position R
.
)
Release the parking brake.
)
Progressively release the foot brake,
then accelerate away.
6-speed electronic
gearbox system Display in the instrument panel
Moving off
11 2
19
FAMILIARI
S
AT I
ON
Speed limiter "LIMIT"
Display in the instrument panel
1.
Limiter mode Selection/Off.
2.
Decreasing the programmed value.
3.
Increasing the programmed value.
4.
Speed limiter On/Off. The cruise control or speed limiter mode
appears in the instrument panel when it
is selected.
1.
Cruise control mode Selection/Off.
2.
Programming a speed/Decreasing
the programmed value.
3.
Programming a speed/Increasing
the programmed value.
4.
Cruise control Off/Resume.
Cruise control "CRUISE"
121
11 9
In order to be programmed or activated,
the vehicle speed must be higher than
25 mph (40 km/h), with at least fourth
gear engaged on the manual gearbox. The values must be set with the engine
running.
Cruise control
Speed limiter
DRIVING SAFELY
20
ECO-DRIVING
Eco-driving is a range of everyday practices that allow the motorist to optimise their fuel consumption and CO2 emissions.
Optimise the use of your gearbox
With a manual gearbox, move off gently,
change up without waiting and drive
by changing up quite soon. If your
vehicle has the system, the gear effi -
ciency indicator invites you to change
up; it is displayed in the instrument panel,
follow its instructions.
With an automatic or electronic gear-
box, stay in Drive "D"
or Auto "A"
, ac-
cording to the type of gearbox, without
pressing the accelerator pedal heavily
or suddenly.
Maintain a safe distance between vehi-
cles, use engine braking rather than the
brake pedal, and press the accelerator
progressively. These practices contrib-
ute towards a reduction in fuel consump-
tion and CO
2 emissions and also helps
reduce the background traffi c noise.
If your vehicle has cruise control, make
use of the system at speeds above
25 mph (40 km/h) when the traffi c is
fl owing well.
Control the use of your electrical equipment
Before moving off, if the passenger
compartment is too warm, ventilate it
by opening the windows and air vents
before using the air conditioning.
Above 30 mph (50 km/h), close the
windows and leave the air vents open.
Remember to make use of equipment
that can help keep the temperature
in the passenger compartment down
(sun roof and window blinds...).
Switch off the air conditioning, unless
it has automatic digital regulation, as
soon as the desired temperature is
attained.
Switch off the demisting and defrosting
controls, if not automatic.
Switch off the heated seat as soon as
possible.
Switch off the headlamps and front fo-
glamps when the level of light does not
require their use.
Avoid running the engine before moving
off, particularly in winter; your vehicle
will warm up much faster while driving.
As a passenger, if you avoid connecting
your multimedia devices (fi lm, music,
video game...), you will contribute to-
wards limiting the consumption of elec-
trical energy, and so of fuel.
Disconnect your portable devices be-
fore leaving the vehicle.
1
22
MONITORING
PETROL - DIESEL INSTRUMENT PANEL
Panel grouping together the digital indicator, the multifunction screen and the
vehicle operation indicator lamps.
1.
Rev counter.
Indicates the speed of rotation of the
engine (x 1 000 rpm).
2.
Rev counter zone indicating that you
must change up a gear.
3.
Speed limiter
or
Cruise control.
(mph or km/h)
4.
Electric child lock indicator lamp.
Indicates, for a few seconds, the
activation of the electric child lock
(deactivation of the rear windows
and doors).
Translucent digital instrument panel
This screen groups together the warning
and information messages.
Multifunction screen
Indicator lamps displa
y zone
This zone groups together the vehicle
operation indicator lamps.
Display zero reset button
This permits resetting of the function
selected to zero (trip distance recorder
or service indicator).
Instrument panel lighting button
This adjusts the brightness of the lighting
of the instruments and controls.
For more information, refer to
the paragraph relating to the
button or function and its associ-
ated display.
5.
Fuel level.
Indicates the quantity of fuel remain-
ing in the tank.
6.
Vehicle speed.
Indicates the current speed of the
moving vehicle (mph or km/h).
7.
Trip distance recorder.
(miles or km)
8.
Service indicator.
(miles or km) then,
Distance recorder.
(miles or km)
9.
Engine oil level indicator.
1
25
MONITORING
Passenger’s
airbag
system
fi xed. The control switch, located
at the driver’s end of
the dashboard, is in the
"
ON
"
position.
The passenger’s front
airbag is activated.
In this case, do not install a
rear-facing child seat. Turn the control switch to the "
OFF
"
position to
deactivate the front passenger’s airbag.
In this case you can install a rear-facing child
seat.
Warning lamp
is on
Cause
Action/Observations
Electric
child lock
temporarily. The electric child lock is
activated. Displayed for a few seconds after activating the
function and every time the ignition is switched on.
For more information, refer to the "Child safety"
section.
1
MONITORING
Service indicator
System which informs the driver when the
next service is due, in accordance with
the manufacturer's servicing schedule.
The point at which the service is due is
calculated from the last indicator zero
reset. It is determined by two parame-
ters:
- the distance travelled,
- the time elapsed since the last
service.
A few seconds after the ignition is
switched on, the spanner goes off
; the
distance recorder resumes its normal
operation. The display then indicates
the total and trip distances.
Less than 600 miles (1 000 km)
remain before the next service is due
Example:
400 miles (900 km) remain
before the next service is due.
For a few seconds after the ignition is
switched on, the display indicates:
A few seconds after the ignition is switched
on, the distance recorder resumes its nor-
mal operation. The spanner remains on
to indicate that a service must be carried
out soon.
Between 600 miles (1 000 km) and
1 800 miles (3 000 km) remain before
the next service is due
For a few seconds after the ignition is
switched on, the spanner symbolising the
service operations comes on. The distance
recorder display line indicates the distance
remaining before the next service is due.
Example:
1 739 miles (2 800 km) re-
main before the next service is due.
For a few seconds after the ignition is
switched on, the display indicates:
More than 1 800 miles (3 000 km)
remain before the next service is due
When the ignition is switched on, no
service information appears on the
display.
1
MONITORING
Following this operation, if you
wish to disconnect the battery,
lock the vehicle and wait at least
fi ve minutes for the zero reset to
be taken into account.
Service indicator zero reset
After each service, the service indicator
must be reset to zero.
The procedure for resetting to zero is as
follows:
)
switch off the ignition,
)
press and hold the trip distance re-
corder zero reset button,
)
switch on the ignition; the distance
recorder display begins a count-
down,
)
when the display indicates "=0"
,
release the button; the spanner dis-
appears. The distance remaining may be
weighted by the time factor, de-
pending on the type of driving.
Therefore, the spanner may also
come on if you have exceeded
the two year service interval.
Service overdue
For a few seconds after the ignition is
switched on, the spanner fl ashes
to in-
dicate that the service must be carried
out as soon as possible.
Example:
the service is overdue by
180 miles (300 km).
For a few seconds after the ignition is
switched on, the display indicates:
A few seconds after the ignition is switched
on, the distance recorder resumes its nor-
mal operation. The spanner remains on
.
Retrieving the service information
You can access the service information
at any time.
)
Press the trip distance recorder zero
reset button.
The service information is displayed
for a few seconds, then disappears.