2012 Citroen C3 warning light

2
CONTENTS
Ventilation 50Heating 52Manual air conditioning 52Digital air conditioning 55Rear screen demist - defrost 57Scented air freshener 58Front seats 59Rear seats 61Mirrors 62Steering wheel adjustment 63
3 - COMFORT 50 Î 63
Remote control key 64
Window controls 68Doors 70Boot 73Fuel tank 74Misfuel prevention (Diesel) 76
4 - ACCESS 64 Î 76
Lighting controls 77Headlamp adjustment 80Wiper controls 81Courtesy lamps 84
Interior mood lighting 85Boot lamp 85
5 - VISIBILITY 77Î 85
Child seats 92ISOFIX child seats 97Child lock 100
7 - CHILD
SAFETY 92 Î 100 FAMILIARISATION 4
Î20
Monochrome screen A 43Monochrome screen C 4516/9 colour screen (MyWay) 48
2 - MULTIFUNCTION
SCREENS 43 Î49
Interior fi ttings 86Boot fi ttings 90
6 - FITTINGS86Î 91
Instrument panels 23Indicator and warning lamps 25Indicators 35Adjustment buttons 38Trip computer 40
1 - MONITORING 23Î42
ECO-DRIVING 21Î22

4

Rear parking sensors
This system provides a warning when
reversing by detecting obstacles located
behind the vehicle.



127


Stop & Start
This system puts the engine temporarily
into standby during stops in the traf-
fi c (red lights, traffi c jams, etc...). The
engine restarts automatically as soon
as you want to move off. The Stop &
Start system reduces fuel consumption,
exhaust emissions and the noise level
when stationary.



11 9


Temporary puncture repair kit
This kit is a complete system consisting
of a compressor and sealant cartridge,
to allow the temporary repair of a tyre.



136



Zenith windscreen
This large windscreen provides incompa-
rable visibility and light in the passenger
compartment.



6


EXTERIOR

1
MONITORING
Panel grouping together the vehicle operation indication dials and warning lamps.
PETROL - DIESEL MANUAL GEARBOX INSTRUMENT PANELS


5.
Display management button


Servicing information.
Adjust the time and choose units.
Reset the service indicator.

6.
Instrument panel lighting button.


Adjusts the brightness of the lighting
of the instruments and controls.
For more information, refer to the
section on the button or function
and its associated display.


1.
Rev counter.

Indicates the speed of rotation of the
engine (x 1 000 rpm).

2.
Vehicle speed.


Indicates the current speed of the
moving vehicle (mph or km/h).

3.
Fuel level.


Indicates the quantity of fuel remaining
in the tank.

4.
Screen.


A.
Ambient temperature.


(°Celsius or °Fahrenheit)

B.
Gear
shift
indicator.


C.
Time.


D.
Engine oil level indicator.



Appears a few seconds after switching
on the ignition, then disappears.

E.
Trip computer.


F.
Service indicato

r.


(miles or km) then,
Total mileage.


These two functions are displayed
successively when switching on the
ignition.


Screen

1
24
MONITORING
INSTRUMENT PANELS FOR PETROL - DIESEL, MANUAL, ELECTRONIC OR AUTOMATIC GEARBOXES
Panel grouping together the vehicle operation indication dials and warning lamps.
Depending on the version, the instrument panel may have permanent back-lighting.

Dials



1.
Rev counter.

Indicates the speed of rotation of the
engine (x 1 000 rpm).

2.
Vehicle speed.

Indicates the current speed of the
moving vehicle (mph or km/h).

3.
Fuel level.

Indicates the quantity of fuel remaining
in the tank.

4.
Screen.

5.
Display management button

Alternates display between range
and trip mileage recorder.
Servicing information.
Resets the selected function to zero
(trip distance recorder or service in-
dicator).

6.
Instrument panel lighting button.

Adjusts the brightness of the lighting
of the instruments and controls.
For more information, refer to the
section on the button or function
and its associated display.

A.
Speed limiter

(mph or km/h) or
Cruise control.


B.
Gear shift indicator.


C.
Electronic
or
automatic gearbox
information.


D.
Range

(miles or km) or
Trip mileage recorder.


E.
Service indicator

(miles or km), then
Total mileage recorder

These two functions are displayed
successively when switching on the
ignition

F.
Engine oil level indicator

Appears a few seconds after switching
on the ignition, then disappears.


Screen

1
25
MONITORING
Indicator and warning lamps
Visual indicators informing the driver that a system is in operation (operation or
deactivation indicator lamps) or of the occurrence of a fault (warning lamp).

When the ignition is switched on
Certain warning lamps come on for a few seconds when the vehicle's ignition is
switched on.
When the engine is started, these same warning lamps should go off.
If they remain on, before moving off, refer to the information on the warning lamp
concerned.

Operation indicator lamps
If one of the following indicator lamps comes on, this confi rms that the corresponding
system has come into operation.
The warning lamps may come
on continuously (fi xed) or fl ash.
Certain warning lamps may
come on in two different modes.
Only by relating the type of illumi-
nation to the operating status of
the vehicle can it be ascertained
whether the situation is normal
or whether a fault has occurred.

Associated warnings
The illumination of certain warning lamps may be accompanied by an audible
signal and a message in the multifunction screen.


Warning lamp



is on



Cause



Action/Observations






Left-hand
direction
indicato

r


fl ashing with
buzzer. The lighting stalk is pushed
down.




Right-hand
direction
indicator


fl ashing with
buzzer. The lighting stalk is pushed
up.





Sidelamps


fi xed. The lighting stalk is in the
"Sidelamps" position.



Hazard
warning lamps

fl ashing with
audible signal.
The hazard warning lamps
switch, located on the
dashboard, has been operated. The left-hand and right-hand direction indicators
and their associated indicator lamps fl ash
simultaneously.

1
MONITORING




Front
foglamps


fi xed. The front foglamps are
switched on. Turn the ring on the stalk rearwards twice to
switch off the front foglamps.




Rear
foglamps


fi xed. The rear foglamps are
switched on. Turn the ring on the stalk rearwards to switch off
the rear foglamps.




Diesel engine
pre-heating


fi xed. The ignition switch is at the
2nd position (ignition on). Wait until the warning lamp goes off before
starting.
The period of illumination of the warning lamp is
determined by the climatic conditions (up to about
thirty seconds in extreme climatic conditions).
If the engine does not start, switch the ignition off
and then on, wait until the warning lamp goes off
again, then start the engine.






Parking brake


fi xed.
The parking brake is
applied or not properly
released. Release the parking brake to switch off the
warning lamp, keeping your foot on the brake
pedal.
Observe the safety recommendations.
For further information on the parking brake, refer
to the "Driving" section.



Dipped beam
headlamps


fi xed. The lighting stalk is in the
"Dipped beam headlamps"
position.




Main beam
headlamps


fi xed. The lighting stalk is pulled
towards you. Pull the stalk to return to dipped beam
headlamps.

Warning lamp



is on



Cause



Action/Observations

1
27
MONITORING



Stop & Start


fi xed. When the vehicle stops (red
lights, traffi c jams, ...) the
Stop & Start system has
put the engine into STOP
mode. The warning lamp goes off and the engine
restarts automatically in START mode, as soon
as you want to move off.

fl ashes for a
few seconds,
then goes off. STOP mode is temporarily
unavailable.
or
START mode is invoked
automatically. Refer to "Driving - § Stop & Start" for special
cases with STOP mode and START mode.



Passenger's
airbag
system
fi xed. The control switch, located
in the glove box, is in
the " ON
" position.
The passenger's front
airbag is activated.
In this case, do not install a
rear-facing child seat. Turn the control switch to the " OFF
" position
to deactivate the front passenger's airbag.
In this case you can install a rear-facing child
seat.



Engine
coolant
temperature


fi xed blue
. On starting the engine,
it indicates that the engine
is cold. After a few minutes driving, it swiches off to
indicate that the engine temperature is normal.
In order to protect your engine, avoid driving too
hard until the warning lamp has switched off.

Warning lamp



is on



Cause



Action/Observations

2
46
MULTIFUNCTION SCREENS

"Trip computer" menu

Once this menu has been selected, you
can consult information concerning the
status of the vehicle (warnings log, sta-
tus of functions, etc.)

Alert log
This summarises the active warning
messages, displaying them in succes-
sion on the multifunction screen.


"Personalisation-Configuration" menu


Defi ne the vehicle parameters
Once this menu has been selected, you
can activate or deactivate the following
equipment:


- wiper linked to reverse gear (refer to
the "Visibility" section),

- guide-me-home lighting and dura-
tion (see "Visibility" section),

- parking sensors (refer to the
"Driving" section).
)
In the "

Trip computer

"
menu, select
one of the following applications:




)
Press the "MENU"
button to gain
access to the general menu.

)
Press the arrows, then the "OK"
but-
ton to select the "

Trip computer

"

menu.
Once this menu has been selected, you
can gain access to the following func-
tions:


- defi ne the vehicle parameters,

- display confi guration,

- choice of language.


Status of functions
This summarises the status (active or
inactive) of the vehicle's functions.

Enter distance to destination
This allows you to enter an approximate
distance until your fi nal destination.