Page 116 of 140
11 4
FREQUENTLY ASKED QUESTIONS
QUESTIONANSWER SOLUTION
Traffi c announcement
TA is displayed. I donot receive any traffi c
information.Th
e radio station does not broadcast traffi c information. Tune to a radio station which broadcasts traffi c
information.
Th
e stored stations arenot found (no sound, 87.5 MHz is displayed...). An in
correct waveband is selected. Press the SRC/TEL button to return to thewaveband (FM1 or FM2) on which the stations arestored.
The CD is e
jected
automatically or is not played by the player. The CD is inserted upside down, is unpla
yable, does not contain any audio data or contains an audio format which the player cannot play.
The
CD is protected by an anti-pirating protection system which is not recognised by the audio equipment.
- Check that the CD is inserted in the pla
yer the
right way up.
-
Check the condition of the CD: the CD cannot
be played if it is too damaged.
-
Check the content in the case of a recordedCD: consult the advice in the "Audio" section.
- The audio equipment's CD pla
yer does not
play DVDs.
- Due to their qualit
y level, certain writeableCDs will not be played by the audio system.
The CD pla
yer sound ispoor.The CD used is scratched or of poor quality. Insert good quality CDs and store them in suitable conditions.
The audio settin
gs (bass, treble, ambience) are unsuitable. Set the treble or bass level to 0, without selectingan ambience.
Th
e Bluetooth connection
is cut. The battery of the peripheral may not be suffi ciently charged. Recharge the battery of the peripheral device.
The messa
ge "USB
device error" is displayedon the screen.The USB memor
y stick is not recognised.
The memor
y stick may be corrupt. Reformat the memor
y stick in FAT 16 or FAT 32.
Page 120 of 140
01
118
FIRST STEPS
With the ignition key in the accessories position or with the ignition on, press this button to switch the
audio equipment on or off.
You exit
from this mode automatically after a fewseconds without any action.
GENERAL FUNCTIONS
When the parameter is displayed, change thesetting using these two buttons.
Pr
ess this button several times in succession togain access to the bass (BASS)
, treble (TREB)
,
front / rear balance (FA D)and left / right balance(BAL) settings.
After the en
gine has been switched off, the audio equipmentcan only operate for approximately 30 minutes, to preventdischarging of the battery.
AUDIO SETTINGS
ON / OFF
Press the upper part o
f this button several times
in succession to increase the volume of theaudio system or the lower part of this button todecrease it.
VOLUME ADJUSTMENT
The audio s
ystem controls enable you to adjust the volume and the
audio settings.
T
o exit from the AUX
source, press AM/FM.
When using an MP3 player:
increase the volume of the radio signifi cantly (between 30 and 60) to obtain a satisfactory playing
volume.
In order to listen to it, connect
your equipment then press this button.
An auxiliary socket "AUX"
is provided for the connection of portable equipment (MP3 player, etc.).
AUXILIARY SOCKET
Page 122 of 140
02
120
RADIO
STATIONS
When the radio receives a station broadcasting in stereo it
automatically plays in stereo and the screen displays "ST". If thereception conditions deteriorate, the radio changes to mono and "ST"is no longer displayed. STEREO RECEPTION
Pr
ess this button. SELECTION OF THE RADIO SOURCE
Press the button successivel
y to select thewavebands FM1, FM2, FM3 and AM. SELECTION OF A WAVEBAND
Pr
ess this button twice to select the next station.
Press this button briefl
y to listen to each stationavailable on the FM waveband for three seconds.To stop the station scan, press this button again.
AUTOMATIC STATION SEARCH
I
f the traffi c information programme TAis selected, only stationswhich broadcast this type of programme are selected.
Press one of these two buttons briefl
y to increase or
decrease the frequency displayed respectively.
I
f you maintain the pressure on the button in thechosen direction, the frequency will be scannedcontinuously.
The scan stops when
you release the button. MANUAL STATION SEARCH
Page 123 of 140
02
121
Select the required station.
Pr
ess one of the buttons "1"
to "6"for more than 2 seconds.
An audible signal confi rms that the station has been preset. MANUAL STATION PRESETTING
Press this button.
Your audio equipment automatically presets the six strongest stations received on AMand FM
in your current location. These stations are stored on the
AMand FM3wavebands. The end of the search is signalled by two audible signals.
AUTOMATIC PRESETTING OF FM STATIONS(AUTOSTORE)
RADIO
If it was not possible to fi nd six stations the remaining memories remain empty: three dashes are displayed on the audio system screen for each empty memory.
RECALLING PRESET STATIONS
On each waveband, a brief press on one of the buttons "1"
to "6"
recalls the corresponding preset station.
RADIO RECEPTION
Your audio system will be subjected to phenomena which do not
affect domestic radio sets. Both MW/LW and FM reception are
subject to various forms of interference. This is no refl ection on the quality of the system but is due to the nature of the signals and the
way in which they are transmitted.
On MW/LW, interference may be noticed when passing under high
voltage power lines or bridges, or in tunnels.
On FM, interference may be the result of increasing distance from
the transmitter, defl ection of the signal by obstacles (mountains,
hills, buildings, etc) or of being in an area which is not covered by a
transmitter.
Page 124 of 140
02
122
This enables you to listen to stations which broadcast a type of programme which has a theme (NEWS, SPORTS, TALK, POP,CLASSICS). SEARCH BY TYPE OF PROGRAMME
(PTY)
Wh
en FM is selected, press this button:
-"no pty"is displayed,
- then press the button brie
fl y to select a programme.
A
fter a few seconds without any action, your selection is stored.
RADIO
RDS SYSTEM
The RDS (Radio Data System)enables you to continue listening
to the same station irrespective of the frequency that it uses in your current location. The radio continuously searches for the transmitter
which provides the best reception. USING THE AF
(ALTERNATIVE FREQUENCIES)FUNCTION ON THE FM WAVEBAND
Some stations, or
ganised in a network, broadcast regionalprogrammes in the various regions which they serve. The regional mode enables you to continue listening to the same programme.
REGIONAL MODE
(REG)
Press this button successively to activate or deactivate the function.
The screen will indicate:
-"AF"if the function is activated,
-
"AF REG"
if the function is activated at regional level,
-
"AF"fl ashing if the function is not available.
Page 125 of 140
02
123
Press this button successively to activate or deactivate the function.
On FM, the multifunction display will indicate:
-
"TP"or "TP EON": the radio transmits a
programme while awaiting the broadcasting of
traffi c information.
-"TA"or "TA EON": the programme transmitted by the radio is put on standby while awaitingthe broadcasting of traffi c information.
TRAFFIC INFORMATION PROGRAMME
(TA)
RADIO
If you wish to interrupt the transmission of a message, press this button again. EON SYSTEM
The volume o
f the traffi c information is independent of the volume of normal radio listening.
You can adjust it using the volume button, when the
TA
programmeis being transmitted.
The settin
g will be stored and will be used during subsequent message transmissions.
This s
ystem links stations which belong to the same network. Itpermits the transmission of traffi c information broadcast by a station
which belongs to the same network as the station to which you arelistening.
In order to benefi t from this, select the traffi c information
programme TA.
Page 127 of 140
03
125
AUDIO
Press this button to select the next track.
CD AND CD CHANGER (depending on equipment)
SELECTION OF A TRACK ON A CD
Pr
ess and hold one of these buttons for fast forwards or backwards play respectively.
The
fast play stops when the button is released. FAST PLAY
Pr
ess this button to return to the start of the current
track or to select the previous track. Pr
ess this button to listen to the start of each trackon the current CD. INTROSCAN
(SCAN)
Page 128 of 140
03
126
When a CD is inserted, printed face uppermost,play begins automatically.
I
f there is a CD in the player already, press this button. SELECTION OF THE CD SOURCE
The tracks on the CD will be played in a random order. Press thebutton again to return to normal play.
The random pla
y mode is deactivated when the audio system isswitched off.When the CD pla
yer is selected, press this button. RANDOM PLAY OF THE CD
(RAND)
CD
Press this button to eject the CD from the player. CD EJECT
The use of copied CDs ma
y cause faults.
Insert circular
CDs only. If
you wish to listen to the current track again, press
this button. To cancel the repetition, press the button again. REPEAT OF A TRACK ON THE CD
(RPT)
AUDIO
