2012 Citroen C1 fuel

30Access























Fuel tank
)
Open the fuel filler flap. )
Inser t the key in the filler cap, turn it slightly
to the left and then return to the right.
The key returns to its initial position and the filler cap is then unlocked.
Low fuel level

When the low fuel level is reached,
the last bar
flashes, accompanied byan audible signal.
You have approximately 5 litres remaining.In cer tain driving conditions and depending on
the engine, the distance which can be travelled
with the fuel remaining may be less than30 miles (50 km).
When the frequency of the flashing increases, you have approximately 3 litres remaining.)Unscrew the cap with the key.

)Hang the filler cap on the bracket, located
on the inner face of the filler flap.


A label affixed on the inside of the flap reminds you which type of fuel to use.
When you fill the fuel tank, do not continue after
the 3rd cut-off of the pump. This could cause
malfunctions.
The capacity of the fuel tank isapproximately 35 litres.)After filling the fuel tank, screw the cap
back on fully to the right until it clicks
thenclose the flap.
The fuel tank must be filled with theengine switched off.
f
If you run out of fuel, the emissioncontrol system warning lamp may come on in the instrument panel. It will go off
automatically after the engine has been started a few times.

2
31 Access
Quality of the fuel used for
petrol engines

The petrol engines are perfectly compatible
with E10 or E24 type petrol biofuels (containing10 % or 24 % ethanol), conforming to Europeanstandards EN 228 and EN 15376.
E85 type fuels (containing up to 85 % ethanol)
are reser ved exclusively for vehicles marketed for the use of this type of fuel (BioFlex
vehicles). The quality of the ethanol mustcomply with European standard EN 15293.
For Brazil only, special vehicles are marketed
to run on fuels containing up to 100 % ethanol(E10 0 type).

34Comfort






















Heating
1. Temperature adjustment
Turn the control from blue (cold) to red(hot) to adjust the temperature to suit your requirements.
2. Air fl ow adjustment
When the ignition is switched on, turn the control to obtain a flow of air which is sufficient
to ensure your comfort.
To maintain a certain level of comfort in thepassenger compar tment, avoid position 0whenever possible.
In position 0, a slight flow of air, due to themovement of the vehicle, can still be felt. Win
dscreen and side windows.


4. Rear screen demisting
With the engine running, press button 4
, the indicator lamp comes on.
The system demists the rear screen.
It is switched off by pressing control 4.

3. Air distribution adjustment
Footwells, diffusion grille and side
vents.
Di
ffusion grille and side vents.

Demisting and defrosting

To quickly demist or defrost the windscreen and side windows:


- set the air distribution to "Windscreen and side windows",

- place the temperature control 1
and the air
fl
ow control 2at maximum,

- close the side vents.
The air distribution can be adjusted byplacing the control in an intermediate
position.
Switch the system off as soon as you consider this necessary as a lower consumption of current reduces fuel consumption.
Windscreen, side windows and
f
ootwells.

Footwells.

36Comfort
Footwells.
4. Air recirculation / Air intake
The recirculation of interior air (control 4to the left) enables you to
isolate the passenger compartment
from exterior odours and smoke.

5. Air distribution adjustment

Windscreen and side windows.

Windscreen, side windows andfootwells.
Footwells, diffusion
grille and side
vents.
Di
ffusion grille and side vents.


6. Rear screen demisting
As soon as possible, move control 4
to the right
to the "Intake of exterior air" position to avoid
the risks of deterioration of the air qualit
y and misting of the windscreen and side windows. The intake of exterior air
(control 4
tothe right) enables you to prevent and eliminate misting of the windscreenand side windows. With the en
gine running, pressbutton 6
, the indicator lamp comes on.
The system demists the rear screen.
It is switched off by pressingbutton 6again.


Demisting and defrosting

To quickly demist or defrost the windscreen and side windows:


- set the air distribution to "Windscreen and side windows",

- place the temperature control 2
and the air
flow control 3at maximum,

- close the side vents,

- place the air intake control 4
in th
e "A ir
intake" position,

- sw
itch on the air conditioning by pressing button 1.
Switch the system off as soon as you consider this necessary as a lower consumption of current reduces fuel consumption.

The air distribution can be adjusted by placing the control in an intermediate position.
In a humid climate, use of the air recirculation may cause misting of thewindows.

9
73 Practical information
*
Fuses located behind the instrument panel. To change them, contact a CITROËN dealer or a qualified workshop.
FuseN°Rating(A)Functions
110Brake lamps - ABS - Electronic gearbox
225Central locking/unlocking - Remote control
320Rear screen demisting
47.5Rear lamps - Number plate lamps - Instrument panel - Screen - headlamp adjustment - LED daytime runninglamps - Sidelamps
57.5Diagnostic socket
67.5Electronic gearbox - Rear foglamp - ESP - LED daytime running lamps - Instrument panel - Rev counter
7-Not used
87.5
ABS/ESP - Power steering - Fan assembly
910Reversing lamps - Central locking/unlocking - Electric windows - Rear screen demisting - Speedometer -Air conditioning - Heating - Rev counter - Remote control
1020Front and rear wipers and screenwash
1115
Audio equipment - 12 V socket (120 W max)
127.5
Heated rear screen - ABS - Fan assembly - Front and rear wipers and screenwash - Power steering - Central
locking/unlocking - Air conditioning - Heating - Electric windows - Speedometer - Rev counter - Remote control -Reversing lamp
1315
Airbag - Fuel injection system - Electronic gearbox - Instrument panel - Rev counter - LED daytime running lamps
147.5 Air conditioning - Heating
15 *40
Audio system - 12 V socket - Front and rear wipers - Power steering - ABS/ESP - Cooling fan assembly
16 * 30Electric windows
17 *40
Air conditioning - Heating

9
75 Practical information
FuseN°Rating(A)Functions
15 LED daytime running lamps
220 Front foglamps
310
Left hand front lamp
410
Right hand front lamp
57.5
Electronic gearbox - Fuel injection system
67.5 Electronic gearbox - Fuel injection system


730
LED daytime running lamps - Front foglamps
825
ABS
30
ABS/ESP (with VSC)
930
Star ter motor - Heated rear screen - ABS -Cooling fan assembly - Front and rear wipersand screenwash - Power steering - Central locking/unlocking - Air conditioning - Heating -Electric windows - Speedometer - Revcounter - Remote control - Reversing lamp -
Airbag - Fuel injection system - Electronic gearbox - Instrument panel - LED daytime running lamps
FuseN°Rating(A)Functions
1010
Hazard warning lamps - Instrument panel -Rev counter - Direction indicators
1120
Left hand front lamp - Right hand front lamp
1215 Courtesy lamp - Speedometer - Audiosystem- Instrument panel - Rev counter
1315
Fuel injection system -Cooling fan assembly
1410
Horn
157.5
Replacement fuse
1610
Replacement fuse
1715
Replacement fuse
1850
Electronic gearbox
1930/40 Cooling fan assembly
20
40 ABS
50 ABS/ESP (with VSC)
2150 Power steering

11
89 Technical data








Engine
Engine
1.0 litre (≈ 68 hp)
Manual gearbox(5-speed)Electronic gearbox(5-speed)
Model codes PM, PNCFB0 / CFB4
CFB0/P

Cubic capacity (cc)
998

Bore x stroke (mm) 71 x 84

EU standard maximum power (kW)
50

Max power engine speed (rpm)
6 000


EU standard max torque (Nm)93

Max torque engine speed (rpm) 3 600


Fuel
Unleaded

Catalytic converter

Yes


Engine oil capacity (with filter replacement)
3.2

Technical data
92











Identifi cation markings


B. Vehicle Identifi cation Number.

This is engraved on the crossmember, under
the front right seat.
A. Manufacturer's plate.
1.
EU approval number. 2.
Vehic le Identification Number (VIN).3.
Gross vehicle weight.4.
Gross train weight.5.
Maximum weight on front axle.
6.Maximum weight on rear axle.7. Paint colour reference.



5-door



3-door


C. T
yres.

The label Caffixed to the pillar, near the left
door striker, indicates:


- the t
yre sizes,

- the t
yre pressures.
The tyre pressures must be checkedwhen cold, at least once a month.
If the tyre pressures are too low, this increases fuel consumption.