2012 Citroen C CROSSER steering

VIII
128
DIESEL ENGINE
Access for checking the levels of the various fl uids and the replacement of certain components.


1. Coolant reservoir.

2. Power steering fl uid reservoir.

3. Screenwash and headlamp wash
reservoir.

4. Brake fl uid reservoir.

5. Fusebox.

6. Battery.

7. Engine oil dipstick.

8. Engine oil fi ller cap.

9. Air fi lter.

VIII
CHECKS
129
CHECKING LEVELS
Brake fluid level
To avoid any risk of scalding, unscrew
the cap by two turns to allow the pres-
sure to drop. When the pressure has
dropped, remove the cap and top up
the level.

Oil level

The reading will only be correct
if the vehicle is on level ground
and the engine has been off for
more than 30 minutes.
The check is carried out either when
the ignition is switched on using the oil
level indicator on the instrument panel,
or using the dipstick.
It is normal to top up the engine oil between
services. The manufacturer recommends
that the oil level be checked, and topped up
if necessary, every 3 000 miles (5 000 km).
The brake fl uid level should be
between the "MAX" and "MIN"
marks.
If it is not, check the brake pad
wear.

Changing the brake fl uid
Refer to the servicing booklet for details
of the interval for this operation.


Coolant level

The coolant level must be mea-
sured when the engine is cold
and should be between the
"LOW" and "FULL" marks.
When the engine is warm, the
temperature of the coolant is regulated
by the fan. This can operate with the ig-
nition off.
On vehicles which are fi tted with a
particle emission fi lter, the fan may
operate after the vehicle has been
switched off, even if the engine is
cold.
In addition, as the cooling system is
pressurised, wait at least one hour after
switching off the engine before carrying
out any work.
Screenwash and headlamp
wash * fluid

Check the fl uid level regularly,
using the gauge.

*
According to country.
Changing the engine oil
Refer to the servicing booklet for details
of the interval for this operation.
In order to maintain the reliability of the
engine and emission control system,
the use of additives in the engine oil is
prohibited.

Oil specifi cation
The oil must correspond to your engine
and conform to the manufacturer's recom-
mendations.

Fluid specifi cation
The brake fl uid must conform to the
manufacturer's recommendations and
fulfi l the DOT4 standards.

Changing the coolant fl uid
Refer to the servicing booklet for details
of the interval for this operation.

Fluid specifi cation
The coolant must conform to the manu-
facturer's recommendations.


Fluid specifi cation
This fl uid must conform to the manufac-
turer's recommendations for optimum
cleaning.

Power steering fluid level

Check the fl uid level with the engine at
idle.
Check that the power steering fl uid
level is always between the "MAX" and
"MIN" marks and top up if necessary.

Fluid specifi cation
This fl uid must conform to the manufac-
turer's recommendations.
Check all of these levels regularly and
top them up if necessary, unless other-
wise indicated.
If a level drops signifi cantly, have the
corresponding system checked by a
CITROËN dealer or a qualifi ed work-
shop.
When working under the bonnet, take
care as certain areas of the engine may
be extremely hot (risk of burns).

IX
PRACTICAL INFORMATION
147

Dashboard fuses

The fuseboxes are placed in the lower
dashboard behind the enclosed storage
compartment (left-hand side).

Access to the fuses


)
Open the cover A
,

)
Pull it towards you to extract it,

)
Change the fuse (refer to the cor-
responding paragraph).

Fuse N°



Rating



Functions




1*



30 A

Heating.


2



15 A

Brake lamps, third brake lamp, built-in systems
interface.


3



10 A

Rear foglamps.


4



30 A

Windscreen wipers and screenwash.


5



10 A

Diagnostic socket.


6



20 A

Central locking, door mirrors.


7



15 A

Audio equipment, telematics, multifunction screen,
Bluetooth system.


8



7.5 A

Remote control key, air conditioning control unit,
instrument panel, switch panel, steering mounted
controls.


9



15 A

Multifunction screen, instrument panel.


10



15 A

Built-in systems interface.


11



15 A

Rear wiper.


12



7.5 A

Instrument panel, 4 wheel drive control unit,
air conditioning control panel, ABS control
unit, multifunction screen, automatic headlamp
adjustment, heated seats, airbag control unit,
steering wheel angle sensor, sunroof, rear screen
demisting, remote control.


13



-

Not used.


14



10 A

Ignition switch.


15



20 A

Sunroof.


16



10 A

Door mirrors, audio equipment, telematics.

IX
!
PRACTICAL INFORMATION
155

Towing another vehicle



)
On the rear bumper, remove the
cover by pulling at the bottom using
the jack handle 2
.

)
Screw in the towing eye fully using
the wheelbrace 3
.

)
Install the towbar.

)
Switch on the hazard warning lamps
on the towed vehicle.
When being towed with the en-
gine off, there is no longer any
braking or steering assistance.


General recommendations

Observe the legislation in force in your country.
Ensure that the weight of the towing vehicle is higher than that of the towed
vehicle.
The driver must stay at the wheel of the towed vehicle.
Driving on motorways and fast roads is prohibited when towing.
When towing a vehicle with all four wheels on the ground, always use an ap-
proved towing bar; rope and straps are prohibited.
When towing a vehicle with the engine off, there is no longer any power assis-
tance for braking or steering.
In the following cases, you must always call on a professional recovery service:


- vehicle broken down on a motorway or fast road,

- when it is not possible to put the gearbox into neutral, unlock the steering,
or release the parking brake,

- towing with only two wheels on the ground,

- where there is no approved towing bar available...

XI
166
AUDIO and TELEMATICS
STEERING MOUNTED CONTROLS




1.
On/Off and selection of

radio or
CD mode


2.
Volume decrease


3.
Volume increase


4.

Search for a higher radio frequency/
Next track/Fast forwards play


5.

Search for a lower radio frequency/
Previous track/Fast backwards play



Switching off

Press button 1
for more than two seconds.


Selecting the source
Press button 1
.

The source changes in the following order: FM1/FM2/FM3/MW/LW/CD/FM1...
Searching in radio mode
Press button 4
or 5
to search for a
higher or lower radio frequency respec-
tively.

Searching in CD mode
Press button 4
or 5
to select the next or
previous track on the CD respectively.
Press and hold button 4
or 5
for fast for-
wards or fast backwards playing of the
current track of the CD respectively.
Switching on

Press button 1
for more than two seconds.

The last source selected before switching
off comes back into operation.

Adjusting the volume
Press and hold button 2
or 3
to decrease
or increase the volume respectively. While a track is being played, press
button 5
once to return to the beginning
of this track.

They can be used when the ignition
switch is in the "ON" or "ACC" position.

XI
216
AUDIO and TELEMATICS

What is the Bluetooth®
hands-free telephone with
voice recognition?

The system uses wireless
communication technology
referred to as Bluetooth
®
which allows you to make
hands-free telephone calls
in your vehicle via your
Bluetooth
® compatible mo-
bile telephone.
You can make telephone calls using
a microphone located in the courtesy
lamp, making use of the simple steering
mounted controls or by the voice rec-
ognition function with voice commands.
Five languages are available: English
(by default), Spanish, French, German
and Italian.
SPEAK
Pressing activates the voice recognition ("Listening" is displayed).
During voice recognition, a brief press pauses this recognition.
An extended press deactivates the recognition.
A brief press will activate the recognition even if a telephone call is progress. Decrease the audio volume.
PICK UP
Press to answer an incoming call.
If a second incoming call is received,
press this button to place the fi rst
call on hold and speak to the second
caller.
In this case, a brief press switches
between callers.
To establish a three-way conver-
sation, press the SPEAK button to
switch to voice recognition mode and
say "Incorporate the call".
HANG UP
Press to reject an incoming call.
During a call, pressing ends this call.



General notes

Increase the audio volume. Audio system on/off.
HANDS-FREE TELEPHONE

227
VISUAL SEARCH
STEERING MOUNTED CONTROLS


Lighting ........................................ 86-88


- dipped beam headlamps,

- main beam headlamps,

- foglamp.

Automatic illumination of headlamps .....88
Headlamp wash .................................90

Audio system controls .............166, 178

Telephone controls ..........................216
Wipers ......................................... 90-91
Screenwash ................................. 90-91

Cruise control .......................... 121-122

Steering wheel, adjustment ...............63
Horn .................................................102
Airbags ..................................... 108-111

Headlamp adjustment........................89
Parking sensors ....................... 123-124
ASC .................................................104

229
VISUAL SEARCH

TECHNICAL DATA - MAINTENANCE


Checking the levels ................. 129-131


- fuel supply,

- dipstick,

- power steering fl uid,

- brake fl uid,

- coolant.


Screen/headlamp wash,
fi lling reservoir ......................... 127-129

Bulbs........................................ 137-145
Changing bulbs........................ 137-145
Engine technical data ......................159
Weights, loads .................................160
Dimensions ......................................161
Identifi cation markings .....................162

Opening the bonnet, stay ................126
Underbonnet view.................... 127-128
Air/oil fi lters, checks ................. 129-131
Fuses ....................................... 146-150

Battery ..................................... 151-152