2012 Alfa Romeo MiTo transmission

GETTING TO KNOW YOUR CAR123
1
RADIO TRANSMITTERS AND CELLULAR PHONES
Radio transceiver equipment (vehicle mobile phones, CB radios,
amateur radio and similar equipment) shall not be used inside
the car unless a separate aerial is mounted on the roof.
IMPORTANT The use of these devices inside the passenger com-
partment (without a separate aerial) may cause the vehicle elec-
trical systems to malfunction. This could compromise safety in ad-
dition to constituting a potential hazard for passengers.
In addition, transmission and reception of these devices may be af-
fected by the shielding effect of the car body. With regards to the
use of EC-approved mobile phones (GSM, GPRS, UMTS), adhere
strictly to the instructions for use provided by the mobile phone
manufacturer.
PARKING SENSORS
(for versions/markets, where provided)
The parking sensors are located in the rear bumper fig. 80 and their
function is to inform the driver, through an intermittent buzzer, of
the presence of obstacles behind the car.
ACTIVATION
The sensors are activated by engaging reverse gear. As the distance
from the obstacle behind the car decreases, the acoustic alarm
becomes more frequent.
fig. 80A0J0088m

188IN AN EMERGENCY
If the fuse blows again contact an Alfa Romeo
Authorised Services.
Never replace a blown fuse with anything other
than a new fuse.
Under no circumstances should a fuse be replaced
with one of a higher amperage; FIRE RISK.
If a general protection fuse for safety systems
(air bag system, braking system), power unit sys-
tems (engine system, transmission system) or
steering system is triggered, contact Alfa Romeo Autho-
rized Services.
If a general protection fuse blows contact an Alfa
Romeo Authorised Services.
Before replacing a fuse, make sure you have re-
moved the key from the ignition and have turned
off and/or unplugged all energy-consuming
devices.
If a general protection fuse (MEGA-FUSE, MIDI-
FUSE, MAXI-FUSE) is activated, contact an Alfa
Romeo Authorised Services.

CARE AND MAINTENANCE207
5
PERIODIC CHECKS
Every 1,000 km or before long journeys, check and top up the fol-
lowing if necessary:
❍engine coolant level, brake fluid and windscreen washer fluid
❍tyre pressure and condition;
❍operation of lights (headlights, direction indicators, hazard
lights, etc.);
❍operation of the windscreen wiper/washer system, position
and wear of windscreen/rearscreen wiper blades;
Every 3,000 km check the following and top-up, if necessary: en-
gine oil level.
We recommend the use of PETRONAS LUBRICANTS products, de-
signed and produced specifically for Alfa Romeo cars (see “Con-
sumables” table in chapter 6).
DEMANDING USE OF THE CAR
If you use the vehicle mainly under one of the following conditions:
❍trailer or caravan towing;
❍dusty roads;
❍repeated short distances (less than 7-8 km) and with exter-
nal temperatures below zero;
❍frequently idling the engine, travelling long distances at low
speeds or long term inactivity;
❍in cities;
perform the following inspections more frequently than shown on
the Scheduled Servicing Plan:
❍check front disc brake pad condition and wear;
❍check cleanliness of bonnet and boot locks, and cleanliness and
lubrication of linkages;
❍visually inspect the condition of: engine, gearbox, transmission,
pipes and hoses (exhaust – fuel supply - brakes) rubber ele-
ments (gaiters – hoses - bushes etc.);

Identification data .................................................................... 228
Engine codes - bodywork versions............................................... 230
Engine................................................................................... 231
Fuel system ............................................................................ 234
Transmission ........................................................................... 234
Brakes.................................................................................... 235
Suspension ............................................................................. 235
Steering ................................................................................. 235
Wheels .................................................................................. 236
Dimensions ............................................................................. 240
Performance ........................................................................... 241
Weights ................................................................................. 242
Consumables .......................................................................... 244
Fluids and lubricants ................................................................. 246
Fuel consumption.................................................................... 248
CO
2emissions ......................................................................... 249
6
TECHNICAL DATA227

234TECHNICAL DATA
FUEL SYSTEM
TRANSMISSION
Modifications or repairs to the fuel feed system that are not carried out properly or do not take the system’s tech-
nical specifications into account can cause malfunctions leading to the risk of fire.
Five forward gears plus reverse with synchronisers
for forward gears
Self-adjusting with pedal without idle stroke
FrontSix forward gears plus reverse with synchronisers
for forward gears
Self-adjusting with pedal without idle stroke
Front
Phased sequential
electronic
Multipoint injection
with detonation controlElectronically-controlled
Multipoint phased
sequential electronic
injection with turbo
and intercoolerPhased electronic
sequential injection with
detonation control and
variable activation
of intake valvesMultijet “Common Rail”
direct electronic injection
with turbo
and intercooler
1.4 Multi Air 1.4 Petrol 1.4 Turbo Petrol 1.3 JTDM-2- 1.6 JTDM
1.4 Turbo Multi Air
Fuel system
1.4 Turbo Multi Air 1.4 Multi Air - 1.4 Petrol
1.4 Turbo Petrol 120HP - 1.3 JTD
M-21.4 Turbo Petrol 155HP
1.4 Turbo Multi Air 170HP Quadrifoglio Verde
1.6 JTDM
Gearbox
Clutch
Drive

Unleaded petrol not less
than 95 R.O.N
(Specification EN228)
Mixture of 50% demineralised water
and 50% PARAFLU
UP(▲)
SELENIA StAR P.E.
TUTELA CAR TECHNYX
(1.4 Petrol, 1.4 Multi Air, 1.4 Turbo
Petrol,1.4 Turbo Multi Air 135HP,
1.3 JTD
M-2versions)
TUTELA CAR MATRYX
(1.4 Turbo Petrol 155HP versions)
TUTELA TRANSMISSION GEARFORCE
(1.4 Turbo Multi Air 170HP,
1.6 JTD
Mversions)
TUTELA TOP 4
Mixture of water and fluid
TUTELA PROFESSIONAL SC 35
45 –
5 - 7 –
6.0 –
3.1 2.65
3.5 3.0
1.87 1.7
–0.5
2.2
(4.5) –
CONSUMABLES
(▲) When the vehicle is used under particularly harsh climate conditions, we recommend using a 60-40 mixture of PARAFLUUPand demineralised water
(***) Values in brackets refer to versions with headlight washer
45 –
5 - 7 –
5.2 –
2.75 2.4
2.9 2.6
1.6 –
–0.5
2.2
(4.5) –45 –
5 - 7 –
5.2 –
3.1 2.65
3.4 2.9
1.6 –
–0.5
2.2
(4.5) –
244TECHNICAL DATA
1.4 Multi Air 1.4 Turbo Multi Air1.4 Petrol Recommended fuels
and original lubricants
litres kg litres kg litres kg
Fuel tank:
including a reserve of:
Engine cooling system– with climate control:
Engine sump:
Engine sump
and filter:
Gearbox/differential casing:
Hydraulic brake circuit withABS system
Windscreen/rearscreen
headlight washer
reservoir: (***):

45 ()–
5 - 7 –
5.7 –
4.3 3.8
4.6 4.0
1.87 1.7
–0.5
3
(6) –Unleaded petrol not less
than 95 R.O.N
(Specification EN228)
(
) Diesel fuel for motor vehicles
(Specification EN590)
Mixture of 50% demineralised water
and 50% PARAFLU
UP(▲)
SELENIA StAR P.E. (petrol versions)
SELENIA WR P.E. (diesel versions)
TUTELA CAR TECHNYX
(1.4 Petrol, 1.4 Multi Air, 1.4 Turbo
Petrol,1.4 Turbo Multi Air 135HP,
1.3 JTD
M-2versions)
TUTELA CAR MATRYX
(1.4 Turbo Petrol 155HP versions)
TUTELA TRANSMISSION GEARFORCE
(1.4 Turbo Multi Air 170HP,
1.6 JTD
Mversions)
TUTELA TOP 4
Mixture of water and fluid
TUTELA PROFESSIONAL SC 35
TECHNICAL DATA245
6
45 ()–
5 - 7 –
7.2 –
3.0 2.7
3.2 2.9
1.8 –
–0.5
3
(6) –45 –
5 - 7 –
6.0 –
2.75 2.4
3.3 2.95
2.0 –
–0.5
2.2
(4.5) –
(▲) When the vehicle is used under particularly harsh climate conditions, we recommend using a 60-40 mixture of PARAFLUUPand demineralised water
(***) Values in brackets refer to versions with headlight washer
1.4 Turbo Petrol1.3 JTDM-21.6 JTDMRecommended fuels
and original lubricants
litres kg litres kg litres kg
Fuel tank:
including a reserve of:
Engine cooling system– with climate control:
Engine sump:
Engine sump
and filter:
Gearbox/differential casing:
Hydraulic brake circuit withABS system
Windscreen/rearscreen
headlight washer
reservoir: (***):

Manual gearboxes and
differentials (only 1.4 Petrol, 1.4
Multi Air, 1.4 Turbo Petrol 120HP,
1.4 Turbo Multi Air 135 HP,
1.3 JTD
M-2, versions)
Manual gearbox and differentials
(1.4 Turbo Petrol 155HP
versions)
Manual gearbox and differentials
(1.4 Turbo Multi Air 170 HP
Quadrifoglio verde, 1.6 JTD
Mversions)
Constant velocity joints
differential-side
Constant velocity joints
wheel-side
Hydraulic brakes and
hydraulically operated
clutches
Cooling circuits
proportions of use:
50% water
50% PARAFLU
UP(❑)
To be mixed with diesel
(25 cc per 10 litres)
To be used diluted or
undiluted in windscreen/
rear window washer/
wiper systems
TUTELA CAR TECHNYX
Contractual Technical
Reference N° F010.B05
TUTELA CAR MATRYX
Contractual Technical
Reference N°F108.F02
TUTELA TRANSMISSION GEARFORCE
Contractual Technical
Reference N°F002.F10
TUTELA STAR 700
Contractual Technical
Reference N°F701.C07
TUTELA ALL STAR
Contractual Technical
Reference N°F702.G07
TUTELA TOP 4
Contractual Technical
Reference N°F001.A93
PARAFLU
UP(●)
Contractual Technical
Reference N°F101.M01
TUTELA DIESEL ART
Contractual Technical
Reference N°F601.L06
TUTELA
PROFESSIONAL SC 35
Contractual Technical
Reference N° F201.D02
TECHNICAL DATA247
6
Synthetic-based oil, grade SAE 75W-85.
Passes API GL-4 specifications
FIAT 9.55550-MX3 qualification
Synthetic-based oil, grade SAE 75W-85.
Passes API GL-4 specifications
FIAT 9.55550-MZ1 qualification
Synthetic-based oil, grade SAE 75W.
FIAT 9.55550-MZ6 qualification
Grease for constant velocity joints with low
friction coefficient. Consistency N.L.G.I. 0-1.
FIAT 9.55580 qualification
Molybdenum disulphide grease, for use at
high temperatures. Consistency N.L.G.I. 1-2.
FIAT 9.55580 qualification
Synthetic fluid for braking and clutch systems
Exceeds specifications: FMVSS n
°116 DOT 4, ISO 4925,
SAE J 1704. FIAT 9.55597 qualification
Inhibited mono ethylene glycol-based antifreeze protection,
red, with organic formulation.
Passes CUNA NC 956-16, ASTM D 3306 specifications.
Additive for diesel fuel protecting Diesel engines.
Mixture of alcohols and surfactants.
Exceeds CUNA NC 956-11 specification.
FIAT 9.55522 qualificationBrakes
Fluid
Protective
for radiators
Additive for
diesel
Fluid for
windscreen/
rearscreen/
headlight washer Lubricants and
grease for drive
transmission
system
Use Fluid qualitative specifications and lubricants Fluids and lubricants Applicationsfor correct vehicle operation original
(●) IMPORTANT Don’t use fluids with different specifications for topping up or mixing.
(❑) When the vehicle is used under particularly harsh climate conditions, we recommend using a 60-40 mixture of PARAFLUUPand demineralised water.