2012 ACURA RL instrument panel

Pull to the side of the road when it is
saf e, shif t to Park, and let the engine
idle until the indicator goes out. This indicator normally comes on f or
a f ew seconds when you turn the
ignition switch to the ON (II)
position.
This indicator has two f unctions:
If it comes on while driving, it
indicates that one or more of your
vehicle’s tires are signif icantly low
on pressure.
Check the tire pressure monitor on
the multi-inf ormation display and
determinethecause(seepage ). You will also see a ‘‘CHECK TIRE
PRESSURE’’ message on the multi-
inf ormation display (see page ).
If this happens, pull to the side of the
road when it is saf e, check which tire
has lost pressure on the multi-
inf ormation display, and determinethe cause. If it is because of a flat tire,
have the flat tire repaired as soon as
possible. If two or more tires are
underinf lated, call a prof essional
towing service. For more
inf ormation, see page .
If this indicator begins to f lash,
there is a problem with the tire
pressure monitoring system
(TPMS). You will also see a
‘‘CHECK TPMS SYSTEM’’
message on the multi-inf ormation
display. The indicator continues to
f lash f or a while (approximately 1
minute), then stays on. If this
happens, have your dealer check
the system as soon as possible.
For more inf ormation, see page
. 1.2.
431
431433521
Instrument Panel Indicators
Low Tire Pressure/
TPMS Indicator
Inst rument s and Cont rols
67
Continuing to drive with the SH-AWD
indicator blinking may cause serious
damage to the system.
11/07/20 18:08:40 31SJA670_072
ProCarManuals.com

This indicator comes on when there
is a system message on the multi-
inf ormation display. Press the INFO
button on the steering wheel (see
page ) to see the message (see
page ).
Most of the time, this indicator
comes on along with other indicators
in the instrument panel such as the
seat belt reminder indicator, SRS
indicator, VSA system indicator, etc. The indicator comes on when you
run the engine while the vehicle is
not moving. To turn the indicator of f ,
restart the engine. This indicator normally comes on
when you turn the ignition to the ON
(II) position and goes of f af ter the
engine starts. If it comes on at any
other time, there is a problem with
the Power Steering system. You will
also see a ‘‘CHECK POWER
STEERING SYSTEM’’ message on
the multi-information display. If this
happens, stop the vehicle in a saf e
place, and turn of f the engine. Reset
the system by restarting the engine,
and watch this indicator. If it does
not go of f , or comes back on again
while driving, take the vehicle to
your dealer to have it checked. With
the indicator on, the ECPS is turned
of f , which could make the vehicle
harder to steer.This indicator normally comes on f or
a f ew seconds when you turn the
ignition switch to the ON (II)
position. If it comes on at any other
time, it indicates that there is a
problem with the system. You will
also see a ‘‘CHECK KEYLESS
ACCESS SYSTEM’’ message on the
multi-inf ormation display. For more
inf ormation, see page .71
78
180
Instrument Panel Indicators
Message Indicator Electronically Controlled
Power Steering System
(ECPS) Indicator
K eyless Access System
Indicator
68
11/07/20 18:08:48 31SJA670_073
ProCarManuals.com

This indicator comes on when the
security system is set. For more
inf ormation, see page . This indicator normally comes on f or
a f ew seconds when you turn the
ignition switch to the ON (II)
position.
Itcomesonasareminderthatyou
have turned off the adaptive front
lighting system (AFS).
This indicator blinks when there is a
problem with the AFS system; you
will also see a ‘‘CHECK ADAPTIVE
FRONT LIGHTING SYSTEM’’
message on the multi-inf ormation
display (see page ). If this
happens, stop the vehicle in a saf e
place, turn the ignition switch to the
ACCESSORY (I) or the LOCK (0)
position, and restart the engine. If
the indicator does not go of f or
blinks again, take your vehicle to a
dealer to have it checked. For more
inf ormation, see page .The CMBS indicator also comes on
if dirt or other debris blocks the
radar sensor in the f ront grille. You
will also see a ‘‘CHECK CMBS
RADAR SENSOR’’ message on the
multi-inf ormation display. When you
clean the radar sensor, the indicator
should go of f the next time you turn
the ignition switch to the ON (II)
position.
If the indicator comes on at any
other time, there is a problem with
the CMBS. You will also see a
‘‘CHECK CMBS SYSTEM’’ message
on the multi-information display. If
this happens, take your vehicle to a
dealer, and have it checked. For
more inf ormation, see page .
When this indicator is on, the CMBS
is not working. This indicator normally comes on f or
a f ew seconds when you turn the
ignition switch to the ON (II)
position. It also comes on as areminder that you have turned of f
the collision mitigation braking
system (CMBS ).
144315
144
424
If equipped
If equipped
A daptive Front L ighting
System (A FS) IndicatorSecurity System Indicator
Collision Mitigation
Braking System
(CMBS ) Indicator
Instrument Panel Indicators
Inst rument s and Cont rols
69
SECURITY SYSTEM INDICATOR
TM
TMTM TM
11/07/20 18:08:59 31SJA670_074
ProCarManuals.com

ÛÝThe multi-inf ormation display in the
instrument panel displays various
inf ormation and messages when the
ignition switch is in the ON (II)
position. Some of the messages help
you operate your vehicle more
comf ortably. Others help to keep
you aware of the periodic
maintenance your vehicle needs f or
continued trouble-f ree driving.
You can change the display and
customize your vehicle control
settings by pressing the SEL/RESET
or INFO buttons on the right side of
the steering wheel.
With the ignition switch in the ON
(II) position, the lower part of the
multi-inf ormation display changes as
shown in the illustration, each time
you press the SEL/RESET button. When you open the driver’s door, a
‘‘Welcome’’ message is shown on the
multi-inf ormation display. When you
turn the ignition switch from the ON
(II) position to the ACCESSORY (I)
position, a ‘‘Goodbye’’ message is
shownonthedisplay.
Multi-Inf ormation Display
Inst rument s and Cont rols
71
U.S.
SEL RESET BUTTON INFO ( / ) BUTTONS
Canada
11/07/20 18:09:13 31SJA670_076
ProCarManuals.com

Î
Î ÎÎ
Î
Î Î Î
Î
Î
Î
ÎTo use the horn, press the center pad of the steering wheel.
On models with navigation system, refer to the navigation system manual.
If equipped. Canadian models only 1:
2:
3:
4:
Controls Near the Steering Wheel
136
MIRROR CONTROLS VEHICLE STABILITY ASSIST (VSA)
SYSTEM OFF SWITCH PADDLE SHIFTERS
ADAPTIVE FRONT LIGHTING
SYSTEM (AFS) OFF SWITCH (P.140, 142)(P.137)
CRUISE CONTROL
BUTTONS
FRONT SEAT HEATER
SWITCHES (P.145)(P.146)
DISTANCE BUTTON
(P.161) (P.407)
(P.436)
HEADLIGHT WASHER
BUTTON(P.138)
REMOTE AUDIO
CONTROLS(P.182)/ HEADLIGHTS/
TURN SIGNAL/
FOG LIGHTSINSTRUMENT
PANEL BRIGHTNESS
(P.146)WINDSHIELD
WIPER/WASHERHAZARD WARNING BUTTON
(P.162)
ADAPTIVE CRUISE
CONTROL (ACC)
BUTTONS
FRONT SEAT HEATER AND
SEAT VENTILATION
BUTTONS
STEERING WHEEL
ADJUSTMENTS(P.148)BLUETOOTH HANDSFREELINK
VOICE CONTROL BUTTONS(P.354)VOICE CONTROL BUTTONS(P.328, 333) (P.278)
(P.304)HORN
(P.183) MULTI INFORMATION
DISPLAY BUTTONS(P.71) (P.319, 324) PASSENGER AIRBAG
OFF INDICATOR(P.35)
REAR WINDOW
DEFOGGER BUTTON
(P.147)/
HEATED MIRROR
BUTTON
(P.316)/ COLLISION MITIGATION
BRAKING SYSTEM (CMBS)
OFF BUTTON(P.423)
4
4 24
4
3 1 4
11/07/20 18:16:56 31SJA670_141
ProCarManuals.com

µ
µ
µ Push down on the
lever to signal a lef t turn and up to
signal a right turn. To signal a lane
change, push lightly on the lever,
and hold it. The lever will return to
center when you release it or
complete a turn.
The rotating switch
on the lef t lever controls the lights.
Turning this switch to the ‘‘ ’’
position turns on the parking lights,
taillights, instrument panel lights,
side-marker lights, and rear license
plate lights.
Turning the switch to the ‘‘ ’’
position turns on the headlights. If
you leave the lights on with the
ignition switch released af ter turned
to the LOCK (0) position or when
the built-in key is removed f rom the
ignition switch, you will hear a
reminder chime when you open the
driver’s door.When the light switch is in the
‘‘ ’’ or ‘‘ ’’ position, the
lights on indicator comes on as a
reminder. This indicator stays on if
you leave the light switch on and
turn the ignition switch to the
ACCESSORY (I) or the LOCK (0)
position.
To switch f rom low
beams to high beams, push the lef t
lever f orward until you hear a click.
The blue high beam indicator will
come on (see page ). Pull it back
to return to low beams. To flash the
high beams, pull the lever back
lightly, then release it. The high
beamsstayonaslongasyouhold
the lever back. Turn Signal
Of f
Parking and instrument panel
AUTO
Headlights on
High beams
Flashhighbeams
Fog lights of f
Fog lights on65 1.
2.
3.
4.
5.
6.
7.
8.
9.Turn Signal
Headlights
High Beams
Turn Signals and Headlights
140
11/07/20 18:17:25 31SJA670_145
ProCarManuals.com

µ
The automatic lighting f eature is
controlledbyasensorlocatedontop
of the dashboard. Do not cover this
sensor or spill liquids on it. Even with the automatic lighting
f eature turned on, we recommend
thatyouturnonthelightsmanually
when driving at night or in a dense
f og, or when you enter dark areas
such as long tunnels or parking
f acilities. To turn on automatic lighting, turn
the light switch to AUTO. The lights
will come on automatically when the
outside light level becomes low (at
dusk, f or example). The lights on
indicator comes on as a reminder.
The lights and indicator will turn of f
automatically when the system
senses high ambient light.To change the ‘‘AUTO LIGHT
SENSITIVITY’’ setting, see page
. The automatic lighting
f eature turns on the headlights, all
other exterior lights, and the
instrument panel lights when it
senses low ambient light.
The lights will remain on when you
turn of f the ignition switch. They will
turn of f automatically when you open
and close the driver’s door. To turn
them on again, either turn the
ignition switch to the ON (II)
position or turn the light switch to
the position.Do not leave the light switch in
AUTO if you will not be driving the
vehicle f or an extended period (a
weekormore).Youshouldalsoturn
of f the lights if you plan to leave the
engine idling or of f f or a long time.120 AUTO
Turn Signals and Headlights
Inst rument s and Cont rols
141
LIGHT SENSOR
11/07/20 18:17:33 31SJA670_146
ProCarManuals.com

This f eature turns of f the headlights,
all other exterior lights, and the
instrument panel lights within 15
seconds after you turn the ignition
switch to the LOCK (0) position and
close the driver’s door.
To change the ‘‘HEADLIGHT AUTO
OFF TIMER’’ setting, see page .
The automatic lighting of f f eature
activates if you leave the headlight
switch in the ‘‘ ’’ or ‘‘ ’’
position or if the lights are turned on
by setting the switch in the ‘‘AUTO’’
position, turn the ignition switch to
the LOCK (0) position, then open
and close the driver’s door.If you turn the ignition switch to the
LOCK (0) position with the
headlight switch on, but do not open
the door, the lights turn of f af ter 10
minutes (3 minutes, if the switch is
in the ‘‘AUTO’’ position).
The lights turn on again when you
unlock or open the driver’s door.
If you unlock the door, but do not
open it within 15 seconds, the lights
go of f . With the driver’s door open,
you will hear a lights-on reminder
chime. 118 Automatic Lighting Of f Feature
Turn Signals and Headlights
Inst rument s and Cont rols
143
11/07/20 18:17:47 31SJA670_148
ProCarManuals.com