2011 YAMAHA YFM350R-W turn signal bulb

Checking and lubricating the brake and
shift pedals ............................................. 8-32
Checking the wheel bearings ................... 8-32
Lubricating the swingarm pivots ............... 8-32
Lubricating the rear suspension relay arm
and connecting arm pivoting points ........ 8-33
Lubricating the upper and lower arm
pivots ...................................................... 8-34
Lubricating the steering shaft ................... 8-35
Battery ...................................................... 8-35
Replacing a fuse ...................................... 8-37
Headlight bulb .......................................... 8-38
Headlight beam ........................................ 8-38
Replacing the tail/brake light bulb ............ 8-38
Replacing a turn signal light bulb ............. 8-38
Replacing the license plate light bulb ....... 8-39
Auxiliary light bulb .................................... 8-40
Removing a wheel .................................... 8-40
Installing a wheel ...................................... 8-41
Troubleshooting ....................................... 8-42
Troubleshooting chart .............................. 8-43
CLEANING AND STORAGE .......................... 9-1
Cleaning ..................................................... 9-1
Storage ....................................................... 9-2SPECIFICATIONS .......................................10-1
CONSUMER INFORMATION.......................11-1
Identification numbers ...............................11-1
U10P60E0.book Page 3 Thursday, June 15, 2006 4:19 PM

8-38
8
EBU28160Headlight bulb If the headlight bulb burns out, have a Yamaha
dealer replace it.EBU28170Headlight beam If a headlight beam adjustment is necessary, have
a Yamaha dealer perform it.EBU25600Replacing the tail/brake light bulb If the tail/brake light bulb burns out, replace it as
follows.
1. Remove the lens by removing the screws.2. Remove the defective bulb by pushing it in
and turning it counterclockwise.
3. Insert a new bulb into the socket, push it in,
and then turn it clockwise until it stops.
4. Install the lens by installing the screws.
CAUTION:ECB00700Do not overtighten the screws, otherwise thelens may break.EBU28030Replacing a turn signal light bulb 1. Remove the turn signal light lens by removing
the screw.
1. Screw
1. Tail/brake light bulb
U10P60E0.book Page 38 Thursday, June 15, 2006 4:19 PM

10-4
10
Front suspension:Type:
Double wishbone
Spring/shock absorber type:
Coil spring/oil damper
Wheel travel:
200 mm (7.9 in)Rear suspension:Type:
Swingarm (link suspension)
Spring/shock absorber type:
Coil spring/gas-oil damper
Wheel travel:
210 mm (8.3 in)Electrical system:Ignition system:
DC. CDI
Charging system:
AC magnetoBattery:Model:
YTZ10S
Voltage, capacity:
12 V, 8.6 AhHeadlight:Bulb type:
Halogen bulbBulb voltage, wattage x quantity:Headlight:
12 V, 35.0/35.0 W × 1Tail/brake light:
12 V, 5.0/21.0 W × 1
Front turn signal light:
12 V, 10.0 W
Rear turn signal light:
12 V, 10.0 W
Auxiliary light:
12 V, 5.0 W
License plate light:
12 V, 5.0 W
Neutral indicator light:
12 V, 1.7 W × 1
High beam indicator light:
LED
Turn signal indicator light:
LED
Reverse indicator light:
12 V, 1.7 W × 1
Fuses:Main fuse:
15.0 A
Signaling system fuse:
7.5 A
U10P60E0.book Page 4 Thursday, June 15, 2006 4:19 PM

License plate light bulb, replacing ................................ 8-39
Light switch .................................................................... 4-4MMain switch .................................................................... 4-1
Model label ................................................................... 11-1NNeutral indicator light ..................................................... 4-2OOwner’s manual and tool kit ........................................... 8-1PParking ........................................................................... 6-7
Parking brake free play, adjusting ................................ 8-24
Parking brake lever ........................................................ 4-7
Parking on a slope ......................................................... 6-8
Part locations ................................................................. 3-1
Periodic maintenance and lubrication chart ................... 8-3
Pre-operation check list .................................................. 5-1RReverse indicator light .................................................... 4-2
Riding your ATV ............................................................. 7-1SSafety information .......................................................... 1-1
Seat .............................................................................. 4-14
Shifting ........................................................................... 6-4
Shift pedal ...................................................................... 4-8
Shock absorber assemblies, adjusting the front .......... 4-14
Shock absorber assembly, adjusting the rear .............. 4-16
Spark arrester, cleaning ............................................... 8-16
Spark plug, checking ...................................................... 8-8
Specifications ............................................................... 10-1
Speed limiter .................................................................. 4-5
Speedometer .................................................................. 4-2Starter (choke) ............................................................. 4-12
Start switch ..................................................................... 4-3
Steering lock ................................................................ 4-13
Steering shaft, lubricating ............................................. 8-35
Storage ........................................................................... 9-2
Suspension, lubricating the upper and lower arm
pivots ......................................................................... 8-34
Suspension relay arm and connecting arm pivoting
points, lubricating the rear ......................................... 8-33
Swingarm pivots, lubricating ........................................ 8-32
TTail/brake light bulb, replacing ..................................... 8-38
Throttle cable free play, adjusting ................................ 8-19
Throttle lever ........................................................... 4-4, 5-4
Tire pressure, measuring ............................................... 5-5
Tires ............................................................................... 5-4
Tire wear limit ................................................................. 5-6
Troubleshooting ........................................................... 8-42
Troubleshooting chart .................................................. 8-43
Turn signal indicator light ............................................... 4-2
Turn signal light bulb, replacing ................................... 8-38
Turn signal switch .......................................................... 4-4VValve clearance ............................................................ 8-19
Vehicle identification number ....................................... 11-1WWheel bearings, checking ............................................ 8-32
Wheel, installing ........................................................... 8-41
Wheel, removing .......................................................... 8-40
U10P60E0.book Page 2 Thursday, June 15, 2006 4:19 PM