2011 VOLVO XC70 lights

REMOTE KEY WITH PCC* – PERsOnal CaR COMMunICaTOR
IgnITIOn MOdEs (MOdEs 0 and I)
To access the following ignition modes: The brake pedal must not be depressed.Mode active functions
Remote key inser ted but not drawn into ignition slot – audio system and cour tesy lighting.
Remote key drawn into ignition slot – audio system and cour tesy lighting. Instrument /clock lighting, steering wheel lock /unlocked.
Remote key drawn into ignition slot and sTa RT pressed briefly – power moonroof/windows, blower, ECC, wipers, 12-volt sockets in center console, Volvo Navigation System*.To exit ignition modes 0/I and turn off the vehicle’s electrical system: Press in the remote key. It will be partially ejected from the igntion slot.
PCC*
1 Green light: vehicle is locked.
2 Yellow light: vehicle is unlocked.
3 Red light: alarm has been triggered.
4 Alternatively flashing red lights: the alarm was triggered less than 5 minutes ago.
Locks the doors and tailgate and arms the alarmA.
Unlocks the doors and tailgate, and disarms the alarmB
Unlocks the tailgate.
Approach lighting illuminates lights in door mirrors, cabin, footwells, license plates. Turn signals and parking lights illuminate.
“Panic” alarm. – Press and hold to sound the alarm. Turn off alarm with unlock button.
Information about the car can be gath-ered within a range of 65 ft. (20 m).
– Press the button and wait for 7 sec-onds.
If the vehicle is out of range when the button is pressed, the most recently stored status information will be shown.A The accessory inclination and movement alarm sensors can be turned off. See the “Alarm” section of your owner’s manual for information.
B Automatic relock occurs if no door/tailgate is opened within 2 minutes after unlock.

lIgHTIng PanEl
WIPERs and RaIn sEnsOR* EMERgEnCY BRaKE assIsT (EBa)
CaR CaRE
EBA is designed to provide full brake effect immediately in the event of sudden, hard braking. When EBA is activated, the brake pedal will go down more than usual.
– Press and hold the brake pedal for as long as necessar y – there will be no braking ef-fect if the pedal is released.
Hand washing is gentler on the paint than an automatic car wash. Since the paint on a new vehicle may take several months to harden completely, we recommend washing the vehicle by hand during this period. Use clean water, a suitable car washing detergent and a sponge. Keep in mind that dirt or grit on the sponge can scratch the paint.
AHigh beam flash
BToggle between high/low beams. Home safe lighting.
1Rain sensor On/Off with the lever in the 0 position.
2Turn to adjust intermittent wiper speed or rain sensor sensitivity where applicable.
3Tailgate wiper – normal/interval.
ASingle wiper sweep.
0Off
BIntermittent wipers. Turn (2) to adjust interval.
CNormal wiper speed.
DHigh wiper speed.
EWindshield and headlight washer.
FTailgate washer.
Displayed when the rain sensor is active.
Display & instrument panel lighting.
Front fog lights.
Rear fog light (driver’s side only).
Automatic headlights. High beam flash only.
Parking lights.
Headlights: turn off when ignition is switched off, high/low beams.
Open the fuel filler door.
Press once to unlock the trunk, press twice to pop open the trunk slightly.

adjusTIng THE fROnT sEaT
1 Lumbar support.
2 Backrest tilt.
3 Raise/lower the seat.
4 Raise/lower the front edge of the seat cushion.
5 Forward/rearward.
6 Folding down the passenger’s seat back-rest.
TP 12009 (
USA & Canada
). AT 1020. Printed in Sweden, Göteborg 2010. Copyright © 2000 -2010 Volvo Car Corporation.
When a low tire pressure warning message (low tire press. check tires or very low tire pressure) has been displayed and the tire pressure warning light ( )has illuminated, one or more tires has low inflation pressure.
Check the inflation pressure of all four tires with a tire pressure gauge as soon as pos-sible and pump the tire(s) with low pressure to the recommended inflation pressure.
Refer to the inflation pressure tables in the section “Wheels and tires” in the Owner’s Manual.
If the BLIS indicator lights illuminate even when there are no vehicles in the blind area, this may be due to light reflected from a wet road surface, the vehicle’s own shadow against a large, light, smooth surface, or sunlight directly in the camera when the sun is low on the horizon.
In the event of a fault, Blind spot syst. service required will be displayed. See the Owner’s Manual for other BLIS-related mes-sages. ElECTRIC PaRKIng BRaKE
setting
–
Press the button. The light flashes until the parking brake is fully applied, then glows continuously.
Releasing
Ignition mode 0 or higher.
Press the brake pedal and pull out the but-ton.
Release automatically
– Select a gear and begin driving. The parking
brake will release automatically (the driver’s seat belt must be fastened).
1.
2.
TIRE PREssuRE MOnITORIng
sYsTEM (TPMs)

BlInd sPOT InfORMa
TIOn
sYsTEM (BlIs)*