
STEERING WHEEL AND MIRRORS11 3
MS13021
To adjust the rear view mirror, simply
operate the control lever.
NOTICE
If ice should jam the mirror, do not
operate the control or scrape the mir-
ror face. Use a spray de−icer to free
the mirror.
MS13088
The rear view mirrors can be folded
backward for parking in compact areas.
To fold the rear view mirror, push back-
ward until you hear the click.
CAUTION
Do not drive with the mirrors folded
backward. Both the driver and pas-
senger side rear view mirrors must
be extended and properly adjusted
before driving.
NOTICE
Do not push backward more than the
click. It may damage the mirror or
vehicle.
AYGO WE 99E37E11 02.18
—Rear view mirror remote
control—Folding rear view mirrors

11 4STEERING WHEEL AND MIRRORS
MS13083
Adjust the mirror so that you can just
see the rear of your vehicle in the mir-
ror.
To reduce glare from the headlights of
the vehicle behind you during night
driving, operate the lever on the lower
edge of the mirror.
Daylight driving—Lever at position 1
The reflection in the mirror has greater
clarity at this position.
Night driving—Lever at position 2
Remember that by reducing glare you also
lose some rear view clarity.
CAUTION
Do not adjust the mirror while the
vehicle is moving. Doing so may
cause the driver to mishandle the ve-
hicle and an accident may occur re-
sulting in death or serious injuries.
MS13023
To use the vanity mirrors, swing down
the sun visor and open the cover.
AYGO WE 99E37E11 02.18
Anti−glare inside rear view
mirrorVanity mirrors

132GAUGES, METERS AND SERVICE REMINDER INDICATORS
(i) Engine Coolant Temperature Warn-
ing Light
This light comes on or blinks in the fol-
lowing cases:
DThe light will come on when the engine
switch is turned to the “ON” position.
After a few seconds, the light will go
off.
DWhen the engine coolant temperature
becomes high, the engine coolant tem-
perature warning light blinks. If the
temperature rises further, the engine
coolant temperature warning light re-
mains on and the “STOP” warning light
blinks at the same time. In such cases,
stop the vehicle and check the engine.
For detailed instructions, see “If your
vehicle overheats” on page 225 in Sec-
tion 4.
NOTICE
Continuing to drive when the engine
coolant temperature warning light is
blinking or the engine coolant temper-
ature warning light remains on and
the “STOP” warning light is blinking
at the same time, could result in the
engine overheating.
(j) “Multi−mode Manual Transmission”
Warning Light (Multi−mode manual
transmission only)
This light will come on when the engine
switch is turned to the “ON” position. After
a few seconds, the light will go off. This
means the multi−mode manual transmis-
sion system isoperating properly.
NOTICE
In case the Multi−mode manual trans-
mission warning light comes on, pull
over, stop the engine and contact any
authorized Toyota dealer or repairer,
or another duly qualified and
equipped professional. Otherwise, the
vehicle may jerk when shifted gear or
the clutch may not engage properly.
In some cases the shift requirement
may be canceled and the gear may be
locked.
(k) “ABS” Warning Light
Vehicles without vehicle stability control
system—
The light comes on when the engine
switch is turned to the “ON” position. If
the anti−lock brake system works properly,
the light turns off after a few seconds.
Thereafter, if the system malfunctions, the
light comes on again.
When the “ABS” warning light is on (and
the brake system warning light is off), the
anti−lock brake systemdoes not operate,
but the brake system stilloperates con-
ventionally.
When the “ABS” warning light is on (and
the brake system warning light is off), the
anti−lock brake systemdoes not operate
so that the wheels could lock up during
sudden braking or braking on slippery
road surfaces.
AYGO WE 99E37E11 02.18

GAUGES, METERS AND SERVICE REMINDER INDICATORS133
If either of the following conditions
occurs, this indicates a malfunction
somewhere in the components moni-
tored by the warning light system.
Contact any authorized Toyota dealer or
repairer, or another duly qualified and
equipped professional, as soon as
possible to service the vehicle.
DThe light does not come on when the
engine switch is turned to the “ON”
position, or remains on.
DThe light comes on while you are driv-
ing.
A warning light turning on briefly during
operation does not indicate a problem.
CAUTION
If the “ABS” warning light remains on
together with the brake system warn-
ing light, immediately stop your ve-
hicle at a safe place and contact any
authorized Toyota dealer or repairer,
or another duly qualified and
equipped professional.
In this case, not only the anti−lock
brake system will fail but also the
vehicle will become extremely unsta-
ble during braking.
Vehicles with vehicle stability control sys-
tem—
The light comes on when the engine
switch is turned to the “ON” position. If
the anti−lock brake system and the brake
assist system work properly, the light
turns off after a few seconds. Thereafter,
if either of the system malfunctions, the
light comes on again.
When the “ABS” warning light is on (and
the brake system warning light is off), the
anti−lock brake system, the brake assist
system, the traction control system and
the vehicle stability control system do not
operate, but the brakesystem stilloper-
ates conventionally.When the “ABS” warning light is on (and
the brake system warning light is off), the
anti−lock brake systemdoes not operate
so that the wheels could lock up during a
sudden braking or braking on slippery
road surfaces.
If either of the following conditions
occurs, this indicates a malfunction
somewhere in the components moni-
tored by the warning light system,
contact any authorized Toyota dealer or
repairer, or another duly qualified and
equipped professional, as soon as
possible to service the vehicle.
DThe light does not come on when the
engine switch is turned to the “ON”
position, or remains on.
DThe light comes on while you are driv-
ing.
A warning light turning on briefly during
operation does not indicate a problem.
CAUTION
If the “ABS” warning light remains on
together with the brake system warn-
ing light, immediately stop your ve-
hicle at a safe place and contact any
authorized Toyota dealer or repairer,
or another duly qualified and
equipped professional.
In this case, not only the anti−lock
brake system will fail but also the
vehicle will become extremely unsta-
ble during braking.
(l) “VSC” Warning Light
This light warns that there is a problem
somewhere in the vehicle stability control
system or traction control system.
The light will come on when the engine
switch is turned to the “ON” position and
will go off after a few seconds.
AYGO WE 99E37E11 02.18

GAUGES, METERS AND SERVICE REMINDER INDICATORS135
CAUTION
If the electric power steering system
warning light comes on, take your ve-
hicle to any authorized Toyota dealer
or repairer, or another duly qualified
and equipped professional, as soon
as possible. In this case, more effort
is required for the steering wheel to
turn than usual. Drive your vehicle
while firmly gripping the steering
wheel.
(o) Light Reminder Buzzer
This buzzer will sound if the driver ’s door
is opened while the engine switch is
turned to the “LOCK” position with the
headlight switch on. Removing the key will
not stop the buzzer as long as the head-
light switch is on.
(p) Warning function of the Multi−mode
manual transmission (Multi−mode
manual transmission only)
When driving, if any incorrect operation
that may cause damage to this system is
performed or if the gear is not shifted as
desired by the driver, the warning buzzer
will sound and the gear position indicator
will blink to warn the driver in some
cases. For details, see “—Warning
functions” on page 154 in Section 1−7.
When the shift lever is shifted to “R”, the
reverse buzzer sounds once. This is to
indicate the shift lever position, not a
malfunction. For details, see “(d) Backing
up” on page 143 or 150 in Section 1−7.CHECKING SERVICE REMINDER
INDICATORS (except the low fuel level
warning light)
1. Apply the parking brake.
2. Turn the engine switch to the “ON”
position, but do not start the engine.
All the service reminder indicators should
come on. The “ABS”, “VSC”, “STOP”, en-
gine coolant temperature, Multi−mode
manual transmission warning lights and
electric power steering system warning
lights go off after a few seconds. The
SRS warning light goes off after 6 sec-
onds.
If any service reminder indicator or warn-
ing buzzer does not function as described
above, have it checked by any authorized
Toyota dealer or repairer, or another duly
qualified and equipped professional, as
soon as possible.
AYGO WE 99E37E11 02.18

138ENGINE (IGNITION) SWITCH, TRANSMISSION AND PARKING BRAKE
Engine (ignition) switch
MS16003c
“START”—Starter motor on. The key
will return to the “ON” position when
released.
For starting tips, see page 209 in Section
3.
“ON”
—Engine on and all accessories on.
This is the normal driving position.“ACC”—Accessories such as the radio
operate, but the engine is off.
“LOCK”—Engine is off and the steering
wheel is locked. The key can be re-
moved only at this position.
When the engine switch is turned from the
“ACC” to the “LOCK” position or 20 sec-
onds have elapsed since the engine
switch is turned from the “ON” to the
“ACC” position, the engine immobilizer
system is automatically set. (See “Engine
immobilizer system” onpage 13 in Section
1−2.)
When starting the engine, the engine
switch may seem stuck at the “LOCK”
position. To free it, first be sure the key
is pushed all the way in, and then rock
the steering wheel slightly while turning
the key gently.
It is not a malfunction if the needles on
all meters and gauges move slightly when
the engine switch is turned to the “ACC”,
“ON” or “START” position.
CAUTION
Never remove the key when the ve-
hicle is moving, as this will lock the
steering wheel and result in loss of
steering control.
NOTICE
Do not leave the engine switch in the
“ON” position if the engine is not
running. The battery will discharge
and the ignition could be damaged.
11 02.18
AYGO WE 99E37E

ENGINE (IGNITION) SWITCH, TRANSMISSION AND PARKING BRAKE157
Traction control system
The traction control system automatical-
ly helps control the spinning of front
wheels when the vehicle is started or
accelerated on slippery road surfaces.
When the engine switch is turned to the
“ON” position, the system automatically
turns on.
CAUTION
Under certain slippery road condi-
tions, full traction of the vehicle and
power against front wheels cannot be
maintained, even though the traction
control system is in operation. Do not
drive the vehicle under any speed or
maneuvering conditions which may
cause the vehicle to lose traction
control. In situations where the road
surface is covered with ice or snow,
your vehicle should be fitted with
snow tires or tire chains. Always
drive at an appropriate and cautious
speed for the present road condi-
tions.
MS16014
Leave the system on during the ordi-
nary driving so that it can operate
when needed.
You may hear a sound in the engine
compartment for a few seconds when the
engine is started or just after the vehicle
begins to move. This means that the trac-
tion control system is in the self−check
mode, but does not indicate a malfunction.
When the traction control system isoper-
ating, the following conditions occur:
DThe system controls the spinning of the
front wheels. At this time, the slip indi-
cator light blinks.
DYou may feel vibration or noise in your
vehicle, caused by operation of the
brakes. This indicates the system is
functioning properly.
The slip indicator light comes on for a few
seconds when the engine switch is turned
to the “ON” position. If the indicator light
does not come on when the engine switch
is turned on, contact any authorized Toyo-
ta dealer or repairer, or another duly qual-
ified and equipped professional.
11 02.18
AYGO WE 99E37E

158ENGINE (IGNITION) SWITCH, TRANSMISSION AND PARKING BRAKE
ST16005
“VSC” warning light
This light warns that there is a problem
somewhere in the traction control system
or the vehicle stability control system.
The light will come on when the engine
switch is turned to the “ON” position and
will go off after a few seconds.
If the light comes on while driving, the
systemdoes not work. However, as con-
ventional braking operates when applied,
there is no problem to continue your driv-
ing.
In the following cases, contact any autho-
rized Toyota dealer or repairer, or another
duly qualified and equipped professional:
DThe warning light does not come on
after the engine switch is turned to the
“ON” position.
DThe warning light remains on after the
engine switch is turned to the “ON”
position.
DThe warning light comes on while driv-
ing.The vehicle stability controlsystem au-
tomatically controls the brakes and en-
gine to help prevent the vehicle from
skidding when cornering on a slippery
road surface or operating steering
wheel abruptly.
The vehicle stability control system is acti-
vated when the vehicle speed is more
than 15 km/h (9 mph).
You may hear a sound in the engine
compartment for a few seconds when the
engine is started or just after the vehicle
begins to move. This means that the sys-
tem is in the self−check mode but does
not indicate a malfunction.
CAUTION
DDo not rely excessively on the ve-
hicle stability controlsystem. Even
if the system is operating, you
must always drive carefully and at-
tentively. Reckless driving will re-
sult in an unexpected accident and
cause death or serious injury. If the
slip indicator light blinks, and spe-
cial care should be taken while
driving.
DOnly use tires of specified size. The
size, manufacture, brand and tread
pattern for all 4 tires should be the
same. If you use the tires other
than specified, or different type or
size, the vehicle stability control
system may not function correctly.
When replacing the tires or wheels,
contact any authorized Toyota deal-
er or repairer, or another duly quali-
fied professional. (See “Checking
and replacing tires” on page 270 in
Section 7−2.)
DIn situations where the road surface
is covered with ice or snow, your
vehicle should be fitted with snow
tire or tire chains.
11 02.18
AYGO WE 99E37E
Vehicle stability control
system