2011 TOYOTA AYGO fog light

LIGHTS, WIPERS AND DEFOGGER11 9
Rear fog light
MS14006a
To turn on the rear fog light, twist the
band of the headlight and turn signal
switch lever to the position of the rear
fog light. They will come on when the
headlights are on.
The rear fog light indicator on the instru-
ment cluster will light up when the rear
fog light is turned on.
The rear fog light will go off automatically
when all other lights are turned off.
After the headlight switch is turned off,
the rear fog light does not come on even
if you turn on the headlight switch again.
To turn on the rear fog light, twist the
band of the headlight and turn the signal
switch lever to the position of the rear fog
light again under the condition stated
above.
Interior light
MS14007
To turn on the interior light, slide the
switch.
The interior light switch has the following
positions:
“
” (ON)—Keeps the light on all the
time.
“
” (OFF)—Turns the light off.
“
” (DOOR)—Turns the light on when
the driver ’s door is opened.
AYGO WE 99E37E11 02.18

120LIGHTS, WIPERS AND DEFOGGER
Windshield wiper and washer
MS14008a
To turn on the windshield wiper, move
the lever to the desired setting.
The engine switch must be in the “ON”
position.
Lever position
Speed setting
Position 1Intermittent
Position 2Slow
Position 3Fast
For a single sweep of the windshield,
push the lever up and release it.
To squirt washer fluid, pull the lever
toward you.
For instructions on adding washer fluid,
see “Adding washer fluid” on page 282 in
Section 7−3.
In freezing weather, warm the windshield
with the defroster before using the washer.
This will help prevent the washer fluid
from freezing on your windshield, which
could block your vision.
NOTICE
Do not operate the wiper if the wind-
shield is dry. It may scratch the
glass.
MS14009a
To turn on the rear window wiper, twist
the lever knob upward. (Position 1)
The engine switch must be in the “ON”
position.
To squirt washer fluid on the rear window,
twist the knob upward or downward as far
as it will go (position 2 or 3). The knob
automatically returns from these positions
after you release it.
For instructions on adding washer fluid,
see “Adding washer fluid” on page 282 in
Section 7−3.
NOTICE
Do not operate the rear wiper if the
rear window is dry. It may scratch the
glass.
AYGO WE 99E37E11 02.18
Rear window wiper and
washer

LIGHTS, WIPERS AND DEFOGGER121
Rear window defogger
MS14010a
To defog or defrost the rear window,
push the switch.
The engine switch must be in the “ON”
position.
The thin heater wires on the inside of the
rear window will quickly clear the window
surface. An indicator light will illuminate to
indicate the defogger is operating.
Push the switch once again to turn the
defogger off.
Make sure you turn the defogger off when
the window surface is clear. Leaving the
defogger on for a long time could cause
the battery to discharge, especially during
stop−and−go driving. The defogger is not
designed for drying rain water or for melt-
ing snow.
NOTICE
zTo prevent the battery from being
discharged, turn the switch off
when the engine is not running.
zWhen cleaning the inside of the
rear window, be careful not to
scratch or damage the heater wires
or connectors.
AYGO WE 99E37E11 02.18

122LIGHTS, WIPERS AND DEFOGGER
AYGO WE 99E37E11 02.18

214STARTING AND DRIVING
Driving in the rain
Driving on a slippery road surface
Drive carefully when it is raining, because
visibility will be reduced, the windows may
become fogged−up, and the road will be
slippery.
DDrive carefully when it starts to rain,
because the road surface will be espe-
cially slippery.
DRefrain from high speeds when driving
on an expressway in the rain, because
there may be a layer of water between
the tires and the road surface, prevent-
ing the steering and brakes from oper-
ating properly.
CAUTION
DSudden braking, acceleration and
steering when driving on a slippery
road surface may cause tire slip-
page and reduce your ability to
control the vehicle, resulting in an
accident.
DSudden changes in engine speed,
such as sudden engine braking,
may cause the vehicle to skid, re-
sulting in an accident.
DAfter driving through a puddle,
lightly depress the brake pedal to
make sure that the brakes are func-
tioning properly. Wet brake pads
may prevent the brakes from func-
tioning properly. If the brakes on
only one side are wet and not func-
tioning properly, steering control
may be affected, resulting in an ac-
cident.
When encountering flooded roads
Do not drive on a road that has flooded
after heavy rain etc. Doing so may cause
serious damage to the vehicle.
NOTICE
Driving on a flooded road may cause
the engine to stall as well as cause
serious vehicle malfunctions such as
shorts in electrical components and
engine damage from water immersion.
In the event that you drive on a
flooded road and the vehicle is
flooded, be sure to have your Toyota
dealer check brake function, changes
in quantity and quality of engine oil,
transaxle fluid, etc. and lubricant con-
dition for the bearings and suspen-
sion joints (where possible) and the
function of all joints and bearings.
AYGO WE 99E37E11 02.18

CORROSION PREVENTION AND APPEARANCE CARE251
Seat belts
The seat belts may be cleaned with
mild soap and water or with lukewarm
water.
Use a cloth or sponge. As you are clean-
ing, check the belts for excessive wear,
fraying, or cuts.
NOTICE
zDo not use dye or bleach on the
belts—it may weaken them.
zDo not use the belts until they be-
come dry.
Windows
NOTICE
zDo not use glass cleaner to clean
the inside of the rear window, as
this may cause damage to the rear
window defogger heater wires. Use
a cloth dampened with lukewarm
water to gently wipe the window
clean. Wipe the window in strokes
running parallel to the heater wires.
zWhen cleaning the inside of the
rear window, be careful not to
scratch or damage the heater wires.
Air conditioning control panel, audio
panel, instrument panel, console panel,
door switch panels and switches
Use a soft damp cloth for cleaning.
Soak a clean soft cloth in cold or luke-
warm water then lightly wipe off any dirt.
NOTICE
zDo not use organic substances (sol-
vents, kerosene, alcohol, gasoline,
etc.) or alkaline or acidic solutions.
These chemicals could cause dis-
coloring, staining or peeling of the
surface.
zIf you use cleaners or polishing
agents, make sure their ingredients
do not include the substances men-
tioned above.
zIf you use a liquid car freshener, do
not spill the liquid onto the ve-
hicle’s interior surfaces. It may con-
tain the ingredients mentioned
above. Immediately clean any spill
using the method mentioned above.
Synthetic leather
DRemove loose dirt using a vacuum
cleaner.
DApply a mild soap solution to the syn-
thetic leather using a sponge or soft
cloth.
AYGO WE 99E37E11 02.18

282DO−IT YOURSELF MAINTENANCE: Electrical components
Adding washer fluid
If any washer does not work, the wash-
er tank may be empty. Add washer
fluid.
You may use plain water as washer fluid.
However, in cold areas where tempera-
tures range below the freezing point, use
washer fluid containing antifreeze. This
product is available at your Toyota dealer
or repairer and most auto parts stores or
another duly qualified professional. Follow
the manufacturer ’s directions for how
much to mix with water.
NOTICE
Do not use engine antifreeze or any
other substitute because it may dam-
age your vehicle’s paint.
Replacing light bulbs—
The following illustrations show how to
gain access to the bulbs. When replacing
a bulb, make sure the engine switch and
light switch are off. Use bulbs with the
wattage ratings given in the table.
CAUTION
DTo prevent burning yourself, do not
replace the light bulbs while they
are hot.
DHalogen bulbs have pressurized gas
inside and require special handling.
They can burst or shatter if
scratched or dropped. Hold a bulb
only by its plastic or metal case.
Do not touch the glass part of a
bulb with bare hands.
NOTICE
Only use a bulb of the listed type.
The inside of the lens of exterior lights
such as headlights may temporarily fog up
when the lens becomes wet in the rain or
in a car wash. This is not a problem
because the fogging is caused by the
temperature difference between the outside
and inside of the lens, just like the wind-
shield fogs up in the rain. However, if
there is a large drop of water on the
inside of the lens, or if there is water
pooled inside the light, contact any autho-
rized Toyota dealer or repairer, or another
duly qualified and equipped professional.
AYGO WE 99E37E1102.18

DO−IT YOURSELF MAINTENANCE: Electrical components283
Light bulbsWTy p e
Headlights60/55A
Position lights5D
Front turn signal lights21C
Side turn signal lights5—
Rear turn signal lights21B
Stop/tail lights21/5B
Back−up lights21B
Rear fog light21B
High mounted stoplight5D
License plate lights5D
Interior light5D
A: H4 halogen bulbs
B: Single end bulbs (clear)
C: Single end bulbs (amber)
D: Wedge base bulbs (clear)
—Headlights
MS73001
1. Open the hood. Unplug the connec-
tor. Remove the rubber cover.
If the connector is tight, wiggle it.
AYGO WE 99E37E1102.18