2011 TOYOTA AURIS jump cable

474
5-2. Steps to take in an emergency
UK_AURIS_HV_EE
If the 12-volt batter y is discharged
The following procedures may be used to start the hybrid system if
the vehicle's 12-volt battery is discharged.
You can call any authorized Toyota dealer or repairer, or another duly
qualified and equipped professional.
If you have a set of jumper (or booster) cables and a second vehi-
cle with a 12-volt battery, you can jump start your Toyota following
the steps below.
Open the hood and fuse block
cover.
Open the exclusive jump start-
ing terminal cover.
STEP1
STEP2

5
475 5-2. Steps to take in an emergency
When trouble arises
UK_AURIS_HV_EE
Connect the jumper cables.
Exclusive jump starting terminal on your vehicle
Positive (+) battery terminal on the second vehicle
Negative (-) battery terminal on the second vehicle
Connect the jumper cable to ground on your vehicle as shown in
the illustration.
Start the engine of the second vehicle. Increase the engine
speed slightly and maintain at that level for approximately 5
minutes to recharge the 12-volt battery of your vehicle.
Maintain the engine speed of the second vehicle and turn
the “POWER” switch to ON mode, then start the vehicle's
hybrid system.
Make sure the “READY” indicator comes on. If the indicator
does not come on, contact at any authorized Toyota dealer
or repairer, or another duly qualified and equipped profes-
sional.
STEP3
STEP4
STEP5
STEP6

476 5-2. Steps to take in an emergency
UK_AURIS_HV_EE
Starting the hybrid system when the 12-volt battery is discharged
The hybrid system cannot be started by push-starting.
Avoiding a discharged 12-volt battery
Turn off the headlights and the audio system while the hybrid system is
turned off.
Turn off any unnecessary electrical components when the vehicle is run-
ning at a low speed for an extended period, such as in heavy traffic, etc.
When the 12-volt battery is removed or discharged
If the 12-volt battery is depleted with the shift position in P, it will not be
possible to shift out of P. In this case, the vehicle cannot be towed without
lifting both front wheels because the front wheels are locked by the park-
ing lock. (P. 423)
The hybrid system may not start. (P. 384)
Once the hybrid system has started, remove the jumper
cables in the exact reverse order in which they were con-
nected.
Close the exclusive jump starting terminal cover and rein-
stall the fuse box cover.
Once the hybrid system starts, have the vehicle checked at any
authorized Toyota dealer or repairer, or another duly qualified and
equipped professional, as soon as possible.STEP7
STEP8

5
477 5-2. Steps to take in an emergency
When trouble arises
UK_AURIS_HV_EE
CAUTION
Avoiding 12-volt battery fires or explosions
The flammable gas that may be generated by the assisting vehicle battery
may catch fire and explode. Make sure to observe the following to prevent
fire or sparks.
Make sure the jumper cable is connected to the correct terminal and that it
is not unintentionally in contact with any part other than the intended termi-
nal.
Do not allow the jumper cables to come into contact with the “+” and “-” ter-
minals.
Do not allow open flame or use matches, cigarette lighters or smoke near
the 12-volt battery.
12-volt battery precautions
The 12-volt battery contains poisonous and corrosive acidic electrolyte,
while related parts contain lead and lead compounds. Observe the following
precautions when handling the 12-volt battery.
When working with the 12-volt battery, always wear safety glasses and
take care not to allow any battery fluids (acid) to come into contact with
skin, clothing or the vehicle body.
Do not lean over the 12-volt battery.
In the event that battery fluid comes into contact with the skin or eyes,
immediately wash the affected area with water and seek medical attention.
Place a wet sponge or cloth over the affected area until medical attention
can be received.
Always wash your hands after handling the battery support, terminals, and
other battery-related parts.
Do not allow children near the 12-volt battery.

478 5-2. Steps to take in an emergency
UK_AURIS_HV_EE
NOTICE
When handling jumper cables
Be careful that the jumper cables do not become tangled in the cooling fan
or any of the belts when connecting or disconnecting them.
Exclusive jump starting terminal precaution
The exclusive jump starting terminal is to be used when charging the 12-volt
battery from another vehicle in an emergency. It cannot be used to jump start
another vehicle.