2011 Peugeot RCZ ECU

2/
ACCESS
ELECTRIC WINDOWS
Fitted with a safety anti-pinch system.


A.
Left-hand electric window control switch.


B.
Right-hand electric window control switch.




ONE-TOUCH ELECTRIC WINDOWS

There are two options:


- manual mode



)
Press or pull the switch gently. The window stops when the
switch is released.

- automatic mode



)
Press or pull the switch fi rmly. The window opens or closes fully
when the switch is released.

)
Pressing the switch again stops the movement of the window.
The electric window switches remain operational for approximately
45 seconds after the ignition is switched off or until the vehicle is
locked after a door is opened.
If the passenger's window cannot be operated from the driver's
door control panel, carry out the operation from the control panel
of the passenger door.
After approximately ten consecutive complete opening/closing
movements of the window, a protection function is activated which
only authorises closing of the windows, so as to prevent damage
to the electric window motor.
Once the window is closed, the switches will become operational
again after approximately 40 minutes.

Safety anti-pinch

When the window rises and meets an obstacle, it stops and partially
lowers again.
If the window cannot be closed (for example, in the presence of ice),
immediately after the movement is reversed:


)
press and hold the switch until the window opens fully,

)
then pull the switch immediately and hold it until the window
closes,

)
continue to hold the switch for approximately one second after
the window has closed.

The safety anti-pinch function is not operational during these
operations.

2/
ACCESS

Pressing the central locking control unlocks the vehicle.
Opening a door from the inside, when stationary, also unlocks the
vehicle, but the vehicle will be locked again when the speed exceeds
6 mph (10 km/h).


Activation/Deactivation

You can activate or deactivate this function.


)
With the ignition on, press the button for more than two seconds.
A confi rmation message appears in the screen.

In the event of a serious impact with triggering of an airbag, the
vehicle's doors unlock automatically to allow the occupants to exit.











EMERGENCY LOCKING

To lock or unlock the doors mechanically in the event of a central
locking system failure or fl at battery.


Locking the driver's door



)
Insert the key in the lock, then turn it to the right.



Unlocking the driver's door



)
Insert the key in the lock, then turn it to the left.



Locking the passenger door



)
Using the key, remove the black cap on the edge of the door.

)
Insert the key in the cavity without forcing, then without turning it,
move the the latch sideways towards the interior of the door.

)
Remove the key and refi t the cap.



Unlocking the passenger door



)
Pull the interior door opening control.




ANTI-ATTACK SECURITY

This function permits automatic and simultaneous locking of the doors,
boot lid and fuel fi ller fl ap as soon as the vehicle speed exceeds 6 mph
(10 km/h).

Operation

If one of the doors is open, the automatic central locking does not take
place.
If the boot lid is open, the automatic central locking of the doors is
active.

1
2
M66
STORING DRIVING POSITIONS
System which takes into account the electrical settings of the driver's
seat and the door mirrors. It enables you to store two positions using
the buttons on the side of the driver's seat.

STORING A POSITION


Using buttons M/1/2



)
Switch on the ignition.

)
Adjust your seat and your door mirrors.

)
Press button M
, then press button 1
or 2
within four seconds.
An audible signal is heard indicating that the settings have been
stored.


RECALLING A STORED POSITION

Storing a new position cancels the previous position.



Using button 1 or 2



)
Press and hold button 1
or 2
until the audible signal is heard
indicating the end of the adjustment.
When the ignition is off, after a few consecutive position recalls,
the function will be deactivated until the engine is started,
to prevent discharging of the battery.

3/
EASE OF USE and COMFORT

ACCESS TO THE REAR SEATS
REAR SEATS

Two-seat bench with one-piece fi xed seat cushion and one-piece
folding backrest.
The rear headrests are fi xed.


FOLDING DOWN THE REAR BACKREST


RETURNING THE REAR BACKREST TO THE UPRIGHT POSITION

When returning the backrest to the upright position, ensure that it is
locked securely to assure your safety.
)
Open the boot.

)
Pull the backrest release handle, located under the shelf.
When transporting long objects, do not place a load of more
than 30 kg on the rear of the backrest.
Do not place rough objects on the rear of the backrest which
could damage it.

)
Check that the front seat has been moved forward suffi ciently.

)
Pull the control upwards to tilt the backrest.
When the seat is put back in place, the backrest returns to its initial position.
The backrest can be folded down to increase the boot storage space.
The backrest release control is located in the boot.


)
Check that the front seats have been moved forward suffi ciently.

)
Check that nothing has been left on the rear seats.

)
Store the seat belt buckles on their respective securing points
located between the headrests.
)
Fold the backrest down onto the seat cushion.

3/
EASE OF USE and COMFORT
MATS
Removable carpet protection.


FITTING

When fi tting the mat for the fi rst time, on the driver's side use only
the fi xings provided in the wallet attached.
The other mats are simply placed on the carpet.


REMOVAL

To remove the mat on the driver's side:


)
move the seat as far back as possible,

)
unclip the fi xings,

)
remove the mat.



REFITTING

To refi t the mat on the driver's side:


)
position the mat correctly,

)
refi t the fi xings by pressing,

)
check that the mat is secured correctly.

To avoid any risk of jamming of the pedals:


- only use mats which are suited to the fi xings already present
in the vehicle; these fi xings must be used,

- never fi t one mat on top of another.
The use of mats not approved by PEUGEOT may interfere with
access to the pedals and hinder the operation of the cruise
control/speed limiter.

3/
EASE OF USE and COMFORT
The duration of lighting varies, depending on the context:


- when the ignition is off, approximately ten minutes,

- in energy economy mode, approximately thirty seconds,

- when the engine is running, no limit.






STORAGE BOX

This has areas for storing a box of spare bulbs, a fi rst aid kit, the
temporary puncture repair kit, a warning triangle, the removable ball
of the towbar system...






BOOT LAMPS

Your vehicle is fi tted with two boot lamps; one in the right-hand boot
side trim and a second in the centre under the rear shelf.
They come on automatically when the boot is opened and switch off
automatically when the boot is closed.
They cannot be deactivated manually.
A second warning triangle can be stored in the boot lid trim. It also contains the vehicle’s handbook pack.
For access to it:


)
raise the fl oor using the strap,

)
secure it in the vertical position behind the stops,
located on the sides of the boot.

5/
SAFETY

REAR SEAT BELTS

The rear seats are each fi tted with a three-point inertia reel seat belt
with force limiter.

Fastening



1.
Pull the strap and insert the tongue F
in the black buckle F
, in the
centre of the bench seat.

2.
Insert the tongue G
in the outer red buckle G
.

3.
Check that each buckle is fastened correctly by pulling the strap.



Unfastening



1.
Press the red button on the buckle G
, then the black button on the
buckle F
.

2.
Guide the strap as it reels in and bring the tongue G
, then the
tongue F
to the corresponding securing point on the backrest.



Seat belt unfastened warning lamps display



A.
Rear seat belts unfastened warning lamp.

D.
Rear right seat belt warning lamp.

E.
Rear left seat belt warning lamp.
The warning lamp A
comes on, either on in the seat belt and
passenger's front airbag warning lamps display, when one or more rear
passengers unfasten their seat belt.
From approximately 12 mph (20 km/h), this warning lamp fl ashes for
two minutes accompanied by an audible signal of increasing volume.
Once these two minutes have elapsed, this warning lamp remains on
until the one or more rear passengers fasten their seat belt.
When the ignition is switched on, with the engine running or the
vehicle moving at a speed below approximately 12 mph (20 km/h), the
corresponding warning lamps D
and E
come on in red for approximately
30 seconds, if the seat belt is not fastened.
When the vehicle is moving at a speed of more than approximately
12 mph (20 km/h), the corresponding warning lamp D
or E
comes on in
red, accompanied by an audible signal and a message in the screen,
if a rear passenger has unfastened their seat belt.
Unfastening is detected on both buckles of the seat belt. The
corresponding warning lamp comes on when at least one of the
two buckles is unfastened.

11 0





The driver must ensure that passengers use the seat belts
correctly and that they are all restrained securely before
setting off.
Wherever you are seated in the vehicle, always fasten your seat
belt, even for short journeys.
Do not interchange the seat belt buckles as they will not fulfi l their
role fully.
The seat belts are fi tted with an inertia reel permitting automatic
adjustment of the length of the strap to your size. The seat belt is
stowed automatically when not in use.
Before and after use, ensure that the seat belt is reeled in
correctly.
The lower part of the strap must be positioned as low as possible
on the pelvis.
The upper part must be positioned in the hollow of the shoulder.
The inertia reels are fi tted with an automatic locking device which
comes into operation in the event of a collision, emergency
braking or if the vehicle rolls over. You can release the device by
pulling fi rmly on the strap and releasing it so that it reels in slightly.
In order to be effective, a seat belt must:


- be tightened as close to the body as possible,

- be pulled in front of you with a smooth movement, checking
that it does not twist,

- be used to restrain only one person,

- not bear any trace of cuts or fraying,

- not be converted or modifi ed to avoid affecting its
performance. In accordance with current safety regulations, for all repairs on your
vehicle, go to a qualifi ed workshop with the skills and equipment
needed, which a PEUGEOT dealer is able to provide.
Have your seat belts checked regularly by a PEUGEOT dealer or a
qualifi ed workshop, particularly if the straps show signs of damage.
Clean the seat belt straps with soapy water or a textile cleaning
product, sold by PEUGEOT dealers.
After folding or moving a seat or rear bench seat, ensure that the
seat belt is positioned and reeled in correctly.


Recommendations for children

Use a suitable child seat if the passenger is less than 12 years old or
shorter than one and a half metres.
Never use the same seat belt to secure more than one person.
Never allow a child to travel on your lap.


In the event of an impact


Depending on the nature and seriousness of the impact
, the
pretensioning device may be deployed before and independently
of the airbags. Deployment of the pretensioners is accompanied
by a slight discharge of harmless smoke and a noise, due to the
activation of the pyrotechnic cartridge incorporated in the system.
In all cases, the airbag warning lamp comes on.
Following an impact, have the seat belts system checked, and if
necessary replaced, by a PEUGEOT dealer or a qualifi ed workshop.