2011 Peugeot RCZ ESP
[x] Cancel search: ESPPage 91 of 276
4/
VISIBILITY
Model without AUTO lighting
Model with AUTO lighting
MANUAL CONTROLS
The lighting commands are issued directly by the driver by means of the
ring A
and the stalk B
.
A.
Main lighting mode selection ring: turn it to position the symbol
required facing the mark.
Lamps off.
Automatic illumination of headlamps.
B.
Stalk for switching headlamps: pull it to switch between dipped
headlamps/main beam headlamps.
In the lamps off and sidelamps modes, the driver can switch on the
main beam headlamps temporarily ("headlamp fl ash") by maintaining a
pull on the stalk. Sidelamps only.
Dipped or main beam headlamps.
DISPLAYS
Lighting of the corresponding indicator lamp on the instrument panel
confi rms the switching on of the lighting selected.
The instrument panel has permanent back-lighting, both day and night.
In this case, illumination of the instrument panel is not linked to the
exterior lighting.
Page 92 of 276
90
C.
Foglamp selection ring.
The foglamps operate with the dipped and main beam headlamps.
Front and rear foglamps.
Press, turning ring C
:
)
forwards once to switch on the front foglamps,
)
forwards again to switch on the rear foglamp,
)
rearwards once to switch off the rear foglamp,
)
rearwards again to switch off the front foglamps.
When the lighting is switched off automatically (with AUTO model) or
when the dipped beam headlamps are switched off manually, the front
foglamps and the sidelamps will remain on.
)
Turn the ring rearwards to switch off the front foglamps,
the sidelamps will then switch off.
In good or rainy weather, both day and night, the front foglamps
and the rear foglamp are prohibited. In these situations, the power
of their beams may dazzle other drivers. They should only be
used in fog or snow.
In these weather conditions, it is your responsibility to switch
on the foglamps and dipped beam headlamps manually as the
sunshine sensor may detect suffi cient light.
Do not forget to switch off the front foglamps and the rear foglamp
when they are no longer necessary.
Switching off of the lamps when the ignition is switched off
On switching off the ignition, all of the lamps turn off immediately,
except for dipped beam if guide-me-home lighting is activated.
Switching on the lamps after the ignition is switched off
To reactivate the lighting control, rotate ring A
to the "0"
position -
lamps off, then to the desired position.
On opening the driver's door a temporary audible signal warns the
driver that the lighting is on.
The lamps, with the exception of the sidelamps, switch off
automatically after a maximum duration of thirty minutes to
prevent discharging of the battery.
Page 101 of 276
5/
SAFETY
DIRECTION INDICATORS
If you forget to cancel the direction indicators for more than twenty
seconds, the volume of the audible signal will increase if the
speed is above 40 mph (60 km/h).
)
Left: lower the lighting stalk passing the point of resistance.
)
Right: raise the lighting stalk passing the point of resistance.
HAZARD WARNING LAMPS
A visual warning by means of the direction indicators to alert other road
users to a vehicle breakdown, towing or accident.
)
Press this button, the direction indicators fl ash.
They can operate with the ignition off.
AUTOMATIC OPERATION OF HAZARD
WARNING LAMPS
When braking in an emergency, depending on the deceleration, the
hazard warning lamps come on automatically.
They switch off automatically the fi rst time you accelerate.
)
You can also switch them off by pressing the button.
Deactivating the ESP/ASR systems also deactivates the automatic
operation of the hazard warning lamps; refer to the section "Trajectory
control systems - § Deactivation".
Page 102 of 276
100
TYRE UNDER-INFLATION DETECTION
System which automatically and continuously checks the pressure of
the tyres while driving.
The tyre under-infl ation detection system is an aid to driving which
does not replace the need for the driver to be vigilant or to drive
responsibly. Sensors fi tted in each valve trigger a warning in the event of malfunction
(speed above 12 mph (20 km/h)).
Under-inflated tyre
This warning lamp is displayed in the instrument panel
accompanied by an audible signal and an alert message
identifying the wheel concerned.
)
Check the tyre pressures as soon as possible.
This check must be carried out when the tyres are cold.
HORN
Audible warning to alert other road users to an imminent danger.
)
Press one of the spokes of the steering wheel.
EMERGENCY OR ASSISTA NCE
CALL
This system allows you to make an emergency or assistance call to the
emergency services or to the dedicated PEUGEOT service.
For more information on the use of this function, refer to the "Audio and
telematics" section.
Page 105 of 276
5/
SAFETY
ANTI-SLIP REGULATION (ASR) AND
ELECTRONIC STABILITY PROGRAMME (ESP)
The anti-slip regulation (also known as Traction Control) optimises
traction to prevent skidding of the wheels, by acting on the brakes of the
driving wheels and on the engine.
The electronic stability programme acts on the brake of one or more
wheels and on the engine to keep the vehicle on the trajectory required
by the driver, within the limits of the laws of physics.
Activation
These systems are activated automatically each time the vehicle is
started.
They come into operation in the event of a grip or trajectory problem.
This is indicated by fl ashing of this warning lamp in the
instrument panel.
SNOW DRIVING ASSISTANCE (INTELLIGENT
TRACTION CONTROL)
Your vehicle has a system to help driving on snow: Intelligent Traction
Control.
This automatic system continuously checks for situations of diffi cult
surface adhesion that could make it diffi cult to move off or make
progress on deep fresh snow or compacted snow.
In these situations, Intelligent Traction Control
limits the amount of
wheel slip to provide the best traction and trajectory control.
In extremely severe conditions (deep snow, mud…), it can be useful
to temporarily deactivate the ESP/ASR
systems to allow a degree of
wheel spin and so recover grip.
It is recommended that the system be reactivated as soon as possible.
Snow tyres are strongly recommended on surfaces offering low levels
of adhesion.
Page 106 of 276
104
Deactivation
In exceptional conditions (starting a vehicle which is bogged down,
stuck in snow, on soft ground, ...), it may be advisable to deactivate the
ASR and ESP systems, so that the wheels can move freely and regain
grip.
)
Press the "ESP OFF"
button, located in the centre of the
dashboard.
If this warning lamp on the instrument panel and the indicator
lamp on the button come on, this indicates that the ASR and
ESP systems are deactivated.
This action also deactivates the automatic operation of the
hazard warning lamps.
Reactivation
These systems are reactivated automatically each time the ignition is
switched back on.
)
You can also press the "ESP OFF"
button again to reactivate them
manually.
This action also reactivates the automatic operation of the hazard
warning lamps.
Operating fault
The ESP/ASR systems offer exceptional safety in normal driving,
but this should not encourage the driver to take extra risks or drive
at high speed.
The correct operation of these systems depends on observation of
the manufacturer's recommendations on
- wheels (tyres and rims),
- braking components,
- electronic components,
- assembly and repair procedures.
After an impact, have these systems checked by a PEUGEOT
dealer or a qualifi ed workshop.
If this warning lamp comes on, accompanied by an audible
signal and a message in the screen, this indicates a
malfunction of these systems.
Have it checked by a PEUGEOT dealer or a qualifi ed workshop dealer.
Page 110 of 276
108
SEAT BELTS
FRONT SEAT BELTS
Fastening
)
Pull the strap, then insert the tongue in the buckle.
)
Check that the seat belt is fastened correctly by pulling the strap.
Unfastening
)
Press the red button on the buckle.
)
Guide the seat belt as it reels in.
Seat belt not fastened/unfastened warning lamps display
A.
Front seat belts not fastened/unfastened warning lamp.
B.
Front left seat belt warning lamp.
C.
Front right seat belt warning lamp.
When the ignition is switched on, the warning lamp A
comes on in the
seat belt and passenger's front airbag warning lamp display, if the driver
and/or the front passenger has not fastened their seat belt.
From approximately 12 mph (20 km/h) this warning lamp fl ashes for two
minutes accompanied by an audible signal of increasing volume. Once
these two minutes have elapsed, this warning lamp remains on until the
driver and/or the front passenger fastens their seat belt.
The warning lamp B
or C
for the corresponding seat comes on in red if
the seat belt is not fastened or is unfastened.
The front seat belts are fi tted with a pretensioning and force limiting
system.
This system improves safety in the front seats in the event of a front or
side impact. Depending on the severity of the impact, the pretensioning
system instantly tightens the seat belts against the body of the
occupants.
The pretensioning seat belts are active when the ignition is on.
The force limiter reduces the pressure of the seat belt on the chest of
the occupant, so improving their protection.
Page 111 of 276
5/
SAFETY
REAR SEAT BELTS
The rear seats are each fi tted with a three-point inertia reel seat belt
with force limiter.
Fastening
1.
Pull the strap and insert the tongue F
in the black buckle F
, in the
centre of the bench seat.
2.
Insert the tongue G
in the outer red buckle G
.
3.
Check that each buckle is fastened correctly by pulling the strap.
Unfastening
1.
Press the red button on the buckle G
, then the black button on the
buckle F
.
2.
Guide the strap as it reels in and bring the tongue G
, then the
tongue F
to the corresponding securing point on the backrest.
Seat belt unfastened warning lamps display
A.
Rear seat belts unfastened warning lamp.
D.
Rear right seat belt warning lamp.
E.
Rear left seat belt warning lamp.
The warning lamp A
comes on, either on in the seat belt and
passenger's front airbag warning lamps display, when one or more rear
passengers unfasten their seat belt.
From approximately 12 mph (20 km/h), this warning lamp fl ashes for
two minutes accompanied by an audible signal of increasing volume.
Once these two minutes have elapsed, this warning lamp remains on
until the one or more rear passengers fasten their seat belt.
When the ignition is switched on, with the engine running or the
vehicle moving at a speed below approximately 12 mph (20 km/h), the
corresponding warning lamps D
and E
come on in red for approximately
30 seconds, if the seat belt is not fastened.
When the vehicle is moving at a speed of more than approximately
12 mph (20 km/h), the corresponding warning lamp D
or E
comes on in
red, accompanied by an audible signal and a message in the screen,
if a rear passenger has unfastened their seat belt.
Unfastening is detected on both buckles of the seat belt. The
corresponding warning lamp comes on when at least one of the
two buckles is unfastened.